• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2000년도 가을 학술발표회논문집(I)
• /
• pp.697-700
• /
• 2000

Fatigue damage to reinforced concrete bridge decks have been found in many bridges. Failure mode of most reinforced concrete decks is caused by local punching shear rather than flexural moment due to cumulated damage. In this study, mechanical degradation of unstrengthened and strengthened bridge deck specimens is experimentally investigated. The unstrengthened deck specimens were damaged under the pulsating loading condition. After the test, deteriorated deck specimens were strengthened with Carbon Fiber Sheet, then loaded to observe the improvement of the fatigue behavior. It is shown that fatigue damaged specimens are similar to real bridge rather than static damaged specimens.

• Advances in Computational Design
• /
• 제8권1호
• /
• pp.13-36
• /
• 2023

The Puebla-Morelos Earthquake (Mw 7.1) occurred in Mexico in 2017 causing 44 buildings to collapse in Mexico City. This work evaluates the non-linear response of a 6-story reinforced concrete (RC) frame prototype model with masonry infill walls on upper floors. The prototype model was designed using provisions prescribed before 1985 and was subjected to seismic excitations recorded during the earthquakes of 1985 and 2017 in different places in Mexico City. The building response was assessed through a damage index (DI) that considers low-cycle fatigue of the steel reinforcement in columns of the first floor, where the steel was modeled including buckling as was observed in cases after the 2017 earthquake. Isocurves were generated with 72 seismic records in Mexico City representing the level of iso-demand on the structure. These isocurves were compared with the location of 16 collapsed (first-floor column failure) building cases consistent with the prototype model. The isocurves for a value greater than 1 demarcate the location where fatigue failure was expected, which is consistent with the location of 2 of the 16 cases studied. However, a slight increase in axial load (5%) or decrease in column cross-section (5%) had a significant detrimental effect on the cumulated damage, increasing the intensity of the isocurves and achieving congruence with 9 of the 16 cases, and having the other 7 cases less than 2 km away. Including column special detailing (tight stirrup spacing and confined concrete) was the variable with the greatest impact to control the cumulated damage, which was consistent with the absence of severe damage in buildings built in the 70s and 80s.

• Structural Engineering and Mechanics
• /
• 제3권4호
• /
• pp.341-358
• /
• 1995

The results of a series of ten W-shaped test specimens subjected to monotonic, quasi-static cyclic loading and fatigue type of loading in the form of constant amplitude tests are presented. The objectives were to assess and compare the rotation capacity and energy absorption of monotonically and cyclically loaded beams, and for the latter specimens to document the deterioration in the form of low cycle fatigue due to local buckling. In addition, strength and energy dissipation deterioration and damage models have been developed for the steel beam section under consideration. Finally, a generalized model which uses plate slenderness values and lateral slenderness is proposed for predicting rate in strength deterioration per reversal and cumulated damage after a given number of reversals.

• Earthquakes and Structures
• /
• 제7권5호
• /
• pp.609-626
• /
• 2014

The capabilities of a high-resolution Digital Image Correlation (DIC) system are presented within the context of deformation measurements of full-scale concrete columns tested under reversed cyclic loading. The system was developed to have very high-resolution such that material strains on the order of the cracking stain of concrete could be measured on the surface of full-scale structural members. The high-resolution DIC system allows the measurement of a wide range of deformations and strains that could only be inferred or assumed previously. The DIC system is able to resolve the full profiles of member curvatures, rotations, plasticity spread, shear deformations, and bar-slip induced rotations. The system allows for automatic and objective measurement of crack widths and other damage indices that are indicative of cumulated damage and required repair time and cost. DIC damage measures contrast prevailing proxy damage indices based on member force-deformation data and subjective damage measures obtained using visual inspection. Data derived from high-resolution DIC systems is shown to be of great use in advancing the state of behavioral knowledge, calibrating behavioral and analytical models, and improving simulation accuracy.

• 한국구조물진단유지관리공학회 논문집
• /
• 제9권1호
• /
• pp.243-250
• /
• 2005

우리나라의 수로교는 구조검토결과 내력부족이 없고 시공결함이 없으며, 사용된 재료나 기술 및 시공된 후의 환경상태 등 모든 조건이 동일함에도 균열, 붕괴 등 구조안전을 위협하는 하자가 대부분 일정간격으로 반복되고 있다. 하자 보수 후 채 손상의 발생은 물론 보수 전 양호하였던 인접교각에까지 손상이 확대되어 감은 물론 보수를 하지 않고 장기간 방치된 경우에도 손상은 확대되었다. 또한 철거 후 재시공한 곳에서도 손상이 반복되는 양상을 보였다. 철근콘크리트조 수로교가 불과 수년경과 후 발생될 수밖에 없었던 손상은 구조적인 결함 때문이 아니라 받침장치의 부식 및 신축유격의 부족 등 기능장치의 결함으로 [대기온도변화에 의한 수로의 길이 방향 신 축 변형의 누적] 이라는 손상 메커니즘의 결과 때문이었다. 따라서 원인과는 무관한 통상적인 방법으로 이루어진 보수는 재 손상이나 이의 확산은 필연적이므로 손상 메커니즘이 형성되지 않도록 설계 및 시공되어야 수로교의 안전 및 내구성 확보가 가능하게 된다.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 1996년도 추계학술대회 논문집
• /
• pp.913-920
• /
• 1996

In this study, the counting method for multi-axial and multi-point load states was proposed. Using this counting method, the load spectrum is generated from the service load history which is measured for boom structure of excavator. Loading state for loading points of boom structure is described as a multi-dimensional state space. From this load spectrum, the stress spectrum was generated by FEM analysis using the superposition of the unit load. The cumulated damage at the severe damage point of In nm structure by the failure example is calculated by Palmgren-Miner's rule. As a result of this study, the fatigue life estimation using the multi-axial and multi-point load counting method is useful.

• 한국건설순환자원학회논문집
• /
• 제7권4호
• /
• pp.438-444
• /
• 2019

본 연구에서는 모르타르의 동결융해피해에 미치는 폴리프로필렌섬유의 영향을 실험적으로 검토하였다. 섬유를 혼입하지 않은 섬유무보강 모르타르와 폴리비닐알코올섬유를 혼입한 모르타르를 비교 대상으로 하여 폴리프로필렌섬유의 혼입이 300사이클의 동결융해시험 후 모르타르의 압축 및 휨특성에 미치는 영향을 평가하였다. 또한, 300사이클의 동결융해 시험 후 모르타르의 질량감소율, 상대동탄성계수 및 공극크기분포에 대한 시험을 실시하였다. 그 결과, 섬유종류에 관계없이 섬유무혼입 모르타르에 비해 섬유혼입 모르타르는 300사이클의 동결융해시험 후 압축강도 및 휨강도의 역학적 성능저하와 질량감소율의 증가를 억제하는 것이 가능했다. 한편, 300사이클의 동결융해시험 후 모르타르의 공극감소에 대한 저항에 폴리비닐알코올섬유뿐만 아니라 폴리프로필렌섬유가 효과적으로 작용할 수 있는 것을 확인했으나 폴리프로필렌섬유를 혼입한 모르타르의 동결융해저항성을 향상시키기 위해서는 폴리비닐알코올섬유에서 기대할 수 있는 시멘트매트릭스와의 결합효율을 증가시킬 필요가 있다.

• 농촌계획
• /
• 제28권4호
• /
• pp.93-104
• /
• 2022

Agriculture is one of the most vulnerable sector to droughts, and drought damage on the agriculture sector could have effects on other sector. Droughts have different characteristics compared to other extreme events, which means more sophisticated methods considering the characteristics of droughts are required when measuring their damage. The purpose of this study is to analyze the damage of droughts based on limited computational general equilibrium model. To be specific, we constructed a CGE model focusing on the agriculture sector in Korea. Also, to limit changes in land use and labor, we limited them, and assume droughts only have effects on productivity of value-added. Lastly, we simulate drought effects on rice production in Korea based on several climate scenarios and GCM to identify the economic effects of droughts. The results show that 1) the cumulated damage of droughts during 2021~2040 is higher than other periods (2040~2061, 2081~2100), 2) the correlation between the damage of droughts and SSP scenarios is insignificant. This result implies the necessity of the effective drought risk management to prevent future droughts effects, irrespective of mitigation policies. 3) Due to increases in rice price, GDP of rice sector is increased. However, GDP of the other sector and consumer welfare are decreased. This result show that indirect effects of droughts would be more important when measuring drought effects on agriculture sector.

• 한국경영과학회지
• /
• 제30권2호
• /
• pp.63-71
• /
• 2005

In the field of nuclear reactor safety study, common cause failures (CCFs) became significant contributors to system failure probability and core damage frequency in most Probabilistic risk assessments. However, it is hard to estimate the reliability of such a system, because of the dependency of components caused by CCFs. In order to analyze the system, we propose an analytic method that can find the parameters with lack of raw data. This study adopts the shock model in which the failure probability increases as the shock is cumulated. We use two-step Expectation and Maximization (EM) algorithm to find the unknown parameters. In order to verify the analysis result, we perform the simulation under same environment. This approach might be helpful to build the defensive strategy for the CCFs.

• 한국양식학회지
• /
• 제16권4호
• /
• pp.223-228
• /
• 2003

전복 치패를 부착기질로부터 분리시키는 박리는 전복양식에 있어서 치패의 선별과 밀도 조절을 위해 필수적인 작업이다. 현재 물리적인 방법과 마취제를 이용한 방법이 개발되어 있으나 치패의 손상이 없는 마취제에 의한 박리가 보다 효과적인 것으로 판단되고 있다. 따라서 본 연구는 요소비료($Co(NH_2)_2$)를 마취제로 이용하여 요소비료의 농도와 수온 등 물리적 요인이 까막전복 Haliotis discus의 박리율과 회복률에 미치는 영향을 조사함으로써 경제적이며 효과적인 박리 기술을 개발하고자 하였다. 실험 결과 9∼15%의 요소비료를 해수에 용해시키고 이를 자연 해수와 동일한 수온으로 상승시킨 후 박리를 실시하였더니 3분 이내에 97% 이상이 박리되었으며 치패의 회복률도 역시 높았다. 또한 요소비료 농도와 수온은 높을수록 박리율도 높았으나 치패의 회복률은 낮았다. 결론적으로 본 연구를 통하여 농업용 요소비료를 전복의 박리에 사용할 수 있음을 확인하였으며, 다른 종류의 전복에서도 본 기술의 적용이 가능할 것으로 생각되며, 본 기술은 현재 사용되고 있는 모든 전복 박리방법이나 전복 마취제로 쓰이는 화학약품을 대체할 수 있는 방법으로 판단된다.