• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.6 no.3
• /
• pp.315-324
• /
• 1994

The energy recovery efficiency(ERE) of an aquifer thermal energy storage system was calculated using curvilinear coordinate. The results of the calculation were compared with the experimental results, and agreed within 11% of the discrepancy. The variation of ERE was investigated as a function of the underground water natural velocity, the amount of the stored energy, and period of the energy recovery. The slower the natural velocity and shorter the recovery period, the higher ERE was yielded. Also it was found that increase in the amount of energy storage yields higher ERE, and carries out less influential ERE to the natural velocity. Reiterative usage of the aquifer as a thermal storage tends to gradually increase ERE. The result of this study implements that the aquifer thermal energy storage system is suitable for large cooling/heating loads, such as district cooling/heating.

• Journal of the Korean Ceramic Society
• /
• v.23 no.5
• /
• pp.35-40
• /
• 1986

The early hydration of tri-calcium silicate $(C_3S)$ with different cooling conditions was studied by varing water/solid ratio and atmosphere. The cooling condition and water/solid ratio affected to the second peak of heat liberation but it had no correlation to the induction period. The $Ca^{2+}$ concentration in the aqueous solution was maximized at the starting point of the second peak of heat liberation but in the $CO_2$ exsistence the $Ca^{2+}$ concentration was low and $SiO_2$ con-centration was increased. The hydration rate of $C_3S$ was so accelerated that the induction period could not appear in the $CO_2$ exsistence.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.25 no.1
• /
• pp.13-19
• /
• 2015

Among the various possible factors affecting the Minority Carrier Life Time (MCLT) of the mc-Si crystal, dislocations formed during the cooling period after solidification were found to be a major element. It was confirmed that other defects such as grain boundary or twin boundary were not determinative defects affecting the MCLT because most of these defects seemed to be formed during the solidification period. With a measurement of total thickness variation (TTV) and bow of the silicon wafers, it was found that residual stress remaining in the mc-Si crystal might be another major factor affecting the MCLT. Thus, it is expected that better quality of mc-Si can be grown when the cooling process right after solidification is carried out as slow as possible.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.11
• /
• pp.33-38
• /
• 2011

In this paper, the effect of pulse current and generated heat on characteristics of the LED is measured and evaluated. For experiments, the LED driving circuit and digital logic which determines period and duty ratio of lighting are designed. At rated current, the temperature and optical characteristics of the LED with change in duty ratio and period are compared, and those of the LED with change in duty ratio and existence of cooling fan are also compared at constant average current. As a result, frequency does not affect device temperature and optical characteristic of the LED but duty ratio does. Also, the cooling fan is less effective on those of the LED at rated current.

• Asian-Australasian Journal of Animal Sciences
• /
• v.12 no.4
• /
• pp.590-596
• /
• 1999

The effect of evaporative cooling in alleviating seasonal variations of dairy cows raised in AlMarai Dairy Farms in the Kingdom of Saudi Arabia were studied using milking record collected during the period of 1991 to 1996. The data included 13303 and 8137 records represented winter and summer calving seasons. Evaporative cooling system improved production for cows calved in summer. The least square means of milk yield were 9631 and 9556 liter for cows calved in winter and summer seasons but no significant differences (p<0.05) were observed between the yield of two seasons. No significant effect of season on calving under evaporative cooling on most of the biweekly points of the lactation curve. The farm, parity and milk level showed a significant effect on the shape of the curve. Functions of the lactation curve like initial yield, 305 MY, peak yield, time of peak and duration were estimated for each phase of the lactation curve.

• Journal of the Korean Society of Tobacco Science
• /
• v.25 no.2
• /
• pp.160-166
• /
• 2003

The majority of ι-menthol is still obtained by freezing the oil of Mentha arvensis to crystallize the menthol present. This 'natural' menthol is then physically seperated by centrifuging the supernatant liquid away from the menthol crystal. But the price of natural ι-menthol has fluctuated widely so effort has been devoted to the production of ι-menthol by synthetic more readily available raw materials. In the 1970's, many researcher synthesised a new compounds with the menthol cooling effect. During this period many molecular structure designed and synthesised on concepts of correlation between structure and biological activity and the various types of molecule which give rise to cooling effect more than ι-menthol. Specially, N-alkyl-carboxamide group is substituted for the hydroxyl group in ι-menthol. Recently, the most active compounds synthesised is 4-methyl-3-(1-pyrrolidinyl)-2-[5H]-furanone. This compound is 35 times more powerful in the mouth and 512 times more powerful on the skin than ι-menthol. The cooling effect also lasts twice as long. While not yet commercially available, it is expected that these types of materials will be subjected to toxicological studies and will soon be sell on the market.

• Advances in Energy Research
• /
• v.7 no.2
• /
• pp.147-166
• /
• 2020

Industrial cooling towers are often ageing infrastructure that is expensive to maintain and operate. A novel approach is introduced in which a heat pump circuit is incorporated to reduce the load upon the towers by extracting low-grade energy from the stream sent to the towers and repurposing in on-site processing operations. To demonstrate the concept, a model was constructed, which uses industrial data on cooling towers linked to a smelter's sulphuric acid plant, to allow direct economic and environmental impact comparison between different heat recovery and repurposing scenarios. The model's results showed that implementing a heat pump system would significantly decrease annual operating costs and achieve a payback period of 3 years. In addition, overall CO₂ emissions could be reduced by 42% (430,000 kg/year) and a 5% heat load reduction on the cooling towers achieved. The concept is significant as the outcomes introduce a new way for energy intensive industrial sectors, such as mineral processing, to reduce energy consumption and improve long-term sustainable performance.

• Entomological Research
• /
• v.48 no.6
• /
• pp.550-558
• /
• 2018

To develop a system for the mass production of Protaetia brevitarsislarvae (Pbl), this study analyzed the oviposition characteristics of third instar Pbl through successive rearing and cold treatments. In the first generation, females laid 50 eggs each on average, and spawned higher numbers of eggs for the first 5 days but then fewer after this. However, all of the $2^{nd}$-generation females that were produced through the successive rearing of eggs from the $1^{st}$ generation did not spawn. When test insects (TI) were raised at $32^{\circ}C$, their $mean{\pm}SE$ pupal period and emergence rate were $28.4{\pm}1.9$ days and 87%, respectively. However, most individuals raised in cold treatments ($5^{\circ}C$ and $-5^{\circ}C$) without a pre-cooling period did not survive. Individuals exposed to a pre-cooling period, however, had a 7-10 days longer pupal period than those raised at $32^{\circ}C$, and their emergence rate (90%) was slightly higher. Different cold treatment temperatures ($0^{\circ}C$, $3^{\circ}C$, or $5^{\circ}C$) and periods (30 or 60 days) were tested in further experiments. The experimental group kept for 30 days at $0^{\circ}C$ and $3^{\circ}C$ had the shortest pupal period of all, and emergence rates exceeded 90% in most groups. With respect to the number of eggs spawned by the second generation females after cold treatments, the experimental groups held in cold treatments at $5^{\circ}C$ for 30 and 60 days were found to spawn the most eggs. Consequently, the experimental group kept at $5^{\circ}C$ for 30 days was the most effective set of conditions tested during the entire breeding period.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.27 no.8
• /
• pp.432-439
• /
• 2015

Current building procedures seek to minimize external air supplies to reduce the energy consumption of air conditioning, resulting in a high dependency on mechanical ventilation. We therefore studied an economizer-cycle system, whereby the introduction of external air saves energy. We analyzed different economizer-control methods, addressing mixed-air temperatures and outdoor-air fractions according to outdoor-air temperatures; also, we analyzed the energy consumption of the three economizer-cycle control types using detailed EnergyPlus simulation modeling. A differential enthalpy control method showed a lower energy consumption range from 5.8% to 6.2% than that of other methods during the simulated period. A differential dry-bulb control method showed a 12.7% lower energy consumption than the no-economizer method in the intermediate period, but also showed 7.1% more energy consumption during the summer period. When latent heat was not removed due to high summer humidity, we found a significant level of resultant energy consumption.

• Journal of Bio-Environment Control
• /
• v.22 no.4
• /
• pp.349-354
• /
• 2013

This study examined a technique for cooling root zone aimed at lowering substrate temperature for sweet pepper (Capsicum annum L. 'Orange glory') cultivation in coir substrate hydroponics during hot season, from the $16^{th}$ of July to $15^{th}$ of October in 2012. The root zone cooling technique was applied by using an air duct (${\varnothing}12$ cm, hole size 0.1 mm) to blow cool air between two slabs during night (5p.m. to 3a.m.). Between the $23^{rd}$ of July and $31^{st}$ of August (hot temperature period), average daily substrate temperature was $24.7^{\circ}C$ under the root zone cooling, whereas it was $28.2^{\circ}C$ under condition of no cooling (control). In sunny day (600~700 W $m^{-2}{\cdot}s^{-1}$), average substrate temperatures during the day (6a.m. to 8p.m.) and night (8p.m. to 6a.m.) were lower about $1.7^{\circ}C$ and $3.3^{\circ}C$, respectively, under the cooling treatment, compared to that of control. The degree of temperature reduction in the substrate was averagely $0.5^{\circ}C$ per hour under the cooling treatment during 6p.m. to 8p.m.; however, there was no decrease in the temperature under the control. The temperature difference between the cooling and control treatments was $1.3^{\circ}C$ and $0.6^{\circ}C$ in the upper and lower part of the slab, respectively. During the hot temperature period, about 32.5% reduction in the substrate temperature was observed under the cooling treatment, compared to the control. Photosynthesis, transpiration rate, and leaf water potential of plants grown under the cooling treatment were significantly higher than those under the control. The first flowering date in the cooling was faster about 4 days than in the control. Also, the number of fruits was significantly higher than that in the control. No differences in plant height, stem thickness, number of internode, and leaf width were found between the plants grown under the cooling and control, except for the leaf length with a shorter length under the cooling treatment. However, root zone cooling influenced negligibly on eliminating delay in fruiting caused by excessively higher air temperature (> $28^{\circ}C$), although the substrate temperature was reduced by $3^{\circ}C$ to $5.6^{\circ}C$. These results suggest that the technique of lowering substrate temperature by using air-duct blow needs to be incorporated into the lowering growing temperature system for growth and fruit set of health paprika.