• Transactions of the Korean hydrogen and new energy society
• /
• v.22 no.2
• /
• pp.129-138
• /
• 2011

Performance changes of an anode-supported tubular SOFC including current collectors are analyzed at different current collecting methods using numerical simulation. From the two dimensional numerical model of the solid oxide fuel cell with nickel felts as anodic current collectors and silver wires as cathodic ones, the performance curves and the distributions of temperature, concentration, current density are obtained. Also, the voltage loss of the cell is divided into three parts: activation loss, concentration loss and ohmic loss. The results show that the performance change of the cell is dominantly influenced by the ohmic loss. Although the temperature and concentration distributions are different, the total activation loss and concentration loss are nearly same. And the ohmic loss is divided into each parts of the cell components. The ohmic loss of the anodic current collectorreaches about 60~80% of the cell's total ohmic loss. Therefore, the reduction of the ohmic loss of the anodic current collector is very important for stack power enhancement. It is also recommended that the load should be connected to the both ends of the anodic current collector.

• Korean Journal of Food Science and Technology
• /
• v.22 no.5
• /
• pp.497-502
• /
• 1990

The effect of sugar concentration, immersion time and temperature on water loss, solid gain or loss, and sugar molality of potatoes during osmotic concentration was analyzed by a response surface methodology (RSM), and those values were predicted by using a second degree polynomial regression model. Effect of osmotic concentration and blanching on vitamin C retention of air dried potatoes (6% MC: wet basis) was also evaluated. The most significant factor was sugar concentration for water loss, solid gain or loss, sugar molality, rate parameter and retention of vitamin C. Second and third factors were immersion time and temperature respectively. Water loss and solid gain were rapid in the first 10 min and then levelled off. A 44.6% of water loss was observed during osmotic concentration using a sugar solution $(60\;Brix,\;80^{\circ}C$) with 20 min of immersion time. Dried potatoes after osmotic concentration had higher vitamin C content than dried potatoes after blanching. Optimum regions for osmotic concentration process of potatoes were $60-70^{\circ}C$ of immersion temperature, 60 Brix of sugar solution and 16-20 min of immersion time based on above 30% of water loss and 50% of vitamin C retention.

• Journal of the Korean Home Economics Association
• /
• v.25 no.4
• /
• pp.9-18
• /
• 1987

This study is conducted to investigate the influence of addition of quarternary ammonium salt(cetyl trimethyl ammonium bromide: CTAB) when polyester(PET) fabric is treated with sodium hydroxide(NaOH), depending on experimental variables such as CTAB concentration, NaOH concentration, time & temperature, and the change in physical & chemical properties of alkaline-hydrolyzed PET fabrics depending on their weight loss. The results are as follows: 1. By adding CTAB in aqueous NaOH, the weight loss of PET fabric is increased remarkably and until the concentration of CTAB is reached at its cmc, and the higher the concentration of CTAB are, the more weight loss on PET fibrics are. 2. The addition of CTAB in aqueous NaOH is most effective at lower NaON concentration(2%) among various NaOH concentration, on increasing the amount of weight loss, while there are almost similar results through various treatment time and temperature. 3. As the amount of weight of weight loss on PET fabric is increased, the increase of void space in the PET yarn, of softness & dyeability of PET fabric and the decrease of tensile strength are found. On the other hand, the moisture regain shows a little increase by alkaline-hydrolysis on PET fabric while vertical absorption test & water retention value are not sufficiently sensitive to distinguish between the hydrophillicity of untreated and treated PET fabric. The shrinkage of PET fabric is induced by swelling in hot aqueous NaOH regardless of NaOH concentration & addition of CTAB.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.19 no.2
• /
• pp.121-126
• /
• 1990

Internal mass transfer during osmotic concentration of apples in sugar solutions was exami-ned as a function of concentration temperature and immersion time of those solutions using moisture loss sugar gain molality and rate parameter. Influence of osmotic concentration processes on browning reaction was also evaluated compared to control In creasin the concen-tration and temperature of sugar solutions increased moistrue loss sugar gain molality and rate parameter. Water loss was rapid early in the process and then levelled off, The same phenomena were occurred on sugar gain only in higher concentration(60$^{\circ}$ brix). IN lower concentration (30$^{\circ}$brix) sugar gain was gradually increased during whole process. Moisture loss during osmotic concentration using a sugar solution(60$^{\circ}$ brix 6$0^{\circ}C$) with 180min immer-sion time was 45.79% Effect of osmotic concentration befor air dried to 4% M.C(wet basis) on browning reaction was significant. Minimum browning reaction during air drying was carried out using a pretreatment such as osmotic concentration in sugar solution(60$^{\circ}$brix 45$^{\circ}C$) with 150min immersion time(O.D=0.01) compared to control(O.D=0.17)

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2001.05a
• /
• pp.152-157
• /
• 2001

This paper was studied on the characteristics of crevice corrosion prevention of SS 400 in marine environment. In NaCl solution, polarization behavior under the crevice corrosion was investigated. And Weight loss rate of SS 400 applied cathodic protection and non cathodic protection was measured according to the NaCl concentration. The main results obtained are as follows : The weight loss rate of Al-alloy galvanic anode was increased as the concentration of NaCl solution increased by 3.5% but the concentration increased over 3.5%, that of Al-alloy galvanic anode become decreased. The protective potential of SS 400 used Al-alloy galvanic anode becomes more cathodic polarization with increasing concentration of NaCl solution. Effects of oxygen on the weight loss rate of Al-alloy sacrificial anode for cathodic protection as the concentration of 3.5% NaCl solution become sensitive than that of 0% NaCl solution.

• Journal of Pharmaceutical Investigation
• /
• v.25 no.2
• /
• pp.95-100
• /
• 1995

Serum electrolyte concentration and body weight were determined before and after exercise for 2h in Korean cyclists. The serum concentration of electrolytes (Na, Ca, Zn, K, P and Cl) was increased but that of Mg was decreased as a result of exercise. The increase of serum K and P concentration was statistically significant after exercise. As the exercise time increased, the loss of body weight also increased due to dehydration and sweat. The loss of body weight ranged 1.0 to 2.3 Kg as a function of exercise time but cyclists showed the exhaustion and muscle fatigue 2h after exercise. As the ambient temperature increased, the loss of body weight was slightly increased. However, frequent drinking water was required because of dehydration and thirst. Although frequent drinking water may reduce weight loss and thirst during exercise, sports drinking beverages simultaneously containing electrolytes and nutrients are more useful to replenish loss of water and electrolytes in an exhausted condition, resulting in the improvement of physical performance.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2000.11a
• /
• pp.1-6
• /
• 2000

This paper was studied on the crevice corrosion behavior of SS 400 in marine environment. In 0%, 2%, 3.5%, 5% NaCl solution, the aspect of the crevice corrosion and polarization behavior under the crevice corrosion was investigated. And Weight loss rate of SS 400 with crevice and non-crevice was measured according to the NaCl concentration. The main results obtained are as follows : 1) Under crevice corrosion, the corrosion potential become less noble as the concentration of NaCl solution increased. 2) The current density under open circuit potential was high drained as concentration of NaCl solution increased by 3.5% but the concentration increased over 3.5%, the current density was low drained. 3) The weight loss rate of SS400 was increased as concentration of NaCl solution increased by 3.5% but the concentration increased over 3.5%, that of SS400 was decreased.

• Journal of the Korean Applied Science and Technology
• /
• v.12 no.1
• /
• pp.81-86
• /
• 1995

Some weight loss accelerating agents, dodecyltrimethylammonium chloride(DTAC), dodecyltrimethylammonium bromide(DTAB), dodecyldimethylammonium chloride(DDBAC), polyoxyethylene(2) dodecylbenzylammonium chloride(PDBAC), and 1-(2-hydroxyethyl)-1-benzyl-2-undecylimidazolinium chloride(AEUIC), were synthesized. As a result of weight loss treatment of the weight loss accelerating agents with NaOH to PET fiber, the increase of weight loss was the order of PDBAC > DDBAC > DTAC > DTAB > AEUIC. Among the weight loss accelerating agents, AEUIC hardly showed weight loss effect, and it was separated into two layer in the NaOH solution at the treatment concentration above 6g/L, but POBAC showed good weight loss effect of 21% that approach almost to a theoretical weight loss, 21.6%, at the concentration above 8g/L.

• Journal of Sensor Science and Technology
• /
• v.20 no.5
• /
• pp.357-362
• /
• 2011

This paper demonstrates a novel electrodynamic technique to remove particles from the wall of microchannels. Dielectrohporesis(DEP) is generated by applying alternating electric potentials to the interdigitated electrodes integrated at the bottom of the micro-channel. The proposed technique is applied to a general microfluidic channel as a feasibility test. To examine the wall loss reduction efficiency, 10 ${\mu}m$ diameter Polystyrene latexes(PSL) were supplied to the inlet of the device. Then, the concentration of collected particles through devices was measured. In the experiment for 10 ${\mu}m$ diameter PSL particles, the concentration of the injected particles was $174.25{\times}10^4$ particles/ml. However, the concentration of collected particles at the outlet was $52.25{\times}10^4$ particles/ml. Only 30 % of particles had arrived at the outlet and 70 % of particles had adhered to the wall of the microfluidic channel. By applying alternating electric potentials from 0 to 20 $V_{pp}$ at 3 MHz, the concentration of injected particles was 135.00${\times}10^4$ particles/ml, the concentration of collected particles was increased as $105.25{\times}10^4$ particles/ml at 20 $V_{pp}$ at the outlet. When the electric potential was 20 $V_{pp}$, the particle loss was decreased by 39 % (initial loss: 70 %, loss at 20 Vpp: 31 %) with 10 ${\mu}m$ particle. The particle loss was decreased along to the incensement of electric potentials and the enlargement of the diameter of particles. According to these measured results, it was confirmed that the proposal of using DEP technique could be a good candidate for particle loss reduction in micro-particle processing chip application. Moreover, it is expected that the proposed technique could enhance performance of microfluidic and biochip devices.

• Mycobiology
• /
• v.40 no.3
• /
• pp.164-167
• /
• 2012

The effects of aeration through lid filters on the hyphal growth of Lentinula edodes (oak mushroom) in sawdust cultivation bags were investigated. The aeration treatment levels were traditional 27 mm hole cotton plugs, cotton balls and combinations of seven hole sizes ${\times}$ two hole positions (up and under) in the lids covering plastic bags containing 1.4 kg sawdust medium at 63% moisture that had been autoclaved for one hour and inoculated with sawdust spawn of L. edodes strain 921. Aeration treatment effects were measured based on the $CO_2$ concentration at the 15th wk, as well as the hyphal growth rate and degree of weight loss of bags every 14 days for 15 wk. In bags with traditional cotton plugs, the $CO_2$ concentration was $3.8{\pm}1.3%$, daily mean hyphal growth was $2.3{\pm}0.6mm$ and daily mean weight loss was $0.84{\pm}0.26g$. In the bags with 15 mm diameter holes, the $CO_2$ concentration was $6.0{\pm}1.6%$, daily hyphal growth was $2.8{\pm}0.2mm$ and daily weight loss was $0.86{\pm}0.4g$. The bags with 15 mm holes had a higher $CO_2$ concentration and lower water loss than bags with other hole sizes, but the hyphal growth was not significantly different from that of other bags. The weight loss of bags increased proportionally relative to the lid hole sizes. Taken together, these results indicate that traditional cotton plugs are economically efficient, but 15 mm hole lids are the most efficient at maintaining hyphal growth and controlling water loss while allowing $CO_2$ emissions.