• Bulletin of the Korean Chemical Society
• /
• v.17 no.4
• /
• pp.324-330
• /
• 1996

We examined the formal oxidation states of Pb and Cu in the Pb2CuO4 slab of Pb2Sr2ACu3O8(A=Y1-xCaxor Nd1-xSrx) and their possible changes by oxygen incorporation in the Cu layer of the slab by performing tight-binding band electronic structure calculations on the Pb2CuO4+δ slab. Our results show that the most likely oxidation state of Pb is +2 and that of Cu is +1 for the Pb2CuO4 slab prior to oxidation. With small δ values, the oxygen incorporation occurs by the formation of such chain fragments as in YBa2Cu3O7-y along the a+b axis. The four-coordinate Cu atoms in the chain fragments are in the +3 oxidation states. For values of δ larger than 0.5, however, an additional oxygen (Oad) goes to the site along the b axis to form short Pb-Oad distances oxidizing Pb2+ to Pb4+. This change in the Pb oxidation state leads to the suppression of superconductivity due to the decrease of holes in the CuO2 layer.

• Korean Chemical Engineering Research
• /
• v.49 no.6
• /
• pp.720-725
• /
• 2011

Gold catalysts supported on metal-oxides were prepared by co-precipitation using the various metal nitrates and chloroauric acid as precursors, and effect of water addition on the catalytic activity in CO oxidation was investigated. Among the various supported gold catalysts, Au/$Co_{3}O_{4}$ and Au/ZnO catalysts showed the excellent activity for CO oxidation. Water in the reactant gas had a negative effect on the oxidation activity over Au/$Co_{3}O_{4}$ catalysts and a positive effect on that over Au/ZnO, which means the activity depends strongly on the nature of support. It was also confirmed that no significant change in the particle size of gold was observed after reaction both in dry and wet conditions. This fact suggested that the deactivated catalyst due to a carbonate species could be regenerated by water addition in the reactant gas.

• Journal of the Korean Chemical Society
• /
• v.47 no.4
• /
• pp.423-426
• /
• 2003

• Journal of Microbiology and Biotechnology
• /
• v.9 no.5
• /
• pp.650-654
• /
• 1999

Undaria pinnatifida oxidized by nitric acid had a high capacity of Cu/sup 2+/ uptake (3.5 mmol Cu/sup 2+/g dry mass) at pH 4 and showed high affinity to Cu/sup 2+/ and Pb/sup 2+/, in a mixed-metal system, compared to Ca/sup 2+/ and Mg/sup 2+/. The IR spectrum showed increase of carboxylic acid on the surface of Undaria pinnatifida, mostly due to the effect of the oxidation reaction.

• Journal of the Korean Chemical Society
• /
• v.18 no.6
• /
• pp.443-446
• /
• 1974

The regenerated lubricating oils for an internal combustion engine, obtained from the sulfuric acid and clay treatment, showed an improved thermal oxidation stability regardless of additives, especially anti-oxidant, originally presented in the oils. It is believed that such improvement is due to the formation of anti-oxidant materials, which is observed by the in crease of 25 % of aromatic compounds.

• Bulletin of the Korean Chemical Society
• /
• v.21 no.1
• /
• pp.31-32
• /
• 2000

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.29 no.5 s.236
• /
• pp.617-624
• /
• 2005

An analysis of the effects of $CO_{2}$ on fundamental combustion characteristics was performed in Oxygen enriched condition by comparing the laminar burning velocities, flame structures, fuel oxidation paths. Fictitious $CO_{2}$ was introduced to discriminate the chemical reaction effects of $CO_{2}$ from the thermal effects. PREMIX code was utilized to evaluate the laminar burning velocities. OPPDIF code was utilized to investigate the flame structure and fuel oxidation path variation. The contributions of thermal effects on laminar burning velocities are dominant at lowly oxygen-enriched condition but those of chemical reaction effects become dominant at highly oxygen-enriched condition. Chemical reaction effects caused the additional flame temperature decrease besides thermal effects and oxygen-leakage increase in non-premixed flame. Specific fuel oxidation path and CO production path is enhanced in spite of overall decrement of fuel consumption rate by chemical reaction effects of$CO_{2}$.

• Journal of Fashion Business
• /
• v.12 no.6
• /
• pp.23-33
• /
• 2008

The physico-chemical characteristics by bleaching treatments were assessed by several instrumental analyses such as surface morphology, chemical structural change, color change as well as tensile strength. The change of morphological characteristic was observed through scanning electron microscope(SEM). The observation of the fine structure on hair surface by SEM showed the bleached hair had much damaged to hair cuticle, and some of cuticle surface were worn away. To investigate the chemical structural changes in hair keratin, the cross-sections of hair samples were directly analysed using Fourier transform infrared microspectroscopy(FT-IRM). The results showed the cysteic acid S=O band intensity was distinctively increased by performing the bleaching treatment. The cleavage of cystine was appeared to proceed primarily through the sulfur-sulfur (-S-S-) fission whereby cysteic acid was formed as a principal oxidation products. The distribution of amide I band in hair keratin was determined by attenuated total reflectance(ATR) FT-IR mapping image. The results showed that the outer side of hair cortex was more damaged than the inner side of the hair cortex. Also, during chemical bleaching of the hair with alkaline peroxide, the hair was turned to reddish yellow due to the oxidative degradation of eumelanin. This means the eumelanin is more unstable than pheomelanin in chemical oxidation. With bleaching, the tensile strength was also reduced as a results of the chemical oxidation.

• Journal of Environmental Science International
• /
• v.15 no.3
• /
• pp.193-201
• /
• 2006

Advanced oxidation processes involving $O_3/H_2O_2$ and $O_3/catalyst$ were used to compare the degradability and the effect of pH on the oxidation of 1,4-dioxane, Oxidation processes were carried out in a bubble column reactor under different pH. Initial hydrogen peroxide concentration was 3.52 mM in $O_3/H_2O_2$ process and 115 g/L (0.65 wt.%) of activated carbon impregnated with palladium was packed in $O_3/catalyst$ column. 1,4-dioxane concentration was reduced steadily with reaction time in $O_3/H_2O_2$ oxidation process, however, in case of $O_3/catalyst$ process, about $50{\sim}75%$ of 1,4-dioxane was degraded only in 5 minutes after reaction. Overall reaction efficiency of $O_3/catalyst$ was also higher than that of $O_3/H_2O_2$ process. TOC and $COD_{cr}$ were analyzed in order to examine the oxidation characteristics with $O_3/H_2O_2\;and\;O_3/catalyst$ process. The results of $COD_{cr}$ removal efficiency and ${\Delta}TOC/{\Delta}ThOC$ ratio in $O_3/catalyst$ process gave that this process could more proceed the oxidation reaction than $O_3/H_2O_2$ oxidation process. Therefore, it was considered that $O_3/catalyst$ advanced oxidation process could be used as a effective oxidation process for removing non-degradable toxic organic materials.

• Journal of Korean Society for Atmospheric Environment
• /
• v.22 no.6
• /
• pp.799-807
• /
• 2006

The catalytic activity of $Pt/{\gamma}-Al_2O_3$ catalysts for the oxidation of toluene and toluene+xylene mixture was investigated in the microreactor of fixed-bed type. The calcination temperatures and loadings of $Pt/{\gamma}-Al_2O_3$ catalysts played the important role in the activity of catalysts for the oxidation of toluene. The increasing calcination temperatures and loadings of $Pt/{\gamma}-Al_2O_3$ catalysts increased the crystallite size of the platinum to result in the higher oxidation activity of catalysts. The catalytic activity for the toluene oxidation over $Pt/{\gamma}-Al_2O_3$ catalysts turned out to be increasing in the order of $500^{\circ}C\;<\;800^{\circ}C<600^{\circ}C\;<\;700^{\circ}C$ for calcination temperatures and 0.1 wt% < 0.3 wt% < 1.0 wt% for platinum loadings, respectively. The 1.0 wt% $Pt/{\gamma}-Al_2O_3$ catalysts calcined at $700^{\circ}C$ for 3 hrs in the air showed the highest activity for the oxidation of the toluene. The decrease of oxidation activity of $Pt/{\gamma}-Al_2O_3$ catalysts calcined at $800^{\circ}C$ might result from the decrease of active sites by sintering of platinum metals as well as ${\gamma}-Al_2O_3$ supports. The 1.0wt% $Pt/{\gamma}-Al_2O_3$ catalyst showed the activity from the lower temperature at $120^{\circ}C$, reached the light-off temperature ($T_{50%}$) at $180^{\circ}C$, and leveled off its activity at $340^{\circ}C$ with the conversion of 100% 'Mutual promotion' effects were observed for the binary mixture of toluene and xylene. The activity of the easy-to-oxidize toluene was slightly increased with the existence of the xylene. It might suggest the different mechanism for the oxidation of toluene and xylene on the $Pt/{\gamma}-Al_2O_3$ catalysts on different sites, and its reaction of gaseous oxygen.