• Journal of the Institute of Convergence Signal Processing
• /
• v.2 no.3
• /
• pp.32-38
• /
• 2001

Multi-carrier data transmission system performance is mostly limited by Inter- symbol-interference that is caused by a dispersive characteristic of the transmission channel. In order to enhance the system performance to meet the service requirements of local access, the channel impulse response shortening method incorporated with a channel frequency response compensation method is proposed. For a fast and efficient implementation of the equalizer proposed, Kalman and LMS algorithms are successively used. To verify the channel equalization performance, a set of computer simulation is performed on a filter bank based multitone system operating in a typical high-speed local area data transmission environment. The results showed us a comparable signal-to-interference improvement over the conventional multitone equalization scheme.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.7
• /
• pp.706-712
• /
• 2004

This paper presents the design technique of output multiplexer(OMUX) for the Ka-band satellite transponder. Output multiplexer consists of low-pass filter(LPF), channel filter and manifold. Channel filters adopt dual-mode technique in design for mass and volume reduction and frequency response of channel filters is 4-pole elliptic response for high frequency selectivity. w-pass filters are designed to be of 13th order corrugated type for high rejection characteristic over reception band of satellite transponder. After initial design of channel filters and manifold, we optimized only a few design parameters for fast and easy optimization instead of optimizing all the design parameter. Measured results of a realized output umltiplexer for Ka-band satellite transponder show good agreement with the computed ones.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.11
• /
• pp.2108-2113
• /
• 2010

The Long Term Evolution (LTE) system is based on the Orthogonal Frequency Division Multiplexing (OFDM) and relies its channel estimation on the lattice-type pilot samples in the multipath fading channel environment. The estimation of the channel frequency response (CFR) makes use of the least squares estimate (LSE) for each pilot samples, followed by an interpolation both in time- and in frequency-domain to fill up the channel estimates for subcarriers corresponding to data samples. Any interpolation scheme could be adopted for this purpose. Depending on the requirements of the target system, we may choose a simple linear interpolation or a sophisticated one. For any choice of an interpolation scheme, these is a trade-off between estimation accuracy and numerical cost. For those wireless communication systems based on the OFDM and the preamble-type pilot structure, the DFT-based channel estimation and its variants have been successfully. Yet, it may not be suitable for the lattice-type pilot structure, since the pilot samples are not sufficient to provide an accurate estimate and it is known to be sensitive to the location as well as the length of the time-domain window. In this paper, we propose a simple interpolated based on the upsampling mechanism in the multirate signal processing. The proposed method provides an excellent alternative to the DFT-based methods in terms of numerical cost and accuracy. The performance of the proposed technique is verified on a multipath environment suggested on a 3GPP LTE specification.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.10A
• /
• pp.941-948
• /
• 2008

In this paper, the effect of unobtainable channel frequency response (CFR) inside virtual subcarreiers on DFT-based channel estimation is derived and introduced numerically because the CFRs cause the leakage to the estimated channel and degrade the estimation performance. In addition, the performance of DFT-based channel estimation is analyzed with respect to the number of virtual subcarriers, pilot spacing and the number of unobtainable CFRs at equi-distance subcarriers inside virtual subcarriers.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.23 no.8
• /
• pp.981-987
• /
• 2019

In this paper, we propose a new SC-FDE (single carrier frequency domain equalization) structure to cope with narrow band interference signals or jammers and reduce pilot overhead. The conventional SC-FDE structure has a problem that the receiver performance degrades severely due to difficulty in time-domain channel estimation when narrow band jammers exist. In addition, the spectral efficiency is lowered by transmitting pilot at every SC-FDE block to estimate channel response. In order to overcome those problems, the proposed structure is devised to estimate frequency domain channel directly without time domain channel estimation. To reduce the pilot overhead, several data blocks are transmitted between two pilots. The channel estimate of each data block is found through linear interpolation of two channel estimates at two pilots. By performing frequency domain channel equalization using this channel estimate, the distortion by the channel is well compensated when narrow band jammers exist. The performance of the proposed structure is confirmed by computer simulation.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.9 no.2
• /
• pp.57-62
• /
• 1997

Based on the facts that significant parts of the harbor response spectrum usually reside in the vicinity of the Helmholtz mode in the eastern part of Korea. economically feasible redemption measures of seiches for malfunctioned harbors already in service is proposed by extending the wisdom of perforated breakwaters and adjusting the width of entrance channel as a control tool. It turns out that as the entrance channel is getting narrower, the harbor system is getting slender due to the increase of added hydrodynamic length so that harbor response can be effectively diminished and separated from the incident wave spectrum where considerable amount of wave energy is located at the lower frequency range.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.5C
• /
• pp.556-564
• /
• 2007

This paper proposes an efficient scheme to track a time variant channel induced by multi-path Rayleigh fading in mobile MIMO-OFDM systems with null sub-carriers. The proposed adaptive channel tracking scheme removes in the frequency domain the interfering signals of the other transmit (Tx) antennas by using a predicted channel frequency response before starting the channel estimation. Time domain channel estimation is then performed to reduce the additive white Gaussian noise (AWGN). The simulation results show that the proposed method is better than the conventional channel tracking method [3] in time varying channel environments. At a Doppler frequency of 300 Hz and bit error rates (BER) of 10-3, signal-to-noise power ratio (Eb/N0) gains of about 2.5 dB are achieved relative to the conventional channel tracking method [3]. At a Doppler frequency of 600 Hz, the performance difference between the proposed method and conventional one becomes much larger.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.3A
• /
• pp.256-268
• /
• 2008

This paper proposes an efficient scheme to track the time variant channel induced by multi-path Rayleigh fading in mobile wireless Multiple Input Multiple Output-Orthogonal Frequency Division Multiplexing (MIMO-OFDM) systems with null sub-carriers. In the proposed method, a blind channel response predictor is designed to cope with the time variant channel. The proposed channel tracking scheme consists of a frequency domain estimation approach that is coupled with a Minimum Mean Square Error (MMSE) time domain estimation method, and does not require any matrix inverse calculation during each OFDM symbol. The main attributes of the proposed scheme are its reduced computational complexity and good tracking performance of channel variations. The simulation results show that the proposed method exhibits superior performance than the conventional channel tracking method [4] in time varying channel environments. At a Doppler frequency of 100Hz and bit error rates (BER) of 10-4, signal-to-noise power ratio (Eb/N0) gains of about 2.5dB are achieved relative to the conventional channel tracking method [4]. At a Doppler frequency of 200Hz, the performance difference between the proposed method and conventional one becomes much larger.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.10 no.6
• /
• pp.327-334
• /
• 1985

A new method on the hardware implementation of multi-channel Finite Impulse Response(FIR) digital filter using vector multiplication structure is proposed. The proposed method can reduce the complexity of hardware structure and improve execution speed. The frequency response of four channel digital filter implemented by the above method is quite agreeable with the frquency response simulated by Remez method.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.11 no.6
• /
• pp.563-567
• /
• 2001

We generalize the widebane P0-weyl symbol (P0WS) and the widebane spreading function (WSF) using the generalized warping function . The new generalized P0WS and WSF are useful for analyzing system and communication channels producing generalized time shifts. We also investigated the relationship between the affine Wey1 symbol(AWS) and the P0WS. By using specific warping functions, we derive new P0WS and WSF as analysis tools for systems and communication channels with non-linear group delary characteristics. The new P0WS preserves specific types of changes imposed on random processes. The new WSF provides a new interpretation of output of system and communication channel as weighted superpositions of non-linear time shifts on the input. It is compared to the conventional method obtaining output of system and communication channel as a convention integration of the input with the impulse response of the system and the communication channel. The convolution integration can be interpreted as weighted superpositions of liner time shifts on the input where the weight is the impulse response of the system and the communication channel. Application examples in analysis and detection demonstrate the advantages of our new results.