• Analytical Science and Technology
• /
• v.28 no.2
• /
• pp.98-105
• /
• 2015

The development of an enzymatic biosensor for dopamine determination based on multiwall carbon nanotubes (MWCNTs) and peroxidase obtained from the crude extract of burley tobacco (Nicotiana tabacum L.) was proposed. Peroxidase catalyzes the oxidation of dopamine to dopamine quinone. The influence on the response of analytical parameters of biosensors such as enzyme concentration, dopamine concentration, pH, and phosphate buffer solution concentration were investigated. The analytical parameters obtained, including sensitivity, linearity, and stability, were investigated. The proposed method for dopamine determination presented good selectivity even in the presence of uric acid and ascorbic acid. The sensor presented a higher response for dopamine in 0.010 M phosphate buffer at pH 6.50, with an applied potential of -0.15 V. The detection limit of the electrode was 2.7×10⁻⁶ M (S/N = 3) and the relative standard deviation of the measurements, which were repeated 10 times using 5.0×10⁻² M dopamine, was 1.3%.

• Journal of the Korean Electrochemical Society
• /
• v.8 no.1
• /
• pp.1-5
• /
• 2005

Electric double layer capacitors(EDLCS) based on the charge stored at the interface between a hi팀 surface area carbon electrode and an organic electrolyte solution are widely used as a maintenance-free power source for IC memories and microcomputers. The achievement of the excellent performance of the capacitor requires an electrolyte solution which provides high conductivities over a wide temperature range and good electrochemical stabilities to allow the capacitor to be operated at high voltage. The electrochemical capacitor using a carbon material as electrodes and using an organic electrolyte with $1M-LiPF_6$ in PC-GBL-DEC(volume ratio 1:1:2) has specific capacitance of 64F/g.

• Journal of the Korean Vacuum Society
• /
• v.18 no.2
• /
• pp.79-84
• /
• 2009

The electron emission source of triode type has been fabricated using CNT paste. The nano Ag particle and photosensitive polymers were added to the CNT paste. The surface roughness of the CNT emitter was uniform by the back exposure method. The added nano Ag particle improves the adhesion and the electric conductance with small variation in the CNTs and between electrode. After the aging with heat-exhausting, the reliability of the triode CNT electron source was secured in the high voltage and current operation for 12 hours. At this time, the gate leakage current was about 10 % less than.

• Analytical Science and Technology
• /
• v.20 no.5
• /
• pp.393-399
• /
• 2007

In principle, the blood galactose level may be determined conveniently with a strip-type biosensor similar to that for glucose. In this study, we describe the development of a disposable galactose biosensor strip for point-of-care testing. The sensor strip is constructed with screen-printed carbon paste electrode (SPCE) and sample amount (< $100{\mu}L$). The developed strip the galactose level in less than 90 s using bienzymatic system of galactose oxidase (GAO) and horseradish peroxidase (HRP). The effects of pH, mediator (1,1-ferrocenedimethanol) concentration, ratio of enzymes, and applied potential were determined preliminarily with glassy carbon electrodes, and optimized further with the strip-type electrodes. The sensor exhibits linear response in the range of $0{\sim}400{\mu}M$ ($r^2$ = 0.997, S/N = 3). Since a low working potential, in principle, the fabricated disposable galactose biosensor has -100 mV (vs. Ag/AgCl), it is applied for the detection of galactose, interfering responses from common interferents such as ascorbic acid, uric acid and acetaminophen could be minimized. The sensor has been used to determine the total galactose level in standard samples with satisfactory reproducibility (CV = 5 %).

• Analytical Science and Technology
• /
• v.13 no.3
• /
• pp.315-322
• /
• 2000

The response characteristics of the bioelectrode developed by the co-immobilization of spinach root tissue and ferrocene in a carbon paste matrix for the amperometric determination of hydrogen peroxide were evaluated. In the range of electrode potential examined (-0.3~0.0V vs. Ag/AgCl). the response time was relatively short ($t_{95%}=11.8$ sec) and it responded in the wide range of pH. Also, its detection limit was $2.25{\times}10^{-6}M$ (S/N=3) and a relative standard deviation of the measurements which were repeated 15 times using $1.0{\times}10^{-3}M$ hydrogen peroxide was 1.87%. The bioelectrode sensitivity decreased to 40% of the original value in 19 days of continuous use.

• Applied Chemistry for Engineering
• /
• v.28 no.3
• /
• pp.369-374
• /
• 2017

The curtailment of production cost is important for the mass production of biosensors. Since horseradish peroxidase, which is a key material of enzyme electrodes for hydrogen peroxide analysis is rather expensive, this has been a limiting factor for fabricating carbon paste based enzyme electrodes. In this paper, the acacia leaf tissue as a zymogen easily obtainable in our living environment was used as an alternative to horseradish peroxidase for developing a hydrogen peroxide sensor and the electrochemical properties were evaluated. Ten or more electrochemical parameters alongside the other experimental results acquired by the potentiostatic method demonstrated that our enzyme electrodes can be used for the quantitative analysis of hydrogen peroxide. This also indicates that acacia leaves can take the place of the marketed peroxidase.

• Journal of the Korean Chemical Society
• /
• v.41 no.7
• /
• pp.343-350
• /
• 1997

The response characteristics of a new biosensor, which was developed by co-immobilisation of chicken liver tissue and ferrocene in a carbon paste matrix for the amperometric determination of hydrogen peroxide, was evaluated. In the range of electrode potential observed ( - 0.5∼ + 0.05 V vs Ag/AgCl), the bioelectrode showed the response time ($t_{95%}$) as low as 13 sec and the detection limit of $5.1{\times}10^{-5}$ M, and exhibited a good selectivity in the case of the addition of the possible interferents tested. Also it offered a high biocatalytic stability and opened up the possibility for the construction of a mediatorless biosensor.

• Toxicological Research
• /
• v.29 no.4
• /
• pp.293-298
• /
• 2013

A method of detecting lead was developed using square wave anodic stripping voltammetry (SWASV) with DNA-carbon nanotube paste electrode (CNTPE). The results indicated a sensitive oxidation peak current of lead on the DNA-CNTPE. The curves were obtained within a concentration range of 50 $ngL^{-1}-20mgL^{-1}$ with preconcentration time of 100, 200, and 400 sec at the concentration of $mgL^{-1}$, ${\mu}gL^{-1}$, and $ngL^{-1}$, respectively. The observed relative standard deviation was 0.101% (n = 12) in the lead concentration of 30.0 ${\mu}gL^{-1}$ under optimum conditions. The low detection limit (S/N) was pegged at 8 $ngL^{-1}$ ($2.6{\times}10^{-8}M$). Results showed that the developed method can be used in real-time assay in vivo without requiring any pretreatment and pharmaceutical samples, and food samples, as well as other materials requiring water source contamination analyses.

• Bulletin of the Korean Chemical Society
• /
• v.26 no.8
• /
• pp.1293-1296
• /
• 2005

• Analytical Science and Technology
• /
• v.13 no.1
• /
• pp.41-48
• /
• 2000

A biosensor for the determination of hydrogen peroxide was constructed by immobilizing of porcine small instestinal tissue in a plain carbon paste, and the effect of varying the $H_2O_2$ concentration and pH on the rate of catalytic reaction was evaluated. For the mathematical simplicity, no mediator was added. Electrochemical properties and the maximal rate could be derived from the quantitative analysis of the observed phenomena related to the electrode reaction. Also, pH dependence of the Michaelis constant enabled to calculate various thermodynamic parameters and subsequently to design a electrochemical method to determine the optimum pH of enzyme.