• Bulletin of the Korean Chemical Society
• /
• v.33 no.9
• /
• pp.2910-2916
• /
• 2012

Cadmium sulphide (CdS) nanorods were prepared by a single precursor thermal decomposition (SPTD) method. The formation of CdS nanorods and their structure, morphology and elemental composition were studied by means of FT-IR, XRD, FE-SEM, HR-TEM and EDAX analysis. Photoluminescence (PL) and lifetime measurements were recorded to study the luminescence properties of the material. The PL spectrum of the CdS nanorods showed one broad peak and four shoulders and the cause for this emission was discussed. The PL emissions from the band edge and deep trap state of the CdS nanorods were studied by lifetime measurements. Further, the synthesized CdS nanorods showed an increase in efficiency of photocatalytic degradation of methylene blue (MB) and rhodamine B (RhB). The increase in the photocatalytic activity was attributed to the mixed phase of the CdS nanorods.

• Proceedings of the IEEK Conference
• /
• 2000.11a
• /
• pp.497-500
• /
• 2000

There are many researches to increase bandwidth of the microstrip patch antenna for wireless LAN. In spite of broad bandwidth, Bow-Tie microstrip patch antenna, broadband microstrip patch antenna, has disadvantages that are low gain and big size. In this paper, stacked Bow-Tie microstrip patch antenna for wireless LAN is designed in 5.725∼5.825㎓ band. This antenna has characteristics that are broadband bandwidth, high gain and small size compared with microstrip patch antenna. In simulated results, the return loss is -34.2㏈ at 5.78㎓ and bandwidth is 11.345% for VSWR 2：1 and 7.75% for VSWR 1.5：1. In measured results, the return loss is -38.45㏈ at 5.78㎓ and bandwidth is 13% for VSWR 2：1 and 5.6% for VSWR 1.5：1. It has 59.37$^{\circ}$-3㏈ beam width and 6.5㏈ gain.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.267.2-267.2
• /
• 2016

Semiconductor photo-catalysis offers the potential for complete removal of toxic chemicals through its effective and broad potential applications. Various new compounds and materials for chemical catalysts were synthesized in the past few decades. As one of the most important II-VI group semiconductors, zinc sulfide (ZnS) with a wide direct band gap of 3.8 eV has been extensively investigated and used as a catalyst in photochemistry, environmental protection and in optoelectronic devices. In this work, the ZnS films and nanostructures have been successfully prepared by wet chemical method. We show that the agglomerates with four successive scales are always observed in the case of the homogeneous precipitation of zinc sulfide. Hydrodynamics plays a crucial role to determine the size of the largest agglomerates; however, other factors should be invoked to interpret the complete structure. In addition, studies of the photocatalytic properties by exposure to UV light irradiation demonstrated that ZnS nanocrystals (NCs) are good photo-catalysts as a result of the rapid generation of electron-hole pairs by photo-excitation and the highly negative reduction potentials of excited electrons. A combination of their unique features of high surface-to volume ratios, carrier dynamics and rich photo-catalytic suggests that these ZnS NCs will find many interesting applications in semiconductor photo-catalysis, solar cells, environmental remediation, and nano-devices.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.10
• /
• pp.4865-4886
• /
• 2017

The user experience of practical indoor power line communication (PLC) applications is greatly affected by the system quality-of-service (QoS) criteria. With a general broadcast-and-multi-access (BMA) relay scheme, in this work we investigate the joint source and relay power optimization of the amplify-and-forward (AF) relay systems used under indoor broad-band PLC environments. To achieve both time diversity and spatial diversity from the relay-involved PLC channel, which is time-varying in nature, the source node has been configured to transmit an identical message twice in the first and second signalling phase, respectively. The QoS constrained power allocation problem is not convex, which makes the global optimal solution is computationally intractable. To solve this problem, an alternating optimization (AO) method has been adopted and decomposes this problem into three convex/quasi-convex sub-problems. Simulation results show the fast convergence and short delay of the proposed algorithm under realistic relay-involved PLC channels. Compared with the two-hop and broadcast-and-forward (BF) relay systems, the proposed general relay system meets the same QoS requirement with less network power assumption.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.51 no.1
• /
• pp.120-127
• /
• 2015

Morphological properties of dark banded rockfish (Sebastes inermis) were analysed to investigate its acoustic scattering characteristics. Total of 18 live samples was prepared for X-ray photos and collected morphological coordinates of their body and swim bladder shapes. Kirchhoff-ray mode model was used to calculate acoustic scattering pattern for broad-band frequency range. Inclination of swim bladder ranged from 17 to 30 and the averaged value was about $25.2^{\circ}$ (S.D.(standard deviation)=3.15). There were no any tendency of increase or decrease in volume and area ratio of swim bladder to fish body and ranged from 2.2 % to 4.43 % and 14.85 % to 21.31 %, respectively. The averaged value of volume and area ratio was 3.13 % (S.D.=0.52) and 17.6 % (S.D.=1.5). $b_{20}$ values were -69.01 for 38 kHz, -69.83 for 70 kHz, -70.17 for 120 kHz and -70.93 for 200 kHz, recpectively. Broadband acoustic patterns of dark banded rockfish for 20 ~ 200 kHz were similar among samples and they reflected size and morphological properties of fish species.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.05a
• /
• pp.66-70
• /
• 2001

The partial discharge testing is widely used in diagnostic measuring technology because it gives low stress to power equipment which is undertaken tests. Therefore it is very useful method compare to previous destructive methods and effective diagnosis method in power system that requires on-line/on-site diagnosis. But partial discharges have very complex characteristics of discharge pattern, so it is required continuous research to development of precise analysis method. In recent, the study of partial discharge is carrying out discover of initial defect of power equipment through condition diagnosis and system development of degradation diagnosis using HFPD(High Frequency Partial Discharge) detection. In this study, simulated system is manufactured and HFPD occurred from those simulator is measured with broad-band antenna in real time, the degradation grade of system is analyzed through produced patterns in simulated target according to the AI/statistics processing.

• Electrical & Electronic Materials
• /
• v.9 no.2
• /
• pp.146-151
• /
• 1996

PZT powders were prepared by the molten salt synthesis method. The porous PZT ceramics were made from a mixture of PZT and polyvinylalcohol(PVA) by BURPS(Bumout Plastic Sphere) technique. The 3-3 type composites were fabricated by impregnating an sintered porous PZT ceramics with various polymer matrices. The relative permittivity of 3-3 type composite specimens was shown 860-1,100 smaller than that of solid PZT ceramics(2,100), and the dissipation factors of composite specimens were about 0.02 to 0.03. The piezoelectric coefficient d$_{33}$ of composite specimens(285-328*10$^{12}$ C/N) was comparable with that of single phase PZT specimens(364*10$^{-12}$ C/N). The thickness mode coupling factor k$_{t}$(O.5-0.6) of composite specimens was comparable with that of single phase PZT specimens(k$_{t}$-0.7), and the mechanical quality factor of composite specimens was smaller than 10, and thus these 3-3 type composite specimens would be believed as a good candidates for broad band transducer applications.ons.

• Journal of Applied Biological Chemistry
• /
• v.51 no.3
• /
• pp.95-101
• /
• 2008

The gene encoding a putative esterase of Xanthomonas oryzae pv. oryzae was cloned using PCR technique. The gene was expressed with His6 tag in E. coli. One-step purification of the recombinant esterase with Ni-NTA resin resulted in one band by SDS-PAGE analysis. The purified enzyme showed a molecular weight of 30 kDa, as expected, therefore the enzyme was a mononer. The enzyme was the most active toward p-nitrophenyl (p-NP) acetate and p-NP-butyrate to a lesser extent. However, the enzyme could not hydrolyze p-NP-myristate, palmitate, and stearate. Therefore, the enzyme is considered as an esterase, very different from lipase. The purified esterase had optimal pH at around 8.0 and was stable in a broad range of pH values. The optimal temperature ranged from 30 to $40^{\circ}C$, and the residual activity observed after heat treatment at $55^{\circ}C$ for 20 min was 72 % of the initial activity. The activity was inhibited by the presence of copper and cobalt ions.

• 한국생물공학회:학술대회논문집
• /
• 2001.11a
• /
• pp.459-462
• /
• 2001

Angiopoietin-2 (Ang2) is a naturally occurring antagonist for angiopoietin-l (Angl) and its Tie2 receptor during vasculogenesis, Although angiopoietins have been expressed in several mammalian cell lines, their expression levels are low. Recombinant Chinese hamster ovary (CHO) cell lines expressing a high level of human Ang2 or its analog, human $Ang2_{443}$, with an amino-terminal FLAG-tag were constructed by transfecting the expression vectors into dhfr-deficient CHO cells and subsequent gene amplification in medium containing stepwise increments in methotrexate level. Secreted Ang2 or human $Ang2_{443}$ were purified from the cultured medium using an anti-FLAG- agarose affinity chromatography, The purified Ang2 and $Ang2_{443}$ migrated on SOS-PAGE as a broad band, characteristic of glycosylated protein. Their biological activity in vitro was demonstrated in a serum deprivation-induced apoptosis assay. Ang2 at high concentration, like AngI, can be an apoptosis survival factor for endothelial cells through the activation of the Tie2 receptor.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.3
• /
• pp.2-11
• /
• 2001

The L-shaped strip is shown to be an attractive feed for the thick mierostrip antenna (thickness around 10% of the operating wavelength). The L-strip incorporated with the radiating patch introduces a capacitance suppressing some of the inductance introduced by the strip itself. In this paper, a wideband microstrip patch antenna fed by L-strip for the PCS ($1,750{\sim}1,850MHz$) and IMT-2000 ($1,920{\sim}2,170MHz$) broad-band is presented. A two-element array fed by L-strip is also proposed. Both the antennas have stable radiation patterns across the passband. The impedance bandwidth is over 31% (VSWR < 1.5, 615 MHz) of the center frequency. Moreover, both the antennas have about 7 dBi average gain.