• Proceedings of the Korean Powder Metallurgy Institute Conference
• /
• 2006.04a
• /
• pp.45-45
• /
• 2006

• Journal of Power Electronics
• /
• v.18 no.4
• /
• pp.985-996
• /
• 2018

The implementation and performance evaluation of an interleaved boundary conduction mode (BCM) boost power factor correction (PFC) converter is presented in this paper by employing three wide band-gap switching devices: a super junction silicon (Si) MOSFET, a silicon carbide (SiC) MOSFET and a gallium nitride (GaN) high electron mobility transistor (HEMT). The practical considerations for adopting wide band-gap switching devices to BCM boost PFC converters are also addressed. These considerations include the gate drive circuit design and the PCB layout technique for the reliable and efficient operation of a GaN HEMT. In this paper it will be shown that the GaN HEMT exhibits the superior switching characteristics and pronounces its merits at high-frequency operations. The efficiency improvement with the GaN HEMT and its application potentials for high power density/low profile BCM boost PFC converters are demonstrated.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.52 no.6
• /
• pp.235-240
• /
• 2003

In this paper, we present the fabrication and the characteristic analysis of sequential lateral solidification(SLS) poly-Si thin film transistors(TFT's) with molybdenum gate for active matrix liquid displays (AMLCD's) pixel controlling devices. The molybdenum gate is applied for the purpose of low temperature processing. The maximum processing temperature is 55$0^{\circ}C$ at the dopant thermal annealing step. The SLS processed poly-Si film which is reduced grain and grain boundary effect, is applied for the purpose of electrical characteristics improvements of poly-Si TFT's. The fabricated low temperature SLS poly-Si TFT's had a varying the channel length and width from 10${\mu}{\textrm}{m}$ to 2${\mu}{\textrm}{m}$. And to analyze these devices, extract electrical characteristic parameters (field effect mobility, threshold voltage, subthreshold slope, on off current etc) from current-voltage transfer characteristics curve. The extract electrical characteristic of fabricated low temperature SLS poly-Si TFT's showed the mobility of 100~400cm$^2$/Vs, the off current of about 100pA, and the on/off current ratio of about $10^7$. Also, we observed that the change of grain boundary according to varying channel length is dominant for the change of electrical characteristics more than the change of grain boundary according to varying channel width. Hereby, we comprehend well the characteristics of SLS processed poly-Si TFT's witch is recrystallized to channel length direction.

• The Journal of the Acoustical Society of Korea
• /
• v.29 no.7
• /
• pp.448-457
• /
• 2010

Vibrations and wave propagations in waveguide structures can be analysed efficiently by using waveguide finite element (WFE) method. The WFE method only models the 2-dimensional cross-section of the waveguide with finite elements so that the size of the model and computing time are much less than those of the 3-dimensional FE models. For cylindrical shells or pipes which have simple cross-sections, the external coupling with fluids can be treated theoretically. For waveguides of complex cross-sectional geometries, however, numerical methods are required to deal with external fluids. In this numerical approach, the external fluid is modelled by the boundary elements (BEs) and connected to WFEs. In order to validate this WFE/BE method, a pipe submerged in water is considered in this study. The dispersion diagrams and point mobilities of the pipe simulated are compared to those that theoretically obtained. Also the acoustic powers radiated from the pipe are predicted and compared in both cases of air and water as an external medium.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.4
• /
• pp.65-80
• /
• 2012

Mobile IP is a simple and scalable global mobility solution. However, it may cause excessive signaling traffic and long signaling delay. So MN (Mobile Node) to the home network in order to reduce the number of location update signaling is necessary to reduce the delay. In this paper, the signaling overhead to be distributed evenly on the boundary of the regional network, each MN's dynamic mobility and traffic load is adjusted according to the PMIPv6 (Proxy Mobile IPv6) networks in the proposed dynamic regional mobility management scheme (dMMS). Each user in a distributed network system that offers the least amount of signaling traffic is tailored to the optimized system configuration. Signaling cost function in order to propose a new discrete analytical model is proposed, MN's mobility and packet arrival patterns. Location update and packet delivery costs to calculate the total average, the optimized area to determine the size of the network is proposed. The results of mathematical analysis, the proposed technique dMMS in terms of reducing the cost of the entire signaling were found to be excellent performance.

• Transactions of the Korean hydrogen and new energy society
• /
• v.34 no.5
• /
• pp.439-446
• /
• 2023

In this study, the computational fluid dynamics (CFD) simulations were conducted to verify the cooling capacity of the cryocooler used for pre-cooling of hydrogen gas. Based on the experimental results, the effect of the flow rate on a copper pipe attached to the bottom of the cryocooler was investigated. In this study, the temperature data was calculated through the change of boundary condition for heat flux in the copper pipe. In addition, the cooling capacity of the cryocooler for pre-cooling hydrogen gas was considered by calculating the cooling temperature according to the flow rate in the certified operating range. Consequently the pre-cooing system for hydrogen gas was validated with a reasonable accuracy through CFD simulations.

• Genomics & Informatics
• /
• v.7 no.2
• /
• pp.131-135
• /
• 2009

Domains are the building blocks of proteins. Exon shuffling is an important mechanism accounting for combination of a limited repertoire of protein domains in the evolution of multicellular species. A relative excess of domains encoded by symmetric exons in metazoan phyla has been presented as evidence of exon shuffling, and symmetric domains can be divided into old and new domains by determining the ages of the domains. In this report, we compare the spread, versatility, and subcellular localization of old and new domains by analyzing eight metazoan genomes and their respective annotated proteomes. We found that new domains have been expanding as multicellular organisms evolved, and this expansion was principally because of increases in class 1-1 domains amongst several classes of domain families. We also found that younger domains have been expanding in membranes and secreted proteins along with multi-cellular organism evolution. In contrast, old domains are located mainly in nuclear and cytoplasmic proteins. We conclude that the increasing mobility and versatility of new domains, in contrast to old domains, plays a significant role in metazoan evolution, facilitating the creation of secreted and transmembrane multidomain proteins unique to metazoa.

• Journal of Korean Institute of Industrial Engineers
• /
• v.28 no.4
• /
• pp.425-434
• /
• 2002

Mobility of service users makes location update and paging (L/P) procedures indispensable features in mobile communication networks. Importance of optimizing the configuration of L/P areas has been increased by the growth of L/P related signaling. In this study, we deal with the L/P configuration which an LA (Location Area) may contain multiple PAs (Paging Areas). Given the network topology, L/P related parameters, and traffics generated by each cell, is provided the problem of finding optimal LA/PA configuration minimizing the amount of L/P related signaling. The optimization problem is solved using a simulated annealing, and detailed computational results are conducted to capture the effects of mobility, call arrival patterns and boundary crossing rate on the LA and PA configurations.

• Journal of the Society of Disaster Information
• /
• v.17 no.3
• /
• pp.655-666
• /
• 2021

Purpose: This study is to develop a method for measuring dynamic speeding risks using vehicle trajectory big data and to demonstrate the feasibility of the devised speeding index. Method: The speed behaviors of vehicles were analysed in microscopic space and time using individual vehicle trajectories, and then the boundary condition of speeding (i.e., boundary speed) was determined from the standpoint of crash risk. A novel index for measuring the risk exposure of speeding was developed in microscopic space and time with the boundary speed. Result: A validation study was conducted with vehicle-GPS trajectory big data and ground-truth vehicle crash data. As a result of the analysis, it turned out that the index of speeding-risk exposure has a strong explanatory power (R²=0.7) for motorway traffic accidents. This directly indicates that speeding behaviors should be analysed at a microscopic spatiotemporal dimension. Conclusion: The spatial and temporal evolution of vehicle velocity is very variable. It is, hence, expected that the method presented in this study could be efficaciously employed to analyse the causal factors of traffic accidents and the crash risk exposure in microscopic space using mobility trajectory data.

• Journal of the Korean Ceramic Society
• /
• v.25 no.4
• /
• pp.390-398
• /
• 1988

Effects of atmospheres and adidtives on the grain growth of TiO2 ceramics were investigated. In the range of 1300~140$0^{\circ}C$, grain growth was increased in CO2 as compared with O2 atmosphere and the grain boundary migration activation energy was lower than the diffusion activation energy of oxygen ion in TiO2. Also, in the case of addition of oxides, the grain growth was increased by oxides acting as a acceptor andinhibited by oxides acting as a donor. From the above results, when the oxygen vacancy concentration was increased, the intrinsic grain boundary mobility was increased and the pore drag force was decreased due to the rapid densification. Also it seems that the pore was migrated by the surface diffusion rather than lattice diffusion.