• 한국자동차공학회논문집
• /
• 제17권2호
• /
• pp.82-89
• /
• 2009

In order to investigate the spray characteristics according to diesel and bioethanol blending with biodiesel fuel, macroscopic spray characteristics were analyzed from the comparison of the effect of the injection pressure, ambient pressure and density on the spray tip penetration and spray cone angle. In addition, spray atomization characteristics were studied with local and overall Sauter mean diameter (SMD) and the contour map of SMD distribution at various injection conditions. It was revealed that the spray tip penetration of biodiesel fuels blended with diesel and ethanol was shorter than that of an undiluted biodiesel fuel at low injection pressure. However, the difference of spray tip penetration among three test fuels reduces at a high injection pressure. Increase of the ambient gas density leads to the decrease of the spray tip penetration of three test fuels. When diesel and ethanol fuels add to an undiluted biodiesel fuel, spray cone angle increases due to the decrease of the fuel density at the same ambient pressure condition. On the other hand, the droplet mean diameter decreases due to the reduction of the kinematic viscosity and surface tension.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2002년도 가을 학술발표회 논문집
• /
• pp.227-232
• /
• 2002

To evaluate the practical application of oyster shells as construction materials, an experimental study was performed. More specifically, the long-term mechanical properties and durability of concrete blended with oyster shells were investigated. Test results indicate that long-term strength of concrete blended with 10% oyster shells is almost identical to that of normal concrete. However, the long-term strength of concrete blended with 20% oyster shells Is appreciably lower than that of normal concrete. 1'hereby, concrete with higher oyster shell has the possibility giving a bad influence on the concrete long-term strength. Elastic modulus of concrete blended with crushed oyster shells decreases as the blending mixture ratio increases. Namely, the modulus is reduced by approximately 10∼15% when oyster shells are blended up to 20% replacing the fine aggregate. The drying shrinkage strain increases as the blending ratio increases. In addition, the existing model code of drying shrinkage does not coincide with the test results of this study. An adequate prediction equation needs to be developed. The utilization of oyster shells as the fine aggregate in concrete has an insignificant effect on freezing and thawing resistance, carbonation and sulfuric acid attack of concrete recycling. However, water permeability is considerably improved.

• 한국식품과학회지
• /
• 제23권4호
• /
• pp.465-470
• /
• 1991

대두유, 팜유, 쇼트닝 그리고 대두유에 팜유를 각각 50%, 70% 배합한 혼합유로 French fry용 감자를 반복 튀김 했을 때 튀김기름의 열분해 및 산화에 대한 안정성을 알아보기 위하여 10회의 반복튀김에 사용된 기름을 매회 취하여 산값, 과산화물값, TBA값, 색도, 굴절율, 비중 등의 이화학적 특성을 측정하였다. 열분해 및 산화에 대한 대두유의 불안정성은 대두유에 팜유를 배합함으로써 감소시킬 수 있었는 바, 대두유에 대한 팜유의 비율이 커질수록 그 안정성이 증가하였다. 팜유가 50% 배합된 혼합유의 경우에는 대두유를 단독 사용했을 때 보다 그 안정성이 현저히 증가하였고 팜유가 70% 배합된 혼합유의 경우에는 팜유를 단독 사용했을 경우와 거의 같았다.

• 한국작물학회지
• /
• 제51권spc1호
• /
• pp.292-296
• /
• 2006

Three rice cultivars of Goami2 (G2), Ilpumbyeo (IP), and Baegjinju (BJJ) of which physicochemical properties are significantly different, were blended by a simplex-lattice mixture design. The effect of blending those rice cultivars on pasting and texture properties were observed. Rapid Visco Analysis (RVA) indicated that the onset gelatinization temperature of pure blend of G2 rice $(83.80{\pm}0.07^{\circ}C)$ was higher than that of IP $(68.08{\pm}0.01^{\circ}C)$ and BJJ $(68.08{\pm}0.04^{\circ}C)$. Increasing G2 rice resulted in lower peak and breakdown viscosity, and adhesiveness and cohesiveness, whereas higher setback viscosity and hardness. Pasting and texture properties of IP and BJJ indicated that G2 rice has quite different physical characteristics compared to IP and BJJ. Thus, it is expected that blending those three rice cultivars can be used to formulate a desirable rice blend on purpose, furthermore to promote the consumption of G2 rice, which has higher indigestible carbohydrate contents.

• 폴리머
• /
• 제34권1호
• /
• pp.84-87
• /
• 2010

구리, 인디움, 셀레늄 이온을 포함한 혼합물을 전기화학적으로 환원하는 1회 반응으로 CIS 입자를 합성하였다. 합성된 입자를 폴리(옥틸티오펜/풀러렌으로 구성된 벌크이종접합에 블렌딩하거나 박막층으로 삽입하여 여러 가지 광기전셀을 제조하였다. CIS의 함량이 증가할수록 개방전압과 단락전류의 급격한 감소가 일어났다. 이러한 광기전성의 감소현상을 블렌드의 구조, 조성, 모폴로지를 분석 해석하였다.

• 한국조경학회지
• /
• 제27권3호
• /
• pp.109-113
• /
• 1999

The objective of this research was to develop growth media for artificial ground by blending calcined clay and coconut peat. To achieve this, aggregates of clay particles were mixed with disel oil and heated to high temperature(1150~120$0^{\circ}C$) to expand clays. The particle sizes of expanded clay were controlled to 2~5mm in diameter. Then expanded clayes were mixed with coconut peat and changes of soil physicochemical properties and their effect on plant growth of Hedera L. were determined. The infiltration rate of calcined clay was very high, but the water holding capacity, the cation exchange capacity(CEC), and the nutrient contents were low. The characteritics of coconut peat was vice verse to calcined clay. This indicates that the mixture of calcined clay and coconut peat have the better characteristics than each material. As compared to mineral soil, the infiltration rate, the water holding capacity, the CEC and the nutrient contents increased, but bulk density decreased to about 1/4. And, Hedera L. grown in the mixture of calcined clay and coconut peat(6:4, v/v) had higher plant height, longer leaf length, more total number of leaves per plant and fresh weight than that grown in mineral soil, but statistical differences were not observed between two treatments.

• 한국산학기술학회논문지
• /
• 제10권6호
• /
• pp.1298-1303
• /
• 2009

현무암 단섬유로 강화시킨 시멘트 복합재료의 섬유장과 혼입률에 따른 인장강도와 굽힘강도의 변화를 고찰하였다. 인장 및 굽힘강도의 증가는 섬유장의 증가에 따른 효과보다는 섬유 혼입률의 증가가 더 큰 역할을 하였다. 또한 현무암 단섬유와 시멘트 사이의 우수한 계면 접착력은 물리적 성질의 향상에 좋은 영향을 미친다고 보여진다. 시멘트의 수화시 생성되는 알칼리 조건과 유사한 포화 $Ca(OH)_2$ 용액에서의 중량감소율을 관찰한 결과 현무암 단섬유는 3주 동안의 침지 후에도 매우 작은 중량감소율을 나타냈다.

• 한국분무공학회지
• /
• 제17권3호
• /
• pp.121-127
• /
• 2012

The study is to investigate the mixing stability, fuel properties, and macroscopic spray characteristics of diesel-gasoline blended fuels in a common-rail injection system of a diesel engine. The test fuels were mixed diesel with gasoline fuel, which were based volume fraction of gasoline from 0 to 100% in 20% intervals. In order to analyze the blended effect of gasoline to diesel fuel, the properties of test fuels such as density, viscosity, and surface tension were measured. In addition, the spray behavior characteristics were studied by investigating the spray tip penetration and spray angle using a spray images through a spray visualization system. It was revealed that the density, kinematic viscosity and surface tension of diesel-gasoline blending fuels were decreased with the increase of gasoline fuel. The injection quantity of test fuels were almost similar level at short energizing duration condition. On the other hand, the increase of energizing duration shows the decrease of injection quantity compared to short energizing duration. The test blending fuels have similar growth in Spray tip penetration and Spray cone angle.

• 한국의류학회지
• /
• 제29권2호
• /
• pp.347-355
• /
• 2005

Biodegradability of cotton/polyester blend fabric was investigated employing activated sluge test, soil burial test and enzyme hydrolysis. Surface changes of the degraded sample were observed through a microscopy. Changes in X-ray diffraction patterns and crystallinity were examined using X-ray diffractometer. Experimental results revealed that biodegradability of cotton/polyester blend fabric was proportional to the blending ratio of cotton, not showing any synergy effect. Polyester 100% hardly degraded in this study. Through the comparison of the experimental method it was shown that the biodegradabilities determined from activated sludge test and enzymatic hydrolysis except soil burial test were linearly related to the blending ratio of cotton in the blent fabrics. It is probably because the biodegradability determined from the retention of tensile strength of fabrics buried in soil was affected by the stress distribution of polyesters throughout the fabric. From the microscopic observations it was revealed that fungi were grown on the fabric surface and the colors turned yellow, brown and black. X-ray diffraction patterns showed that the heights of crystalline peak coming from cotton part in blend fabrics decreased whereas those coming from polyester part increased comperatively as time passed by. Crystallinities of cotton 100% fabric increased slightly at the begining and then decreased continuously.

• Korean Membrane Journal
• /
• 제11권1호
• /
• pp.1-7
• /
• 2009

This work reports the preparation of proton conductive crosslinked polymer electrolyte membranes by blending poly(vinyl chloride)-g-poly(hydroxyl ethyl acrylate) (PVC-g-PHEA) and poly(vinyl alcohol) (PVA). The PHEA chains of the graft copolymer were crosslinked with PVA using sulfosuccinic acid (SA) via the esterification reaction between -OH of polymer matrix and -COOH of SA. The PVC-g-PHEA graft copolymer was synthesized via atom transfer radical polymerization (ATRP) using direct initiation of the secondary chlorines of PVC backbones. Ion exchange capacity (IEC) continuously increased with increasing concentrations of SA, due to the increasing portion of charged groups in the membrane. However, the water uptake increased up to 20.0 wt% of SA concentration above which it decreased monotonically. The membrane exhibited a maximum proton conductivity of 0.026 S/cm at 20.0 wt% of SA concentration, which is presumably due to competitive effect between the increase of ionic sites and the crosslinking reaction.