• ETRI Journal
• /
• v.41 no.2
• /
• pp.184-196
• /
• 2019

Wavelet packet modulation (WPM) is a multicarrier modulation (MCM) technique that has emerged as a potential alternative to the widely used orthogonal frequency-division multiplexing (OFDM) method. Because WPM has overlapped symbols, equalization cannot rely on the use of the cyclic prefix (CP), which is used in OFDM. This study applies linear minimum mean-square error (MMSE) equalization in the time domain instead of in the frequency domain to achieve low computational complexity. With a modest equalizer filter length, the imperfection of MMSE equalization results in subcarrier attenuation and noise amplification, which are considered in the development of a bit-loading algorithm. Analytical expressions for the bit error rate (BER) performance are derived and validated using simulation results. A performance evaluation is carried out in different test scenarios as per Recommendation ITU-R M.1225. Numerical results show that WPM with equalization-aware bit loading outperforms OFDM with bit loading. Because previous comparisons between WPM and OFDM did not include bit loading, the results obtained provide additional evidence of the benefits of WPM over OFDM.

• Journal of electromagnetic engineering and science
• /
• v.10 no.2
• /
• pp.50-55
• /
• 2010

Orthogonal Frequency Division Multiplexing(OFDM) dual-hop systems can take full advantages of the techniques of both multi-hop communication and OFDM. To achievethis end, we propose a joint subcarrier matching, power allocation and bit loading algorithm operating under a total power constraint and the same Bit Error Rate(BER) threshold over all subcarriers. Simulation results demonstrated system throughput improvement compared to single-hop systems and dual-hop systems with different bit loading algorithms for each relay position, power constraint, and required BER.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.4A
• /
• pp.315-321
• /
• 2010

In Ad-hoc networks, centralized power control is not suitable due to the absence of base stations, which perform the power control operation in the network to optimize the system performance. Therefore, each node should perform power control algorithm distributedly instead of the centralized one. The conventional distributed power control algorithm does not consider the adaptive bit loading operation to change the MCS (modulation and coding scheme) according to the received SINR (signal to interference and noise ratio), which limits the system throughput. In this paper, we propose a novel distributed bit loading and power control algorithm, which considers the adaptive bit loading operation to increase total system throughput and decrease outage probability. Simulation results show that the proposed algorithm performs much better than the conventional algorithm.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.2
• /
• pp.18-26
• /
• 2009

When channel state information (CSI) is available at the transmitter, the system throughput can be enhanced by adaptive transmissions and opportunistic multiuser scheduling. In this paper, we consider multiple-input multiple-output (MIMO) systems employing bit-interleaved coded orthogonal frequency division multiplexing (BIC-OFDM). We first propose a bit-loading algorithm based on the Levin-Campello algorithm for the BIC-OFDM. Then we will apply this algorithm to the MIMO system with a finite set of constellations, by reassigning residual power on each stream Simulation results show that proposed bit-loading scheme which takes the residual power into account improves the system performance especially at high signal-to-noise ratio (SNR) range.

• ETRI Journal
• /
• v.29 no.4
• /
• pp.445-451
• /
• 2007

An adaptive modulation scheme is presented for multiuser orthogonal frequency-division multiplexing systems. The aim of the scheme is to minimize the total transmit power with a constraint on the transmission rate for users, assuming knowledge of the instantaneous channel gains for all users using a combined bit-loading and subcarrier allocation algorithm. The subcarrier allocation algorithm identifies the appropriate assignment of subcarriers to the users, while the bit-loading algorithm determines the number of bits given to each subcarrier. The proposed bit-loading algorithm is derived from the geometric progression of the additional transmission power required by the subcarriers and the arithmetic-geometric means inequality. This algorithm has a simple procedure and low computational complexity. A heuristic approach is also used for the subcarrier allocation algorithm, providing a trade-off between complexity and performance. Numerical results demonstrate that the proposed algorithms provide comparable performance with existing algorithms with low computational cost.

• Journal of Information Processing Systems
• /
• v.10 no.2
• /
• pp.163-175
• /
• 2014

This paper will focus on improving the performance of orthogonal frequency division multiplexing (OFDM) in Rayleigh fading environments. The proposed technique will use a previously published method that has been shown to improve OFDM performance in independent fading, based on ordered sub-carrier selection. Then, a simple non-iterative method for finding the optimal bit-loading allocation was proposed. It was also based on ordered sub-carrier selection. We compared both of these algorithms to an optimal bit-loading solution to determine their effectiveness in a correlated fading environment. The correlated fading was simulated using the JTC channel models. Our intent was not to create an optimal solution, but to create a low complexity solution that can be used in a wireless environment in which the channel conditions change rapidly and that require a simple algorithm for fast bit loading.

• Proceedings of the IEEK Conference
• /
• summer
• /
• pp.15-18
• /
• 2004

In this paper we present a linear discrete bit-loading algorithm that maximizes the transmit bit rate using the channel informations to optimize the performance of the very high-speed digital subscriber line(VDSL) system. It will be useful under the constraint of a maximum transmit power for each user. When the level of crosstalk is high, the power allocation of a user changes the noise experienced by the other users in the same binder. In this case, the performance of DSL modems can be improved by jointly considering the bit and power allocation of all users.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.7C
• /
• pp.624-632
• /
• 2005

We consider an adaptive bit-loading technique for bit interleaved coded modulation-orthogonal frequency division multiplexing(BICM-OFDM) systems. By adjusting transmission parameter of each subcarrier adaptively depending on the subchannel state, the performance of OFDM system can be improved dramatically. In this paper, the number of bits for each subcarrier is allocated to minimize bit error rate keeping the constant throughput for the adaptive transmission technique of BICM-OFDM system which can be applied to real time transmission. Also, We use the discrete Lagrange multiplier method to get the optimum solution under the integer bit allocation constraint. Simulation results show that computational amount of the proposed bit allocation technique is not high and BICM-OfDM system using the proposed technique can get the SNR gain by 2$\~$3 dB over nonadaptive one.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.5 no.11
• /
• pp.1959-1975
• /
• 2011

Adaptive Bit Loading (ABL) in Multiple-Input Multiple-Output Orthogonal Frequency-Division Multiplexing (MIMO-OFDM) is often used to achieve the desired Bit Error Rate (BER) performance in wireless systems. In this paper, we discuss some of the bit loading algorithms, compare them in terms of the BER performance, and present an effective and concise Adaptive Grouped Loading (AGL) algorithm. Furthermore, we propose a "weight factor" for loading algorithm to converge rapidly to the final solution for various data rate with variable Signal to Noise Ratio (SNR) gaps. In particular, we consider the bit loading in near optimal Singular Value Decomposition (SVD) based MIMO-OFDM system. While using SVD based system, the system requires perfect Channel State Information (CSI) of channel transfer function at the transmitter. This scenario of SVD based system is taken as an ideal case for the comparison of loading algorithms and to show the actual enhancement achievable by our AGL algorithm. Irrespective of the CSI requirement imposed by the mode of the system itself, ABL demands high level of feedback. Grouped Loading (GL) would reduce the feedback requirement depending upon the group size. However, this also leads to considerable degradation in BER performance. In our AGL algorithm, groups are formed with a number of consecutive sub-channels belonging to the same transmit antenna, with individual gains satisfying predefined criteria. Simulation results show that the proposed "weight factor" leads a loading algorithm to rapid convergence for various data rates with variable SNR gap values and AGL requires much lesser CSI compared to GL for the same BER performance.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.5
• /
• pp.153-160
• /
• 2004

In this paper, we propose an efficient bit loading algorithm for IEEE 802.11a wireless LAN systems. While a conventional bit loading algorithm uses the SNR value of each subcarrier, it is very difficult to estimate the exact SNR value in wireless LAN systems due to randomness of AWGN. Therefore, in order to solve this problem our proposed algorithm uses the channel frequency response instead of the SNR of each subcarrier. Through simulation results, we can obtain the performance gain of 3.5∼8㏈ at PER of 10-2 with the proposed bit loading algorithm while the conventional one obtains the performance gain of 0.5∼5㏈ at the same conditions. Also, the increased data rate can be confirmed 63Mbps. After the logic synthesis using 0.3${\mu}{\textrm}{m}$ CMOS technology, the logic gate count for the processor with proposed algorithm can be reduced by 34% in comparison with the conventional one.