• Journal of the Korea Society of Computer and Information
• /
• v.18 no.3
• /
• pp.27-34
• /
• 2013

A wideband patch antenna fed by an L-strip feeder is studied. The objective of this paper is to design small wideband antenna for 3G and 4G wireless mobile communication service. The enhanced features were confirmed and proved by comparing the proposed antenna with the antennae that have been reported in the relevant literatures. Measurement results confirm that an impedance bandwidth($VSWR{\leq}2$) of 636MHz(32.5%, fo=1,960MHz) is achieved at 3G and 4G frequency band for L-strip-fed triangular patch antenna. In general, probe feed has only the parasitic reactance caused by the probe, which reduces the bandwidth performance of the antenna. The experimental results proved that the effects of improvement could be achieved because the proposed antenna is capable of compensating the parasitic reactance from the feeding mechanism. The studied antenna can be designed easily for extension of array because it has simple structure.

• Journal of IKEEE
• /
• v.23 no.1
• /
• pp.91-98
• /
• 2019

LTE's extension for unlicensed spectrum called Licensed Assisted Access (LAA) is equipped with Listen-Before-Talk (LBT) designed similar with the backoff mechanism of Wi-Fi for coexistence. However, Wi-Fi's backoff mechanism has not evolved from its old design for compatibility with legacy devices, thus LAA's LBT is not efficient either in utilizing spectrum. If LAA operates with no Wi-Fi systems in proximity, it can run more efficient LBT. In this paper, we propose Narrowband Clear Channel Assessment (NCCA) for narrowband transmission. In NCCA, an LAA node performs LBT in either wide or each narrow bandwidth segment. This allows multiple LAA nodes to perform simultaneous transmissions in orthogonal bandwidth segments in the same time slot. We design four variants of NCCA implementation and model their performance using a mathematical model. The coexistence performance of NCCA with conventional wideband nodes and the accuracy of the model are shown via simulation.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.1
• /
• pp.69-74
• /
• 2021

This paper introduces a low-power voltage-controlled oscillator(VCO) with filters that consist of resistors and capacitors. The proposed VCO contains a 5-stage current mode buffer, and each buffer cell has a resistor-capacitor filter that connects input and output terminals. The filter adds a zero to the buffer cell. Because the zero moves the oscillation condition to high frequencies, the proposed VCO can generate a high frequency clock with low power consumption. The proposed circuit has been designed with 0.18 ㎛ CMOS process. The power consumption is 9.83 mW at 2.7 GHz. The proposed VCO shows 3.64 pJ/Hz in our simulation study, whereas the conventional circuit shows 4.79 pJ/Hz, indicating that our VCO achieves 24% reduction in power consumption.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.5
• /
• pp.925-933
• /
• 2003

Network is expected to be developed into optical Internet network collected IP layer and optical layer, but GMPLS is risen at the transitional evolution stage because of the present technology level. GMPLS that MPLS is extended and generalized is able to support not only the packet switching device but also the devices which perform switching in time, wavelength, and space domain. To implement the common control plane to these various switching types, GMPLS extends the existing MPLS signaling and routing protocol. In this paper, we describe the overview of GMPLS technology, and then we will refer to the OSPF(Open Shortest Path First), which was used to exchange the status information of link, as the plan of routing extension to exchange the information of various link type, bandwidth, link protection type etc. And also, we describe the definition of new protocol, so called, LMP that is a signaling protocol for solving complex problem which manages hundreds and thousands of links between two nodes. And we will examine and analyze the plan of signaling protocol extension to apply signaling protocol RSVP-TE(Resource Reservation Protocol) for traffic engineering in MPLS to network, and the message objects and formats associated with modified RSVP.

• Journal of Broadcast Engineering
• /
• v.13 no.1
• /
• pp.34-42
• /
• 2008

This paper proposes the mechanism which improves the qualify of video on a limited network bandwidth by applying the ROI technique to an H.264 Scalable Extension technique. The network environment assumed in this parer is the next generation network convergence environment in which the mobile device has one or more network interfaces. Therefore, we allocate the priority to video packets as the hierarchy structure of H.264 SVC-encoded video stream and ROI information, and transmit those packets over appropriate network channel for using those multiple network interfaces. This paper shows two experiments first one is extracting and allocating the video stream on an appropriate network channel, second one is unequal packet transmission by allocated priorities (e.g. ROI). Performance evaluations show that this approach delivers an improved decoded video quality when compared with conventional transmission schemes, especially on device which has multiple network interfaces.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.12
• /
• pp.9-16
• /
• 2005

A new online routing algerian is proposed in this paper, which use the interference-prediction to solve the network congestion originated from extension of Internet scope and increasing amount of traffic. The end-to-end QoS has to be guaranteed in order to satisfy service level agreements (SLAs) in the integrated networks of next generation. For this purpose, bandwidth is allocated dynamically and effectively, moreover the path selection algorithm is required while considering the network performance. The proposed algorithm predicts the level of how much the amount of current demand interferes the future potential traffic, and then minimizes it. The proposed algorithm considers the bandwidth on demand, link state, and the information about ingress-egress pairs to maximize the network performance and to prevent the waste of the limited resources. In addition, the interference-prediction supports the bandwidth guarantee in dynamic network to accept more requests. In the result, the proposed algorithm performs the effective admission control and QoS routing. In this paper, we analyze the required conditions of routing algorithms, the aspect of recent research, and the representative algorithms to propose the optimized path selection algorithm adequate to Internet franc engineering. Based on these results, we analyze the problems of existing algorithms and propose our algorithm. The simulation shows improved performance by comparing with other algorithms and analyzing them.

• Journal of electromagnetic engineering and science
• /
• v.6 no.2
• /
• pp.103-109
• /
• 2006

This paper suggests an efficient and comprehensive algorithm of the protection ratio derivation and illustrates some calculated results applicable to the initial planning of frequency coordination in the fixed wireless access networks. The net filter discrimination associated with Tx spectrum mask and overall Rx filter characteristic has been also examined to show the effect of the adjacent channel interference. The calculations for co-channel and adjacent channel protection ratios are performed for the current microwave frequency band of 6.7 GHz including Tx spectrum mask and Rx filter response. According to results, fade margin and co-channel protection ratio reveal 41.4 and 75.2 dB, respectively, for 64-QAM and 60 km at BER $10^{-6}$. It is shown that the net filter discrimination with 40 MHz channel bandwidth provides 28.9 dB at the first adjacent channel, which yields 46.3 dB of adjacent channel protection ratio. In addition, the protection ratio of 38 GHz radio relay system is also reviewed for millimeter wave band applications. The proposed method gives some advantages of an easy and systematic extension for protection ratio calculation and is also applied to frequency coordination in fixed millimeter wave networks.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.125-130
• /
• 2005

This paper suggests an efficient method of protection ratio calculation and shows some calculated results applicable to frequency coordination in microwave relay system networks, and the net filter discrimination (NFD) associated with Tx spectrum mask and overall Rx filter characteristics has been examined to obtain the adjacent channel protection ratio. The protection ratio comprises several factors such as C/N of modulation scheme, noise-to-interference ratio, multiple interference allowance, fade margins of multi-path and rain attenuation, and NFD. According to computed results for 6.7 GHz, 64-QAM, and 60 km at BER $10^{-6}$, fade margin and co-channel protection ratio are 41.1 and 75.2 dB, respectively, In addition, NFD for channel bandwidth of 40 MHz reveals 28.9 dB at the first adjacent channel, which results in adjacent channel protection ratio of 46.3 dB. The proposed method provides some merits of an easy calculation, systematic extension, and applying the same concept to frequency coordination in millimeter wave relay system networks.

• Journal of KIISE:Information Networking
• /
• v.28 no.3
• /
• pp.426-434
• /
• 2001

Striping is a scheme that partitions data into blocks and distributes the blocks on different servers in a well defined order and thus could improve system capacity through load balance. In this paper, we propose a parallel VOD server and striping policies for load balancing when extra storage nodes are attached to a parallel VOD server for insufficient disk space in that VOD server. When new video data is stored on the attached storage node, the node may be overloaded. Since it decreases the system bandwidth, appropriate striping policies are required. We therefore present three striping policies that move some block of data o existing nodes into the new node and distribute the new data across all the storage nodes including the new node. Our experiment result shows that FSM bi-direction is the most effective technique.

• The KIPS Transactions:PartA
• /
• v.11A no.1
• /
• pp.49-56
• /
• 2004

The performance of the multiprocessor systems is limited by the several factors. The system performance is affected by the processor speed, memory delay, and interconnection network bandwidth/latency. By the evolution of semiconductor technology, off the shelf microprocessor speed breaks beyond GHz, and the processors can be scalable up to multiprocessor system by connecting through the interconnection networks. In this situation, the system performances are bound by the latencies and the bandwidth of the interconnection networks. SCI, Myrinet, and Gigabit Ethernet are widely adopted as a high-speed interconnection network links for the high performance cluster systems. Performance improvement of the interconnection network can be achieved by the bandwidth extension and the latency minimization. Speed up of the operation clock speed is a simple way to accomplish the bandwidth and latency betterment, while its physical distance makes the difficulties to attain the high frequency clock. Hence the system performance and scalability suffered from the interconnection network limitation. Duplicating the link of the interconnection network is one of the solutions to resolve the bottleneck of the scalable systems. Dual-ring SCI link structure is an example of the interconnection network improvement. In this paper, I propose a network topology and a transaction path algorism, which optimize the latency and the efficiency under the duplicated links. By the simulation results, the proposed structure shows 1.05 to 1.11 times better latency, and exhibits 1.42 to 2.1 times faster execution compared to the dual ring systems.