• Journal of Ecology and Environment
• /
• v.31 no.4
• /
• pp.333-339
• /
• 2008

We investigated death rates, growth rates and recruitment of culms in two neighboring bamboo (Phyllostachys bamboosoides) stands nested in by two different bird species to analyze stand structure and to design conservation strategies. A third bamboo grove not used by birds, the Taewha stand, was included as a control stand. The bamboo stand occupied by birds in the family Ardeidae (the Ardeidae stand) had an approximately 1.5 times higher culm density than the stand occupied by birds in the family Corvidae (the Corvidae stand). The crude death rate and the number of newly emerged shoots were also higher in the Ardeidae stand than the Corvidae stand. The death rate for bamboo in the Ardeidae stand was not dependent on diameter at breast height (DBH) and was almost 40% for culms of all sizes, whereas most dead culms in the Corvidae stand were < 4 cm DBH. Consequently, we conclude that in the Ardeidae stand, density-independent causes of death are operating, while density-dependent factor are more important in the Corvidae site. The results of soil analysis in these stands suggest that the density-independent death pattern observed in the Ardeidae stand may be due to soil acidification resulting from wastes produced by the birds during breeding. On the other hand, the culm distribution and death patterns in the Corvidae stand suggest that the stand characteristics were not affected by the nesting birds. These results suggest that different conservation strategies must be applied to conserve bamboo groves used by ardeids and corvids for nesting.

• Journal of Korean Society of Forest Science
• /
• v.26 no.1
• /
• pp.13-18
• /
• 1975

This study was intended to clarify interrelations among seven characters of bamboo and their influences upon its culm-volume. The analysis of covariance was used to obtain phenotypic correlations, genotypic correlations and environmental correlations among some characters of Phyllostachys bambusoides Sieb. et Zucc., and thereby path-coefficients were calculated based on Dewey's method. The characters considered here included the breast height diameter, culm-height, clear-length, subterranean stem, number of bamboo joints, butt-end diameter and culm-volume of bamboo. Average values, standard errors, variances and standard deviations for the characters mentioned above are shown in Table 1, and phenotypic correlations, genotypic correlations and environmental correlations among seven characters are shown in Table 2, according to the results, there are highly significant relationships among lines but not among some replications. According to Table 4, heritability values in the breast height and butt-end diameters are higher than those in other characters mentioned above. On the other hand, environmental correlations among general characters appear to have lower values than phenotypic and genotypic correlations do. It also appears that the butt-end diameter and breast height diameter are highly correlated with the culm-volume of bamboo. The path-coefficients of individual characters to the culm-volume of bamboo are computed from the correlations (Table 4) and presented in Figure 1 and Table 5, where it could shown the direct and indirect effects on the bamboo culm-volume of each character.

• Journal of Korean Society of Forest Science
• /
• v.101 no.1
• /
• pp.138-147
• /
• 2012

For biomass estimation of Phyllostachys pubescens stands by optimal survey method we established 9 bamboo sample plots in the research forests of KFRI (Korea Forest Research Institute). The dry weight of culm segment determined by relative heights of total bamboo height show us two groups of 1st to 5th culm segment (up to 0~55% culm of tree height from the bottom area) and 6th to 8th culm segment (55~100%) by the results of cluster analysis for dry weight ratio. This results show that upper and lower part of 55~70% reference height from the bottom area against total culm height can be used in obtaining 1 kg of a sample bamboo, respectively, rather than 2.0 m stem segments of other forest tree species. In above-ground biomass estimation by $W=aD+bD^2$ having the highest coefficient of determination in this study, above ground stand biomass was 57.77 ton/ha (culm 40.47 ton/ha, branch 9.29 ton/ha, and leaf 8.01 ton/ha) of which 70% was contributed by culm component followed by branch (16%) and leaf (14%). Below-ground biomass was 53.35 ton/ha in total.

• Journal of Korean Society of Forest Science
• /
• v.76 no.4
• /
• pp.338-347
• /
• 1987

The research was carried out to investigate the related phenomena, the latent structures and synthetical characteristics in various growth factors of Phyllostachys bambusoides Sieb. et Zucc. growing at Damyang gun, Chollanamdo, using multivariate analysis. 1. By synthetical characteristics in canonical correlation between height-growth factor group and diameter-growth factor group, the former was determined by the culm height ($x_1$), and the latter by the. diameter of the largest internode($x_7$). And for those between quantitative growth factor group and qualitative growth factor group, the former was determined by the surface area($x_{10}$), and the latter by the diameter of the largest internode ($x_7$). 2. The ten growth factors of bamboo culm were simplified by two principal components on the basis of accumulated proportion aimed at 90%. The first principal component($Z_1$) as a "size factor" showed high correlation with growth factors except eye-height diameter($x_5$). The second principal component($Z_2$) as a "shape factor" showed high correlation only with $x_5$. 3. The bamboo culm, and the latent phenomenon between their growth factors could be determined by two common factors showing high communality(94.16%). The ten growth factors can be grouped into two attribute factors: quantity and quality. 4. The bamboo culms can be classified into five types: total, volume, shape-quality, inferior and middle.

• Journal of Korean Society of Forest Science
• /
• v.25 no.1
• /
• pp.49-71
• /
• 1975

The importance of bamboo as raw material for bamboo wares and several kinds of industrial products is highly appreciated at home and abroad. But different kinds of bamboo-bundle systems have been traditionally used in the local areas. There being no reasonable bamboo-bundle system, we have a lot of difficulty in trading bamboo products and executing adrinistmative works. Therefore, a reasonable bamboo-bundle system based on scientific proofs needs to be tested and established for fair trade and administration. This study is carried out to solve the above difficulty with statistical investigation and analysis. The results obtained are as follows. 1. The larger the circles at eye-height become, the more the possibility of the largest internode covering the span between eye-height and 1/4 height increases. 2. The longest internodes are distributed according to a rule without relation to circles at eye-height. 3. The tapering grade of bamboo culms is very high and its form is almost the same without relation to its size. (Form exponent; 0.71-1.05, eye-height form factor; 0.60-0.66, 1/4 becomes, seeing that the circle grade and the percentage of actual volume height form factor; 0.61-0.69). 4. The larger the circles at eye-height are, the lower the percentage of actual volume have negative curve relation to each other. 5. It is considered that the numbers of bamboos bundled in a "Sok" is not decided according to the usefulness of bamboos, judging from the fact that the outputs of bamboo wares per "Sok" in every circle grade are not the same. 6. As the results of the regression analysis, the empirical formulae of several amounts to circles at eye-height and culm length are as follows; Volume, $${\hat{y}}_i=\bar{3}.821874+2.013181log\;C_i+0.839128log\;H_i$$ $$V=0.0066355\;C^{2.013181}\;H^{0.839128}$$ Actual volume, $${\hat{y}}_{ai}=3.915338+0.776549log\;C_i+1.857000log\;H_i$$ $$V_a=0.0082288\;C^{0.776549}\;H^{1.857000}$$ Weight, $$w_i=3.869148+1.936410log\;C_i+0.566904log\;H_i$$ $$W=0.0073986\;G^{1.936410}\;H^{0.565904}$$ 7. Korean Phyllostachys bambusoides Sieb. et Zucc. is almost the same as that of Japan in several amounts, just the same especially in the weight. 8. It is found that the bamboo-bundle systems of Korea and Japan have much closer relation to the weight than other amounts. So It is, therefore, considered that the weight is important factor in deciding bamboo-bundle system. 9. According to the item 8, I should like to propose the appropriate numbers per "Sok" adjusted on the basis of the weight in the Table 18.

• Journal of Korean Society of Forest Science
• /
• v.56 no.1
• /
• pp.51-65
• /
• 1982

The growth characteristics and appropriate fertilizer-managements in the rejuvenating bamboo grove were studied with Phyllostachys reticulata. The bamboo soil was the sandy loam with rich humus. In the fertilized plots, the N-fertilizer was significantly absorbed, and it was necessary to fertilize the K-fertilizer continuously. According to the development of rejuvenating after flowering, the temperature and relative illumination became lower. while the moisture became higher. The relationship between the diameter at eye height (D) and the culm length (H) of each bamboo can be expressed as follow; $H=2.5538D^{0.5031}$ The leaf area is the major factor for the production of the bamboo grove. Therefore in the rejuvenating grove, we should refrain form pruning or felling of not -flowering bamboo. The theoretical distribution of the internodal length was obtained by the distribution curve line of the internodal length derived from the regular distribution curve line. Relatively long and even internodal length was found in the fertilized plots 2 and 4. The relation between $D^2H$ and dry weight of culm or dry weight of the above ground part were given by linear regression in both relations respectively on the logarithmic coordinates, but the propertional relation was not established in these relations. The biomass of the above ground part obtained by the allometry method showed high values in the fertilized plots 2.5 and 6. The appropriate amounts of the three elements, N, P and K for the maximum dry matter were 24.19, 15.51, 8.63 kg/10a, respectively.

• Journal of Korean Society of Forest Science
• /
• v.85 no.3
• /
• pp.453-461
• /
• 1996

Three Phyllostachys stands of P. pubescens, P. bambusoides and P. nigra var, henonis in Sunchon were studied to investigate biomass, net production and nutrient distribution. Five $10m{\times}10m$ quadrats were set up and 20 sample culms of 2 years and over were harvested for dimension analysis in each stand. One year old culms and subterranean parts were estimated by the harvested quadrat method. The largest mean DBH, height and basal area were shown in P. pubescens stand, and followed by P. nigra var. henonis stand and P. bambusoides stand. There was little difference in accuracy among three allometric biomass regression models of logWt=A+B1ogD, $logWt=A+BlogD^2H$ and logWt=A+BlogD+ClogH, where Wt, D and H were dry weight, DBH and height, respectively. Analysis of covariance showed that there were significant differences in intercept among the linear allometric biomass regressons of three Phyllostachys species. Biomass included subterranean parts was the largest in P. pubescens stand(103.621t/ha), and followed by P. nigra var. henonis stand(86.447t/ha) and P. bambusoides stand(36.767t/ha). Leaf biomass was 6.3% to 7.8% of total biomass in each stands. The ratio of aboveground biomass and subterranean biomass in each stand was 1.87 to 2.26. Net production included subterranean parts was the greatest in P. pubescens stand(6.115t/ha/yr), and followed by P. nigra var. henonis stand(5.609t/ha/yr) and P, bambusoides stand(3.252t/ha/yr). The highest net assimilation ratio was estimated in P. pubescens stand(2.979), and followed by P. nigra var. henonis stand(2.752) and P. bambusoides stand(2.187). Biomass accumulation ratio of each stand was 2.679 to 5.358. Concentrations of N, P and Mg were the highest in leaves, and followed by subterranean parts, and culms+branches in all three species. Concentration of Ca was the highest in leaves, and followed by culms+branches, and subterranean parts in all three species. The difference in biomass among three species stands was caused by their culm size, leaf biomass, net assimilation ratio, and efficiency of leaves to produce culms.