• Korean Chemical Engineering Research
• /
• v.48 no.2
• /
• pp.253-258
• /
• 2010

In the field of the $CO_2$ absorption process using aqueous ammonia, the effects of regeneration pressure and temperature on $CO_2$ absorption performances of the aqueous ammonia were investigated. The absorbents were prepared by dissolving ammonium carbonate solid in water to grant the resulted solution 0.5 $CO_2$ loading ($mol\;CO_2/mol\;NH_3$) and various ammonia concentration (14, 20, 26 and 32 wt%). As-prepared absorbents were regenerated at high pressure and temperature (over $120^{\circ}C$ and 6 bar) before the absorption test. The absorption test was carried out by injecting the simulated gas that contains 12 vol% of $CO_2$ into a bubbling reactor. The introduction of 26 wt% of the ammonia concentration for $CO_2$ absorption test resulted in the higher absorption capacities than other experimental conditions. In particular, when the absorbents with 26 wt% of the ammonia were regenerated at $150^{\circ}C$ and 14 bar, the highest absorption capacity, $45ml\;CO_2/g$, was obtained. According to the analysis of absorbents using acid-base titration, the ammonia loss during the regeneration of the absorbents with a fixed ammonia concentration decreased as the regeneration pressure increased, while it increased as the regeneration temperature increased. In the condition of fixed regeneration pressure and temperature, as expected, the ammonia loss increased as the ammonia concentration increased. The measured $CO_2$ loadings and ammonia concentrations of absorbents were compared to the values calculated by Electrolyte NRTL model in Aspen Plus.

• Resources Recycling
• /
• v.12 no.3
• /
• pp.31-37
• /
• 2003

A study on the characteristics of ammonia desorption from aqueous solutions has been performed by air stripping as the first stage of ammonia recycling for the preparation of ammonium sulfate from it. For air stripping experiments, a stripping column made with acrylic tube of 40 mm diameter was employed and compressed air was injected into solutions through air sparger equipped at the bottom of stripping column. As a result of experiments, the stripping efficiency was increased with the aqueous pH and it was found that the appropriate pH for air stripping of ammonia was between pH 10 and 12. As far as the effect of air flow rate on ammonia stripping was concerned, ammonia stripping was not proportional to the air flow rate although it was affected by the air flow rate to some extent. Moreover, when more than 20 cm of water height was maintained, total ammonia desorbed from solution was not varied with the water height. Stripping temperature was also found to play an important role in ammonia desorption and about 90fo of initial ammonia was desorbed in 14 hours at pH 12.8 and at $60^{\circ}C$ Finally, it was believed that stripping temperature as well as the aqueous pH was one of the most important factors in air stripping of ammonia.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.418-421
• /
• 2009

Effects of aqueous ammonia soaking to three annual plants (hemp woody core, tobacco stalk and corn stover) awere investigated to focus on the enzymatic saccharification characteristics change by this treatment. At two different levels of treatment ($90^{\circ}C$-16 h and $45^{\circ}C$-6 days), higher temperature treatment led to more enzymatic saccharification of cellulose to glucose by commercial cellulase mixtures (Celluclast 1.5L and Novozym 342 from Novozyme Korea). Difference among annual plants were significant. corn stover was the best response to enzymatic saccharification of cellulose and xylan by comercial enzymes all treatment conditions but tobacco stalk was the worst response to all of them. chemical composition or physical structure difference may brought this difference.

• Korean Journal of Materials Research
• /
• v.10 no.6
• /
• pp.445-449
• /
• 2000

Nickel ferrite $(Ni_{0.75}Fe_{2.25}O_4$ was synthesized by co-precipitation method in order to investigate its behavior under conditions of the reactor coolant system in pressurized light water nuclear power plants. Ammonia or potassium carbonate was used as a solution pH control agent, and aqueous ammonia or potassium carbonate solution or secondary distilled water was used as a co-precipitate washing agent. The effects of the pH control agent and the co-precipitate washing agent on the production yield on the basis of the Ni/Fe molar ratio and the particle characteristics of final products were investigated by XRD, SEM, EDX and XPS. The production yield was almost congruent with that of the initial aqueous mixture in case of using potassium carbonate as a pH control agent, while in case of using ammonia, it was quite changed. The difference seemed to be due to the effects of $Ni^{2+}{\leftarrow}NH_3$complexation in the aqueous solution and of the pH of co-precipitate washing agent.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.5
• /
• pp.451-457
• /
• 2000

Experimental investigations on the effect of two kinds of additives ; aqueous NaOH solution and ammonia(NH$_3$) for removal of NOx and SO$_2$ simultaneously by corona discharge were carried out. The simulated combustion flue gas was[NO(0.02[%])-SO$_2$(0.08[%])-$CO_2$-Air-$N_2$] Volume percentage of aqueous NaOH solution used was 20[%] and $N_2$flow rate was 2.5[$\ell$/min] for bubbling aqueous NaOH solution Ammonia gas(14.81[%]) balanced by argon was diluted by air. NH$_3$ molecular ratios(MR) based on [NH$_3$] and [NO+SO$_2$] were 1, 1.5 and 2.5 The vapour of aqueous NaOH solution and NH$_3$was introduced to the main simulated combustion flue gas duct through injection systems which were located at downstream of corona discharge reactor. NOx(NO+NO$_2$) removal rate by injecting the vapour of aqueous NaOH solution was much better than that by injecting NH$_3$however SO$_2$removal rate by injecting NH$_3$was much better than that by injecting the vapour of aqueous NaOH SO$_2$removal rate slightly increased with increasing applied voltage. When the vapour of aqueous NaOH solution and NH$_3$were simultaneously injection NOx and SO$_2$ removal rate were significantly increased.

• Resources Recycling
• /
• v.11 no.3
• /
• pp.3-9
• /
• 2002

Relnoval of ammonia from aqueous solutions has been studied with zeolite and bentonite minerals. Zeolite and bentonite powder were supplied by a domestic company and used as delivered without further purification. The aqueous pH was found to increase by addition of zeolite or bentonite up to pH 8.5 from initial pH of 5.5∼5.7. From the C.E.C. measurement by ammonium acetate leaching method, the values of C.E.C. of zeolite and bentonite sample were observed to be 129.7 meq/100 gr and 65.1 meq/100 gr, respectively and Na+ ion accounted for the major part of total C.E.C. in both cases. In the removal of ammonia with zeolite and bentonite, physical adsorption of ammonium ion onto minerals was believed to contribute to the removal of it as well as the intrinsic cation exchange reaction. Finally, zeolite was found to be superior to bentonite in the removal of ammonia from aqueous solutions.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.253-253
• /
• 2010

Rice straw was pretreated with aqueous ammonia in order to enhance enzyme digestibility. Soaking in ammonia aqueous (SAA) was conducted with 15% ammonia, at $60^{\circ}C$. for 24 h. Optimization of both saccharification conditions and enzyme loading of SAA rice straw was carried out. Especially enzyme loading test was performed using statistical method. Moreover proton beam irradiation (PBI) was also performed to overcome the problem which inhibit the enzyme digestibility at 1-25 kGy doses with 45 MeV of beam energy. Optimal condition for enzymatic saccharification was follows; pH 4.8, $50^{\circ}C$, 60 FPU of enzyme activity, 1:4 ratio of celluase and ${\beta}$-glucosidase. Also, optimal doses of PBI on rice straw and SAA-treated rice straw for efficient sugar recovery were found to be 3 kGy, respectively. When saccharification was performed with optimal condition, glucose conversion yield was 89% of theocratical maximum in 48 h, and 3 kGy of PBI was applied to SAA-treated rice straw, approximately 90% of the theoretical glucose yield was obtained in 12 h. The results of X-ray diffractometry (XRD) support the effect of both SAA and PBI on sugar recovery, and scanning electron microscopy (SEM) images unveiled the physical change of the rice straw surface since rugged rice straw surface was observed.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.12
• /
• pp.4191-4194
• /
• 2011

Sodium periodate ($NaIO_4$) and potassium iodide (KI) in aqueous ammonia has been used for the one-pot synthesis of nitriles from the corresponding aldehydes and alcohols in moderate to good yield. This transformation, proceeds via an in situ oxidation- imination-aldimine oxidation sequence.

• Journal of Environmental Health Sciences
• /
• v.27 no.1
• /
• pp.1-7
• /
• 2001

Ammonia is used in the manufacture of fertilizers, refrigerants, stabilizers and many household cleaning agents. These wide applications resulted in ammonia contamination in water. Ammonia can be removed from water by physical, biological, and chemical methods. Ozonation is effictive in the treatment of water with low concentration of ammonia. This study is undertaken to provide kinetic data for the ozonation of ammonia with or without hydrogen peroxide. The results were as follows; The destruction rate of ammonia increased gradually with the influent hydrogen peroxide concentration up to 0.23 mM and inhibited in the range of 0.23~11.4mM, and the maximum removal rate of ammonia achieved at 0.23mM of hydrogen peroxide, and the overall kinetics was first order. The combination effect of hydrogen and ozone to oxide ammonia in aqueous solution was better than ozone alone. The reacted ammonia was converted completely to nitrate ion.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.41 no.5
• /
• pp.15-19
• /
• 2009

Ammonia soaking treatment was introduced for hemp woody core pretreatment to increase enzymatic saccharification of polysaccharides. Portions of the xylan, cellulose, and lignin were removed by aqueous ammonia soaking, which improved the enzymatic saccharification of cellulose and xylan. Following ammonia soaking, 37% ($50^{\circ}C$-6 day treatment) to 61% ($90^{\circ}C$-16 h treatment) of the cellulose was converted to glucose and 33% ($50^{\circ}C$-6 day treatment) to 48% ($90^{\circ}C$-16 h treatment) of the xylan to xylose. Cellulose responded better to enzymatic saccharification than did xylan after the ammonia soaking treatment. Aqueous ammonia soaking pretreatment was more effective than electron beam irradiation for increasing enzymatic saccharification of xylan and cellulose in hemp woody core.