• Transactions of the Society of Information Storage Systems
• /
• v.3 no.3
• /
• pp.118-122
• /
• 2007

Phase-change wet-etching technology using GeSbTe phase-change films is developed. Selective etching between an amorphous and a crystalline phase can be carried out with an alkaline etchant of NaOH. Etching selectivity is dependent not only on the concentration of the alkaline etchant but also on the film structure. Specifically, metal films for heat control cause marked effects on the etching properties of GeSbTe film. Surviving amorphous pits can be obtained with Al metal layer, however etched amorphous pits are seen with Ag metal layer. An opposite selective etching behavior can be observed between samples with two different metal layers.

• Transactions of the Society of Information Storage Systems
• /
• v.2 no.3
• /
• pp.196-200
• /
• 2006

We are developing a phase change etching technology using an inorganic photoresist of GeSbTe film which is the recording material of the phase change disc. A selective etching phenomenon between amorphous and crystalline states can be utilized with an alkaline etchant. Phase-change pits could be formed using this technique, in which the etching selectivity is strongly dependent on the concentration of the etchant. The degree of etching was investigated by the transmittance between crystalline and amorphous films after the wet-etching. The pits patterned on the disc could be observed by AFM after wet-etching.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1997.04a
• /
• pp.23-26
• /
• 1997

This work presents the TMAH/IPA anisotropic etching characteristics with addition of Pyrazine. (100) Si etching rate of 0.747 ${\mu}{\textrm}{m}$/min at 8$0^{\circ}C$ was obtained using TMAH 25 wt.% / IPA 17 vol.% / pyrazine 0.1 g. The etching rate of (100) Si is increased about 52% compare to pure TMAH 25 wt.%. But etching rate of (100) Si is decreased with increasing Pyrazine additive. Activation energy of TMAH/IPA/pyrazine is much lower than TMAH and TMAH/IPA solutions. Addition of Pyrazine does not effect on surface flatness and decreases undercutting ratio about 20 %. Therefore, TMAH/IPA/pyrazine is an attractive anisotropic etchant because of alkaline-ion free.

• Clean Technology
• /
• v.2 no.1
• /
• pp.47-52
• /
• 1996

The solvent extraction method was applied on a spent solution containing copper, which was produced in a printed circuit board process, to recover copper and to reuse the etching solution. Lix 64 N ($\alpha$-Hydroxyoxime + $\beta$-Hydroxybenzophenone Oxime) was used as a solvent. The acidic spent copper solution was mixed with and alkaline copper solution to pH=2. The solvent including 30 volume% of Lix 64 N extracted 17.1gr/l of copper from the mixed spent copper solution. In the continuous bench scale experiment, 4 stages for extraction, 2 stages for stripping and 4 stages for washing were used. Recovered copper was recycled as copper sulfate and the raffinate was reused as copper etchant. The percentage of copper recovery and the purity of copper sulfate were higher than 99.9%, respectively.