• Applied Chemistry for Engineering
• /
• v.5 no.2
• /
• pp.285-294
• /
• 1994

Some supported gold catalysts were prepared by impregnation and coprecipitation methods. Effect of gold addition and active sloe formation were studied by investigating particle sizes of gold, amounts of oxygen adsorbed, adsorption properties of CO and NO, and reduction and oxidation properties, etc.. The gold particles of the catalyst by impregnation were irregular and very large as 30~100 nm, but those by coprecipitation were uniform and ultra-fine as about 4 nm. On $Au/Al_2O_3$ catalyst, the addition of gold to inactive $Al_2O_3$ caused the decomposition of $N_2O$, and CO was not irreversibly adsorbed while $O_2$ was atomically and irreversibly adsorbed. The adsorption sites of oxygen were attributed to the active sites which were restricted to the circumference of hemispherical gold particle-support interface rather than all atoms on the surface of gold particle. Also, CO was reversibly and irreversibly adsorbed on $Al_2O_3$ at low temperature, and the addition of gold weakened both reversible and irreversible adsorptions. The affinity for CO on $Au/Co_3O_4$ catalyst decreased conspicuously compared to $Co_3O_4$. The effect of gold addition did not appear in reduction step but did remarkably in reoxidation step; the added gold promoted the reoxidation of the reduced cobalt atoms.

• Journal of Environmental Science International
• /
• v.19 no.2
• /
• pp.247-254
• /
• 2010

Ultrasound and Surfactant aided soil washing process has been shown to be an effective method to remove diesel from soils. The use of surfactants can improve the mobility of diesel in soil-water systems by increasing solubility of adsorbed diesel into surfactant micelles. However, a large amount of surfactant is required for treatment. In addition, synthetic surfactants, specially anionic, are more toxic and the surfactant wastewater is hard to treat by conventional wastewater treatments even by AOPs. Ultrasound improves desorption of the diesel adsorbed on to soil. The mechanisms are based on physical breakage of bonds by hot spot, directly impact onto soil particle surface, the fragmentation of long-chain hydrocarbons by micro-jet and microstreaming in the soil pores. The use of ultrasound as an enhancement method in both anionic and nonionic surfactant aided soil-washing processes were studied. And all experiments were examined proceeded under CMC surfactant concentration, frequency 35 khz, power 400 W, Soil-water ratio 1:3(wt%), particle size 0.24 ~ 2mm and initial diesel concentration. 20,000 mg/kg. Combination with ultrasound showed significant enhancements on all the processes. Especially, nonionic surfactant Triton-X100 with ultrasound showed remarkable enhancements and diesel removal rate enhanced by ultrasound helps desorpting of surfactant adsorbed onto soils which prevented decreasing surfactant activity.

• Korean Journal of Environmental Agriculture
• /
• v.6 no.2
• /
• pp.46-52
• /
• 1987

This study of adsorption and column percolation was conducted to examine the utilization of natural zeolite for the removal of heavy metals from waste water to compare with that of absorption activated carbon. The adsorption of heavy metals by natural zeolite was conformed to the Freundlich isotherm (1/n values: $0.12{\sim}0.45$, K values: $18.77{\sim}59.48$) and natural zeolite was turned out to be an effective adsorbent of heavy metals. At the same particle size and percolation velocity, zeolite adsorbed a greater amount of heavy metals was adsorbed on natural zeolite than activated carbon. The smaller the particle size, the more heavy metals that were adsorbed. It was postulated that the most effective size as an adsorbent of heavy metals from waste water ranged from 0.5 to 2.0mm. The slower the percolation velocity that of the heavy metal solution in column, the more heavy metals were adsorbed. Natural zeolite in a single solution adsorbed more heavy metals than that in mixed solution, and the order of the adsorption amount on natural zeolite was Cu>Zn>Cd.

• Journal of the Korean Society of Safety
• /
• v.27 no.6
• /
• pp.59-63
• /
• 2012

The use of dry chemical powder has been increased as it can be stored for a long period and sustain in stable condition compared to gas or liquid phase extinguishing agents. A new type of dry chemical powder using Zeolite was produced in the research. Chemical powder was adsorbed into Zeolite 13X, a porous material appearing negative catalytic effect, to create extinguishing powder obtaining core shell structure and measured physical properties and run a small scale fire extinguishment. SEM, XRD, TA analysis was also executed, and extinguishing characteristics were measured by fire extinguishing experiment on oil pool fire. The experiment showed that the average particle size of Zeolite 13X was equivalent, indicating about $3{\pm}1{\mu}m$ and thermal analysis result illustrated that Zeolite 13X showed exothermic reaction peaks at $900^{\circ}C$ due to solid-state transformation. Extinguishing characteristics on oil fire of $NaHCO_3$/Zeolite 13X and $NH_4H_2PO_4$/Zeolite were improved, influenced by adsorbed extinguishing powders on Zeolite 13X and Zeolite 13X that contains high phase transition temperature.

• Fashion & Textile Research Journal
• /
• v.6 no.6
• /
• pp.803-809
• /
• 2004

In order to activate the characteristics of charcoal in fiber systems, this was carried out to experiment with the particle size from two micrometers to ten micrometers of charcoal powders on cotton fabrics. The results obtained were as follows; The fabrics were dyed with gray colors by charcoal. The K/S values, that were indicative of the dye affinity, became higher as the increase of dyeing temperature, dyeing time, and dyeing concentration. Also it was confirmed the morphology of the fiber surfaces adsorbed with the particle size from two micrometers to four micrometers of charcoal powder by scanning electronmicronscope. The cotton fabrics dyed by charcoals generally recorded 3-4 degree of wash fastness, 4-5 degree of dry-cleaning fastness, 4-5 degree acidic and alkaline perspirations and water fastness. In connection with the functional properties, cotton fabrics dyed with charcoal appeared that antibacterial, deodorization, far infrared emissivity were improved. Especially the deodorization was improved greatly by using charcoal.

• Journal of the Korean Ceramic Society
• /
• v.27 no.1
• /
• pp.13-22
• /
• 1990

The magnetite ferrofluids of which solvents are water or kerosene have been prepared by making surfactant absorbed on the surface of the magnetite which have been synthesized by air oxidation of Fe(OH)2 at pH 11 and 75$^{\circ}C$, and their basic properties have been measured by XRD, SEM, DTA, TG, viscometer, magnetometer and B-H tracer. The results are as follows ; 1) The shape of magnetite prepared by air oxidation is found to be sphere-like shape and its particle size is smaller than 200A. 2) The maximum amount of sodium oleate adsorbed on the surface of magnetite is about 20% in the weight of the magnetite including the adsorbed sodium oleate. And when magnetite is well dispersed into solvent, R(the weight ratio of the added sodium oleate to Fe3O4) is 0.40-0.48. 3) The dispersion ratio, the viscosity and the magnetization of magnetite ferrofluid are constant regardless of the added amount of sodium oleate above R=0.40-0.48. 4) The magnetic hysteresis curves of magnetite ferrofluid show superparamagnetism-like behavior.

• Progress in Superconductivity and Cryogenics
• /
• v.18 no.1
• /
• pp.10-13
• /
• 2016

In this study, we developed a new volume reduction technique for cesium contaminated soil by magnetic separation. Cs in soil is mainly adsorbed on clay which is the smallest particle constituent in the soil, especially on paramagnetic 2:1 type clay minerals which strongly adsorb and fix Cs. Thus selective separation of 2:1 type clay with a superconducting magnet could enable to reduce the volume of Cs contaminated soil. The 2:1 type clay particles exist in various particle sizes in the soil, which leads that magnetic force and Cs adsorption quantity depend on their particle size. Accordingly, we examined magnetic separation conditions for efficient separation of 2:1 type clay considering their particle size distribution. First, the separation rate of 2:1 type clay for each particle size was calculated by particle trajectory simulation, because magnetic separation rate largely depends on the objective size. According to the calculation, 73 and 89 % of 2:1 type clay could be separated at 2 and 7 T, respectively. Moreover we calculated dose reduction rate on the basis of the result of particle trajectory simulation. It was indicated that 17 and 51 % of dose reduction would be possible at 2 and 7 T, respectively. The difference of dose reduction rate at 2 T and 7 T was found to be separated a fine particle. It was shown that magnetic separation considering particle size distribution would contribute to the volume reduction of contaminated soil.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.1
• /
• pp.84-91
• /
• 2010

The centrifugal oil purifier is used in ships for purifying the engine lubrication oil. The momentum needed for the rotation of the cylindrical chamber is obtained by jet injections. The dust particles in the oil are separated by the centrifugal forces moving to the inner wall of the rotating cylindrical chamber body. The dust particles are eliminated when the particles are adsorbed onto the surface of the inner wall of the chamber body. The flow characteristics and the physical behaviours of particles in this centrifugal oil purifier have been investigated numerically and the filtration efficiencies have been evaluated. For the calculations, a commercial code has been used and the SST k-${\omega}$ turbulence model has been adopted. The MRF (Multiple Reference Frame) method has been introduced to consider the rotating effect of the flows. Under various variables, such as particle size, particle density and rotating speed, the filtration efficiencies have been evaluated. It has been verified that the filtration efficiency is increased with the increments of the particle size, the particle density and the rotating speed of the cylindrical chamber.

• Environmental Analysis Health and Toxicology
• /
• v.28
• /
• pp.6.1-6.7
• /
• 2013

Objectives In this study, we investigated the influence of ionic strength and natural organic matter (NOM) on aggregation and soil adsorption of citrate-coated silver nanoparticles (AgNPs). Methods Time-resolved dynamic light scattering measurements and batch adsorption experiments were used to study their aggregation and soil adsorption behaviors, respectively. Results The aggregation rate of AgNPs increased with increasing ionic strength and decreasing NOM concentration. At higher ionic strength, the AgNPs were unstable, and thus tended to be adsorbed to the soil, while increased NOM concentration hindered soil adsorption. To understand the varying behaviors of AgNPs depending on the environmental factors, particle zeta potentials were also measured as a function of ionic strength and NOM concentration. The magnitude of particle zeta potential became more negative with decreasing ionic strength and increasing NOM concentration. These results imply that the aggregation and soil adsorption behavior of AgNPs were mainly controlled by electrical double-layer repulsion consistent with the Derjaguin-Landau-Verwey-Overbeek theory. Conclusions This study found that the aggregation and soil adsorption behavior of AgNPs are closely associated with environmental factors such as ionic strength and NOM and suggested that assessing the environmental fate and transport of nanoparticles requires a thorough understanding of particle-particle interaction mechanisms.

• Membrane Journal
• /
• v.6 no.2
• /
• pp.109-116
• /
• 1996

This work is a fundamental study for applying hybrid process coupling adsorption with microfiltration to waste-water treatment. Phenol was separated by adsorption on powdered activated carbon, adsorbed phenol with activated carbon was separated by microfiltration. As the particle size in suspension increased, filtration resistance decreased, and effect of particle concentration on resistance was less pronounced. The rate of uptake was greatly dependent on the degree of phenol loading. For a smaller amounts of activated carbon, the change of permeate concentration before break point and phenol loading with time were steeper than in the case of large amounts. Permeate concentration before break point decreased with decreasing particle size, this could be due to the increase of outer surface of particle and film mass transfer coefficient.