• 분석과학
• /
• 제7권1호
• /
• pp.1-10
• /
• 1994

형광체의 원료로 사용되고 있는 희토 산화물 중 불순물로 존재하는 희토류 원소를 분석하기 위하여 검출한계, 재현성, matrix effect, linear dynamic range 및 yttrium과 europium의 memory effect를 조사하였다. 유도결합 플라즈마 질량분석법(ICP-MS)에 의해 thulium의 정량분석시 europium이 존재함으로써 플라즈마 내에 polyatomic ion인 $EuO^+$이 형성되고, 이로 인해 thulium에 영향을 끼침을 확인할 수 있었다. Europium의 농도에 따른 thulium의 세기가 직선적으로 변화함을 이용하여 thulium의 실제 농도를 결정할 수 있었다.

• 한국세라믹학회지
• /
• 제53권6호
• /
• pp.635-640
• /
• 2016

Electrical behavior of AlN ceramics sintered with $Y_2O_3$ as a sintering aid has been investigated with respect to additional $TiO_2$ dopant. From the impedance spectroscopy, it was found that the grain and grain boundary conductivities have greatly decreased with addition of $TiO_2$ dopant. The $TiO_2$ dopant also increased the activation energy of the grain conductivity by about 0.37 eV; this increase was attributed to the formation of an associate between Al vacancies and Ti ions at the Al sites. Similarly, the electronic conductivity was reduced by $TiO_2$ addition. However, $TiO_2$ solubility in AlN grains was below the detection limit of typical EDX analysis. Grain boundary was clean, without liquid films, but did show yttrium segregation. The transference number of ions was close to 1, showing that AlN is a predominantly ionic conductor. Based on the observed results, the implications of using AlN applications as insulators have been discussed.

• 한국전기전자재료학회논문지
• /
• 제19권5호
• /
• pp.457-460
• /
• 2006

Y doped zinc oxide (YZO) thin films were deposited on F doped $SnO_2$ (FTO) glass substrate by sol-gel method using the spin-coating system. A homogeneous and stable solution was prepared by dissolving acetate in the solution added diethanolamine as sol-gel stabilizer. YZO films were obtained after preheated on the hot-plate for 5minute before each coating; the number of coating was 3 times. After the coating of last step, annealing of YZO films performed at $450^{\circ}C$ for 30 minute. In order to confirming of a ultraviolet ray interruption and down-conversion effects, optical properties of YZO films, transmission spectrum and fluorescent spectrum were used. Also, for understanding the obtained results by experiment, the elestronic state of YZO was calculated using the density functional theory The results obtained by experiment were compared with calculated structure. The detail of electronic structure was obtained by the discrete variational Xa (DV-Xa) method, which is a sort of molecular orbital full potential method. The density of state and energy levels of dopant element were shown and discussed in association with optical properties.

• 한국재료학회지
• /
• 제31권6호
• /
• pp.339-344
• /
• 2021

Composite materials offer distinct and unique properties that are not naturally inherited in the individual materials that make them. One of the most attractive composites to manufacture is the aluminum alloy matrix composite, because it usually combines easiness of availability, light weight, strength, and other favorable properties. In the current work, Powder Metallurgy Method (PMM) is used to prepare Al2024 matrix composites reinforced with different mixing ratios of yttrium oxide (Y₂O₃) particles. The tests performed on the composites include physical, mechanical, and tribological, as well as microstructure analysis via optical microscope. The results show that the experimental density slightly decreases while the porosity increases when the reinforcement ratio increases within the selected range of 0 ~ 20 wt%. Besides this, the yield strength, tensile strength, and Vickers hardness increase up to a 10 wt% Y₂O₃ ratio, after which they decline. Moreover, the wear results show that the composite follows the same paradigm for strength and hardness. It is concluded that this composite is ideal for application when higher strength is required from aluminum composites, as well as lighter weight up to certain values of Y₂O₃ ratio.

• Bulletin of the Korean Chemical Society
• /
• 제34권1호
• /
• pp.99-106
• /
• 2013

Polyaniline-yttrium trioxide (PAni-$Y_2O_3$) composites were synthesized by the in-situ polymerization of aniline in the presence of $Y_2O_3$ The composite formation and structural changes in these composites were investigated by X-ray diffraction (XRD), Fourier transform infra red spectroscopy (FTIR), scanning electron microscopy (SEM) and high resolution transmission electron microscopy (HRTEM). The direct current (DC) electrical conductivity of the order of $0.51{\times}10^{-2}\;S\;cm^{-1}-0.283\;S\;cm^{-1}$ in the temperature range 300 K-473 K indicates semiconducting behavior of the composites. Room temperature AC conductivity and dielectric response of the composites were studied in the frequency range of 10 Hz to 1 MHz. The variation of AC conductivity with frequency obeyed the power law, which decreased with increasing weight percentage (wt %) of $Y_2O_3$. Studies on dielectric properties shows the relaxation contribution coupled by electrode polarization effect. The dielectric constant and dielectric loss in these composites depend on the content of $Y_2O_3$ with a percolation threshold at 20 wt % of $Y_2O_3$ in PAni. Electromagnetic interference shielding effectiveness (EMI SE) of the composites in the frequency range 100 Hz to 2 GHz was in the practically useful range of -12.2 dB to -17.2 dB. The observed electrical and shielding properties were attributed to the interaction of $Y_2O_3$ particles with the PAni molecular chains.

• 대한화학회지
• /
• 제28권4호
• /
• pp.231-237
• /
• 1984

$YO_{1.5+x}$와 $HoO_{1.5+x}$로 표시되는 산화이트륨과 산화홀뮴의 비화학양론적 조성식의 x-값을 700$^{\circ}$C에서 1000$^{\circ}$C까지의 온도영역과 대기압에서 $1{\times}10^{-6}$기압 산소압력까지의 구간에서 중량 분석법에 의하여 측정하였다. 측정된 x-값은 온도가 상승하면 증가하고 산소압력이 증가하면 또한 증가하였다. 비화학양론적 조성의 생성엔탈피 $({\Delta}H_f)$는 산소압력이 감소하면 감소하였고 그 값이 양의 값을 갖는 것으로 과잉산소의 형성 과정이 흡열과정임을 알 수 있다. 산소압력 의존성 1/n-값은 온도가 상승하면 상승하고 양의 값을 갖는 것으로 높은 온도일수록 산소압력 의존성이 커짐을 보여 주었다. 그리고 x-값과 열역학적 자료로 부터 비화학양론적 결합과 전도성메카니즘을 규명하였다.

• 한국응용과학기술학회지
• /
• 제17권2호
• /
• pp.144-148
• /
• 2000

A modification of the sol-gel method to obtain phase pure superconducting oxides is described. The method starts from organic salts of yttrium, barium and copper, such as acetates, and avoids the sudden and uncontrollable decomposition of the organic fraction which occurs if nitrates are used as starting materials. The aqueous solution obtained with citric acid in an alkaline medium is concentrated under vacuum. The solid so prepared is decomposed at about $300^{\circ}C$ thus giving an oxide precursor containing well dispersed yttrium, barium and copper. Pyrolysis at 850 - $920^{\circ}C$ followed by oxygen annealing gives the superconducting orthorhombic 123 phase. The results of TGA/DTA of the precursor, as well as XRD, electrical and magnetic property measurements on the pyrolysis products are presented and discussed.

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2004년도 International Symposium on Powder Materials and Processing
• /
• pp.15-16
• /
• 2004

• 한국분말야금학회:학술대회논문집
• /
• 한국분말야금학회 2006년도 Extended Abstracts of 2006 POWDER METALLURGY World Congress Part2
• /
• pp.939-939
• /
• 2006

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 2000년도 International Symposium on Magnetics The 2000 Fall Conference
• /
• pp.423-424
• /
• 2000