• Journal of the Korean Wood Science and Technology
• /
• v.20 no.4
• /
• pp.65-72
• /
• 1992

Steam defiberated pulp and steam exploded wood(birch chip) were extracted with solvents (hot-water, 1% NaOH, MeOH, hot water, 1% NaOH). The properties of residual fiber were examined for the utilization as ruminants feed. The digestibility is 38% in steam defiberated pulp(10kg /$cm^2$-15min) and 62-77% in exploded wood(17-18kg/$cm^2$-2~10min), respectively. The more steam pressure and time increase, the more the digestibility increase. The sugars obtained from extractives is amount from 7% to 13% in asplund pulp and from 7% to 10% in exploded pulp. The sugars was mainly composed of 70-80% xylose. The digestibility of residual fiber which is extracted with solvents is low than these of original fibers. Considering the yield and digestibility as ruminant feed, exploded pulp under 17kg /$cm^2$ for 10min has the best efficiency. The exploded wood gives 75.3% on yield(O. D. chip) and 48% on the digestibility.

• Journal of the Korean Wood Science and Technology
• /
• v.50 no.5
• /
• pp.315-324
• /
• 2022

The termicidal activity and chemical components of wood vinegar from two sources of biomass, nipah fruit shells (NFS) and a mixture of shells and fiber (MSF), were evaluated against Coptotermes curvignathus. A no-choice test was carried out to evaluate their termicidal activity using filter paper samples treated with 2.5%, 5.0%, 7.5%, 10.0%, and 12.5% NFS or MSF vinegar. Both wood vinegars exhibited antitermitic activity against C. curvignathus. The results show that increased concentrations of NFS and MSF vinegar significantly increased termite mortality. In particular, the NFS vinegar caused complete mortality and the lowest filter paper mass losses at 2.18% when treated with 12.5% wood vinegar. The most abundant chemical compounds of NFS vinegar were cyclopropanecarbonyl chloride, 2,5-dichlorophenol, 2-propanone, acetic acid, propanoic acid, benzenesulfonic acid, 3,7-dimethyl-6-octenal, and trans-geraniol. Meanwhile, the main compounds in the MSF vinegar were 1,2-ethanediol, formic acid, acetic acid, ethanoic acid, 2-furancarboxaldehyde, phenol, 2-methoxy phenol, and 4-methyl phenol.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.18 no.3
• /
• pp.87-91
• /
• 2010

Wood and non-wood material is widely used as a medium for filtration. It is a relatively low cost material and because of its construction, can be used to filter small particles(${\sim}5{\mu}m$). This fiber filter is concerned with characterizing some of the physical properties of wood & non-wood materials particularly relating to filtration of particles from dilute suspensions. In addition, they are nonuniform and tortuous as a result of the formation and variations in individual fibers.

• Journal of the Korean Wood Science and Technology
• /
• v.48 no.6
• /
• pp.807-819
• /
• 2020

The aim of this study was to investigate the anatomical characteristics of Quercus mongolica infested by oak wilt disease. To analysis the anatomical characteristics of the wood specimens infested by the oak wilt, the anatomical structures of an infected wood, a dead wood, and sound wood were observed at 10-year-old intervals from 10 to 50 annual rings using both an optical and a scanning electron microscope. The fiber length was measured in units of 5 annual rings from the pith, and the diameter of the vessel element and the ratio of the vessel including the tyloses were measured for each 10 annual ring. In the cross section, on the infected and dead wood specimens, mycelium was also observed with the tyloses in the vessel. There was no signification difference between the wood specimens in the fiber length and the vessel diameter of the vessel element. The fiber length was not difference after 20-30 annual rings which is a part of juvenile wood. The average of the vessel ratio including tyloses in the infected wood was the highest. Especially, the ratio of tyloses was the highest 40-50 annual rings in the infected wood and the dead wood. Therefore, the large difference between the infested wood by oak wilt and the sound wood was the ratio of tyloses. This result can be used as a basic data to utilize the infested wood.

• Journal of the Korean Wood Science and Technology
• /
• v.44 no.4
• /
• pp.571-588
• /
• 2016

Eucalyptus pellita F. Muell is one of pulp woods that is being developed through breeding plantation programs in Indonesia. The research aimed at exploring the chemical and morphological characteristics of fiber, and to determine the rank of plus trees from 4 provenances based on the suitability for pulps. The materials included the plus trees of E. pellita (9 years) from the 2nd generation of progeny tests in Pelaihari, South Borneo. Wood properties under investigation included the chemical properties and morphological fiber characteristics (fiber dimensions and its derived properties). In the present study, data were analyzed using descriptive statistic, Analytic Hierarchy Process (AHP) and Pearson's correlation. Results showed that the chemical properties of E. pellita, i.e. the contents of ethanol-toluene extractives, hot water soluble extractives, holocellulose, alphacelullose, and lignin were $3.08{\pm}1.00%$, $1.41{\pm}0.38%$, $75.26{\pm}2.58%$, $49.02{\pm}2.88%$, and $29.49{\pm}1.86%$, respectively. The average values of wood fiber morphology were $1.02{\pm}0.08$ mm (fiber length), $13.25{\pm}1.64{\mu}m$ (fiber diameter), of $6.94{\pm}1.70{\mu}m$ (lumen diameter), $3.15{\pm}0.52{\mu}m$ (fiber wall thickness), $0.97{\pm}0.30$ (Runkel ratio), $0.57{\pm}0.10$ (Luce's shape factor), $78.21{\pm}10.34$ (slenderness ratio) and $130.91{\pm}33.77{\times}10^3{\mu}m^3$ (solids factor). The AHP scoring rank indicated that the best individuals were 28.4.3.28 (Kiriwo Utara), 12.1.5.28 (North Kiriwo), 19.11.5.45 (Serisa Village), 3.8.4.9 (South Kiriwo), and 6.6.3.15 (South Kiriwo). Pearson correlation analysis showed significant correlations between the levels of fiber length with alpha-cellulose content (r = 0.39) as well as the fiber length with ethanol-toluene extractive contents (r = -0.41).

• Journal of the Korean Wood Science and Technology
• /
• v.45 no.4
• /
• pp.463-470
• /
• 2017

The objectives of this study are to obtain the basic knowledge of anatomical characteristics and wood properties of thinning trees of young teak (Tectona grandis L.F.) for fulfill the timber demand in Indonesia. Nine thinning trees of 5-year-old teak clone trees were used for analyzing the cell morphology and air-dry density. Vessel diameters in pore and outer pore zones were 165 and $90{\mu}m$, respectively. Mean value of fiber diameter, cell wall thickness, and fiber length in outer pore zone were $14.6{\mu}m$, $2.07{\mu}m$, and 1.04 mm, respectively. In addition, mean value of air-dry density was $0.55g/cm^3$. The measurement and values of vessel diameter, fiber diameter, cell wall thickness, fiber length and air-dry density in the experimental had lower than those in the older teak. Therefore, it could be suggested that the wood from thinning young teaks was not appropriate as construction material, but it could be used for furniture which do not need high of strength properties. Furthermore, since the measurements values of anatomical characteristics were still increasing from pith to bark, it could be suggested that 5-year-old teak clones are still in a juvenile phase. Positively significant correlations were found between air-dry density and cell wall thickness, indicating that cell wall thickness is strongly correlated with wood density of teak.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.43 no.2
• /
• pp.24-30
• /
• 2011

The accelerated aging characteristics of electroconductive papers manufactured with a mixture of carbon fiber were investigated by heating in dry oven. By accelerated aging time, the tensile strength, tensile stretch of the papers were decreased more slowly with increase of carbon fiber content, but the electrical conductivity was more rapidly decreased in case of high carbon fiber content. The weight loss of papers by thermal analysis were reduced as increasing the carbon fiber content. These results were indicated that the electrical conductivity of carbon fiber was diminished easily by heat aging, but thermal characteristic of carbon fiber was much better than that of wood pulp.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.41 no.3
• /
• pp.29-34
• /
• 2009

Electroconductive papers were manufactured as handsheet by mixing carbon fiber in LBKP and BCTMP. The electrical conductivity of the paper was improved by increasing carbon fiber content and basis weight. The porosity was increased and tensile strength was decreased by the addition of carbon fiber. Electrical conductivity of carbon fiber and BCTMP-based sheet was much better than those of carbon fiber and LBKP-based one. This result indicated that the electrical conductivity of paper can be affected by the kinds of raw material of wood fibers used.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.37 no.2 s.110
• /
• pp.78-86
• /
• 2005

Hwaseonji(Korean traditional paper) used for writing and painting has been made from the mulberry bast-fiber and the short-length fiber pulps, wood pulps. However, besides wood pulps, other short-length fiber pulps also can be used instead of wood pulps. Hence, this research was carried out to make the various Hwaseonjis with the different properties, using the five kinds of short-length fiber pulps respectively. The short-length fiber pulps used in this research were softwood bleached kraft pulp(SwBKP) hardwood bleached kraft pulp(HwBKP), rice-straw bleached sulfite pulp(RsBSP), bamboo bleached kraft pulp(BbBKP) and recycled pulp from vellem paper(RP). And, the mixture ratios of the mulberry bast-fiber pulp and short-length fiber pulps were 100:0, 80:20, 60:40, 40:60 and 20:80. After various Hwaseonjis were made from different mixtures mentioned above with hand-made method, physical properties and chinese ink blot property of each paper were measured. The strengthes were the highest in the Hwaseonji made from the mixture of the mulberry bast-fiber pulp and SwBKP. However, chinese ink blot property and smoothness were better when RsBSP, BbBKP or RP were mixed into the mulberry bast-fiber pulp. As a result, the various kinds of Hwaseonjis which the users can choose based on their needs were made.

• Journal of the Korean Wood Science and Technology
• /
• v.25 no.2
• /
• pp.75-80
• /
• 1997

This research has been examined to measure the degree of the fiber damage of ozonenation high yield pulp in the beating process. Ozone treated the TMP(Thermomechanical Pulp) and CTMP(Chemithermomechanical Pulp) of spruce and the CTMP of birch has been beaten to be reached 200ml(freeness) of its content. It had been studied the forming of fiber distribution by treatment for long fiber, short fiber, fine with the above method. As ozone treatment time gets longer, the pulp has showed the tendency of increasing the fiber content of 28, 48mesh. Ozone treated fiber has been increased long fiber content by being added softness. By given longer ozone treatment time, the TMP and CTMP of spruce has showed the decreasing of fiber content. On the contrary, CTMP of birch has showed the increasing its fiber content. It had proved that the results of difference are rather closer to the species of tree than closer to the kinds of pulp. The fiber content of over 200mesh which has created in beating process demonstrates the decreasing of its fiber content by getting longer ozone treatment time. The softness of fiber can be extracted by the lignin of fiber surface that had been formed by ozone treatment. Thus we assume that the fiber in the process of beating obtains less physical damage.