• 환경영향평가
• /
• 제16권6호
• /
• pp.503-510
• /
• 2007

Since 1990s many skyscrapers have been built in Seoul. However, gusty winds occur among tall buildings by descending turbulences due to the upper air blocking. This study aims to investigate the wind characteristics of skyscraper prevailing wind direction. In order to evaluate the building wind in this area, The wind speed and the wind direction were measured using propeller type RM-Young wind monitor in this study. The maximum wind speed was recorded by 15.1 m/sec and the main wind direction is WNW and NW. The ultimate purpose of this study is to figure out the phenomena of building wind impact and also to provide essential basic data for establishing proper guidelines in building wind impact assessment for skyscrapers in Korea.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2006년도 Proceedings of ISRS 2006 PORSEC Volume I
• /
• pp.386-389
• /
• 2006

The sea surface wind speed (SSWS) derived by microwave radiometer can be contaminated by change of microwave brightness temperature owing to the angle between the sensor azimuth and the wind direction (Relative Wind Direction). We attempt to correct the contamination to the SSWS derived by Advanced Microwave Scanning Radiometer (AMSR) on Advanced Earth Observing Satellite II (ADEOS-II), by applying the method proposed by Konda and Shibata (2004). The improvement of accuracy of the SSWS estimation amounts to roughly 60% of the error caused by the RWD effect.

• 대한토목학회논문집
• /
• 제28권2A호
• /
• pp.197-205
• /
• 2008

본 연구에서는 광양-묘도 지역의 평균풍속을 추정하기 위하여, 일별 최대 풍속과 해당 방향에 대한 결합분포확률의 통계학적 해석에 극한값 확률분포 모델이 사용되었다. 이를 위하여, 교량 가설지점 인근의 기상관측소에 대한 일별 최대풍속 및 해당풍향의 데이터로부터 각각의 관측소에 대한 일별 최대기록의 빈도를 조사하였으며, 16방위 및 전방위에 대한 년 최대풍속의 표본을 추출하였다. 이러한 풍속기록은 Gumbel 및 Weibull 분포모델에 적용하였으며, 모멘트방법 및 최소제곱법 등을 통해 모수를 추정하였다. 또한, PPCC 검사를 통해 분포모델 및 모수의 적합 여부를 검사하였다. 적합 여부가 판단된 모수로부터, 해당 관측소별로 데이터의 표본 크기 및 교량 가설지점으로부터의 거리에 대한 요소를 고려하여 16방위 및 전방위에 대한 년 최대풍속을 추정하였다.

• Wind and Structures
• /
• 제17권4호
• /
• pp.419-433
• /
• 2013

This paper investigates the vertical profiles of horizontal mean wind speed and direction based on the synchronized measurements from a Doppler radar profiler and an anemometer during 16 tropical cyclones at a coastal site in Hong Kong. The speed profiles with both open sea and hilly exposures were found to follow the log-law below a height of 500 m. Above this height, there was an additional wind speed shear in the profile for hilly upwind terrain. The fitting parameters with both the power-law and the log-law varied with wind strength. The direction profiles were also sensitive to local terrain setups and surrounding topographic features. For a uniform open sea terrain, wind direction veered logarithmically with height from the surface level up to the free atmospheric altitude of about 1200 m. The accumulated veering angle within the whole boundary layer was observed to be $30^{\circ}$. Mean wind direction under other terrain conditions also increased logarithmically with height above 500 m with a trend of rougher exposures corresponding to lager veering angles. A number of empirical parameters for engineering applications were presented, including the speed adjustment factors, power exponents of speed profiles, and veering angle, etc. The objective of this study aims to provide useful information on boundary layer wind characteristics for wind-resistant design of high-rise structures in coastal areas.

• 한국해안해양공학회지
• /
• 제15권2호
• /
• pp.138-142
• /
• 2003

이어도 해양과학기지가 주변의 바람장에 미치는 영향을 풍동실험을 통하여 검토하였다. 이어도 해양과 학기지에서 관측한 바람자료는 구조물로 인하여 풍속과 풍향의 왜곡이 발생하므로 정확한 풍속과 풍향을 알기 위해서는 관측자료에 구조물의 영향을 보정하여야 한다. 풍속비는 접근풍속의 크기보다는 풍속의 방향과 풍속 관측위치에 민감한 것으로 나타났다. 과학기지 옥상에 설치된 주 관측탑에서의 풍속은 모든 방향에서 접근풍속보다 크며 풍향 왜곡도는 6$^{\circ}$이내로 나타났다.

• 대기
• /
• 제27권4호
• /
• pp.445-453
• /
• 2017

This study investigates turbulent flow around a square cylinder mounted on a flat surface at high Reynolds number using a large-eddy simulation (LES) model, particularly focusing on vortex streets behind the square cylinder. Total 9 simulation cases with different inflow wind directions, inflow wind speeds, and cylinder widths in the x- and y-directions are considered to examine the effects of inflow wind direction, speed, and cylinder widths on turbulent flow and vortex streets. In the control case, the inflow wind parallel to the x-direction has a maximum speed of $5m\;s^{-1}$ and the width and height of the cylinder are 50 m and 200 m, respectively. In all cases, down-drafts in front of the cylinder and updrafts, wakes, and vortex streets behind the cylinder appear. Low-speed flow below the cylinder height and high-speed flow above it are mixed behind the cylinder, resulting in strong negative vertical turbulent momentum flux at the boundary. Accordingly, the magnitude of the vertical turbulent momentum flux is the largest near the cylinder top. In the case of an inflow wind direction of $45^{\circ}$, the height of the boundary is lower than in other cases. As the inflow wind speed increases, the magnitude of the peak in the vertical profile of mean turbulent momentum flux increases due to the increase in speed difference between the low-speed and high-speed flows. As the cylinder width in the y-direction increases, the height of the boundary increases due to the enhanced updrafts near the top of the cylinder. In addition, the magnitude of the peak of the mean turbulent momentum flux increases because the low-speed flow region expands. Spectral analysis shows that the non-dimensional vortex generation frequency in the control case is 0.2 and that the cylinder width in the y-direction and the inflow wind direction affect the non-dimensional vortex generation frequency. The non-dimensional vortex generation frequency increases as the projected width of the cylinder normal to the inflow direction increases.

• 제어로봇시스템학회논문지
• /
• 제17권11호
• /
• pp.1173-1178
• /
• 2011

The power generated by wind turbines changes rapidly because of the continuous fluctuation of wind speed and direction. It is important for the power industry to have the capability to predict the changing wind power. In this paper, neural network based wind power prediction scheme which uses wind speed and direction is considered. In order to get a better prediction result, compression function which can be applied to the measurement data is introduced. Empirical data obtained from wind farm located in Kunsan is considered to verify the performance of the compression function.

• Nuclear Engineering and Technology
• /
• 제55권10호
• /
• pp.3599-3616
• /
• 2023

After a nuclear power plant (NPP) accident, it would be helpful to predict the movement of the radioactive plume emitted from the NPP as accurately as possible to protect the nearby population. Radioactive plumes are mainly affected by wind direction and speed. Since it is difficult to identify the wind direction and speed immediately after the accident, a good understanding of the historical wind data could save many lives and ensure smoother evacuation procedures. In this study, wind data for the past 10 years are analyzed for the five NPPs in the Republic of Korea (ROK). The analyzed data include wind direction and wind speed from 2012 to 2021. In particular, the characteristics of the wind field blowing from the NPPs to the nearest densely populated regions are examined. Finally, suggestions to improve evacuation plans are made.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 1999년도 Proceedings of International Symposium on Remote Sensing
• /
• pp.485-490
• /
• 1999

Wind vector information over the ocean is currently obtained using multiple beam scatterometer data. The scatterometers on ERS-1/2 generate wind vector information with a spatial resolution of 50km and accuracies of $\pm$2m/s in wind speed and $\pm$20$^{\circ}$ in wind direction. Synthetic aperture radar (SAR) data over the ocean have the potential of providing wind vector information independent of weather conditions with finer resolution. Finer resolution wind vector information can often be useful particularly in coastal regions where the scatterometer wind information is often corrupted because of the lower resolution system characteristics which is often contaminated by the signal returns from the coastal areas or ice in the case of arctic environments. In this paper we tested CMOD_4 and CMOD_IFR2 algorithms for extracting the wind vector from SAR data. These algorithms require precise estimation of normalized radar cross-section and wind direction from the SAR data and the local incidence angle. The CMOD series algorithms were developed for the C-band, VV-Polarized SAR data, typically for the ERS SAR data. Since RADARSAT operates at the same C-band but with HH-Polarization, the CMOD series algorithms should not be used directly. As a preliminary approach of resolving with this problem, we applied the polarization ratio between the HH and VV polarizations in the wind vectors estimation. Two test areas, one in front of Inchon and several sites around Jeju island were selected and investigated for wind vector estimation. The new results were compared with the wind vectors obtained from CMOD algorithms. The wind vector results agree well with the observed wind speed data. However the estimation of wind direction agree with the observed wind direction only when the wind speed is greater than approximately 3.0m/s.

• 한국정보통신학회논문지
• /
• 제11권8호
• /
• pp.1478-1485
• /
• 2007

본 논문에서는 풍향 풍속 계측모듈 및 DSP 센서인터페이스 회로 보드를 포함하는 기상계측 시스템을 제안한다. 이 DSP 시스템은 풍향풍속모듈, 대기압센서, 대기 온도 센서의 정보를 받아들이고, 빠르게 처리하여 PC 모니터링 시스템에 전달한다. 특히 풍향 풍속 모듈과 DSP 하드웨어는 직접 설계하여 적용한다. 풍향 풍속 모듈은 바람에 관한 벡터적 정보를 얻기 위해 4개의 박막형 RTD(Resistive Temperature Detectors) 저항센서를 히팅 코일에 의해 일정하게 가열된 원기둥 모양의 지지 표면에 벡터적으로 배치하는 구조를 채택한다. 이 구조를 채택한 계측 모듈은 진동, 습기, 부식 등에 강인하면서 정확한 계측을 가능케 한다. 센서 신호처리 회로는 TI사의 고속 DSP인 TMS320F2812 사용한다. 적용된 풍향 풍속 모듈을 통해 얻어진 데이터와 DSP 인터페이스 회로보드의 빠른 데이터 처리를 통해 저렴한 기상계측시스템을 구성 할 수 있었다.