• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.10a
• /
• pp.221-228
• /
• 2005

The economic growth brought the demand of bridge connected to island and land increasingly in Korea. Therefore, Civil engineer has faced a lot of problem to be considered such as structural stability, economic feasibility and constructional method. At the bridge site to be constructed, the depth of water is about 24m, the thickness of weathered rock overlaying bed rock is thicker than 36m. If open caisson foundation is supported in bed rock, the hight of foundation is about 60m. It is difficult to construct in these conditions. If open caisson foundation is supported in weathered rock, the size of the foundation should be increased. And If we apply the pile foundation, the higher construction cost will be needed. Under the circumstances, we need a new foundation type-composite foundation that is consisted of open caisson and cast-in-place piles. Because the design concept of composite foundation is not presented in Korea Bridge Design Standard, we are willing to clear the bearing behavior of composite foundation by numerical analysis in this paper.

• Economic and Environmental Geology
• /
• v.55 no.5
• /
• pp.429-438
• /
• 2022

This study evaluated the effect of the degree of weathering on the particle size distribution and the amount of fine particles generated in the aggregate production process during the crushing of igneous rock. Rock samples were collected from three areas with differences in strength from the Schmith hammer measurement at the aggregate quarry in Geochang, Gyeongsangbuk-do. After crushing with a jaw crusher under the same conditions in laboratory, particle size analysis, mineral analysis, chemical analysis, and weathering index were calculated. The Schmidt hammer measurements were 56, 28, and <10, and the CIA and CIW values of weathering index were also different, so the rock samples were classified into hard rock, soft rock, and weathered rock according to the weathering degree. It shows a smaller particle size distribution toward weathered rocks under the microscope, and the proportion of altered clay minerals such as sericite increased. The composition of feldspar and quartz was high for hard rock, and the ratio of muscovite and kaolinite was low. As a result of the crushing of the jaw crusher, hard rock produced a lot of coarse crushed material (13.2mm), while soft rock and weathered rock produced fine crushed material (4.75mm). The former showed the characteristics of the beta distribution curve, and the latter showed the bimodal distribution curve. The production of fine rock particles (based on 0.71mm of sieve, wt. %) increased to 13%<21%<22% in hard rock, soft rock, and weathered rock, and the greater the degree of weathering, the more fine rock particles were generated. The fine particles are recovered by the operation of the sand unit in the wet aggregate production process. Therefore, in order to minimize the amount of sludge generated in the aggregate production process, it was judged that a study on the optimal operation of cyclones could be necessary.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.03a
• /
• pp.85-106
• /
• 2000

The load distribution and deformation of drilled shafts subjected to axial loads were evaluated by a load transfer approach. The emphasis was on quantifying the load transfer mechanism at the interface between the shafts and surrounding highly weathered rocks based on a numerical analysis and small-scale tension load tests performed on nine instrumented piles. An analytical method that takes into account the soil coupling effect was developed using a modified Mindlin's point load solution. Based on the analysis, a single-modified hyperbolic model is proposed for the shear transfer function of drilled shafts in highly weathered rocks. Through comparisons with field case studies, it is found that the prediction by the present approach is in good agreement with the general trend observed by in-situ measurements.

• Journal of the Korean Ceramic Society
• /
• v.32 no.1
• /
• pp.71-82
• /
• 1995

The weathered two-mica granite is widely distributed in Korea and called a kind of ground rock for kaolin. The major minerla compositions are consist of this quartz, feldspar, mica and clay mineral. At present, only a small portion of this granite is used as the material for the low-grade tile industry due to the low S.K. value and the high contents of impurities such as Fe2O3 and FeO. The low S.K. value is caused by feldspars not weathered to clay minerals. The refinement of this thus has been required for the recent shortage of the resources of high-grade one. This paper concerns an optimum hydrothermal treatment condition to refine the low-grade weathered two-mica granite of which impurities are feldspar mineral and Fe2O3. FeO components in using for the main material of ceramic industry. And then, from this result, we tried to fine out the basic formation mechanism of clay mineral from feldspar etc and develope the effectual utilization method of this.

• Journal of the Korean Geosynthetics Society
• /
• v.6 no.3
• /
• pp.1-7
• /
• 2007

The property of weathered soil cannot but have a possibility of having a limit when its precise approaching due to the various weathering environment, and the peculiarity of its conduct affected by the weathering degree and effect factors. Especially most domestic or international researches are concentrated on the sedimentary soil, trying to analyze the mechanical behavior of weathered soil from the viewpoint of sedimentary soil. Therefore, it's difficult to judge if those results meet the actual conduct of weathered soil. This study suggested a way of weathering degree changing experiment as an early stage in an experiment of artificially changing weathering degree. In order to find out the property of strength change by the change of weathering degree, indoor mechanical experiment was made using soil sample after freezing and thawing. Under the weathering degree, characteristic change is watched by country rock and region of weathered granite soil.

• Geomechanics and Engineering
• /
• v.28 no.6
• /
• pp.625-636
• /
• 2022

The standard penetration test (SPT) obtaining the N value of the number of blows has been widely used in various subsurface conditions, including in weathered soil and rock on fresh bedrock, in geotechnical studies pertaining to the design of foundations and earth structures. This study examined the applicability of SPTs terminated conventionally after 50 blows for a penetration of less than 30 cm, particularly in weathered strata, at four sites in Korea. The N values obtained during practical SPTs are typically extrapolated linearly at 30 cm penetration, despite the possibility of a nonlinear relationship between blow counts and penetration. Such nonlinearity in weathered strata has been verified by performing special SPTs ensuring 30 cm penetration. To quantify the nonlinearity in dense strata, we conducted statistical regression analyses comparing the differences (DN) between the N values measured by the special SPTs and those extrapolated using the practical approach with the differences (DP) between the 30 cm penetration and the penetration during 50 blows. Bi-linear relationship models between DN and DP were subsequently proposed for determining the N values at 30 cm penetration in weathered strata. The N values reflecting nonlinearity could be determined from the linearly extrapolated N values by adding a modeled DN value.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.10a
• /
• pp.409-429
• /
• 2006

In designing rock-socketed drilled shaft, bearing capacity evaluation is very important because the maximum values of base and side resistance are not generally mobilized at the same value of displacement, FHWA and AASHTO code suggest different ultimate bearing capacity formular according to rock type and shaft settlement. In domestic code suggest base resistance and side resistance can be added on condition that after confirming the result of field load test with axial load transfer test. This paper shows that static load test and hi-directional load test result analysis of deep rock-socketed drilled shaft in three different sites. Load-settlement curve, t-z, and q-w curve in rock-socketed part were calculated and compared. t-z curve in weathered and soft rock showed no deflection softening behavior in pretty large strain (about 2-3% of diameter). Ultimate resistance could be the summation of side resistance and base resistance in rock-socketed drilled shaft in domestic sites.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2021.11a
• /
• pp.142-143
• /
• 2021

The general ground conditions in Korea are distributed in order of fill, deposit soil, weathered soil, weathered rock, soft rock. The fill soil and deposit soil located at the top have relatively low strength compared to the lower layer, and they are sometimes classified as soft ground according to the standard penetration test results. In this study, the PF method, a ground improvement method, was applied to the soft layer, a large plate load test was conducted on the improved ground, and the results were reviewed.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1998.06b
• /
• pp.17-34
• /
• 1998

• Journal of the Korean Society for Railway
• /
• v.9 no.1 s.32
• /
• pp.89-94
• /
• 2006

We, presently, don't have clear diagram methods and analysis criteria in rock bolt pull test usable for tunnel reinforcement. So this paper has suggested that; first, 'scheme of apposite diagram method at hard rock and the different application method of rock bolt pull test at weathered and hard rock', and second, 'the pullout capacity specification criteria for design and construction of rock bolt', based on foreign criteria and field test.