• Journal of Korea Society of Industrial Information Systems
• /
• v.23 no.6
• /
• pp.29-38
• /
• 2018

In this paper, we developed a virtual cloth try-on (VTON) technology that segement the cloth image worn on the mannequin and applies it to the user 's photograph. The two-dimensional image-based virtual wear study which does not require three-dimensional information of cloth and model is of practical value, but the research result shows that there are limitations of of the current technology for the problem of occlusion or distortion. In this study, we proposed an algorithm to apply the results obtained from the DNN- based segmentation and posture estimation to the user 's photograph, assuming that the mannequin cloth reduces the difficulties in this part. In order to improve the performance compared with the existing one, we used the validity check of the pre-attitude information, the improvement of the deformation using the outline, and the improvement of the divided area. As a result, a significantly improved result image of more than 50% was obtained.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.9
• /
• pp.768-773
• /
• 2016

Engine valve seat and face, which are the important factors affecting engine performance, are required to have wear, heat and corrosion resistance. In order to produce surface layer with these characteristics, PTA(plasma transferred arc) surfacing procedure is generally employed, but problems, such as large HAZ and high dilution etc., frequently occurr. Laser cladding, which overcomes the drawbacks of conventional technologies, can be employed to create a superior clad layer with low dilution, small heat affected zone, and minimal distortion. However, in case cladding is to be applied to a large area, it is necessary to overlap 1 pass clad layer because of limited clad layer width. Two criteria for the overlapping ratio-beam size and clad layer width-have been considered thus far. Upon inspection of multi pass clads, produced by different overlapping criteria, it was observed that the greater the increase in overlapping ratio, the greater was the decrease in clad layer width and increase in clad layer height regardless of the criterion used. However, a multi pass clad overlapped by the beam size criterion demonstrated a higher hardness value than a clad overlapped by the clad layer width owing to decreasing dilution of the substrate. In conclusion, the beam size was defined as the criterion for the overlapping, because the clad layer width increased or decreased depending upon process parameters.