• Korean Journal of Environmental Agriculture
• /
• v.27 no.4
• /
• pp.349-355
• /
• 2008

The causes of salt accumulation in soils of plastic film houses nearby Sumjin river estuary in Mokdo-ri($127^{\circ}46'E\;35^{\circ}1'N$), Hadong, Gyeongnam, Korea were investigated in 2006. With chemical properties soils and water analyzed and fertilization status monitored, the study showed that mean salt concentration of soil was much higher at EC $4.3\;dS\;m^{-1}$ than the Korean average (EC $2.9\;dS\;m^{-1}$) in 2000s for plastic film house's soil with exchangeable Na $0.8\;cmol^+\;kg^{-1}$ and water-soluble Cl $232\;mg\;kg^{-1}$, and then might result to salt damage in sensitive crop plants. Salt concentration of ground water used as main irrigation water source contained very high EC with corresponding value of $2.6\;dS\;m^{-1}$. Particularly, increase of EC value was directly proportional with the increased pumping of ground water used as a water-covering system in order to protect the temperature inside plastic film houses from the early winter season. High Na and Cl portion of ions in water might had contributed to the specific ion damage in the crops. Secondly, heavy inputs of chemicals and composts significantly increased the accumulated salts in soil. Conclusively, salt accumulation might had been accelerated by use of salted-groundwater irrigation and heavy fertilization rate. To minimize this problem, ensuring good quality of irrigation water is essential as well as reducing fertilization level.

• Korean Journal of Remote Sensing
• /
• v.36 no.6_3
• /
• pp.1669-1679
• /
• 2020

This study examines the washing effect of precipitation on particulate matter (PM) and the rainwater quality (pH, electrical conductivity (EC), water-soluble ions concentration). Of six rain events in total, rainwater samples were continuously collected every 50 mL from the beginning of the precipitation using rainwater collecting devices at Pukyong National University, Busan, South Korea, from March 2020 to July 2020. The collected rainwater samples were analyzed for pH, EC, and water-soluble ions (cations: Na+, Mg2+, K+, Ca2+, NH4+, and anions: Cl-, NO3-, SO42-). The concentrations of particulate matter were continuously measured during precipitation events with a custom-built PM sensor node. For initial rainwater samples, the average pH and EC were approximately 4.3 and 81.9 μS/cm, and the major ionic components consisted of NO3- (5.4 mg/L), Ca2+ (4.2 mg/L), Cl- (4.1 mg/L). In all rainfall events, rainwater pH gradually increased with rainfall duration, whereas EC gradually decreased due to the washing effect. When the rainfall intensities were relatively weak (<5 mm/h), PM10 reduction efficiencies were less than 40%. When the rainfall intensities were enhanced to more than 7.5 mm/h, the reduction efficiencies reached more than 60%. For heavy rainfall events, the acidity and EC, as well as ions concentrations of initial rainwater samples, were higher than those in later samples. This appears to be related to the washing effect of precipitation on PM10 in the atmosphere.

• Clinical and Experimental Pediatrics
• /
• v.46 no.2
• /
• pp.198-202
• /
• 2003

Of all toxic inhalant exposures, chlorine is one of the most common toxic chemical inhalants. When acutely inhaled, it can be responsible for symptoms ranging from upper air way irritation to more serious respiratory effects. It can also deteriorate lung function and lead to death. Chlorine and its compounds such as chlorinated cyanurates and hypochlorites are commonly used in water disinfection. The chemical agents discussed in this article are sodium dichloroiso cyanurate and calcium hypochlorite which are the two most popular products for swimming pool chlorination. They are both strong oxidizing agents which are soluble in water. Between the above two alkali agents, acid-base interaction occurred and generated heat. And the acid drove the combination of hypochlorous and chloride ions to form chlorine gas. We have experienced, two boys who had inhalation injuries caused by an accidental explosion which occurred in a swimming pool by mixing two different chlorinating agents : sodium dichloroiso cyanurate and calcium hypochlorite. The children suffered from respiratory difficulties after the exposure. They both required intensive care management and one needed the support of mechanical ventilation.

• Journal of the Korea Concrete Institute
• /
• v.17 no.5 s.89
• /
• pp.821-828
• /
• 2005

To investigate the role of RH and temperature on the transport of chloride in the concrete, two groups of specimens were configured. For both groups, mix design was based on w/c=0.45, $400kg/m^3$ cement, $794kg/m^3$ fine aggregate and $858kg/m^3$ coarse aggregate. After specimen fabrication these were exposed to four different RH (35, 55, 75 and $95\%$ RH) and temperature (0, 20, 30 and $40^{\circ}C$) conditions. After 3 and 6 months $15\%$ NaCl exposure 5mm cores were taken. These cores were sliced and individual cores were ground to powder. In addition, to evaluate the effect of temperature on the chloride binding some powder samples were leached in the each of four temperature chambers. Chloride titration fur these was performed using FDOT acid titration method. Based upon the resultant data conclusions were reached regarding that 1) effective diffusion coefficient, $D_e$, increased with increasing exposure RH, suggesting that the size and number of water paths increased with elevated moisture content in the specimens, 2) $D_e$ increased with increasing temperature in the range of 0 to $40^{\circ}C$ possibly by elevated thermal activation of chloride ions and reduced chloride binding at higher temperature, 3) water soluble chloride concentration, $[Cl^-]_s$, increased with increasing temperature, and 4) chloride concentration profile for initially dry concrete specimens was higher than for the initially wet ones indicating pronounced capillary suction (sorption) occurred for the dry concrete specimens.

• Corrosion Science and Technology
• /
• v.8 no.3
• /
• pp.110-115
• /
• 2009

At the onset of corrosion of steel in concrete, hydrogen ions usually evolve in the process of electrochemical reaction, thereby decreasing the pH of the pore solution, which can be buffered by cement hydration products, as being representatively illustrated by calcium hydroxide. Hence, a fall in the pH is dependent on properties of cement hydration (i.e. hydration products and degree of hydration). The present study tested acid neutralization capacity (ANC) of cementitious binders of OPC(Ordinary Portland Cement), 30% PFA(Pulverized Fuel Ash), 60% GGBS(Ground Granulated Blast Furnace Slag), 10% SF(Silica Fume) to quantify the resistance of cement matrix to a pH fall. Cement pastes were cast at 0.4 of a free W/C ratio with 1.5% chlorides by weight of binder in cast. Powder samples obtained crushed and ground specimen after 200 days of curing were diluted in still water combined with different levels of 1M nitric acid solution, ranging from 0.5 to 20 mol/kg. Then, the pH of diluted solution was monitored until any further change in the pH did not take place. It was seen that the pH of the diluted solution gradually decreased as the molar amount of nitric acid increased. At some particular values of the pH, however, a decrease in the pH was marginal, which can be expressed in the peak resistances to a pH fall in the ANC curve. The peaks occurred at the variations in the pH, depending on binder type, but commonly at about 12.5 in the pH, indicate a resistance of precipitated calcium hydroxide. The measurement of water soluble chloride at the end of test showed that the amount of free chloride was significantly increased at the pH corresponding to the peaks in the ANC curve, which may reflect the adsorption of hydration products to chlorides.

• Applied Chemistry for Engineering
• /
• v.3 no.1
• /
• pp.148-155
• /
• 1992

For the enhancement of the concrete durability, we developed high - durable portland cement (ACTPC) by physical treatment of ordinary portland cement with asphalt and carbon black. In this research, the hydration reaction characteristics of ACTPC were studied by using SEM, X-Ray, Conduction Micro Calolimeter etc. When the ACTPC is mixed with water, it is believed the asphalt films on cement particles suppress the early stage of hydration reactions of cements, because the films hinder the contact with water and the elusion of soluble ions from particles. But the carbon blacks on the cement particles accelerated the hydration reactions of cement after a while, because the micro particles can be used as seed crystals in $CaO-SiO_2-H_2O$ gel formation.

• Journal of Soil and Groundwater Environment
• /
• v.27 no.1
• /
• pp.39-49
• /
• 2022

Bottom ash generated from thermal power plants is mainly disposed in landfills, from which metals may be leached by infiltrating water. To evaluate the effect of metals in leachate on soil and groundwater, we characterized bottom ash generated from burning cokes, bituminous coal, the mixture of bituminous coal and wood pellets, and charcoal powder. The bottom ash of charcoal powder had a relatively large particle size, and its wood texture was well-preserved from SEM observation. The bottom ash of charcoal powder and wood pellets had relatively high K concentration from total element analysis. The eluates of the bottom ash samples had appreciable concentrations of Ca, Al, Fe, SO₄, and NO₃, but they were not a significant throughout the batch test. Therefore, it is considered that there is low possibility of soil and groundwater contamination due to leaching of metal ions and anions from these bottom ash in landfills. To estimate the trend of various trace elements, long-term monitoring and additional analysis need to be performed while considering the site conditions, because they readily adsorb on soil and aquifer substances.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.4
• /
• pp.638-643
• /
• 2007

The full encoding sequence for human type II hexokinase (HXK II) was cloned into the E. coli expression vector pET 21b and expressed as a C-terminally hexahistidine-tagged protein in the BL2l (DE3) strain. The IPTG-induced HXK II approximately accounted for 17% of the total E. coli proteins, and 81% of HXK $II_{6{\times}His}$ existed in inclusion bodies. To improve the production of soluble recombinant HXK II protein, in the functionally active form, we used low temperature, and the osmotic stress expression method. When expressed at $18^{\circ}C$, about 83% of HXK $II_{6{\times}His}$ existed in the soluble fraction, which amounted to a 4.1-fold yield over that expressed at $37^{\circ}C$. The soluble form of HXK $II_{6{\times}His}$ was also highly produced in the presence of 1M sorbitol under the standard condition $(37^{\circ}C)$, which indicated that temperature downshift and low water potentials were required to improve the yield of active recombinant HXK II protein. The expressed protein was purified by metal chelate affinity chromatography performed in an IDA Excellose column charged with $Ni^{2+}$ ions, resulting in about 40mg recombinant HXK II protein obtained with purity over 89% from 51 of E. coli culture. The identity of HXK $II_{6{\times}His}$ was confirmed by Western blotting analysis. Taken together, using the stress-governed expression described in this study, human active HXK II can be purified in sufficient amounts for biochemical and biomedical studies.

• Korean Journal of Ecology and Environment
• /
• v.46 no.3
• /
• pp.388-394
• /
• 2013

Growth, inorganic solutes and glycine betaine accumulation in spinach beet (Beta vulgaris var. cicla L.) were studied under different salt conditions. Plants of fortythree days old were assessed by growing for a further 10 and 20 days at four NaCl concentrations (0, 100, 200, 300 & 400 mM). The dry weight of leaves was maximal in plants which were grown at 100 to 200 mM NaCl treatments and after 10d it was decreased slightly at salt treatments of more than 300 mM NaCl. Under the salt conditions, leaves of B. vulgaris contained high inorganic ions to maintain low water potential, but low water soluble carbohydrate contents. Total ionic content and osmolality increased with increasing salt concentration. Salt stress led to a preferential accumulation of glycine betaine in leaves of B. vulgaris, especially for the 200 mM NaCl treatment. These findings suggest that a high degree of NaCl tolerance of B. vulgaris resulted from the accumulation of glycine betaine, which is known to have osmoprotectant properties in the cytoplasm.

• Korean Journal of Remote Sensing
• /
• v.36 no.6_3
• /
• pp.1733-1741
• /
• 2020

This study analyzed the effect of meteorological factors on the concentration of PM10 (particulate matter 10) in the atmosphere and the variation of rainwater quality using multivariate statistical analysis. The concentration of PM10 in the atmosphere was continuously measured during eleven precipitation events with a custom-built PM sensor node. A total of 183 rainwater samples were analyzed for pH, EC (electrical conductivity), and water-soluble cations (Na+, Mg2+, K+, Ca2+, NH4+) and anions (Cl-, NO3-, SO42-). The data has been analyzed using two multivariate statistical techniques (principal component analysis, PCA, and Pearson correlation analysis) to identify relationships among PM10 concentrations in the atmosphere, meteorological factors, and rainwater quality factors. When the rainfall intensity was relatively strong (> 5 mm/h, rainfall type 1), the PM10 concentration in the atmosphere showed a negative correlation (r = -0.55, p < 0.05) with cumulative rainfall. The PM10 concentration increased the concentration of water-soluble ions (r = 0.25) and EC (r = 0.4), and decreased the pH (r = -0.7) of rainwater samples. However, for rainfall type 2 (< 5 mm/h), there was no negative correlation between the PM10 concentration in the atmosphere and cumulative rainfall and no statistically significant correlation between the PM10 concentration in the atmosphere and rainwater quality.