• 한국안전학회지
• /
• 제35권5호
• /
• pp.128-136
• /
• 2020

In the present experimental study, the effect of water-based iron(III) oxide nanofluid on the MFB(Minimum Film Boiling) point during quenching was investigated. As the highly heated test specimen, the cylindrical stainless steel rod was used, and as the test fluids, the water-based iron(III) oxide nanofluids of 0.001 and 0.01 vol% concentrations were prepared with the pure water. To examine the effect of location in the test specimen, the thermocouples were installed at the bottom and middle of wall, and center in the test specimen. Through a series of experiments, the experimental data about the influences of nanofluid concentrations, the number of repeated experiments, and locations in the test specimen on the reaching time to MFB point, MFBT(Minimum Film Boiling Temperature), and MHF(Minimum Heat Flux) were obtained. As a result, with increasing the concentration of nanofluid and the number of repeated experiments, the reaching time to MFB point was reduced, but the MFBT and MHF were increased. In addition, it was found that the effect of water-based iron(III) oxide nanofluid on the MFB point at the bottom of wall in the test specimen was observed to be greater than that at the middle of wall and center. In the present experimental ranges, as compared with the pure water, the water-based iron(III) oxide nanofluid showed that the maximum reduction of reaching time to MFB point was about 53.6%, and the maximum enhancements of MFBT and MHF were about 31.1% and 73.4%, respectively.

• 한국지하수토양환경학회지:지하수토양환경
• /
• 제12권6호
• /
• pp.53-59
• /
• 2007

액체섬광계수기(liquid scintillation counter: LSC)를 이용한 지하수 $^{14}C$의 측정에서 휘발성유기화합물(volatile organic compounds: VOC)에 따라 소광효과(quenching effect)를 정확하게 보정할 수 있는 최적 소광곡선(quenching curve)의 작성조건을 조사하였다. 우선, VOC에 따른 소광효과를 알기 위하여 benzene, toluene, ethylbenzene, o-(m-,p-)xylenes, trichloroethylene(TCE)과 tetrachloroethylene(PCE), carbon tetrachloride, chloroform과 같은 주요 지하수오염유기물에 의한 소광인자(spectral quench parameter of the external standard, SQP(E))를 측정하였다. 소광곡선은 $^{14}C$ 표준용액과 chloroform 소광시약을 이용하여 작성하였으며 $^{14}C$ 표준용액의 비방사능(specific activity, dpm/mL), LSC 측정시간, 소광시약 농도 등의 최적조건을 도출하였다. 소광효과는 분자 내에 염소원자를 포함하지 않는 BTEX(benzene, toluene, ethylbenzene, o-(m-,p-)xylenes) 보다 염소원자를 포함하는 TCE, PCE, carbon tetrachloride와 chloroform에서 매우 높게 나타났다. 실험에서는 여건상 $^{14}C$ 비방사능이 7,000 dpm/mL 정도의 표준용액을 사용하였는데 이 경우 LSC측정시간은 100분, 소광시약으로 chloroform을 사용할 경우 수 mL의 첨가량이 적당하였다. 이러한 조건으로 BTEX(benzene, toluene, ethylbenzene, m-xylene)에 대해 작성한 소광곡선의 상관계수(coefficient of correlation)는 0.99이상으로 통계학적으로 신뢰할 수 있는 값을 얻을 수 있었으며 이 소광곡선을 지하수와 수돗물의 $^{14}C$ 측정에 적용한 결과 표준용액의 비방사능 값과 잘 일치하여 연구결과의 유효성을 확인할 수 있었다.

• Elastomers and Composites
• /
• 제54권3호
• /
• pp.201-208
• /
• 2019

Superabsorbent hydrogel (SAH) is a lightly crosslinked hydrophilic functional polymer material comprising a flexible chain structure, which can absorb and retain high amounts of water or aqueous fluids even under high pressure. Therefore, it is important to improve their characteristics such as absorption performance, residual monomer content, and water permeability. SAH nanocomposites were prepared using clay mineral as an inorganic filler and the influence of post-treatment processes such as quenching and aging process on their properties was studied. In addition, surface-crosslinking process was applied to improve the absorption performance associated with mechanical properties and water permeability. The structure of the SAH was characterized using attenuated total reflectance Fourier transform infrared spectroscopy, X-ray diffraction analysis, and scanning electron microscopy.

• 한국세라믹학회지
• /
• 제34권7호
• /
• pp.767-773
• /
• 1997

Thermal shock behavior of alumina ceramics were studied by quenching the heated alumina specimen into the water of various temperatures over 0~10$0^{\circ}C$. The critical thermal shock temperature difference ( Tc) of the specimen decreased almost linearly from 275$^{\circ}C$ to 20$0^{\circ}C$ with increase in the cooling water temperature over 0~6$0^{\circ}C$. It is probably due to the increase of the maximum cooling rate which is dependent of the convection heat transfer coefficient. The convection heat transfer coefficient is a function of the temperature of the cooling water. However, the critical thermal shock temperature difference( Tc) of the specimen increased at 25$0^{\circ}C$ over 80~10$0^{\circ}C$ due to the film boiling of the cooling water. The maximum cooling rate, which brings about the maximum thermal stress of the specimen in the cooling process, was observed to increase linearly with the increase in the quenching temperature difference of the specimen due to the linear relationship of the convection heat transfer coefficient with the water temperature over 0~6$0^{\circ}C$. The critical maximum cooling rate for thermal shock fracture was observed almost constant to be about 260$\pm$1$0^{\circ}C$/s for all water temperatures over 0~6$0^{\circ}C$. Therefore, thermal shock behavior of alumina ceramics is greatly influenced by the convection heat transfer coefficient of the cooling water.

• 열처리공학회지
• /
• 제21권3호
• /
• pp.137-143
• /
• 2008

Effect of quenching medium on the mechanical properties of ductil iron GCD 50 has been investigated using ADI treated specimens. The specimens have been austenitized at $900^{\circ}C$ for 2 hours, followed by controlled cooling to $800^{\circ}C$ under the cooling rate of $0.05^{\circ}C/sec$, then austempered at $380^{\circ}C$, $330^{\circ}C$, $280^{\circ}C$ and $230^{\circ}C$ for 1 hour. The specimens treated in the salt of 5% water were found to have higher tensile strength than that of the normal salt bath. Elongation and impact energy increased in proportion to the increase of retained austenite volume fraction. The increase of cooling rate of the salt by the addition of 5% water to the salt resulted in the increase of retained austenite volume fraction and the formation of fine bainitic ferrite.

• Nuclear Engineering and Technology
• /
• 제42권2호
• /
• pp.193-202
• /
• 2010

In order to study the cladding properties of zirconium after a loss-of-coolant accident (LOCA)-simulation oxidation and water quenching test, commercial Zircaloy-4 and two kinds of HANA claddings were oxidized at temperatures ranging from $900^{\circ}C$ to $1250^{\circ}C$ and exposed for 300 s, and then cooled to $700^{\circ}C$ before quenching. Microstructural observations were made to evaluate the matrix characteristics with the chemical compositions after the LOCA-simulation test. Ring compression testing was then performed to compare the ductile behaviour of the HANA and Zircaloy-4 claddings. An X-ray diffraction (XRD) analysis was carried out for temperatures ranging from room temperature to $1250^{\circ}C$ for the oxide layer to verify the oxide crystal structure at each oxidation temperature.

• Nuclear Engineering and Technology
• /
• 제45권6호
• /
• pp.811-820
• /
• 2013

SiC has been under investigation as a potential cladding for LWR fuel, due to its high melting point and drastically reduced chemical reactivity with liquid water, and steam at high temperatures. As SiC is a brittle material its behavior during the reflood phase of a Loss of Coolant Accident (LOCA) is another important aspect of SiC that must be examined as part of the feasibility assessment for its application to LWR fuel rods. In this study, an experimental assessment of thermal shock performance of a monolithic alpha phase SiC tube was conducted by quenching the material from high temperature (up to $1200^{\circ}C$) into room temperature water. Post-quenching assessment was carried out by a Scanning Electron Microscopy (SEM) image analysis to characterize fractures in the material. This paper assesses the effects of pre-existing pores on SiC cladding brittle fracture and crack development/propagation during the reflood phase. Proper extension of these guidelines to an SiC/SiC ceramic matrix composite (CMC) cladding design is discussed.

• 대한기계학회논문집
• /
• 제17권6호
• /
• pp.1529-1540
• /
• 1993

본 연구에서는 금속 열처리를 위한 고온면의 막비등 급냉각에 관한 1차적 연구로서 과냉과도 비등곡선의 정확한 형상과 냉각제의 냉각조건이 강재의 과냉과도 비등열전달에 미치는 영향, $A_1$변태점 부근의 $A_1$냉각속도와 상변태열량광의 관계, 그리고 상변태열이 냉각곡선에 미치는 영향 등을 규명하고자 한다.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2009년도 추계학술대회 논문집
• /
• pp.173-176
• /
• 2009

A great emphasis has been placed on the design of heat treatment process to achieve desired microstructure and mechanical property of final product. In this study, finite element analysis was carried out to predict temperature, microstructure and hardness of eutectoid steel after water quenching. Convective heat transfer coefficients were determined by inverse analysis using surface temperatures measured with three different installation methods of thermocouples. Finally, the effect of convective heat transfer coefficients on the prediction of temperature history and hardness was analyzed by comparing experimental and simulation results.

• Journal of Photoscience
• /
• 제5권1호
• /
• pp.17-22
• /
• 1998

Changes of chlorophyll fluorescence and xanthophyll cycle pigment contents in maize leaves were investigated dunng desiccation in darkness or in the light. In darkness, a drastic dehydration of detached maize leaves down to 50% relative water content (RWC) affected photochemical efficiency of photosystem II (Fv/Fm) and pht)tochemical quenching (qP) only slightly. In contrast, desiccation in the light with a moderate intensity led to a pronounced reduction in Fv/Fm with a Fo quenching when RWC was greater than 70%. This reduction in Fv/Fm could be recovered in darkness under hutrod condition. In leaves with RWC below 70%, significant reduction in Fv/Fm was accompanied by an increase of Fo, which could not be reversed within 5 h in darkness under humid condition. The nonphotochemical quenching increased during desiccation in the light with a concomitant rise in zeaxanthin at the expense of violaxanthin. Pretreatment with dithiothreitol (DTT), an inhibitor of zeaxanthin synthesis, inhibited the development of nonphotochemical quenching and prevented the xanthophyll interconversion during desiccation in the light. These results suggest that even light with a moderate intensity becomes excessive under dehydration and zeaxanthin-associated photoprotection of photosynthetic apparatus against photodamage is involved, but the protection is not complete against severe desiccation.