• 반도체디스플레이기술학회지
• /
• 제18권4호
• /
• pp.87-91
• /
• 2019

The diagnosis of the failure for the existing electrical facilities was based on regular preventive maintenance, but this preventive maintenance was limited in preventing a lot of cost loss and sudden system failure. To overcome these shortcomings, fault prediction and diagnostic techniques are critical to increasing system reliability by monitoring electrical installations in real time and detecting abnormal conditions in the facility early. As the performance and quality deterioration problem occurs frequently due to the increase in the number of users of the motor pump, the purpose is to build an intelligent control system that can control the motor pump to maximize the performance and to improve the quality and reliability. To this end, a vibration sensor, temperature sensor, pressure sensor, and low water level sensor are used to detect vibrations, temperatures, pressures, and low water levels that can occur in the motor pump, and to build a system that can identify and diagnose information to users in real time.

• 한국화재소방학회논문지
• /
• 제26권5호
• /
• pp.85-91
• /
• 2012

소방차에 설치되는 소방펌프에 대한 방수성능 기준이 현장에서 운용하고 있는 실태와 상이한 부분이 있고, 기준이 명확하게 규정되어 있지 않아 소방공무원이 화재현장에서 소방펌프의 사용시간, 최대사용압력, 사용 호스 직경 등 사용 실태를 분석하고, 그 결과를 토대로 소방펌프에 대한 압력별, 호스 직경별 수량별로 다양하게 성능시험을 실시하였다. 현장조사 결과, 소방자동차용 소방펌프의 성능에 관한 인정기준에서 규정하고 있는 규격방수압력(0.85MPa)과 고압방수압력(1.4 MPa)보다 현장에서는 더 높은 압력을 사용하고 있는 것으로 조사되었다. 또한, 펌프의 성능시험 결과는 방수량 및 방수압력 등이 호스의 직경, 관창에 따라 현재 규정하고 있는 인정기준과 매우 상이하게 측정되었으며, 본 연구 결과로 새로운 규격을 제안한다.

• 동력기계공학회지
• /
• 제21권6호
• /
• pp.79-85
• /
• 2017

A heat pump system is a highly efficient, eco-friendly device which consumes a small amount of energy and supply a lot of energy for heat formation. In addition, it is a single device system that has low generation effect about carbon dioxide. There are many researches related to the electronic expansion valve and the heat pump, but the detailed data analysis of each influence is insufficient. In this study, the cooling capacity and COP of the heat pump system were investigated by varying frequency of the inverter connected to compressor, inlet temperature of chilled water into evaporator and inlet temperature of cooling water into condenser. The results are as follows : (1) The cooling capacity increased as the inverter frequency, inlet temperature of chilled water into evaporator increased, and inlet temperature of cooling water into condenser decreased. (2) The COP increased as the frequency of inverter, inlet temperature of cooling water into condenser decreased and the inlet temperature of chilled water into evaporator increased.

• 한국화재소방학회논문지
• /
• 제26권4호
• /
• pp.10-17
• /
• 2012

본 연구에서는 목조 사찰 화재시 펌프(물탱크)차의 현장 도착 가능여부에 따라 사찰화재 유형별 진압대책을 4가지 유형으로 분류하고, 각 유형별 화재진압 전술 및 방법을 도출하였다. 연구결과, 펌프(물탱크)차의 접근 및 소방용수 확보가 가능한 사찰은 일반 건축물화재 진압전술을 적용하지만, 그렇지 않은 경우는 헬기, Water Bag, 연계급수 집중 진압전술, 무선통신을 이용한 소방차 수위 자동전송 System 및 급수낭을 활용하고, 사찰 인근 소방서에 화재진압 장비(동력펌프, 호스, 노즐, 급수낭 등)를 적재한 일반 4륜구동 차량 배치와 A자 사다리를 활용한 진압대책 등이 필요한 것으로 나타났다.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2022년도 학술발표회
• /
• pp.458-458
• /
• 2022

It is essential to reduce global carbon emissions, mainly from energy use. The water supply and distribution sector is a vital part of human society and is one of the primary energy consumers. The procurement and distribution of water require electricity to operate the pump to deliver water to users with sufficient pressure. As the water users are spatially distributed over a wide area, the energy required to deliver water to each user differs depending on the corresponding supplying element (reservoir, tank, pipe, pump, and valve). This difference in energy required for each user also comes with a difference in pressure availability which affects the level of service for individual users and the whole network. Typically, there is a disproportion where users close to the source experience excessively high pressure with low energy consumption. In contrast, remote users need more energy to get the minimum pressure. This study proposes the Energy Return Index (ERI) to quantify the pressure return from particular energy consumption to supply water to each node. The disproportionality can be quantified and identified in the network using the proposed ERI. The index can be applied to optimize the network elements such as pump operation and tank location/size to reach a balanced energy consumption with the appropriate level of service.

• International Journal of Computer Science & Network Security
• /
• 제24권4호
• /
• pp.197-205
• /
• 2024

This paper presents a fully automated stand-alone irrigation system with GSM (Global System for Mobile Communication) module. Solar energy is utilized to power the system and it is aimed to conserve water by reducing water losses. The system is based on a DC water pump that draws energy from solar panels along with automated water flow control using a moisture sensor. It is also fitted with alert and protection system that consists of an ultrasonic sensor and GSM messages sender that transmits signals showing the levels of the water in the reservoir and the battery charge. The control system is designed to stop the water pump from pumping water either when the battery level drops to equal or less than 10% of its full charge, or when the water level becomes less than 10 cm high in the reservoir. The experimental results revealed that the system is appropriate to use in remote areas with water scarcity and away from the national grid.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2012년도 추계학술대회 논문집
• /
• pp.737-738
• /
• 2012

• 한국의학물리학회지:의학물리
• /
• 제14권1호
• /
• pp.51-53
• /
• 2003

The results of the measured specific activities of Rn-222 in water for public water supply pump houses (wells) of Ulaanbaatar City, Mongolia using the HP-Ge gamma-spectrometer, are described. The average of the specific radioactivies for the Rn-222 were for the station “Centre” 82.59 Bq/l, station “Combinat” 91.35 Bq/l and station “Makh” 158.25 Bq/l, respectively.

• Journal of Electrical Engineering and Technology
• /
• 제10권3호
• /
• pp.1304-1310
• /
• 2015

In remote islands, due to expense of existing generation systems, installation of photovoltaic cells (PVs) and wind turbines has a chance of reducing generation costs. However, in island power systems, even short-term power fluctuations change the frequency of grids because of their small inertia constant. In order to compensate power fluctuations, the authors proposed the power consumption control of pumps which send water to tanks. The power control doesn’t affect water users’ convenience as long as tanks hold water. Based on experimental characteristics of a pump system, this paper shows methods to determine reference power consumption of the system with compensation for short-term PV fluctuations while satisfying water demand. One method uses a PI controller and the other method calculates reference power consumption from water flow reference. Simulations with a PV and a pump system are carried out to find optimum parameters and to compare the methods. Results show that both PI control method and water flow calculation method are useful for satisfying the water demand constraint. The water demand constraint has a little impact to suppression of the short-term power fluctuation in this condition.

• 유공압시스템학회논문집
• /
• 제4권3호
• /
• pp.7-12
• /
• 2007

This paper presents an energy saving hydrostatic pressure exchanger for sea water desalination equipment. In a reverse osmosis(RO) system for desalinating sea water, more than 70 percent of the supplied sea water, brines which were impassable through RO membrane are bypassed, resulting in high energy losses. In this paper, a hydrostatic pressure exchanger consisting of an embedded water hydraulic piston motor and a water hydraulic piston pump was proposed and investigated in order to recover the energy of the bypassed brines. The pressurized brines are supplied to the embedded water hydraulic piston motor as power sources and the water hydraulic piston pump is driven by the output torque of the embedded water hydraulic piston motor as well as electric motor. Consequently, the energy of the bypassed brines can be recovered. To examine the electric energy saving characteristics of the hydrostatic pressure exchanger, a simulation model was constructed using commercial software and experiments were conducted. Through the results of simulation and experiment, the feasibility of the electric energy saving effect of the proposed hydrostatic pressure exchanger was investigated.