• Journal of Environmental Science International
• /
• v.20 no.5
• /
• pp.623-630
• /
• 2011

This study investigated the degradation of N, N-Dimethyl-4-nitrosoaniline (RNO, indicator of the generation of OH radical) by using dielectric barrier discharge (DBD) plasma. The DBD plasma reactor of this study consisted of a quartz dielectric tube, titanium discharge (inner) and ground (outer) electrode. The effect of shape (rod, spring and pipe) of ground electrode, diameter (9~30 mm) of ground electrode of spring shape and inside diameter (4~13 mm) of quartz tube, electrode diameter (1~4 mm), electrode materials (SUS, Ti, iron, Cu and W), height difference of discharge and ground electrode (1~15.5 cm) and gas flow rate (1~7 L/min) were evaluated. The experimental results showed that shape of ground electrode and materials of ground and discharge electrode were not influenced the RNO degradation. The thinner the diameter of discharge and ground electrode, the higher RNO degradation rate observed. The effect of height gap of discharge between ground electrode on RNO degradation was not high within the experimented value. Among the experimented parameters, inside diameter of quartz tube and gas flow rate were most important parameters which are influenced the decomposition of RNO. Optimum inside diameter of quartz tube and gas flow rate were 7 mm and 4 L/min, respectively.

• Journal of Environmental Science International
• /
• v.21 no.4
• /
• pp.479-488
• /
• 2012

A Dielectric barrier discharge (DBD) plasma is shown in the present investigation to be effective of phenol degradation in the aqueous solutions in batch reactor with continuous air bubbling. Removal of phenol and effects of various parameters on the removal efficiency in the aqueous solution with high-voltage streamer discharge plasma are studied. The effect of 1st voltage (80 ~ 220 V), air flow rate (3 ~ 7 L/min), pH (3 ~ 11), electric conductivity of solution (4.16 ${\mu}S$/cm, deionized water) ~ 16.57 mS/cm (addition of NaCl 10 g/L) and initial phenol concentration (2.5 ~ 20.0 mg/L) were investigated. The observed results showed that phenol degradation was higher in the basic solution than that of the acidic. The optimum values on the 1st voltage and air flow rate for phenol degradation were 140 V and 6 L/min, respectively. It was considered that absorbance variation of $UV_{254}$ of phenol solution can be use as an indirect indicator of change of the non-biodegradable organic compounds within the treated phenol solution. Electric conductivity was not influenced the phenol degradation. To obtain the removal efficiency of phenol and COD of phenol over 97 % (initial phenol concentration, 10.0 mg/L), 80 min and 120 min were need, respectively. Phenol and COD degradation showed a pseudo-first order kinetics.

• The Journal of Internal Korean Medicine
• /
• v.13 no.1
• /
• pp.143-155
• /
• 1992

The following results were obtained from the observation on the change of plasma cortisol concentration in the experiment of intravenous administration of Haengsoyeum Water Extract in the rabbit. And the effects of Haengsoyeum extract on the contractile force of the isolated guinea pig trachea smooth muscle. 1. In intravenous administration the plasma cortisol concentration increased significantly about 1 hours after with a does of 0.2 ml/kg. 2. In intravenous administration the plasma cortisol concentration increased significantly about from 1 to 3 hours after with a does of 0.4 ml/kg. 3. The contractile response of the trachea smooth muscle of isolated guinea pig to histamine $10^{-4}\;M$ was significantly inhibited by Haengsoyeum extract. 4. The contractile response of the trachea smooth muscle of isolated guinea pig to acetylcholine $10^{-4}\;M$ was considerably inhibited by Haengsoyeum extract. 5. The contractile response of the trachea smooth muscle of isolated guinea pig to 5-hydroxytryptamine $10^{-4}\;M$ was inhibited by Haengsoyeum extract.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.49 no.2
• /
• pp.126-135
• /
• 2013

This study was performed to have an effect on control the growth of algae such as "Actinastrum fluviatile" which occurs frequently in the aquaculture tank using by a cold plasma, and it also would be expected to promote the growth of water plants due to active element causing OH radicals in the water. In addition, it was verified on the death rate as 99.9% on the scale protrusion of "Aeromonas hydrophila" as well as E. coli, especially, under extreme conditions more than 100 million pathogenic bacterium in the aqua pet tank, the ornamental fish had to act in a safe and healthy environment at over 98% death rate within 48 hours. It has been proven to give no affect on aerobic bacteria that exist in the filter or soil because there was no residual toxicity in the water tank. As the results, it will help to develop and apply on the sterilization device in other industries as well as aquarium organisms due to adopted energy-saving algorithm and reliability in use.

• Proceedings of the KIEE Conference
• /
• 2005.07c
• /
• pp.2109-2111
• /
• 2005

The effect of arc like streamer discharge is investigated on the hydrogen generation in the plasma reactor with multineedle - plate electrode geometry and SDR (Plasma reactor using the surface discharge). An additive of the two type (the saw type and the pellet type) was placed under the water surface to investigate the effect of the water surface conditions. The experimental results are compared in case of the reactor with and without an additive on the water surface. The generation of arc streamer discharge is more powerful with increasing applied voltage in the saw type. The maximum hydrogen Production concentration is about 4300 ppm at 74W in the SDR with additive of the saw type. Also, the Energy yield of the SDR (28990 g/kWh, 4300ppm, 74W) is higher than of the multineedle - plate electrode geometry (20892g/kWh, 3300ppm, 77W).

• Analytical Science and Technology
• /
• v.13 no.4
• /
• pp.423-427
• /
• 2000

Total arsenic in drinking water such as spring, small water-supply system and mineral water was determined by inductively coupled plasma mass spectrometry. The contents of total arsenic were analyzed after acidification by nitric acid to become 1% in water samples. According to the results, total concentration of arsenic in drinking water was below 30ppb.

• Biomolecules & Therapeutics
• /
• v.18 no.3
• /
• pp.257-261
• /
• 2010

While it's been shown that arsenic impairs male reproductive function, it remains unclear whether the mechanism involves an effect on testosterone (T) production. We examined plasma T and luteinizing hormone (LH) levels in mice given water containing either 20 or 40 mg/L sodium arsenite (SA). The plasma T levels were lower in SA-treated mice than in controls and correlated well with testicular T levels within individuals. However, SA treatment did not significantly affect plasma LH levels. The ratio of plasma T to LH was reduced by the treatment with 40 mg/L SA. These results suggest arsenic-induced defect in testicular testosterone production in mice.

• YAKHAK HOEJI
• /
• v.44 no.3
• /
• pp.251-256
• /
• 2000

Sterically stabilized liposomes (SSL) composed of distearoylphosphatidylcholine, cholesterol, dicetylphosphate and distearoylphosphatiodylethanolamine-N-poly(ethyleneglycol) 2000 (DSPE-PEG 2000) were made by reverse phase evaporation method to prolong biological half-life and decrease toxic side effect of drug. Streptozocin (572), a water-soluble antitumor agent with short half-life, was selected as a model drug. The size of SSL was controlled by polycarbonate extrusion to 100 nm which is adequate size for long circulation in plasma. The release rate of drugs from SSL in PBS was evaluated. And the stability of STZ-containing liposomes against drug leakage into rat plasma was evaluated in order to investigate the interaction of liposome and plasma protein. Incorporation of DSPE-PEG 2000 into conventional liposomes significantly decreased the drug leakage into rat plasma.

• Proceedings of the KSME Conference
• /
• 2008.11a
• /
• pp.1582-1584
• /
• 2008

This paper reports a simple fabrication method for creating the superhydrophobic polymer surface using a plasma etching. Generally, it is necessary for the superhydrophobic surfaces to have a rough structure on surface with the composition of the low surface energy. In this study, Poly(methyl methacrylate) (PMMA), poly(ethylene terephthalate) (PET), acrylonitrile butadiene styrene (ABS) with superhydrophobic surface were fabricated using $O_2$ plasma etching and vapor deposition with the fluoroalkylsilane self-assembled monolayers. The plasma treated polymer surfaces are covered with the nano-pillar shaped structures after treatment for $1{\sim}2min$. And these samples with FOTS SAMs coating are showed the superhydrophobicity having the water contact angle of around $150^{\circ}$ and sometimes around $180^{\circ}$ depending on the treatment time. Furthermore the nanostructured polymer is transparent for the visible light.

• Textile Coloration and Finishing
• /
• v.18 no.1
• /
• pp.20-27
• /
• 2006

On the purpose of surface modifications of polypropylene meltblown(PPMB) nonwovens, PPMB nonwovens were treated in the plasma system by oxygen atmosphere with different treatment time and discharge power. Dimensional change and physical properties of the treated nonwovens were evaluated. Contact angles onto PPMB nonwovens about water and methyleneiodide were measured and surface energies were calculated by Owen's method. As the results, microcraters were observed on the surface of treated nonwovens. Tenacity and breaking strain of PPMB nonwovens decreased with increasing treatment time and discharge power. Surface energy of PPMB nonwovens increased by plasma treatment. Meanwhile, the friction static voltage and dyeability of PPMB nonwovens have enhanced to some extent by oxygen plasma treatment due to the improvement of surface hydrophilicity.