• Journal of Pharmaceutical Investigation
• /
• v.31 no.4
• /
• pp.217-224
• /
• 2001

To develop a novel transdermal delivery system of loxoprofen (LP), a potent antiinflammatory and analgesic agent, the effects of various vehicles and penetration enhancers on the skin permeation of LP from solution formulations were investigated. The permeation rate of LP through excised guinea pig skin was measured using a side-by-side permeation system at $32^{\circ}C$. The solubilities of LP in various vehicles were determined by the equilibrium solubility method, and partition coefficients $(P_c)$ were determined. The solubility of LP increased in the rank order of water & isopropyl myristate (IPM) & glyceryl dicaprylate/dicaprate & propylene glycol dicaprylate/caprate & propylene glycol laurate (PGL) & polyethylene glycol 400 & diethylene glycol monoethyl ether (DGME) & ethanol. n-Octanol-water $P_c$ value was 15.5. Among pure vehicles tested, IPM and PGL showed highest fluxes of $89.9{\pm}5.0$ and $45.4{\pm}0.3\;{\mu}g/cm^2/hr$ from saturated solutions, respectively. However, it was not possible to demonstrate any correlation between the solubility of LP and its permeation rate, indicating the change in the barrier property of the skin and/or carrier mechanisms by vehicles tested. The addition of DGME to IPM or PGL markedly increased the solubility of LP, but the permeation rate did not decrease when the concentration of DGME in the cosolvent was increased upto 40%. The addition of linoleic acid (3%) in the cosolvent slightly increased the permeation rate, but others such as lauroyl sarcosine, fatty alcohols and fatty acids tested did not show enhancing effect. In conclusion, the DGME-IPM or DGME-PGL cosolvent system proved to be a good vehicle to enhance the skin permeation of LP.

• Journal of the Korean Applied Science and Technology
• /
• v.25 no.2
• /
• pp.123-129
• /
• 2008

Transdermal therapeutic system(TTS) is often used as the method of drug dosage into the epidermic skin. Natural polymer were selected as ointment material of TTS. We investigated the permeation of natural polymer ointment containing drug in rat skin using horizontal membrane cell model. Permeation properties of materials were investigated for water-soluble drug such as Nicotinic acid N-oxide in vitro. These results showed that skin permeation rate of drug across the composite was mainly dependent on the property of ointment base and drug. Proper selection of the polymeric materials which resemble and enhance properties of the delivering drug was found to be important in controlling the skin permeation rate. This result suggests a possible use of natural polymer ointment base as TTS of antihyperlipoproteinemic agent.

• Clean Technology
• /
• v.5 no.2
• /
• pp.69-78
• /
• 1999

Separation characteristics of cutting oil-in-water emulsions were studied experimentally by using various kinds of flat-type microfiltration and ultrafiltration membranes. For ultrafiltration membranes the permeation behavior of cutting oil emulsions obeys the film model, whereas a significant deviation from the model was observed for ASYPOR microfiltration membranes. The experimental data obtained for all the membranes showed that the effect of operating pressure on the permeation flux of oil-in-water emulsions is not very significant. At low transmembrane pressures the permeation flux decreased gradually with increasing filtration time, whereas the permeation flux at high transmembrane pressures decreased steeply for early filtration time. However, every flux eventually reached a constant value that depends only on the applied transmembrane pressure. For the hydrophobic polycarbonate microfiltration membrane the permeation flux increased with the filtration time. The critical permeation pressures were also determined from the data obtained from unstirred cell experiments.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.450-450
• /
• 2012

In recent days, advances in ZnO-based oxide semiconductor materials have accelerated the development of thin-film transistors (TFTs), which are the building blocks for active matrix flat-panel displays including liquid crystal displays (LCD) and organic light-emitting diodes (OLED). In particular, the development of high-mobility ZnO-based channel materials has been proven invaluable; thus, there have been many reports of high-performance TFTs with oxide semiconductor channels such as ZnO, InZnO (IZO), ZnSnO (ZTO), and InGaZnO (IGZO). The reliability of oxide TFTs can be improved by examining more stable oxide channel materials. In the present study, we investigated the effects of an ALD-deposited water vapor permeation barrier on the stability of ZnO and HfZnO (HZO) thin film transistors. The device without the water vapor barrier films showed a large turn-on voltage shift under negative bias temperature stress. On the other hand, the suitably protected device with the lowest water vapor transmission rate showed a dramatically improved device performance. As the value of the water vapor transmission rate of the barrier films was decreased, the turn-on voltage instability reduced. The results suggest that water vapor related traps are strongly related to the instability of ZnO and HfZnO TFTs and that a proper combination of water vapor permeation barriers plays an important role in suppressing the device instability.

• Applied Chemistry for Engineering
• /
• v.10 no.6
• /
• pp.954-959
• /
• 1999

Radiation-induced grafting of 2-hydroxyethyl methacrylate(HEMA), acrylic acid(AAc) and methacrylic acid(MAAc) onto polypropylene microfiltration membrane has been studied. The effect of grafting conditions such as solvent composition(MeOH and $H_2O$) and monomer concentration on the grafting yield in investigated. The highest degree of grafting is obtained at a solvent composition of 25% $H_2O$:75% MeOH for HEMA, pure water for AAc and 50% $H_2O$:50% MeOH for MAAc. Modification of the PP membranes with hydrophilic monomers is shown to cause an increase in the water permeation flux of the membranes. It is found that HEMA is the best monomer to increase the water permeation flux and the highest water permeation flux is obtained at 99% degree of grafting. The water permeation flux of AAc-grafted PP membrane and MAAc-grafted PP membrane is very sensitive to environmental pH and $Cu^{2+}$ ion, but the water permeation flux of HEMA-grafted PP membrane scarcely depends on pH and $Cu^{2+}$ ion.

• Journal of Pharmaceutical Investigation
• /
• v.37 no.5
• /
• pp.311-314
• /
• 2007

Paclitaxel (PTX) is an antineoplastic agent approved for the treatment of ovarian and breast carcinomas. However, the use of paclitaxel as an anticancer drug is limited by its extremely poor water solubility (below $0.3\;{\mu}g/mL$). Furthermore, it has very low bioavailability when administered orally because paclitaxel is a substrate of P-glycoprotein (P-gp) efflux pump. In this study, buccal delivery of PTX was investigated as one of the alternatives for PTX delivery. Ethanol and glyceryl monooleate (GMO) were selected as permeation enhancing agents to increase solubility and permeation across buccal mucosa of PTX. At the different concentrations of ethanol solution ($30{\sim}70\;w/w\;%$), PTX permeation was studied, followed effects of GMO in the concentration range of $2.5{\sim}25%$ with ethanol vesicle. The transbuccal ability of PTX was evaluated in vitro using Franz diffusion cells mounted with rabbit buccal mucosa. As a result, incorporation of PTX into ethanol vesicle with GMO significantly enhanced the PTX permeation in rabbit buccal mucosa. Particularly, the mixtures of ethanol:water:GMO at the ratio of 50:47.5:2.5 showed the most excellent enhancing ability. The results showed a promising possibility for buccal delivery of PTX.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07a
• /
• pp.589-593
• /
• 2005

It is well known that proper encapsulation is crucial for the lifetime of organic light emitting diode (OLED) displays. With the development of increasingly better barrier coatings and perimeter seals, it has now become very desirable to be able to precisely measure the rate of water vapor and oxygen permeation through barrier coatings and perimeter sealing. This paper demonstrates a new permeation measurement method that uses tritium-containing water (HTO) as a tracer material. The theoretical detection limit of this direct method is $2.4{\times}10^{-8}g/(m^2day)$.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.12 no.6
• /
• pp.599-608
• /
• 2000

One dimensional numerical modeling was carried out for the melting behavior of dry snow and the unsaturated flow when heat was supplied from the bottom surface. Discrepancy between the previous experimental data and the present numerical results is substantially reduced by considering the density change of water permeation layer due to the infiltration of meltwater. In the parametric study for effective thermal conductivity, it was found that the effect of this parameter to the behavior of snow melting is minor. Sensitivity analysis showed that the melting time is most sensitive to changes in supplied heat flux, snow temperature, and bulk density, whereas snow bulk density and residual saturation have a significant effect on the height of water permeation layer in snow.

• Membrane Journal
• /
• v.10 no.3
• /
• pp.121-129
• /
• 2000

The membrane requires both high in selectivity and flux. However, the permselective membrane has low flux. In this study, the porous alumina membrane was coated with silane coupling agent in order to enhance the flux with proper selectivity. The contact angle of water to the surface-modified alumina membrane was greater than 90$^{\circ}$, which indicated the high hydrophobicity. The modified membrane was tested in vapor permeation for the concentration of aqueous ethanol, isopropanol, and n-butanol. With the increase of ethanol, isopropanol, butanol concentration in the feed, permeation flux increased due to the greater affinity of ethanol, isopropanol, butanol with surface-modified alumina membrane than that of water. The experimental results showed that the permeation tate of surface-modified alumina membrane was 20~1000 times greater than that of a polymer membranes.

• Membrane Journal
• /
• v.24 no.5
• /
• pp.393-399
• /
• 2014

The permeation experiments were carried out to examine the separation characteristics of the modules which were piled up the disc-ring shape patterned membranes in this study. First of all, permeability of the pure water was measured for the self-made 5 shape disc filters, and varied from 0.25 to $2.24L/m^2{\cdot}hr{\cdot}bar$. The module showed the maximum pure water permeability was the maximum permeation flux, and the module showed the minimum pure water permeability was the minimum permeation flux for 0.1 wt% kaolin solution. However, all of the modules were not proportioned to the pure water permeability. Also, the backwashing was performed periodically for the module 1 in order to operate with 0.1 wt% kaolin solution for a long time. The most efficient operating condition was the 8 minute permeation and 2 minute backwashing cycle.