• 대한기계학회논문집
• /
• 제16권1호
• /
• pp.180-188
• /
• 1992

본 연구에서는 와류실식 디젤 기관에 경유-물의 유화연료 사용시 시관의 회전 속도(1500rpm)가 일정인 경우 물의 첨가량(체적비, 0~20%)과 기관의 부하(BMEP,2.1~ 7.5kg/$\textrm{cm}^2$)변화에 따른 연소실내 압력, 압력상승률 및 열발생률, 착화지연 기간, 연료 소비율 등의 연소특성과 CO, HC, NOx 및 매연의 배출능도 등 유해 배출 가스에 미치는 영향에 관하여 실험적으로 구한 것이다.

• 한국식품영양학회지
• /
• 제9권3호
• /
• pp.325-330
• /
• 1996

Foaming capacity (FC) and stability (FS) of protein recovered from red crab (Chitinonecetes opilio) processing in water and soybean protein isolate were determined at pH 2.0~10.0 in water and NaCl solution. The FC values for both proteins showed the lowest values at the isoelectric point (pH 4.0) and increased nth an increase in pH above the isoelectric point. FC of RCP was higher than that of SPI at pH 10.0 in water and both NaCl solutions. FC of SPI increased with an increase in NaCl concentration at pH 4.0 and 6.0, but FC of RCP was not affected. The highest FS values for both proteins were obtained at pH 4.0 in water. At pH 2.0, FC of RCP decreased with NaCl concentration increase, but FS increased. NaCl concentration had little effect on FS of RCP at pH 4.0 and 6.0, but the FS decreased at pH 10.0. FS of SPI was similar to that of RCP at pH 2.0 and increased with NaCl concentration Increase from 0.1 to 0.5M NaCl at pH 10.0.

• Bulletin of the Korean Chemical Society
• /
• 제34권3호
• /
• pp.801-809
• /
• 2013

We investigate sensitivity and limit of detection (LOD) of trace copper (Cu) metal using pristine carbon nanotube (CNT) and acidified CNT (ACNT) electrodes. Squarewave based anodic stripping voltammetry (SWASV) is used to determine the stripped Cu concentration. Prior to performing the SWASV measurements, its optimal conditions are determined and with that, effects of potential scan rate and $Cu^{2+}$ concentration on stripping current are evaluated. The measurements indicate that (1) ACNT electrode shows better results than CNT electrode and (2) stripping is controlled by surface reaction. In the given $Cu^{2+}$ concentration range of 25-150 ppb, peak stripping current has linearity with $Cu^{2+}$ concentration. Quantitatively, sensitivity and LOD of Cu in ACNT electrode are 9.36 ${\mu}A\;{\mu}M^{-1}$ and 3 ppb, while their values are 3.99 ${\mu}A\;{\mu}M^{-1}$ and 3 ppb with CNT electrode. We evaluate the effect of three different water solutions (deionized water, tap water and river water) on stripping current and the confirm types of water don't affect the sensitivity of Cu. It turns out by optical inspection and cyclic voltammetry that superiority of ACNT electrode to CNT electrode is attributed to exfoliation of CNT bundles and improved interfacial adhesion occurring during oxidation of CNTs.

• Journal of Advanced Marine Engineering and Technology
• /
• 제38권10호
• /
• pp.1200-1205
• /
• 2014

The effect of nanofluids on the heat transfer performance of a pulsating heat pipe has been experimentally investigated. Water-based diamond nanofluid and aluminium oxide ($Al_2O_3$) nanofluid were tested in the concentration range of 0.5-5%. The pulsating heat pipe was constructed using clear Pyrex tubes of 1.85 mm in inner diameter in order to visualize the pulsating action. The total number of turns was eight each for heated and cooled parts. The supply temperatures of heating water and cooling water were fixed at $80^{\circ}C$ and $25^{\circ}C$ respectively. The liquid charging ratio of the nanofluid was 50-70%. The test results showed that the case of 5% concentration of diamond nanofluid showed 18% increase in heat transfer rate compared to pure water. The case of 0.5% concentration of $Al_2O_3$ nanofluid showed 24% increase in heat transfer rate compared to pure water. But the increase of $Al_2O_3$ nanofluid concentration up to 3% did not show further enhancement in heat transfer. It is also observed that the deposited nanoparticles on the tube wall played a major role in enhanced evaporation of working fluid and this could be the reason for the enhancement of heat transfer by a nanofluid, not the enhanced thermal conductivity of the nanofluid.

• 한국물환경학회지
• /
• 제29권5호
• /
• pp.618-624
• /
• 2013

This study was conducted to suggest the concentration distribution of organic matters in 348 tributaries of Nakdong River, and to review the validity of the conversion of organic matter indexes. The average concentration of organic matters in the tributaries was TOC 2.4 mgC/L, DOC 2.1 mgC/L, COD 1.0 mgC/L, respectively. DOC ratio to TOC is 87% and COD ratio is 44%. First tributaries shows higher organic pollution than second tributaries. The correlation between TOC and COD was relatively high as 0.796 (p < 0.01, n = 670). Based upon these results, a regression analysis was conducted. The results showed that TOC concentration was 2.5 times higher than COD concentration. In conclusion, it is appropriate to use TOC for the management of all organic matters. Furthermore, there is a need to build organic matter-related Databases for more rivers so as to establish TOC standards and manage the water quality.

• Environmental Engineering Research
• /
• 제17권2호
• /
• pp.95-102
• /
• 2012

To evaluate the effect of the 4 major rivers restoration project in the Nakdong River to water quality of the river, the Environmental Fluid Dynamics Code (EFDC) and Water Quality Analysis Simulation Program (WASP), are applied in series. Results showed overall decrease in biochemical oxygen demand ($BOD_5$) concentrations and increase in chlorophyll-a concentrations, while total nitrogen and total phosphorous concentrations did not show significant changes, relatively. Decrease in $BOD_5$ concentrations seems to be influenced by an increased hydraulic residence time, which may allow more time for the degradation of organic material. Changes in Chlorophyll-a (Chl-a) concentration, due to the project were more significant for the upper stream areas that show relatively low Chl-a concentration ranges (less than 20 g/L). After the introduction of the Geumho River in the middle part of the Nakdong River, rapid growth of phytoplankton was observed. However, in this middle part of the Nakdong River, the ratio of Chl-a concentration change are less significant, compared to the upper stream areas, due to the project. In the lower stream area, Chl-a concentration decreased after the project. This seems to be resulted from the decreased light availability, due to increased depth, while the nutrient concentrations have been high enough to support phytoplankton growth.

• 한국식생활문화학회지
• /
• 제32권6호
• /
• pp.583-588
• /
• 2017

This study examined the antioxidant and neuronal cell protective effects of the water and methanol extracts of Eugenia caryophyllata Thunb. The total polyphenol content was significantly higher in the methanol extract than in the water extract. The DPPH radical scavenging activity in the water extract was similar to Vit. C at a concentration of $100{\sim}200{\mu}g/mL$. The ABTS radical scavenging activity in the water and methanol extract was similar to Vit. C at a concentration of $800{\sim}1,000{\mu}g/mL$. The superoxide dismutase (SOD)-like activity in the methanol extract was similar to Vit. C at a concentration of $800{\sim}1,000{\mu}g/mL$. The DPPH, ABTS radical scavenging and (SOD)-like activity increased with increasing extract concentration. In a cell viability using MTT, the water extract (50 and 100 ppm) and methanol extract (100 ppm) had a protective effect against $H_2O_2$-induced neurotoxicity.The result ssuggest that the extract of E. caryophyllata Thunb. has antioxidant activities and may be useful for treating neurodegenerative disorders.

• 한국환경과학회지
• /
• 제7권2호
• /
• pp.217-222
• /
• 1998

Organics matters including algae are the major contaminants of Nak-dong river and it's concentration Is more Increasing now. The use of coagulants has been Incresed for the effective treatment of drinking water, and aluminum coagulants have been the most widely used in raw water treatment. However, when inorganic metal coagulant is excessively used for long period, it would result in secondary problems, such as increasing sludge production, enhancing the cost of water treatment process, and increasing concentration of residual metal, especially aluminum. Therefore, recently. in order to reduce the use of metal coagulant and enhance the coagulation effectiveness, several alternative coagulants, such as polymeric Inorganic coagulants and organic polymers, have been used In water treatment plants. The objectives of thins research were (11 to determine optimum dosage concentration and compare the coajuiation efnciency at various pH ranees with alum alone, alum+cationic polymer, and alum+anlonlc polymer, (21 to evaluate the amount of alum reduced by using organic polymer, (31 to maximize removal officiency of organic matter and minimize the concentration of residual aluminum.

• 상하수도학회지
• /
• 제33권3호
• /
• pp.225-234
• /
• 2019

This study is focused on effects of factors that affect the formation of THMs during chlorination in drinking water treatment. During the chlorination, chlorine consumption is increased by increasing the initial chlorine dose, the pH and the total dissolved solid (TDS) concentration. Also THMs formation is increased up to $58.82{\mu}g/L$ and $55.54{\mu}g/L$ by increasing initial chlorine concentration and increasing pH. However, concentration of chloroform is decreased by increasing TDS concentration. This is caused the cation($Na^+$) of the total dissolved solids preferentially reacts with the functional groups of the organic material which influence the trihalomethane formation. But total trihalomethane formation is increased up to $127.46{\mu}g/L$ by $Br^-$ contained in the total dissolved solids. DOC reduction was not influenced by any of the factors.

• Membrane and Water Treatment
• /
• 제10권5호
• /
• pp.361-372
• /
• 2019

Effect of different alkane based solvents on the stability of emulsion liquid membrane was investigated using normal alkanes (n-hexane, n-heptane, n-octane and n-decane) under various operating parameters of surfactant concentration, emulsification time, internal phase concentration, volume ratio of internal phase to organic phase, volume ratio of emulsion phase to external phase and stirring speed. Results of stability revealed that emulsion liquid membrane containing n-octane as solvent and span-80 (5 % (w/w)) as emulsifying agent presented the highest amount of emulsion stability (the lowest breakage) compared with other solvents; however, operating parameters (surfactant concentration (5% (w/w)), emulsification time (6 min), internal phase concentration (0.05 M), volume ratio of internal phase to organic phase (1/1), volume ratio of emulsion phase to external phase (1/5) and stirring speed (300 rpm)) were also influential on improving the stability (about 0.2% breakage) and on achieving the most stable emulsion. The membrane with the highest stability was employed to extract acridine orange with various concentrations (10, 20 and 40 ppm) from water. The emulsion liquid membrane prepared with n-octane as the best solvent almost removed 99.5% of acridine orange from water. Also, the prepared liquid membrane eliminated completely (100%) other cationic dyes (methylene blue, methyl violet and crystal violet) from water demonstrating the efficacy of prepared emulsion liquid membrane in treatment of dye polluted waters.