• Nuclear Engineering and Technology
• /
• v.21 no.2
• /
• pp.63-72
• /
• 1989

An analysis for the gamma radiation fields in the research reactor MAPLE-X10 facility has been peformed under the assumption of partial loss of reactor and service pool water to assess the safety from the view point of design. Four photon source terms considered in the analysis were calculated using the ORIGEN-S code. Gamma dose rate calculations over the reactor and service pools during the water-loss accident conditions were performed using QAD-CG code. MCNP code (Monte Carlo Neuron and Photon Transport code), also, was used to assess the scattered radiation fields away from the pools, which is appropriate for calculating the scattered photon dose rates outside of the solid angle subtended by the source and pool walls.

• Journal of the Korean Applied Science and Technology
• /
• v.28 no.3
• /
• pp.374-378
• /
• 2011

The studied results of the gasohol, which is the mixture of gasoline and ethanol, were investigated for the promotion of applications on commercially by gasoline vehicle referring to octane number, minimum water contents be involved, and separation inhibitors for protecting phase separation etc. especially for the E10 and E20. The results showed that octane number will be revised by higher value as the ethanol is added more, and it's more effect in case of be added as a mixture than individually when inhibition agents is added for the inhibition of separation. and it's reasonable for the water contents of less than 1% by comparing with experimental results and in view of regulations of various countries.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.4 no.4
• /
• pp.332-341
• /
• 1992

An absorption heat pump cycle has been modeled and simulated to analyze the system performance of water-cooled, series-flow, double-effect absorption heat pump, which can be applied to a direct gas fired cooling system with the medium range of cooling capacity (15RT level). Effect of absorption cooling system parameters, such as concentration difference, inlet temperature of cooling water, 1st generator temperature, leaving temperature differences of condenser and evaporator and efficiency of solution heat exchanger, has been investigated in the view of system cooling performance.

• 유체기계공업학회:학술대회논문집
• /
• 2005.12a
• /
• pp.735-741
• /
• 2005

We have studied the prearranged plan and the economy of a candidate site for the development of small hydro power. And also we have confirmed its economy by suggesting the technology of the unmanned operation and the selection of the water turbine generator which has a great efficiency, working rate and suitability to the topographical characteristics of various development sites, for example, irrigation reservoirs, water works pipes, sewage systems and cooling water of a steam power station. We proposed some opinions such as the better improvement of small hydropower industry the people' view, cooperation among industry/university/ research institutes, remote control/maintenance and goverment's legislature and supporting system etc.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.6 no.2
• /
• pp.93-102
• /
• 1994

It is the goal of this study to provide the essential data for design and operation of optimum water supply system. Experimental and theoretical analyses have been conducted for various parameters, for example, volume and air percent of pressurizing tank, pump speed and pressure range inside tank, etc. Pressure inside tank with time, flow rate, energy consumption rate and pump operation time have been obtained for design and operating parameters to optimize the components and to establish the operating method of system, and therefore to contribute to the development of technology from a point of view of the improvement of quality, the enhancement of system efficiency and the reduction of construction cost.

• Proceedings of the KIEE Conference
• /
• 2003.07b
• /
• pp.762-764
• /
• 2003

In Korea, over 97% of local energy demand is imported from other countries. And we have to lift the energy independence level up to 5% with replacement energy (renewable energy) such as solar, small hydropower, etc. by 2011 according to the energy agreement made in Kyoto Protocol. So, we proposed some opinions such as the better improvement of small hydropower industry the people' view, cooperation among industry/university/research institutes, remote control/maintenance and goverment's legislature and supporting system etc.

• Journal of the Society of Naval Architects of Korea
• /
• v.54 no.1
• /
• pp.34-42
• /
• 2017

In rough seas, green water shipped on board may impose quite large impact loads on the structures on deck and sometimes result in structure damages. One of the essential tasks of the naval fluid engineers is to provide the design impact loads which are needed for proper design of the structure strength against the green water impacts. Computation of the design impact load due to green water needs first a process to find the sea condition and the ship cruising condition which cause maximum green water impacts on structures as well as other succeeding processes to compute ship motion responses, green water flows and impact loads. Also, as a bold and practical process, it is needed that the irregular real seas are to be substituted by design regular waves which are equivalent in view points of green water impacts. In this paper, the whole processes to compute the design green water loads acting on bow structure are set up creatively. And the green water design impact loads acting on the box-type structure of a high-speed ship's bow are computed and discussed.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.121-125
• /
• 2009

There have been many developed systems for harnessing the solar energy such as solar water heaters, solar thermal power systems, PV systems, daylighting and solar hydrogen systems. all of them are capable of reducing $CO_2$ emission. However, the efficiency of those systems which work without a solar tracker is lower. This paper is a step by step procedure for fabrication and a performance test of a solar tracking system. The system developed in this study consists of motion controllers, motor drives, step-motors, feedback devices and application. CdS sensors are introduced into the solar tracking system for playing a primary role in poor conditions for tracking due to a gear backlash and a strong wind. Mini-dish was used as a concentrator for collecting sun light. The solar position data, in terms of azimuth and elevation, sunrise and sunset times was compared with those of KASI(Korea Astronomy & Space Science Institute). The results presented in this article provide the high accuracy of the present system in solar tracking and indicate a potential for energy savings.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2004.05b
• /
• pp.1267-1270
• /
• 2004

DEM(Digital Elevation Model)을 활용한 기술이 수자원분야에서 필수적인 GIS 활용기술인 이유는 DEM을 이용할 경우 유역의 수문학적 지형특성인자를 객관적인 방법으로 추출할 수 있고 이를 활용하여 분포형 수문모형을 개발, 적용할 수 있기 때문이다. 국내에서도 GIS를 이용하여 수문모형의 입력인자를 추출한 다든가 분포형 수문모형에 대한 연구를 수행할 경우 DEM을 활용한 연구를 수행하고 있다. 이러한 것은 GIS S/W인 Arc/Info, ArcView, WMS 등에서 DEM을 활용하여 수문학적인 유역분석 기능을 제공해 주기 때문에 가능하다. 즉, DEM을 이용하여 하천망을 추출하고, 유역을 분한하고 이를 이용하여 유역 Boundary 내에서의 지형특성인자를 추출하는 기능을 말한다 본 연구는 수자원분야에서 GIS를 활용할 때 필요한 필수기능인 DEM의 활용기술을 순수 국내기술로 개발하였다. DEM활용에 대한 최신 알고리즘을 검토하여 국내 기술로 개발된 GIS Engine인 GEOMaina v.3.0을 이용하여 수문학적인 DEM 활용 Module을 개발하였으며 HyGIS(Hydrologic Geography Information System)라 명하였다. 본 연구에서는 개발된 HyGIS를 이용하여 수문학적 지형특성인자를 추출하고 기존에 사용되어오던 GIS S/W와 비교 검토하여 HyGIS의 환용 가능성에 대하여 검토하고자 한다.

• Journal of Korea Water Resources Association
• /
• v.37 no.4
• /
• pp.329-339
• /
• 2004

The main objective of this study is to develop a GIS-based two-dimensional model for the simulation of rainfall-runoff process and overland flow of a watershed. The tasks of this study are summarized: to develop a two-dimensional model for overland flow and to construct a rainfall-runoff simulation system linked with GIS. The mathematical formulation of the model incorporates four parts: spatially varied rainfall, spatially distributed infiltration, 1-directional, 4-directional and 8-directional overland flow routing scheme, and one-dimensional channel routing scheme. For the development of stochastic model, Monte Carlo simulation method has been directly integrated into the model. GIS using Arc/Info and ArcView has been applied to prepare the model input data(elevation, soil type, rainfall data, etc.) for a simulation and to demonstrate the simulation results.