• Resources Recycling
• /
• v.29 no.6
• /
• pp.57-64
• /
• 2020

In this study, removal of OCA and organic impurities for recycling LCD touch panel glass was conducted by mechanical and chemical dissolution methode. Cut mill and oscillation mill were used for mechanical crushing of touch panel, and water, ethanol, dichloromethane were used to remove OCA and organic impurities. As a result of TGA, when applied only dicloromethane in the process, the efficiency of organic removal was to be best. In addition, removal effect of organic impurities increased as the cleaning temperature increased. As a result of zeta potential analysis to confirm the dispersion degree of touch panel glass in the solvent, the absolute value of the zeta potenial of water with the lowest cleaning effect was lower than other solvents, and it was confirmed that efficiency of organic removal is affected not only by the chemical dissolution properties but also the physical dispersion properties in the solvent.

• Journal of Korean Society of Water and Wastewater
• /
• v.7 no.2
• /
• pp.9-23
• /
• 1993

Emission of hazardous and volatile organic chemicals from solid waste landfill site was become to important issue because of environmental pollution and health risk by such chemicals. Laboratory batch and continuous experiments were conducted respectively to elucidate isothermal sorption behaviors and transport phenomena(by gas through unsaturated solid waste layer) in wet solid waste-gas system. Source separated and size reduced refuse(bulky waste) and incinerated ash were used after controlling water content, and trichloroethylene(TCE) was chosen among many such chemicals because of it's generality among those man-created pollutants. Isothermal TCE sorption equilibria wet solid waste-gas system can be described in linear equation and partition coefficient in this system can be estimated approximately by the simple equation derived from schematic structure of the system. Transport equation modified by instantaneous equilibrium sorption fraction and kinetic sorption rate(overall mass transfer capacity coefficient) simulated well the column experiment results.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.11
• /
• pp.2675-2679
• /
• 2009

This paper reports the example of headspace mulberry paper bag micro solid phase extraction (HS-MPB-$\mu$-SPE) as a new sampling method for the determination of volatile flavor composition of coriander seeds. Adsorption efficiencies between two configurations of mulberry paper bag were compared, and several parameters affecting the HS-MPB-$\mu$-SPE were investigated and optimized. The optimized technique uses an adsorbent (Tenax TA, 0.1 mg) contained in a mulberry paper bag of front configuration where fine surface was outside, and minimal amount of organic solvent (0.6 mL). Linalool and $\gamma$-terpinene were found as abundant flavor compounds from coriander seeds. The limit of detection (LOD) and the limit of quantitation (LOQ) for linalool of major flavor in coriander seeds were 10.3 ng/mL and 34.4 ng/mL, respectively. The proposed method showed good reproducibility and good recovery. The HS-MPB-$\mu$-SPE is very simple to use, inexpensive, requires small sample amounts and solvent consumption. Because the solvent for extraction is reduced to only a very small volume, there is minimal waste or exposure to toxic organic solvent and no further concentration step.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1992.04a
• /
• pp.11-28
• /
• 1992

In this paper we will first give a short overview of the more recent developments in MF, UF and RO. This is followed by a closer look on newer technologies applied in environmental problems. The applications looked an are the recovery of organic components from solvent laden gas streams and the separation of organic volatiles from aqueous waste waters via pervaporation. Technical solutions, the advantages and disadvantages of the processes and, where possible, cost estimations will be presented.

• Analytical Science and Technology
• /
• v.24 no.5
• /
• pp.395-400
• /
• 2011

This study has been carried out in order to effectively manage three groups of unregulated hazardous organic substances (PCDD/DFs, PAHs, PCBs) in South Korea. The investigated substances have been analyzed according to the test methods for hazardous substances in specified wastes provided by the National Institute of Environmental Research, Korea. Total contents of the organic compounds have been determined for hazardous wastes from three major industrial categories (paint, iron removal, steelmaking), such as waste organic solvent, waste paint or dust. By investigating the waste samples for 7 PAHs using GC/MSD, Naphthalene has been detected (N.D~1631.33 mg/kg). The highest Naphthalene concentration, which exceeded the korean marine dumping waste standard, was found in waste organic solvents and waste paints. Although a content analysis of 7 PCB isomers has been conducted, none of these compounds was detected. The analysis of PCDD/DFs has revealed that all samples meet the criterion for low POP content defined in the technical guidelines developed under the Basel Convention. The PCDD/DFs content in dust samples deriving from 10 manufacturing processes (billet, bloom) was determined to be in the range of N.D~5.66 ng I-TEQ/g waste.

• Journal of Environmental Science International
• /
• v.23 no.1
• /
• pp.89-96
• /
• 2014

Styela clava tunic is generated in large amounts as a waste from S. clava processing plants and causes environmental problem. Although biological activities of S. clava were reported by many investigators, study on S. clava tunic was little. In this study, therefore, tyrosinase inhibition and antioxidative activities of extracts from S. clava tunic using different solvent were investigated for recycling of the fishery waste. Among extraction methods tested, autoclaved extraction (25.7%) and hot water extraction (18.2%) appeared to be effective for extraction. The highest total phenolic content was 46.6 mg/g in autoclaved extract while the highest flavonoid content was 23.0 mg/g in chloroform extract. All extracts possessed tyrosinase inhibition activity and the inhibition activity was concentration-dependent. Inhibition concentration ($IC_{50}$) against tyrosinase activity was $0.36{\times}10^4$ mg/ml in ethanol extract, $0.11{\times}10^3$ mg/ml in acetone extract and 0.27 mg/ml in n-butanol extract. Among extracts tested, hot water and autoclaved extracts displayed higher antioxidative activity than organic solvent extracts. Therefore, our data suggest that extract from S. clava tunic may potential candidate for cosmetic product with whitening effect and medicine for diseases caused by various oxidative stresses.

• Korean Journal of Soil Science and Fertilizer
• /
• v.50 no.6
• /
• pp.606-614
• /
• 2017

Amount of food waste has been increased annually in Korea and re-use of food waste as a fertilizer or soil amendment in agricultural field has been studied. Therefore, main purpose of this research was to determine optimum condition of hydrolysis for food waste management. Three different solvents, HCl, $H_2SO_4$, and KOH, were used and varied concentration at the range of 10~30% and hydrolysis time at the range of 1~3 hours were evaluated. In general, reduction rate of food waste was increased when concentration of solvent and hydrolysis time was increased except when KOH was used. Among different solvents, concentration, and hydrolysis time, the highest reduction rate (97.79%) was observed when 30% of HCl was used with temperature of $140^{\circ}C$ at 2 hours of hydrolysis time. In addition, neutralization effect of alkalic materials, shell waste (SW) and egg shell (ES) was evaluated. Both SW and ES increased pH of finished acid hydrolysis solution up to 7.61 indicating that neutralization effect of SW and ES was sufficient for finished acid hydrolysis solution. Contents of organic matter was also at the range of 10.7~13.04% and 5.53~8.04% respectively when HCl and $H_2SO_4$ were used as solvent. Overall, hydrolysis technique can be used to manage food waste with selected optimum condition in this study and characteristics of finished hydrolysis solution after neutralization might be suitable for soil amendments.

• Clean Technology
• /
• v.18 no.1
• /
• pp.111-119
• /
• 2012

These days many companies are trying to reduce, recycle and reuse their wastes. Even though many wastes can be recycled, those are incinerated or landfilled. To solve these problems, there are many projects to make efforts to recycle wastes in especially the industrial complexes. But, due to the absence of information about waste recycling, recyclable wastes are still incinerated or landfilled. Based on these research background, this study aims to suggest the evaluation methodology of the $CO_2$ emissions and cost reduced by circulating the industrial waste to resource. We evaluated the environmental and economic effect between companies which emit the plastic waste and organic solvent waste and use them as raw-materials in the off-line recycling information exchange network. The environmental and economic aspects were analyzed comparing waste recycling with waste incineration. By recycling the plastic waste as raw-materials, $CO_2$ emission were reduced 1,070 ton in 2009 and 1,234 ton in 2010 and 657.4 million won in 2009 and 755.0 million won in 2010 were reduced. In recycling the organic solvent waste, 7.3 ton-$CO_2$ in 2010 and 5.6 ton-$CO_2$ in 2011 were reduced and 15.9 million won in 2010 and 12.2 million won in 2011 were reduced.

• Resources Recycling
• /
• v.14 no.6 s.68
• /
• pp.28-36
• /
• 2005

A hydrometallurgical process to leach cobalt from the waste cathodic active material, $LiCoO_{2}$, and subsequently to separate it by solvent extraction was developed. The optimum leaching conditions for high recovery of colbalt and lithium were obtained: 2.0 M sulfuric acid, 5 $vol.\%$ hydrogen peroxide, $75^{\circ}C$ leaching temperature, 30 minutes leaching time and an initial pulp density of 100 g/L. The respective leaching efficiencies for Co and Li were $93\%$ and $94.5\%$. About $85\%$ Co was extracted from the sulfuric acid leach liquor containing 44.72 g/L Co and 5.43 g/L Li, using 1.5 M Cyanex272 as an extractant at the initial pH 5.0 and in organic to aqueous phase ratio of 1.6:1 under the single stage extraction conditions. The Co in the raraffinate was completely extracted by 0.5 M Na-Cyanex272 at the inital pH 5.0, and an organic to aqueous phase ratio of 1;1. The cobalt sulfate solution of higher than $99.99\%$ purity could be recovered from waste $LiCoO_{2}$, using a series of hydrometallurgical processes: sulfuric acid leaching of waste $LiCoO_{2}$- solvent extraction of Co by Na-Cyanex 271 - scrubbing of Li by sodium carbonate solution - stripping of Co by sulfuric acid solution.

• Resources Recycling
• /
• v.1 no.1
• /
• pp.58-68
• /
• 1992

A process development for direct synthesis of high pure ZnO powders from zinc-bearing waste was investigated. This waste contains a 55% of zinc and it was extracted by the sulfuric acid(leaching). After removal of iron ion by precipitation from the zinc solution, the purification through a solvent extraction by the use of D2EHPA as an extractant was carried out. Then, loaded zinc in organic solution was stripped and precipitated simultaneously using a precipitant such as oxalic acid. Then, loaded zinc in organic solution was stripped and precipitated simulataneously using a precipitant such as oxalic acid. The synthesized $ZnC_2O_4$ powders by the precipitation stripping method was calcined to obtain more than 99.9% of ZnO powders. The effect of sulfuric acid concentration, leaching time, pulp density on the extraction of zinc was studied and the optimum conditions for the solvent extraction were obtained through the investigation of purification of zinc solution. The size, morphology and size distribution of synthesized $ZnC_2O_4$ powders were studied in terms of oxalic acid concentration, temperature, surfactant added, precipitation time, etc.