• Fire Science and Engineering
• /
• v.25 no.3
• /
• pp.85-90
• /
• 2011

This study of the vestibule of pressurizing smoke control system installed in domestic high-rise buildings for evacuation in case of fire, when the door is open to forming characteristics of the air flow was analyzed using fire dynamics simulator and analyzed of variance. Vestibule which is compartment of the design condition, air flow in the exhaust damper was formed severe turbulence confirming preceding research. The door position is in the range of formed vortex, unsteady flow of air occurs at the point that the door could be confirmed. According to the NFSC 501A, door to symmetrically separate the average of 10 points or more as measured from the average of wind speed to do is based. Under these conditions, it is difficult to measure the characteristics of the upper air flow of upper points. so measuring points are subdivided by more than 64 points method presented in TAB because severe deviation of wind speed.

• The Journal of the Acoustical Society of Korea
• /
• v.24 no.1
• /
• pp.1-10
• /
• 2005

This paper presents a wideband LPA (local polynomial approximation) beamforming algorithm that is appropriate for wideband moving sources. The Proposed wideband LPA algorithm adopts STMV (steered minimum variance) method that utilizes a steered covariance matrix obtained from multiple frequency components in one data snapshot, instead of multiple data snapshots in one frequency bin. The wideband LPA cost function is formed using STMV weight vector. The Proposed algorithm searches for the instantaneous DOA and angular velocity that maximize the wideband LPA cost function. resulting in a higher resolution performance than that of a DS LPA beamforming algorithm. Several simulations using artificial data and sea trial data are used to demonstrate the performance of the Proposed algorithm.

• Journal of Navigation and Port Research
• /
• v.35 no.10
• /
• pp.785-791
• /
• 2011

This paper describes the evaluation and selection of MEMS(Micro-Elect Mechanical System) based inertial sensor to fit to implement the Inertial Measurement Unit(IMU) for a small-sized vessel at sea. At first, the error model and the noise model of the inertial sensors are defined with Euler's equations and then, the inertial sensor evaluation is carried out with Allan Variance techniques and Monte Carlo simulation. As evaluation results for the five sensors, ADIS16405, SAR10Z, SAR100Grade100, LIS344ALH and ADXL103, the combination of gyroscope and accelerometer of ADIS16405 is shown minimum error having around 160 m/s standard deviation of velocity error and around 35 km standard deviation of position error after 600 seconds. Thus, we select the ADIS16405 inertial sensor as a MEMS-based inertial sensor to implement IMU and, the error reducing method is also considered with the search for reference papers.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.14 no.1
• /
• pp.73-83
• /
• 2011

The opening status of Saemangeum sluice gate is an important factor to the coastal water qualities near Saemangeum dikes. The sluice gate opening information is important in analysing current velocity and water quality data measured at the Saemanguem observation tower as well as in determining boundary conditions of numerical simulation for coastal environment outside Saemangeum dikes. This study establishes unmanned camera monitoring system on Saemangeum observation tower using mini notebook and digital camera, and extracts information on the opening status from images automatically. Images are analysed using variance difference of images together with edge detection techniques in order to get correct information.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.7 no.2
• /
• pp.193-203
• /
• 1983

The mixed convective heat transfer problems are characterized by the relatively significant contribution of buoyancy force to the transport processes of momentum and heat. Past analytical studies on this kind of problems have been carried out by employing either the conventional R-.epsilon. turbulence model which includes constant turbulent Prandtl number .sigma.$_{+}$ 1 or an extended R-.epsilon. turbulence model which takes account of the buoyancy effect in appropriate length scale equations. But in the latter case, the temperature variance .the+a.$^{2}$ over bar is approximated by a model under local equilibrium condition and the time scale ratio between velocity and temperature is assumed to be constant. These approximation is known to break down when the buoyancy effect is dominant. The present study is aimed at development of new computational turbulence closure level which can be applied to this rather complex turbulent process. The temperature variance is obtained directly by solving its dynamic transport equation and the time scale ratio which is variable in space is computed by a solution of a dynamic equation for the rate of scalar dissipation .epsilon.$_{\thetod}$ It was found that the computational results are in good agreement with available experimental data of wide range of unstable conditions.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.16 no.1
• /
• pp.9-15
• /
• 2012

An unsteady internal ballistic performance model was proposed to take account for the variance of local regression rate along the grain port of a hybrid rocket combustor. The characteristic parameters of hybrid rocket motor was investigated. The performance model of concern in the study was fairly comparable with the test result. The combustion coefficients and local burning characteristics of a hybrid rocket motor were evaluated. The local variation of the oxidizer mass flow rate results in the changes of local regression rate, pressure, temperature, and gas velocity to flow direction, which was analyzed quantitatively.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.12 no.1
• /
• pp.137-151
• /
• 1988

Thurbulent thermal convection between two plates, bottom plate is at higher temperature $T_{h}$ and the upper plate is at lower temperature $T_{i}$ is numerically investigated. Model equations are abridged Reynolds stress equations; full Reynolds stress equations are simplified to yield algebraic relations in case of mean square velocity fluctuations in vertical and horizontal directions. Boundary conditions for turbulent kinetic energy k and mean square temperature variance .thera.$^{2}$oner bar at the plate surfaces are set to be zero and those of dissipation rate of turbulent kinetic energy .epsilon. and dissipation rate of mean square temperature variance .epsilon.$_{\theta}$ are assumed at first grid point nearest to the boundary surfaces, whose values are approximated by inviscid estimates. Results show that temperature profiles are in good agreement with experimental data except transition region, in which temperature is over-predicted. Such discrepancy becomes larger as the Rayleigh number becomes smaller. Nusselt numbers, which are calculated from the temperature gradients at the boundary surfaces, are also in good agreement with experimental data.a.a.

• Physical Therapy Korea
• /
• v.19 no.3
• /
• pp.98-104
• /
• 2012

The aim of this study was to examine the effects of repeated passive movement (RPM) of different velocities on the improvement of knee joint position sense (JPS) in post-stroke patients with hemiplegia, thereby investigate the possibility of clinical application in the initial stage of rehabilitation for patients with post-stroke hemiplegia. Thirteen hemiplegic patients participated in this study. For the subjects' knee JPS tests, a passive angle reproduction test and an active angle reproduction test were performed prior to and after the intervention, which involved 30 repetitions of passive full-range-of-motion flexion and extension exercise of the knee joints at randomized degrees of $0^{\circ}/s$, $45^{\circ}/s$, and $90^{\circ}/s$. Paired t-test analysis was done in order to compare changes in the pre- and post-intervention knee JPS. One-way repeated analysis of variance was used in order to compare changes in JPS after intervention at three different movement velocities. The level of significance was set at .05. The result was that the subjects' post-intervention knee JPS significantly improved after the RPM exercise at a $45^{\circ}/s$ and a $90^{\circ}/s$ relative to the RPM exercise $0^{\circ}/s$ (p<.05). JPS changes with RPM intervention at the rapid velocity of $90^{\circ}/s$ were most increased, suggesting the most effective enhancement in knee JPS is with intervention at the velocity (p<.05). Therefore, RPM intervention at a half or higher velocity improved stroke patients' knee JPS. During the initial stage of rehabilitation for patients with post-stroke hemiplegia, the efficient application of the RPM exercise at a half or higher velocity will be possible.

• Ocean and Polar Research
• /
• v.36 no.2
• /
• pp.165-177
• /
• 2014

In an effort to investigate the structure and variability of the coastal current in the East Sea, a moored ADCP observation was conducted off Uljin from late May to mid-October 2006. Owing to the transition of season from summer to autumn, the features of the current and wind can be divided into two parts. Until mid-August (Part-I), a southward flow is dominant at all depths with a mean alongshore velocity of 4.2~8.9 cm/s but northward winds are not strong enough to reverse the near-surface current. During Part-II, a strong northward current occurs frequently in the upper layer but winds are predominantly southward including two typhoons that have deep-reaching influence. Profile of mean velocity has three layers with a northward velocity embedded at 12~28 m depth. The near-surface current of Part-II significantly coheres with winds at 4-8 day periods with a phase lag of about 12 hours. The modal structure of the current obtained by EOF analysis is: (1) Mode-1, having 83.6% of total variance, represents the current in the same direction at all depths corresponding to the southward North Korean Cold Current (NKCC). (2) Mode-2 (11.7%) reveals a two-layer structure that can be explained by the northward East Korean Warm Current (EKWC) in the upper layer and NKCC in the lower. (3) Mode-3 (2.6%) has three layers, in which the EKWC is reversed near the surface by opposing winds. This mode is particularly similar to the mean velocity profile of Part-II.

• Journal of Korea Water Resources Association
• /
• v.43 no.4
• /
• pp.399-408
• /
• 2010

The sensitivity of Nash model parameters is analyzed about characteristic velocities considering geomorphological dispersion in the present study. And changing shape of IUH compared and analyzed as variation of characteristic velocities through numerical experiment. Application watersheds are selected 4 subwatersheds which are located at main stream of Bocheong basin. The mean and variance of hillslope and stream path length are estimated in each watershed with GIS. And Nash model parameters are estimated with moments of path lengths and characteristic velocities. The changing trend about IUH which is derived Nash model parameters are compared as variation of characteristic velocities. The Major results of this study are summarized as follows. The Nash model parameters sensitively present changes about hillslope characteristic velocity. And the effect of the peak discharge and shape of recession in IUH dominate with hillslope's characteristic velocity, the effect of the peak time and shape of ascension in IUH dominate with channel's characteristic velocity.