• 한국전기전자재료학회논문지
• /
• 제29권11호
• /
• pp.696-701
• /
• 2016

In this study, to increase output of road piezoelectric energy harvester, it was made into rack type in which many piezoelectric materials can be installed and load transfer device of the leverage type to transfer vehicle load was made. By paving it in the road, the output characteristics depending on vehicle load and speed were evaluated. Changing vehicle load, harvester output characteristics depending on speed changes were evaluated at the interval of 10 km/h from 10 km/h to 100 km/h. Also, by making a wireless switch and sending wireless signal with output of rack type harvester, whether to receive it was evaluated by distance. It was checked that all switches work up to front-to-back 100 m from harvester.

• Journal of Advanced Marine Engineering and Technology
• /
• 제36권4호
• /
• pp.430-436
• /
• 2012

본 연구에서는 납축전지가 장착된 소형 전기자동차의 여러 가지 주행 특성에 따른 배터리의 전압강하를 실증실험을 통하여 측정하였다. 실험을 통하여 2인승의 소형전기자동차의 에너지 소비량을 평가하고 주행거리 등을 점검하기 위하여 속도별 주행특성과 주행 중에 난방장치를 가동하였을 경우에 감소하는 주행거리를 평가하였다. 전기자동차의 주행속도는 10km/h에서 20km/h씩 증가시키면서 히터의 가동유무에 따른 에너지 소비량을 측정하였다. 실험결과 본 실험용 소형 전기자동차의 에너지효율이 가장 높은 경제속도는 35km/h로 나타났으며, 일회 충전으로 경제속도로 주행할 경우에 약 75km의 거리를 주행할 수 있으며, 일반적인 주행의 경우에는 약 58km를 주행할 수 있다. 또한 난방장치를 최대로 가동할 경우에는 약 35%의 에너지 소비가 증가하는 것을 알 수 있다.

• 한국대기환경학회지
• /
• 제28권1호
• /
• pp.94-104
• /
• 2012

The purpose of this research is to quantify the compliance of on-road emission from a light duty diesel vehicle, based on a comparison to emission regulation standard. $NO_x$, CO and THC emissions were measured using a portable device on a selected real-world driving route with a length of approximately 22 km. On-road measurements were repeated by 10 times on a same route to reflect variability in traffic conditions. A test route was divided into 22 road links with length of 1 km to analyze emission results with higher spatial resolution. The average emissions of $NO_x$, CO and THC over total travel distance, which is approximately 220 km, were quantified to be in compliance with emission regulation standards. Under higher spatial resolution, $NO_x$ concentration exceeded a standard in 92 links out of 220 links. The extended time in stop period and the stop-and-go driving cycle were identified as two important reasons for increased $NO_x$ emissions in observed cases. Heavy traffics showed higher $NO_x$ emissions than free flow. These results indicate that the real-world vehicle emissions might exceed the compliance level associate with traffic conditions. Another interesting observation of this research is that the on-road emission characteristics can be independent to the average speed of road links with higher spatial resolution. Variability in on-road emission might not be fully described by solely relying on an average speed, because variability in traffic conditions and road conditions can influence on real-world vehicle emissions.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2011년도 춘계학술대회 논문집
• /
• pp.671-679
• /
• 2011

Now, for the continuous location detection of train, The method which the moving distance and speed of vehicles are detected using an odometer mounted within railway vehicle, is used in railway domain generally. There are some problems that the train's positioning errors are accumulated as the moving distances increase. To solve this problems, The Train-borne Positioning System is being developed at Korea Railroad Research Institute. It is required to evaluate exactly a positioning performance of The Train-borne Positioning System for improvement of performance. Therefore, in this paper, we review the CDGPS methods to acquire reference position for performance evaluation of Train-borne Positioning System and verify the accuracy of the reference position through the static test and the vehicle test.

• 한국ITS학회 논문지
• /
• 제20권1호
• /
• pp.146-159
• /
• 2021

본 연구는 고령운전자 운전특성 파악을 위한 실증적 분석의 일환으로 차량 시뮬레이터를 이용하여 고령운전자의 주행특성을 파악하고자 하였다. 이를 위해 기존연구 고찰에서 고령운전자의 주행특성 요소를 파악한 후, 시뮬레이션 환경을 구축하고 일반 운전자와의 주행 비교를 통해 고령자 운전특성을 명확히 도출하고자 하였다. 실험 결과 고령운전자는 주행속도, 운전조작(브레이크, 스로틀, 스티어링 작동) 등 차로편측을 제외한 모든 항목에서 일반 운전자와는 다른 주행특성을 보이는 사실을 확인하였으며, 주요 특성으로 차로변경 시 속도유지 및 적정 차간간격 확보가 어렵고, 돌발 상황 발생 시 정지거리와 소요시간이 더 많이 필요한 것으로 확인되었다. 결과적으로 고령운전자 주행거동의 일의적 특성을 입증할 수 있었고, 도로설계, 고령자 관련 교통정책 수립 등에 유효한 지침을 제공할 수 있을 것으로 기대된다.

• 한국철도학회논문집
• /
• 제5권1호
• /
• pp.18-25
• /
• 2002

This paper is to study a comparison of ride stabilities for the guideway vehicle between its three primary steering types; the front-rear wheel steering type, tile independent wheel steering and the front wheel steering. A numerical model were built to investigate various factors to have an influence on the vehicular stability. It was shown that dynamic stabilities of the three types were dependent on the steering gain ratio of front wheel steering to rear. The front-rear wheel steering type was more stable for the value of positive steering gains and the shorter distance between front axle and guide link showed better stabilities. On the contrary, the independent wheel steering was more stable for the value of negative gains and the longer distance between front axle and guide link showed better stabilities. Ride characteristics of he front wheel steering seemed to be found midway. Ride behaviors due to time delay from front steering to rear were very different from steering type to type.

• 공학교육연구
• /
• 제17권5호
• /
• pp.17-22
• /
• 2014

Unmanned aerial vehicles (UAVs) that have been recently commercialized can largely be divided into fixed-wing aircraft and rotor aircraft by their styles and flight characteristics. Although the fixed-wing aircraft represents higher power efficiency, higher speed, longer flight distance and larger loading weight than the rotor aircraft, they have a disadvantage of requiring a space for take-off and landing. On the other hand, the rotor aircraft can implement vertical take-off and landing (VTOL) and represents various flight modes (hovering, steep bank turns and low-speed flights). But they require both precision take-off control and attitude control. In this study, we used a quad-tilt rotor UAV to combine advantages in both the fixed-wing aircraft and the rotor aircraft. The quad-tilt rotor (QTR) system was designed and constructed by adding a tilt device with a servo motor to a general quad-rotor vehicle.

• International Journal of Aeronautical and Space Sciences
• /
• 제18권3호
• /
• pp.425-435
• /
• 2017

In this work, an overview of flow diagnosis in a shock tunnel is made by means of using established techniques that are easy to setup, economical to arrange, and simple to measure. One flow condition was considered having Mach number of 6 at the nozzle-exit, regarded as freestream. Measured aerothermodynamic data such as shock wave speed, wall static and total pressures, surface heat flux, and shock stand-off distance ahead of test model showed good agreement with calculation. This study shows an overall procedure of flow diagnosis in a shock tunnel in a single manuscript. Outcomes are thought to be useful in the field of education and also in a preliminary stage of high-speed vehicle design and tests, that need to be performed within a short time with decent accuracy.

• 산업경영시스템학회지
• /
• 제22권50호
• /
• pp.33-44
• /
• 1999

This paper describes the Autonomous Vehicles (AV) which are operated for their own tasks. There are chances of conflict resolution such as sharing the same path which can lead to the risk of a collision. This research represents some ways of negotiating the conflict resolution by generating cooperative actions. Negotiation while traveling the path is accomplished by using priority and by announcing the start time of the task. When there is a risk of collision, the AV tries to dissolve the situation of conflict resolution by concurrently adjusting mutual speed and by performing the algorithm of passing. If the speed of the AV cannot be adjusted, it measures the distance between the counterpart of the AV and an obstacle along the path. Then it judges either to proceed by passing the counterpart of the AV or to turn back after observing the current circumstances. The performance of the algorithm described above was proven by a simulator.

• 대한교통학회지
• /
• 제28권5호
• /
• pp.107-116
• /
• 2010

도심지에서 수요지간의 이동시간은 복잡한 도로사정과 외부환경으로 인하여 실시간 변화하는 교통상황에 큰 영향을 받고 있으며, 수요는 시기나 성향에 따라 확률적으로 변화하고 있다. 대부분의 차량경로문제 연구는 차량경로를 선정함에 있어 수요지간의 이동거리와 평균속력, 확정된 수요를 고려하여 경로를 구성하고 있으며, 교통상황과 확률적인 수요의 동적인 외부환경 반영이 미흡하였다. 본 연구에서는 원활 지체 정체의 교통상황과 확률적인 수요를 고려한 현실적인 차량경로문제를 제안하였다. 수리모형을 구축하고, CPLEX 11.1을 이용하여 검증하였으며, 총 소요시간을 최소화하는 Hybrid 유전자 알고리즘을 제안하였다. 교통상황과 확률적 수요를 고려한 차량경로문제의 결과를 기존의 휴리스틱 알고리즘과 비교하였으며, 본 연구에서 제안한 알고리즘이 가장 우수한 해를 제공하였다.