• 한국대기환경학회지
• /
• 제6권1호
• /
• pp.57-72
• /
• 1990

The oxidation of carbon monoxide on a catalyst, $LaSrNiCoO_3$ was investigatigated with a plug flow system. Kinetic quantities such as reaction-rate, reaction order and Arhenius-parameters at various reactor temperature from 200$^\circ$C to 300$^\circ$C were determined. Also, the optimum condition for the oxidation of carbon monoxide with this catalyst was determined and are as follows. Partial pressure of oxigen ; 428mmHg Partial pressure of carbon monoxide ; 332mmHg Mixed moral ratio of oxigen and Carbon monoxide ; 1.3 : 1 Total gas flow ; 224ml/min Reaction temperature ; 340$^\circ$C The reaction kinetic equation at the optimum condition, temperature range from 200$^\circ$C to 340$^\circ$C, are as follow. $$ $v = Ae^{6.5Kcal/RT} [CO]^{0.93 \sim 0.98} [O_2]^{0.42 \sim 0.50}$ $$ In addition to this, numerical calculation were performed to evaluate the mass and heat transfer effect on this system.

• 열처리공학회지
• /
• 제6권4호
• /
• pp.223-229
• /
• 1993

Extensive reseach has been performed on the process condition-micro structure-stress relations of TiN film. The various proposed models are mainly base on physical vapor deposition processes. Especially the study on the micro-structure and deposition condition has not been sufficient in TiN deposited by PECVD. In this study, therefore, we discussed the morphological changes of TiN films by PECVD with different temperature and pressure, and compared it with the structure zone model. We could find out that the oxygen and chlorine contents and the texture coefficient increased with deposition temperature, and the morphology of TiN transformed from Zone 1 to Zone T, but deposition pressure didn't remarkly affected.

• 한국표면공학회지
• /
• 제35권1호
• /
• pp.53-63
• /
• 2002

Ni coating was carried out by pulse plating at room temperature. So, experimental conditions for Ni-coating were based on Watt's bath, and new additives(propionic acid) were introduced in the Watt's bath electrolyte as $H_3$$BO_3$ alternatives. By adding propionic acid, coating layer demonstrated a good adhesion and uniformity without special pre-treatment of the 316L stainless steel at room temperature. With a decrease of amount of propionic acid and applied average current density, cathode current efficiency increased. Also, edge effect was decreased with decreasing a peak current and increasing a pulse frequency in the same bath condition. It was found that the optimum condition for Ni coating was a current density of 10~20mA/$\textrm{cm}^2$ at below 500 mA peak current in the $5m\ell/\ell$ propionic acid solution.

• 대한기계학회논문집
• /
• 제3권4호
• /
• pp.173-180
• /
• 1979

Temperature distriburion in a hollow chlinder has been analyzed mathematically. Unsteady condition considered assumed a constant heat flux input from the inside. The results are compared with experimental results of surface temperature rise of a gun barrel during continuous firing. Their agreements are acceptable. Effects of various dimensionless parameters on the surface temperature rise are discussed. For small Biot numbers, the external survface temperature approaches more rapidly to the steady temperature. Temperature difference between internal and external surfaces becomes greater for small Biot number. Steady solution assumed that the gas temperature inside the cylinder varies periodically. Relative amplitude and phase angles between the gas temperature and the internal or external surface temperature are obtained. Phase angles become smaller for large radiancy of gas temperature variation, small external Biot number, or large internal biot number. Relative amplitudes become samller as radiancy of gas temperature variation and internal Biot number become smaller. or external Biot number becomes larger. The solution obtained in this paper can be applied to gun barrels, heat pipes used in heat excangers, and reciprocation engines.

• 한국멀티미디어학회논문지
• /
• 제7권10호
• /
• pp.1370-1377
• /
• 2004

동일한 장면을 다양한 조건에서 촬영한 영상이나 비디오는 서로 다른 색감을 가지며 촬영 조건에서 중요한 역할을 하는 것은 현장의 조명이다. 조명의 색온도에 따라 전체적인 색감이 결정되므로 조명색의 변환방법이 필요하다. 본 논문에서는 임의로 지정된 색온도로의 조명색 변환 방법을 제안한다. 기존의 조명색 변환 방법은 미리 정해진 일정한 개수의 대표성이 있는 색온도에 대한 변환 관계를 미리 계산하여 두었다가 활용하는 정도이다. 제안한 방법은 임의로 지정한 기준과 목표로 하는 색온도에 대한 변환 관계를 직접적으로 구하여 적용할 수 있는 장점이 있다.

• International Journal of Automotive Technology
• /
• 제5권3호
• /
• pp.155-164
• /
• 2004

The direct injection gasoline spray-wall interaction was characterized inside a heated pressurized chamber using various visualization techniques, including high-speed laser-sheet macroscopic and microscopic movies up to 25,000 frames per second, shadowgraph, and double-spark particle image velocimetry. Two hollow cone high-pressure swirl injectors having different cone angles were used to inject gasoline onto a heated plate at two different impingement angles. Based on the visualization results, the overall transient spray impingement structure, fuel film formation, and preliminary droplet size and velocity were analyzed. The results show that upward spray vortex inside the spray is more obvious at elevated temperature condition, particularly for the wide-cone-angle injector, due to the vaporization of small droplets and decreased air density. Film build-up on the surface is clearly observed at both ambient and elevated temperature, especially for narrow cone spray. Vapor phase appears at both ambient and elevated temperature conditions, particularly in the toroidal vortex and impingement plume. More rapid impingement and faster horizontal spread after impingement are observed for elevated temperature conditions. Droplet rebounding and film break-up are clearly observed. Post-impingement droplets are significantly smaller than pre-impingement droplets with a more horizontal velocity component regardless of the wall temperature and impingement angle condition.

• 환경생물
• /
• 제21권2호
• /
• pp.120-125
• /
• 2003

본 연구는 토지피복현황과 수림의 계층구조 등이 다양한 도시녹지를 대상으로 기온 및 급도에 미치는 영향물 점성 빛 정량적으로 파악하기 위해 녹지내의 기온 및 습도를 관측하였다. 그 데이터클 바탕으로 녹지내의 토지피복현황과 기온 및 습도분포, 녹지내의 수목그루와 녹적량및 습도와의 관련성을 회귀분석 둥에 의해 해석 하였다. 그 결과, 고온역은 인공구조물과 나지 주변에서, 저온역은 수림지와 수면 주변에서 형성되었다. 습도는 기온분포에 거의 대응하는 형태로 고온역이 저습역이고, 저온역이 고습역으로 나타났다. 또한, 수림의 계층구조가 2,3층으로 덮여 있는 구역과 수면을 핵으로 그 주변은 수림으로 둘러싸인 구역이 상대적으로 높은 습도를 나타냈다. 수루그루 빛 녹적량의 증가는 어떤 수고라도 습도의 상승에 효과적이고 그 효율은 교목, 소교목, 관루의 순이다.

• International Journal of Aeronautical and Space Sciences
• /
• 제3권1호
• /
• pp.9-18
• /
• 2002

Thermal humidity characteristics were considered theoretically and experimentally. A Simply well-fitted correlation of a saturated vapor pressure-temperature curve of water was introduced based on Antoine equation to make theoretical prediction of relative humidity according to temperature variation. Characteristics of dew point were also examined theoretically and its relation with temperature and humidity was evaluated. The exact mass of water vapor in a specified humidity and temperature condition was estimated to provide useful insight into the idea about how much amount of water corresponds to a specified humidity and temperature condition in a confined system. A simple but well-fitting model of dehumidification process was introduced to anticipate the trend of relative humidity level during GN2(gaseous nitrogen) purge process in a humidity chamber. Well-suitedness of this model was also verified by comparison with experimental data. The overall appearance and specification of two thermal humidity chambers were introduced which were used to perform various thermal humidity tests in order to yield useful data necessary to support validity of theoretical models.

• 한국의류산업학회지
• /
• 제6권5호
• /
• pp.613-617
• /
• 2004

The intent of this study was to determine whether different light exposure could modify the clothing behavior in the evening cold environment or not. Nine female subjects volunteered to this study. In a bright light or a dim light condition, light intensity was controlled 3000 lx or 10 lx respectively. Subjects were introduced to wear various kinds of garments whenever they need to feel comfortable as the room temperature began to decrease. The room temperature was lowered from $30^{\circ}C$ to $15^{\circ}C$ for one hour (21:00 h~22:00 h) and maintained at $15^{\circ}C$ for additional one hour (22:00 h~23:00 h). Subjects stayed in chamber from 08:00 to the next day 07:00. Clothing behavior, core temperature, subjective temperature sensation and melatonin secretion were measured. Most subjects put on the clothing more quickly and more thickerly in the bright light rather than in the dim light condition. The fall of core temperature during night was significantly less under the bright light in the late afternoon, suggesting that the set-point of core temperature has been set at a higher level during the evening and the night, being supported by the less amount of melatonin secretion. Thus, it is concluded that the quicker dressing behavior with thicker clothing in the "Bright" condition is advantageous in evening cold exposure, since it enables the core temperature to reach its set-point value more easily.

• 멤브레인
• /
• 제9권4호
• /
• pp.193-201
• /
• 1999

기존의 정수처리 공정인 응집 침전 과정을 대체하여 분리막을 이용한 상수처리 시스템의 개발을 목적으로한다. 따라서 4가지 형태의 정수처리 공정과 분리막의 분획 분자량을 변화시켰을 때 막 투과수의 변화와 안정적이며 높은 투과수를 얻기 위해 필요한 운전 조건의 최적화를 실험하였다 실험결과 한외여과막이 정밀여과막보다 막 투과수 감소경향이 완만했으며 초기 투과수 회복율은 더 높았다. 수질 분석의 결과 한회여과막이 정밀 여과막보다 우수하였지만 전처리에 의한 차이는 나지 않았다. 운전 조건에 따른 flux 는 온도, 선속도가 높을수록 압력이 낮을수록 flux 감소율이 적은 경향을 나타내었다.