• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.5
• /
• pp.419-424
• /
• 2009

ZnO films doped with different contents of indium ($0.1{\sim}10$ at.%) were deposited on Si (111) substrate by Pulsed Laser Deposition (PLD). The structural, electrical and optical properties of the films were investigated using XRD, AFM, Hall and PL measurement. Results showed that un-doped ZnO film had (002) plane as the c-axis orientated growth, whereas indium doped ZnO films exhibited the peak of (002) and the weak (101) plane. In addition, in the indium doped ZnO films, the electron concentration is ten times higher than that of un-doped ZnO film, while the resistivity is ten times lower than that of un-doped ZnO film. The indium doped ZnO films have UV emission about 380 nm and show a red shift with increasing contents of indium. The I-V curve of the fabricated diode show the typical diode characteristics and have the turn on voltage of about 2 V.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.327-327
• /
• 2009

ZnO with a large band gap (~3.37 eV) and exciton binding energy (~60 meV), is suitable for optoelectronic applications such as ultraviolet (UV) light emitting diodes (LEDs) and detectors. However, the ZnO-based p-n homojunction is not readily available because it is difficult to fabricate reproducible p-type ZnO with high hall concentration and mobility. In order to solve this problem, there have been numerous attempts to develop p-n heterojunction LEDs with ZnO as the n-type layer. The n-ZnO/p-GaN heterostructure is a good candidate for ZnO-based heterojunction LEDs because of their similar physical properties and the reproducible availability of p-type GaN. Especially, the reduced lattice mismatch (~1.8 %) and similar crystal structure result in the advantage of acquiring high performance LED devices. In particular, a number of ZnO films show UV band-edge emission with visible deep-level emission, which is originated from point defects such as oxygen vacancy, oxygen interstitial, zinc interstitial[1]. Thus, defect-related peak positions can be controlled by variation of growth or annealing conditions. In this work, the undoped ZnO film was grown on the p-GaN:Mg film using RF magnetron sputtering method. The undoped ZnO/p-GaN:Mg heterojunctions were annealed in a horizontal tube furnace. The annealing process was performed at $800^{\circ}C$ during 30 to 90 min in air ambient to observe the variation of the defect states in the ZnO film. Photoluminescence measurements were performed in order to confirm the deep-level position of the ZnO film. As a result, the deep-level emission showed orange-red color in the as-deposited film, while the defect-related peak positions of annealed films were shifted to greenish side as increasing annealing time. Furthermore, the electrical resistivity of the ZnO film was decreased after annealing process. The I-V characteristic of the LEDs showed nonlinear and rectifying behavior. The room-temperature electroluminescence (EL) was observed under forward bias. The EL showed a weak white and strong yellowish emission colors (~575 nm) in the undoped ZnO/p-GaN:Mg heterojunctions before and after annealing process, respectively.

• Journal of the Korean Vacuum Society
• /
• v.18 no.5
• /
• pp.384-389
• /
• 2009

ZnO, a wurtzite lattice structure, has attracted much attention as a promising material for light-emitting diodes (LEDs) due to highly efficient UV emission resulting from its large band gap of 3.37 eV, large exciton binding energy of 60 meV, and low power threshold for optical pumping at room temperature. For the realization of LEDs, both n-type ZnO and p-type ZnO are required. Now, n-type ZnO for practical applications is available; however, p-type ZnO still has many drawbacks. In this study, ZnO films were grown on glass substrates by using atomic layer deposition (ALD) and the ZnO films were irradiated by nitrogen ion beams (20 keV, $10^{13}{\sim}10^{15}ions/cm^2$). The effects of nitrogen-beam irradiation on the ZnO structure as well as the electrical property were investigated by using fieldemission scanning electron microscopy (FESEM) and Hall-effect measurement.

• Journal of the Korean Vacuum Society
• /
• v.20 no.3
• /
• pp.211-216
• /
• 2011

In this study, the effects of growth temperature on structural and optical properties of hydrothermally grown ZnO nanorod arrays have been investigated. Zinc nitrate ($Zn(NO_3)_2$) and hexamethylenetetramine were used as precursors. The ZnO buffered Si(100) with a thickness of 40 nm was used as the substrates. The ZnO nanorods were grown on these substrates with the temperature ranging from 55 to $115^{\circ}C$. The results were characterized by scanning electron microscope, X-ray diffraction and room temperature photoluminescence measurements. Well-aligned ZnO nanorods arrays were obtained from all samples. The tips of nanorods were flat when the temperature was less than $95^{\circ}C$, and the sharp-tip nanoneedle-like morphologies were obtained with the temperature of $115^{\circ}C$. In addition, some bundles were on the nanorods arrays with $115^{\circ}C$ due to the non-equilibrium growth. The growth temperature could affect the crystal and optical properties of ZnO. For the effects on crystal properties, the intensity of (002) peak was increased as the temperature was increased to $75^{\circ}C$, then decreased as the temperature was further increased to $115^{\circ}C$. As for the effects on optical properties, the intensity ratio of UV peak to visible peak is increased with the temperature increasing and the strongest UV peak intensity was obtained with the growth temperature of $95^{\circ}C$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.23 no.2
• /
• pp.93-97
• /
• 2010

We have studied the effect of the chemical composition of the ZnO nanorod surface on the optical characteristics. The surface was treated with H- and O-plasma at different surface temperatures. The chemical composition of the surface of the ZnO nanorod, being investigated by Auger Electron Spectroscopy(AES), was related to the Photoluminescence(PL) data reported in our previous results. The AES showed the opposite results for the $H_2$ and $O_2$ plasma treatments. The ratio of Zn to O on the surface of the ZnO nanorod increased in the case of $H_2$ plasma, while the composition rate of O increased after $O_2$ plasma treatment. The AES results seems to be correlated to the shift in PL peaks. The increase in the composition rate of Zn on the surface of ZnO nanorod is considered to cause the blue shift of the UV peak. On the contrary, the relative increase of O is considered to cause the red shift in PL peaks.

• Particle and aerosol research
• /
• v.12 no.2
• /
• pp.37-42
• /
• 2016

$CeO_2$ nanoparticles were prepared by a flame spray pyrolysis from aqueous solution of cerium nitrate. The morphology, structure crystallinity and specific surface area of as-prepared nanoparticles were characterized by transmission electron microscopy (TEM), X-ray diffraction (XRD), and Brunauer-Emmett-Telle (BET). The $CeO_2$ nanoparticles about 5 nm in diameter showed a cubic fluorite structure and polyhedral morphology. The average particle size increased as the cerium nitrate concentration increased. UV absorption performance of the as-prepared nanoparticles was measured by UV-visible spectroscopy. UV absorption of $CeO_2$ nanoparticles was more effective than that of commercial $TiO_2$ nanoparticles. Effect of dopants such as Ti and Zn to $CeO_2$ nanoparticles on UV absorption properties was also investigated. In case of $Ti/CeO_2$, and $Zn/CeO_2$ nanoparticles, they showed a little higher UV absorption values compared with $CeO_2$ nanoparticles. The as-prepared nanoparticles can be promising materials with high UV absorption value.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.167.2-167.2
• /
• 2014

In this work, ZnO shell on mesoporous $SiO_2$ ($ZnO/SiO_2$) was prepared by atomic layer deposition (ALD). Diethylzinc (DEZ) and $H_2O$ were used as precursor of ZnO shell. $ZnO/SiO_2$ sample was characterized by X-ray diffraction (XRD), N2 sorption isotherms, X-ray photoelectron spectroscopy (XPS), Scanning electron microscopy (SEM) and Fourier-transform infrared spectroscopy (FT-IR). $ZnO/SiO_2$ showed higher adsorption capacity of MB than that of bare mesoporous $SiO_2$ and the adsorption capacities of $ZnO/SiO_2$ could be regenerated by UV exposure through the photocatalytic degradation of the adsorbed MB. This system could be used for removing organic dye from water by adsorption and reused after saturation of adsorption due to its photocatalytic regeneration.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.227-227
• /
• 2012

본 연구에서는 RF스퍼터링법에 의하여 glass substrate에 In-Zn-Sn-O (IZTO)를 Zn 성분에 변화를 주면서 $350{\AA}$ 만큼 증착시키고, 1시간 동안 $350^{\circ}C$로 열처리 하였다. In:Zn:Sn의 성분 비율은 20:48:32 (IZTO1), 13:60:27 (IZTO2)이다. 박막의 전자적, 광학적 특성은 XPS (X-ray Photoelectron Spectroscopy), REELS(Reflection Electron Energy Loss Spectroscopy), UV-Spectrometer를 이용하여 연구하였고, 박막의 전기적 특성은 van der Pauw 법을 이용하여 측정하였다. XPS측정결과, IZTO박막은 In-O, Sn-O and Zn-O의 결합을 가진다. REELS를 이용해 Ep=1,500 eV에서의 밴드갭을 얻어보면, $350^{\circ}C$로 열처리 한 박막은 열처리를 하지 않은 것에 비해 밴드갭이 IZTO1는 3.36 eV에서 3.54 eV로, IZTO2는 3.15 eV에서 3.31 eV로 증가하였다. 반면에 Zn 함량이 증가할수록 밴드갭이 감소하는 것을 확인할 수 있었다. 이 값은 UV-Spectrometer를 이용한 광학적 밴드갭과 일치하였다. 또한 van der Pauw method를 이용한 전기적 특성 분석 결과, 열처리를 하기 전에 비하여 carrier concentration이 IZTO1는 $-4.4822{\times}10^{18}cm^{-3}$에서 $-2.714{\times}10^{19}cm^{-3}$로, IZTO2는 $-3.6931{\times}10^{17}cm^{-3}$에서 $-1.7679{\times}10^{19}cm^{-3}$로 증가하였다. 반면에 Resistivity는 IZTO1의 경우 $1.7122{\times}10^{-1}{\Omega}{\cdot}cm$에서 $5.5496{\times}10^{-3}{\Omega}{\cdot}cm$로, IZTO2는 $1.3290 {\Omega}{\cdot}cm$에서 $1.3395{\times}10^{-2}{\Omega}{\cdot}cm$로 감소하였다. 그리고 UV-Spectrometer를 이용한 광학적 특성을 측정해본 결과, 가시광선영역인 380~780 nm에서의 투과율이 83%이상으로 투명전자소자로의 응용이 가능하다는 것을 보여주었다.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.7
• /
• pp.567-571
• /
• 2009

Polycrystalline ZnO and Ga doped ZnO (GZO) films are deposited on glass substrate by RF magnetron sputtering at room temperature. The characteristics of ZnO and GZO films are investigated with X-ray diffraction measurement, UV-VIS-NIR spectrophotometer $(250{\sim}1200nm)$ and hall measurement. The post-growth thermal treatment of these films is carried out in N2 ambient at $500^{\circ}C$ for 30 min and an hour. ZnO and GZO films have different changing behavior of structural and optical properties by annealing. To use transparent conductive films for solar cell, films should have not only high transmittance but also good electrical property. Although as deposited GZO films have electrical properties than ZnO films, GZO films have not good transmittance properties. Consequently, we succeed that the high transmittance of GZO films is improved by annealing process.

• Korean Journal of Materials Research
• /
• v.28 no.2
• /
• pp.101-107
• /
• 2018

Li-incorporated ZnO thin films were deposited by using ultrasonic-assisted spray pyrolysis deposition (SPD) system. To investigate the effect of Li-incorporation on the performance of ZnO thin films, the structural, electrical, and optical properites of the ZnO thin films were analyzed by means of X-ray diffraction (XRD), field-emssion scanning electron microscopy (FE-SEM), Hall effect measurement, and UV-Vis spectrophotometry with variation of the Li concentraion in the ZnO sources. Without incorporation of Li element, the ZnO surface showed large spiral domains. As the Li content increases, the size of spiral domains decreased gradually, and finally formed mixed small grain and one-dimensional nanorod-like structures on the surface. This morphological evolution was explained based on an anti-surfactant effect of Li atoms on the ZnO growth surface. In addition, the Li-incorporation changed the optical and electrical properties of the ZnO thin films by modifying the crystalline defect structures by doping effects.