• Journal of the Korean Solar Energy Society
• /
• v.35 no.4
• /
• pp.17-24
• /
• 2015

The formation of heat islands causes high energy demand for space cooling and peak cooling loads in conditioned buildings. High-temperature fluctuations on a building roof may cause mechanical stress and increase surface deterioration. Thermal energy storage (TES) systems using microencapsulated phase-change materials (MPCMs) have been recognized as one of the most advanced energy technologies for enhancing the energy efficiency and sustainability of buildings. In this study, we prepared MPCM/paint composites for mitigating the heat island effect and reducing peak temperature. In addition, we carried out thermal and physical analysis of prepared MPCM composite samples by means of SEM, FTIR spectroscopy, DSC, and TGA. Further, we evaluated the dynamic heat transfer performance of heat-storage tiles painted with 10 g of heat-storage paint. From the obtained results, we deduced that MPCM/hydrophilic paint composites are more applicable to various fields, including the building sector, than MPCM/hydrophobic paint composites. On the basis of SEM and FTIR spectroscopy results, we concluded that materials with hydrophilic properties are more compatible with MPCMs than those with hydrophobic properties. In addition, DSC analysis results revealed that MPCM/hydrophilic paint composites have better compatibility, higher latent heat capacity, and better thermal properties than other composites. TGA results showed that hydrophilic-paint-based composites have higher thermal durability than hydrophobic-paint-based composites. Finally, a lot of MPCM-loaded heat-storage tiles showed lower peak temperatures at all measurement positions.

• Journal of Environmental Impact Assessment
• /
• v.31 no.1
• /
• pp.63-74
• /
• 2022

In orderto understand the urban thermal conditions, many studies have been conducted to estimate the thermal fluxes. Currently sensible heat fluxes are estimated through various methods, but studies about comparing the differences between each method are very insufficient. Therefore, this study try to estimate the sensible heat flux of the same area by two representative estimation methods and compare their results to confirm the significance and limitation between methods. As a result of the study, the heat balance methods has a great advantage in terms of resolution but it can not consider the anthropogenic heat flux, so sensible heat flux can be underestimated in urban areas. When estimating based on physical equation, anthropogenic heat flux can be considered and the error is relatively small, it has a limitations in time and space resolutons. The two methods showed the largest difference in industiral areas where anthropogenic heat fluxes are high, with an average of 135 W/m² and a maximum of 400 W/m². On the other hand, the green and water have a very small difference with and average of 20 W/m². The results between two methods show significant differences in urban areas, it is necessary to select a suitable method for each research purpose.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.39 no.2
• /
• pp.113-122
• /
• 2021

Urban expansion, particularly converting sub-urban areas to residential and commercial land use in metropolitan areas, has been considered as a significant signal of regional economic development. However, this results in urban climate change. One of the key impacts of rapid urbanization on the environment is the effect of UHI (Urban Heat Island). Understanding the effects of urban land cover change on UHI is crucial for improving the ecology and sustainability of cities. This research reports an application of remote sensing data, GIS (Geographic Information Systems) for assessing effects of urban land cover change on the LST (Land Surface Temperature) and heat budget components in Ho Chi Minh City, where is one of the fastest urbanizing region of Vietnam. The change of urban land cover component and LST in the city was derived by using multi-temporal Landsat data for the period of 1998 - 2020. The analysis showed that, from 1998 to 2020 the city had been drastically urbanized into multiple directions, with the urban areas increasing from approximately 125.281 km² in 1998 to 162.6 km² in 2007, and 267.2 km² in 2020, respectively. The results of retrieved LST revealed the radiant temperature for 1998 ranging from 20.2℃ to 31.2℃, while that for 2020 remarkably higher ranging from 22.1℃ to 42.3℃. The results also revealed that given the same percentage of urban land cover components, vegetation area is more effective to reduce the value of LST, meanwhile the impervious surface is the most effective factor to increase the value of the LST.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.4
• /
• pp.1619-1629
• /
• 2013

It turned out that there was a direct or an indirect relationship among global warming, urban heat island effects, urban and traffic environments, and public's health. In particular, unusual climate phenomena such as frequent heavy rainfall and scorching heat in a row that had rarely happened before have a negative effect on quality of life for people living in urban areas. This study focuses on the effects of roadway geometric design and traffic conditions on air temperature of roadside in Seoul Metropolitan Areas, controlling of roadway micro-climate environment. Five roadway segments containing different roadway and traffic conditions in terms of traffic median with trees, street trees, traffic volume and average travel speeds were surveyed. According to statistical results(t-test) from three roadway air temperature regression model estimations, air temperature is found to be different from one another in three periods-morning, afternoon and evening. Regarding roadway geometric design, air temperature of urban roads with vegetated median strips is lower about 1.3~2.2 degrees in celcius. Higher traffic volumes per lane and lower average travel speeds will tend to increase roadside air temperature, and efficient traffic operation policies can protect from increasing roadside air temperature in urban areas.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.26 no.2
• /
• pp.42-54
• /
• 2023

The population is concentrated in the metropolitan areas in Korea, and low-density residential areas are transforming into high density residential areas through redevelopment to meet this demand. However, large-scale redevelopment in a short period of time has a negative impact on the urban climate, such as generating a heat island effect due to the reduction of urban green areas. In this study, the change in surface temperature from 2013 to 2022 in the redevelpment areas of Godeok-dong and Dunchon-dong, Gangdong-gu, Seoul, was analyzed using Landsat 8 satellite images. In the Godeok-dong area, the difference in surface temperature was analyzed for the target redevelopment area, forest area, mixed forest and urban area, and low density residential area. In the Dunchon-dong area, the difference in surface temperature was analyzed for the target redevelopment area, forest area, and low density residential area. The difference in surface temperature was analyzed through multiple regression analysis conducted yearly over the three different stages in redevelopment period. The results from the multiple regression analysis show that in both areas, the land surface temperature of target redevelopment area was higher than that of the forest area and lower than low density residential area. It can be seen that these results occurred because the low-density residential area in Godeok-dong and Dunchon-dong had a lower green area ratio and a higher building-to-land ratio than the target redevelopment area. The results of this study suggest that even if low-density residential areas are transforming into high-density areas, adjusting the management of green areas and building-to-land ratio can contribute to lessen urban heat island effect.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2010.05a
• /
• pp.91-100
• /
• 2010

To investigate the thermal properties of a water-retentive artificial turf system (W-ATS), we estimated hydrologic parameters including thermal conductivity, heat capacity, and surface albedo for both the W-ATS and natural grass. We used a model experiment to measure surface temperature and evaporation for both the W-ATS and natural grass. We found that the W-ATS had lower thermal conductivity than natural grass did, and it was difficult for the W-ATS to convey radiant heat to the ground. Compared to natural grass, the W-ATS also had lower heat capacity, which contributed to its larger variation in surface temperature: the W-ATS had higher surface temperatures during daytime and lower surface temperatures during nighttime. The albedo of the W-ATS was one-quarter that of natural grass, and reflected shortwave radiation from the W-ATS surface was lower than that from the surface of natural grass. These results indicate that the W-ATS caused the soil temperature to increase. Furthermore, evaporation from the W-ATS was one-quarter the value of evapotranspiration from natural grass.

• 한국태양에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.21-25
• /
• 2009

This study is about heat island as one of the urban climate variation factors in urbanized modern society, which compared and observed the thermal characteristics both the downtown location and the outskirt site in summer. The diurnal air temperature range at each point is $12.6^{\circ}C$ in the downtown location and $14.3^{\circ}C$ in the outskirt site, so, it was found that the diurnal air temperature range in the outskirt site was $1.7^{\circ}C$ higher than in the downtown location. There was 20 minutes difference to reach the highest temperature between globe temperature and air temperature in the downtown location, however, the time spent to reach the highest temperature between globe temperature and air temperature in the outskirt site was the same. When we compared the globe temperature between the downtown location and outskirt site, we found that the temperature in the outskirt site was lower than in the downtown location after sunset due to the sudden temperature drops, although the exposed time to insolation in the outskirt site is longer. The average of globe temperature difference on the sample days was $1.1^{\circ}C$, the average of surface temperature difference on the sample days was $1.0^{\circ}C$, and the average of air temperature difference on the sample days was $2.0^{\circ}C$ Thus, it was found that the average of air temperature difference was higher than the average of globe temperature and the average of surface temperature. The result of this study is that the urban environment factors have more effect on the air temperature difference than globe temperature and surface temperature.

• Korea Science and Art Forum
• /
• v.36
• /
• pp.11-22
• /
• 2018

This study recent changes in urban thermal environment caused by climate change generate diverse problems such as urban heat island effects, heat wave, and drought. Under this condition, with the increased perception and expectation of the quality of life, the urban citizens' desire for outdoor activities is increasing. This study conducted the thermal environment analysis focusing on the urban ecological park used by many urban citizens, and also suggested the renovation measures for urban ecological park considering the thermal environment. As the research site, the ecologically-favorable Gildong Ecological Pak with diverse space composition was selected. The measuring items were measured and analyzed by dividing them into thermal environment index and thermal comfort index. In the results of analysis in each type of park space, the forest zone showed the most favorable result. Based on such results, total three kinds of renovation measures for urban ecological park considering the thermal environment were suggested. Through this, the urban ecology park renovation plans were presented in three ways. The results of this study are meaningful in that it can be used as a base material for creating an ecological park considering the thermal environment.

• Journal of the Korean housing association
• /
• v.24 no.1
• /
• pp.51-59
• /
• 2013

This study aims to improve the thermal comfort level of detached housing area by reducing the impact of thermal environment. The study focused on reducing surface temperature that is generated in buildings and adjacent spaces as a result of sensible heat load and presented a proposal on implementing planting method considering its outdoor condition and structure and composed materials. To perform the study, we utilized 3D-CAD to examine the outdoor condition and structure and composed materials that impact on surface temperature and conducted space design after reflecting climatic elements in simulations. The result is as follows. In reviewing temperature distribution of Heat Island Potential (HIP) of buildings and adjacent spaces, in case where green coverage ratio is increased, there was a $6^{\circ}C$ temperature difference and in regard to changes in the thermal environment in detached housing area, in case where rooftop planting, surface improvement, planting, and overall green coverage ratio is increased, there was a $10^{\circ}C$ temperature difference. In addition, there was difference in temperature in detached housing area following the changes in wind.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.44 no.4
• /
• pp.109-120
• /
• 2016

This study aims to assess vulnerability in urban thermal environments of Seoul by using indicators frequently used in previous studies as well as effective indicators for spatial planning like urban and environmental planning. For this purpose, fifteen indicators that influence urban thermal environments such as heat waves, urban heat island effects, and urban micro-climates were identified based on literature reviews. Indicators for presenting urban structure and spatial properties were included; for example, building volume as 'exposure to climate', buildings completed before 1980 as 'sensitivity', and green space areas as 'adaptive capacity'. Among them, twelve indicators were applied to assess vulnerability in urban thermal environments of Seoul by using a GIS spatial analysis combined with fuzzy logic. The results show that the Gangnam area is identified as more vulnerable to a heat environment as compared to the Gangbuk area. In the Gangnam area, Seocho-gu, Gangnam-gu, Dongjak-gu, Yeongdeungpo-gu, Gangseo-gu were relatively high in vulnerability, while Dongdaemun-gu, Gangbuk-gu, Gwangjin-gu, Jungrang-gu were relatively high in the Gangbuk area. Gwanak-gu, Dobong-gu, Eunpyeong-gu, and Nowon-gu, which include forested areas, have low vulnerability in the sectors of 'exposure to climate' and 'sensitivity' due to the impact of Gwanaksan and Bukhansan. However, some areas with high vulnerability like Seocho-gu and Gangnam-gu may have lower vulnerability if the indicator 'status of air conditioning' from the sector of 'adaptive capacity' is used. This study could support the establishment of a practicable thermal environment policy and spatial planning to reduce heat-related risks in the field of urban and environmental planning.