• Journal of Korea Water Resources Association
• /
• v.45 no.1
• /
• pp.65-73
• /
• 2012

Recently climate change and increase of surface runoff caused the urban flooding. Traditional way of dealing with urban flooding has been to increase the sewer capacity or construction of pumping stations, however, it is practically almost impossible because of time, money and traffic problems. Multipurpose DRMS (Decentralized Rainwater Management System) is a new paradigm proposed and recommended by NEMA (National Emergency Management Agency) for both flood control and water conservation. Suwon City has already enacted the ordinance on sound water cycle management by DRMS. In this study, a flood prone area in Suwon is selected and analysis of DRMS has been made using XP-SWMM for different scenarios of RT installation with same total rainwater tank volume and location. Installing one rainwater tank of 3,000$m^3$ can reduce the peak flow rate by 15.5%. Installing six rainwater tanks of 500$m^3$ volume in the area can reduce the peak flow rate by 28%. Three tanks which is concentrated in the middle region can reduce peak rate more than evenly distributed tanks. The method and results found from this study can be used for the design and performance prediction of DRMS at a flood prone area by supplementing the existing sewer system without increase of the sewer capacity.

• Journal of Environmental Science International
• /
• v.14 no.12
• /
• pp.1185-1194
• /
• 2005

The runoff characteristics of non-point source pollutions in the municipal area of Jeonju were investigated and analyzed by using the SWMM (Storm Water Management Model). The flow rates and water qualities of runoff from two types of drainage conduits were measured respectively. One was a conventional combined sewer system and the other was a separated sewer system constructed recently From August to November in 2004, investigations on two rainfall events were performed and flow rate, pH, BOD, COD, SS, T-N and T-P were measured. These data were also used for model calibration. On the basis of the measured data and the simulation results by SWMM, it is reported that $80-90\%$ of pollution load is discharged in the early-stage storm runoff. Therefore, initial 10-30 mm of rainfall should be controlled effectively for the optimal treatment of non-point source pollution in urban area. Also, it was shown that the SWMM model was suitable for the management of non-point source pollution in the urban area and for the analysis of runoff characteristics of pollutant loads.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.11 no.2
• /
• pp.13-27
• /
• 2008

This paper aim to reorganize zoning areas for decreasing first-flush runoff contamination in a separated sewer system via suitability analysis, and to simulate the discharge pollution loads of first-flush runoff using SWMM. For these purposes, diffuse pollution, which is accumulated on a surface and first-flush runoff flow were investigated. Suitability conditions for zoning were defined using the results of these investigation and suitable zoning areas were analyzed for the each condition. AHP analysis was conducted to establish weights of the suitability conditions. The most suitable zoning areas were analyzed via overlaying weights and suitability conditions. From the result, it was noted that the most suitable zones for detached houses & apartments are location they already occupied. Some school areas analyzed were found to be suitable as commercial centers. Some zones within the area analyzed were found to be suitable for commercial zones. From results obtained from simulation, the zone re-organization showed BOD and SS concentration to reduce from 91.2% to 0.09% ans 72.74% to 0.31% respectively.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.14 no.1
• /
• pp.40-50
• /
• 2011

We study the characteristic and total flux of non-point pollutants such as total suspended solids (TSS), chemical oxygen demand (COD), dissolved nutrients, total phosphorus (TP) and total nitrogen (TN) in the storm water runoff from urban streams and sewer outlets of Banweol Industrial Complex around Shihwa Lake. The concentrations of non-point pollutants were generally increased with increasing of the duration and intensity of rainfall. Mean TSS concentration of Ansan stream was higher than that of sewer outlets but mean concentrations of COD, TP and TN were approximately 2~5 times higher of sewer outlet than of urban stream. TSS showed statistically positive relationships with COD and TP but it had negative correlation with dissolved nutrients. There was a significant correlation between total flux of non-point pollutants in the storm water runoff and total basin area of each sewer outlet, showing that the highest runoff flux was observed at 3rd sewer outlet which represents the largest basin area from Banweol industrial complex. Total runoff fluxes for TSS, COD, TP and TN in this study were 187,536 kg, 17,118 kg, 922 kg, 13,519 kg, respectively. Given the basin area of sewer outlet in Banweol industrial complex which corresponds only 3% from total catchment area around Shihwa Lake, enormous amount of non-point pollutants will be entered into Shihwa Lake without any treatment. It is necessary to manage and reduce of various non-point sources and pollutants because the runoff of nonpoint pollutants during storm events should be deteriorating the water quality of Shihwa Lake. Our results provides useful informations on the development of best managements practices (BMPs) for effective implementation of total pollution loads management system of Shihwa Lake.

• Journal of Korea Water Resources Association
• /
• v.43 no.2
• /
• pp.211-220
• /
• 2010

The objective of this paper presents the application of an "integrated urban flood modeling-runoff model, urban flood model and sewer system model-" in a highly urbanized area of Samcheok where is seriously inundated in 2002 and 2003. For this, we demonstrate how couple a 1-D hydrodynamic model of the river, a 2-D hydrodynamic model of the overland (surface) flow, and a sewer network model including each boundary conditions. In order to make data file for the model, topographic information like elevation and share rate of buildings are directly extracted from DEM or topographical source data without data exchange to avoid uncertainty errors. Furthermore, the research is to assess the impacts of Manning n and buildings influences to inundated depth by changing its share ratio from 10 % to 30 % in low-land urban area. As a results, we found out that the urban inundated depth was decreased by Manning n but increased by buildings ratio. The calculated results of inundation was similar with observed one in 2002 and 2003 flooding. Furthermore, the area was also inundated under not riverbank break case in 2002 flooding.

• Journal of Korean Society of Water and Wastewater
• /
• v.20 no.4
• /
• pp.573-584
• /
• 2006

This study was carried out to investigate the causes of fish kills in the Yudeung Stream in Daejeon, Korea using literature reviews, governmental and our water quality monitoring data of the study site, rainfall data, intensive water quality monitoring during rainfall events, sediment pollutant contents and laboratory bioassay tests. Fish kill in urban streams can be caused by combined effect of reduction in dissolved oxygen concentration, increase in toxic material or increase in turbidity in waterbody due to introduction of surface runoff or effluent of combined sewer overflows after rainfall from the watershed areas. Despite of extensive and intensive field surveys and laboratory tests, it was found that those conventional methods have limitations to identify causes of fish kills in urban streams. It would be necessary to use dynamic water quality modeling to predetermine the range and level of water pollution in the stream and automatic water quality monitoring system that can collect water samples and detect water quality continuously.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.51 no.3
• /
• pp.9-14
• /
• 2009

Flow and pollution load were monitored at 2 combined sewer outlets (C-1 and C-2) of urban watersheds during dry weather from September, 2004 to April, 2006 for 20 months. The objectives were to investigate the diurnal variation of flow and pollutant load and to find the proper sampling time that could measure representative flow and pollutant load. Pollution load closed to the average daily load at C-1 could be measured at 00:00 hour and by the mean of 15:00 and 18:00 hour measures, and 15:00 and 21:00 hour measures, respectively. In addition at C-2, it was 21:00 hour and the mean of 15:00 and 18:00 hour measures. This study concluded that arbitrary sampling of flow and water quality could cause large errors in the estimation of urban pollution load and recommended that urban combined sewers should be monitored when flow and water quality showed daily average and concentration.

• International conference on construction engineering and project management
• /
• 2013.01a
• /
• pp.367-374
• /
• 2013

Underground infrastructure systems provide essential public services and goods through buried structures including water and sewer, gas and petroleum, power and communication pipelines. The majority of existing underground infrastructure systems was installed in green field areas prior to development of complex urban built environments. Currently, there is a global trend to escalate major demand for underground infrastructure system renewal and new installation while minimizing disruption and maintaining functions of existing superstructures. Therefore, Engineers and utility owners are rigorously seeking technologies that minimize environmental, social, and economic impact during the renewal and installation process. Trenchless technologies have proven to be socially less disruptive, more environmentally friendly, energy conservative and economically viable alternative methods. All of those benefits are adequate to enhance overall sustainability. This paper describes effective sustainable solutions using trenchless technologies. Sustainability is assessed by a comparison between conventional open cut and trenchless technology methods. Sustainability analysis is based on a broad perspective combining the three main aspects of sustainability: economic; environmental; and social. Economic includes construction cost, benefit, and social cost analysis. Environmental includes emission estimation and environmental quality impact study. Social includes various social impacts on an urban area. This paper summarizes sustainable trenchless technology solutions and presents a sustainable construction method selection process in a proposed framework to be used in urban underground infrastructure capital improvement projects.

• International conference on construction engineering and project management
• /
• 2015.10a
• /
• pp.54-55
• /
• 2015

Increase of impervious areas due to expansion of housing area, commercial and business building of urban is resulting in property change of stormwater runoff. Also, rapid urbanization and heavy rain due to climate change lead to urban flood and debris flow damage. In 2010 and 2011, Seoul had experienced shocking flooding damages by heavy rain. All these have led to increased interest in applying LID and decentralized rainwater management as a means of urban hydrologic cycle restoration and Natural Disaster Prevention such as flooding and so on. Urban development is a cause of expansion of impervious area. It reduces infiltration of rain water and may increase runoff volume from storms. Low Impact Development (LID) methods is to mimic the predevelopment site hydrology by using site design techniques that store, infiltrate, evaporate, detain runoff, and reduction flooding. Use of these techniques helps to reduce off-site runoff and ensure adequate groundwater recharge. The contents of this paper include a hydrologic analysis on a site and an evaluation of flooding reduction effect of LID practice facilities planned on the site. The region of this Case study is LID Rainwater Management Demonstration District in A-new town and P-new town, Korea. LID Practice facilities were designed on the area of rainwater management demonstration district in new town. We performed analysis of reduction effect about flood discharge. SWMM5 has been developed as a model to analyze the hydrologic impacts of LID facilities. For this study, we used weather data for around 38 years from January 1973 to August 2014 collected from the new town City Observatory near the district. Using the weather data, we performed continuous simulation of urban runoff in order to analyze impacts on the Stream from the development of the district and the installation of LID facilities. This is a new approach to stormwater management system which is different from existing end-of-pipe type management system. We suggest that LID should be discussed as a efficient method of urban disasters and climate change control in future land use, sewer and stormwater management planning.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.2
• /
• pp.521-528
• /
• 2013

Urban drainage systems are generally designed as open channel flow. The system, however, shows a partially surcharged flow in its body, especially at junctions or manholes. Thus, a special case of this condition needs to be explained as pressurized flow condition for designing the sewer system. This study considered the surcharged manhole flows during an unexpected rainfall event or an excess of design frequency. Overflows from surcharged manholes and urban flooding can occur from the effect of surcharged flows. Thus, sewer systems should be designed with the concept of open channel flow and pressurized flow. Also, energy losses in a manhole need to be considered. The aim of this study is to develop the numerical model which can evaluate the effect of the energy losses at the manhole. The numerical model was verified and compared with hydraulic model and SWMM. The results showed that the water depth of numerical model was in good agreement with hydraulic model at the each manhole. However, the SWMM underestimated the water depth because that model ignored the energy losses at manholes. Thus, the developed numerical model in this study could be a useful tool for the assessment of a conveyance of urban drainage system.