• The KSFM Journal of Fluid Machinery
• /
• v.10 no.2 s.41
• /
• pp.16-21
• /
• 2007

Potential advantages of using vapor injection in a two stage rotary compressor for a $CO_2$ heat pump water heater system were addressed in this paper by numerical simulation. Vapor separated from a flash tank in the middle of the expansion process can be used for injection into the second stage suction plenum of the compressor to improve the system performance. Vapor injection increases the intermediate pressure between the two stages, thus increasing the first stage compressor work and reducing that of the second stage. As a whole, however, the compressor input power increases due to injected mass flow rate for the second stage. Computer simulation showed that increment of the cooling capacity by vapor injection exceeded that of the compressor work, thus improving the system performance. COP improvement by vapor injection was calculated to be about 5-14% for normal operating conditions. With vapor injection, a maximum COP was found when the displacement volume of the second stage becomes 90-95% of that of the first stage of the compressor.

• Tribology and Lubricants
• /
• v.33 no.4
• /
• pp.153-167
• /
• 2017

The aim of this study is to find the change in trend in the eccentricities of two journal bearings supporting the crankshaft of a single cylinder engine and the degree of misalignment of the shaft. We analyze the change in oil film thickness considering the wear scar under mixed-elasto-hydrodynamic lubrication regime at potential wear regions. For this, we first calculate the central eccentricities of the two journal bearings by using the mobility method. Then we calculate the outer end eccentricity by using the geometry of the bearings. Further, the tilting angle and degree of misalignment of the shaft are calculated by using the eccentricities of the two bearings. We show that the eccentricity of bearing #1, on which higher load is applied, increases at the beginning of the start-up cycle and during the coast-down cycle. However, the eccentricity of bearing #2, on which lower load is applied, decreases at the beginning of the start-up cycle and increases during the coast-down cycle. From the results of the analysis of oil film thickness, we show that the mixed-elasto-hydrodynamic lubrication regime for a misaligned shaft is at the initial stages of the start-up cycle for both bearing #1 and #2 and at the final stage of the coast-down cycle for only bearing #1.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2001.11a
• /
• pp.123-127
• /
• 2001

In this paper, prototype high-power-factor single-stage electronic ballast for fluorescent lamps is designed and implemented. A new low cost single stage high power factor electronic ballast for fluorescent lamps is based on integration of two-boost converter and LC type high frequency resonant converter. A ballast is obtained by simple construction, because full bridge rectifier diode is eliminated and simple control circuit is applied. Using two boost converter operating positive and negative half cycle respectively at line frequency (60Hz), operation in discontinuous conduction mode performs high power factor. The experimental results Show the good performance as PF 0.99, $A_{THD}$ 15.4%, and CF 1.65 at Output 63.5W.W.

• Progress in Superconductivity and Cryogenics
• /
• v.15 no.1
• /
• pp.45-50
• /
• 2013

Closed-loop J-T (Joule-Thomson) refrigeration cycle is advantageous compared to common open loop $N_2$ decompression system in terms of nitrogen consumption. In this study, two closed-loop pure $N_2$ J-T refrigeration systems with sub-atmospheric device for cooling High Temperature Superconductor (HTS) power cable are investigated. J-T cooling systems include 2-stage compressor, 2-stage precooling cycle, J-T valve and a cold compressor or an auxiliary vacuum pump at the room temperature. The cold compressor and the vacuum pump are installed after the J-T valve to create sub-atmospheric condition. The temperature of 67 K is possible by lowering the pressure up to 24 kPa at the cold part. The optimized hydrocarbon mixed refrigerant (MR) J-T system is applied for precooling stage. The cold head of precooling MR J-T have the temperature from 120 K to 150 K. The various characteristics of cold compressor are invstigated and applied to design parameter of the cold compressor. The Carnot efficiency of cold compressor system is calculated as 16.7% and that of vacuum pump system as 16.4%. The efficiency difference between the cold compressor system and the vacuum pump system is due to difference of enthalpy change at cryogenic temperature, enthalpy change at room temperature and different work load at the pre-cooling cycle. The efficiency of neon-nitrogen MR J-T system is also presented for comparison with the sub-atmospheric devices. These systems have several pros and cons in comparison to typical MR J-T systems such as vacuum line maintainability, system's COP and etc. In this paper, the detailed design of the subcooled $N_2$ J-T systems are examined and some practical issues of the sub-atmospheric devices are discussed.

• Journal of Korean Institute of Industrial Engineers
• /
• v.41 no.5
• /
• pp.488-498
• /
• 2015

Research on stem cells can be divided into three categories : pluripotent stem cell, adult stem cell, and induced pluripotent stem cell. Technology life cycle (TLC) on research stage is analyzed for the three stem cell categories based on diffusion model. Three diffusion models-logistic, Bass, and Bass model with integration constant (BMIC)-are applied to the number of articles related to each stem cell category in SCOPUS lists. Two different parameter estimation methods is used for each of logistic and Bass model. Results show that (1) the current year, 2015, lies in growth period at pluripotent stem cell and adult stem cell, and lies in growth period or maturity period at induced pluripotent stem cell. (2) Model fitness is the highest at BMIC model. (3) Imitation effect works best at the research area of induced pluripotent stem cell.

• The Journal of Asian Finance, Economics and Business
• /
• v.8 no.3
• /
• pp.497-504
• /
• 2021

This extended study aims to analyze empirically the influence of firm diversification on firm performance moderated by the stages of the firm life cycle, which consists of introduction, growth, maturity, and decline. The target population of this study is the firms listed on the Indonesian Stock Exchange. The sampling method uses purposive sampling in the multi-business firm in Indonesia; it includes as many as 127 firms over the period from 2011 to 2017, totaling 889 firm-year observations. The firm performance is measured using a return of equity while the level of firm diversification with the minimum number of two operating segments is proxied by the Herfindahl index. The analysis method used in this study is the estimator model of the Generalized Method of Moment (GMM). The main findings show that the firm life cycle at the stage of growth and maturity significantly strengthens the influence of firm diversification on firm performance. On the other hand, the stage of decline fails to moderate the relationship between firm diversification and firm performance. This study discusses the implications and contributions of the findings theoretically, and provide some policy justifications for potential investors before they invest their money in the capital market.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.8 no.2
• /
• pp.39-50
• /
• 2000

Thermodynamic cycle analysis is presented to estimate the maximum liquefaction rate of hydrogen for various systems using a Gifford-McMahon(GM) cryocooler. Since the present authors` previous experiments showed that the gaseous hydrogen was liquefied approximately at the rate of 5.1 mg/s from the direct contact with a commercial two-stage GM refrigerator, this study has been proposed to predict how much the liquefaction rate can be increased in different configurations using the GM cooler and with improved heat exchangers. The optimal operating conditions have been analytically sought with real properties of normal hydrogen for the Linde-Hampson(L-H) system precooled by single-stage GM, the direct-contact system with two-stage GM, the L-H system precooled by two-stage GM, and the direct-contact system with helium GM-JT (Joule-Thomson). The maximum liquefaction rate has been predicted to be only about 7 times greater than the previous experiment, even though the highly effective heat exchangers may be employed. It is concluded that the liquefaction rate is limited mainly because of the cooling capacity of the commercially available GM cryocoolers and a practical scale of hydrogen liquefaction is possible only if the GM cooler has a greater capacity at 70-100 K.

• Asian-Australasian Journal of Animal Sciences
• /
• v.18 no.7
• /
• pp.1022-1028
• /
• 2005

The objectives of this study were to evaluate and compare the environmental load of two different concentrate feed supply systems to the Japanese domestic livestock industry using the Life-cycle Assessment (LCA) method. The current system was defined as that requiring 11.469 million tons of corn imported from the US by sea transport and supplied as concentrate feed to the Japanese domestic livestock industry. The new system proposed by Kaku et al. in 2004 was defined as where 802,830 tons of US imported corn would not be planted in US and would be replaced by barley planted in 278 thousand ha of Japanese domestic land left fallow for the past year. In this case, 909,000 tons of domestic harvest barley would have been supplied as concentrate feed to the Japanese domestic livestock industry in 2000. The activities taken into account within the two system boundaries were three stages: concentrate feed production, feed transportation and gas emission from the soil by chemical fertilizer. Finished compost was regarded as organic fertilizer and was put instead of chemical fertilizers within the system boundary. Adoption of this new concentrate feed supply system by the Japanese domestic livestock industry could reduce 78,462 tons $CO_2$-equivalents of global warming potential, 347 tons $SO_2$-equivalents of acidification potential, 54 tons $PO_4$-equivalents of eutrophication potential and 0.842 million GJ as energy consumption below 2,000 levels. This LCA study comparing two Japanese domestic livestock concentrate feed supply systems showed that the stage of feed transport contributed most to global warming and the stage of emission from the soil contributed most to acidification and eutrophication. The Japanese domestic livestock industry could participate in emissions trading with $CO_2$-equivalents reduced by shifting from some imported US corn as a concentrate feed to domestic barley planted in land left fallow. In that case the Japanese government could launch emissions trading in accordance with Kyoto Protocol in the future.

• Journal of Korean Elementary Science Education
• /
• v.32 no.2
• /
• pp.139-158
• /
• 2013

This study investigated elementary students' (grade 4~6) learning progressions for water cycling drawn from iterative assessments using ordered multiple-choice (OMC) items. An assessment system, which consisted of construct map, item design, outcome space, and measurement model, was employed in this study to examine children's learning progressions. At the first stage of the assessment system, a construct map was designed on which children's conceptual understandings from naive to most sophisticated were represented. At the item design stage, 8 OMC items were drawn from the construct map. Each item option of the OMC items was scored from 0 to 3 according to its level of understanding at the stage of outcome space. As a measurement model, Rasch model, a branch of item response theory, was applied to interpreting the outcomes of the OMC items. This cycle of assessment system was furtherly implemented iteratively in order to elaborate on the first version of water cycling learning progression. In conclusion, children's understanding of water cycling could be described in two aspects: water distribution and water movement. We identified children's conjectural developmental pathways about water cycling existed from superficial and naive accounts to more complex and abstract accounts.

• Journal of the Korean housing association
• /
• v.8 no.3
• /
• pp.59-66
• /
• 1997

The purpose of this study is to explore the relationships between the various types of activities occurring in domestic space and the resident's characteristics in Belgium. Data for this study was collected by questionnaires mailed to 133 staff member. both academic and administrative. working at The Free University of Brussels. a university serving the Dutch speaking community in Belgium. General leneal model and Duncan test were used in analyzing the data. The major findings of the study can be summarized as follows: First. families in the life-cycle stage of having no children are more likely to relax and watch T.V. and do housework in the master bedroom than those in the launching stage. Families in the life-cycle stage of elementary school are more likely to eat meals in the kitchen than those in the launching period. Second. families made up two members and under tend to do more housework in the master bedroom than those of three and over. Third. those with aged 30 and under are more likely to relax and watch T.V., and to do housework in the master bedroom than those with aged 51 and over. Forth. the renter status of homeownership tend to more relax and watch T.V., and to do housework in the master bedroom than the owner Fifth. those living with less floor space tend to relax and watch T.V. in the master bedroom more than those with larger residences.