• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.1
• /
• pp.31-38
• /
• 2020

In this paper, we propose a quadruple band antenna for GPS/WLAN/WiMAX application. The proposed antenna has quadruple band characteristics by considering the interconnection of four strip lines and DGS on the ground place. The total substrate size is 20.0 mm (W1) ⨯27.0 mm (L1), thickness (h) 1.0 mm, and the dielectric constant is 4.4, which is made of 20.0 mm (W2)⨯ 27.0 mm (L8 + L6+ L10) antenna size on the FR-4 substrate. From the fabrication and measurement results, bandwidths of 60 MHz (1.525 to 1.585 GHz) bandwidth for GPS band, 825 MHz (3.31 to 4.135 GHz) bandwidth for WiMAX band and 480 MHz (2.395 to 2.975 GHz) and 385 MHz (5.10 to 5.485 GHz) bandwidth for WLAN band were obtained on the basis of -10 dB. Also, gain and radiation pattern characteristics are measured and shown in the frequency of triple band as required.

• Korean Journal of Agricultural Science
• /
• v.35 no.1
• /
• pp.11-17
• /
• 2008

This study was conducted to isolate polyacetylenes from the Acanthopanax senticosus and to identify the chemical structure of the polyacetylenes by UV, IR, $^1H$-NMR and $^{13}C$-NMR. One of the liposoluble materials was extracted with petroleum ether. Polyacetylene compounds were collected through solvent fractionation at silica gel column chromatograph. The HPLC was used for the semi-preparative separation IR spectra of fraction 5 showed triple bonds at $2256cm^{-1}$ and double bond at $1654cm^{-1}$, respectively, $^1H$-NMR spectra of Fraction 5 showed the double bond at 5.35-5.48 ppm. Triple bond at 64.0. 71.2, 74.2, 80.2 ppm and double bond at 121.89, 133.0 ppm were observed in the $^{13}C$-NMR spectra.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.6
• /
• pp.87-96
• /
• 1999

For analog optical transmission of narrow-band microwave signal, a novel all-optical linearization technique of electro-absorption (EA) optical modulator by using dual modulation scheme is proposed and theoretically investigated. By using the dual modulation scheme where the sub-modulator has a different length, DC bias and band-gap wavelength, the DC bias operation point where the third-order intermodulation products of ~30dB and the following increase of spurious free dynamic range (SFDR) of ~20dB wave achieved in sub-octave narrow band operation.

• 한국정보통신설비학회:학술대회논문집
• /
• 2008.08a
• /
• pp.441-446
• /
• 2008

In this papers, a PLDRO(Phase Locked Dielectric Resonator Oscillator) is designed and implemented at the oscillator in which fundamental frequency is 18.3 GHz. The proposed PLDRO so as to improve the PLDRO of the general structure is designed to the goal of the minimize of the size and the performance improvement. Three VCO(Voltage controlled Oscillator) and the power combiner improved the output power. A VCDRO(Voltage Controlled Dielectric Resonator Oscillator) is manufactured using a varactor diode to tune oscillating frequency electrically, and its phase is locked to reference frequency by SPD(Sampling Phase Detector). This product is fabricated on Teflon substrate with dielectric constant 2.2 and device is ATF -13786 of Ka-band using. This PLDRO generates an output power of 5.67 dBm at 18.3 GHz and has the characteristics of a phase noise of -80.10 dBc/Hz at 1 kHz offset frequency from carrier, the second harmonic suppression of -33 dBc. The proposed PLDRO can be used in Ka-band satellite applications

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.11
• /
• pp.1259-1268
• /
• 2010

In this paper, we presented a new LC prototype synthesis method for the multi-band filter. For synthesis a multi-band filter with the required frequency response, we proposed the diagram of poles and zeros, also, we proposed the optimization process for finding the combination of optimized poles and zeros. From the transfer and reflection functions calculated from poles and zeros, we performed the quasi-elliptic LC prototype synthesis of multi-band filter. Using the proposed LC prototype synthesis method of multi-band filter, dual-band filter operating at GSM(880~960 MHz) and ISM(2,400~2,500 MHz) and triple-band filter operating at GSM(880~960 MHz) and ISM(2,400~2,500, 5,725~5,850 MHz) were designed and fabricated.

• Proceedings of the IEEK Conference
• /
• 2003.07a
• /
• pp.334-337
• /
• 2003

GSM / DCS1800 / PCS 대역에서 사용 가능한 9.5mm x 6.5mm 크기의 트리플 밴드 초소형 전압제어 발진기를 설계하였다. 설계된 트리플 밴드 VCO는 GSM(880∼915MHz) 대역에서 7±3dBm의 출력전력, DCS1800 (1720∼1785MHz) 대역에서 8±3dBm의 출력전력, PCS(1720∼1780MHz) 대역에서 0±3dBm의 출력전력의 특성을 보인다. 위상 잡음의 특성은 -110dBc @100KHz 이하의 만족할만한 성능을 보인다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.320-320
• /
• 2014

Amorphous silicon alloy (a-Si) solar cells and modules have been receiving a great deal of attention as a low-cost alternate energy source for large-scale terrestrial applications. Key to the achievement of high-efficiency solar cells using the multi-junction approach is the development of high quality, low band-gap materials which can capture the low-energy photons of the solar spectrum. Several cell designs have been reported in the past where grading or buffer layers have been incorporated at the junction interface to reduce carrier recombination near the junction. We have investigated profiling the composition of the a-SiGe alloy throughout the bulk of the intrinsic material so as to have a built-in electrical field in a substantial portion of the intrinsic material. As a result, the band gap mismatch between a-Si:H and $a-Si_{1-x}Ge_x:H$ creates a barrier for carrier transport. Previous reports have proposed a graded band gap structure in the absorber layer not only effectively increases the short wavelength absorption near the p/i interface, but also enhances the hole transport near the i-n interface. Here, we modulated the GeH4 flow rate to control the band gap to be graded from 1.75 eV (a-Si:H) to 1.55 eV ($a-Si_{1-x}Ge_x:H$). The band structure in the absorber layer thus became like a U-shape in which the lowest band gap was located in the middle of the i-layer. Incorporation of this structure in the middle and top cell of the triple-cell configuration is expected to increase the conversion efficiency further.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.11
• /
• pp.2512-2520
• /
• 2013

In this paper, the T-SRR (Triple Split Ring Resonator) using MNG (mu-Negative) meta-material adapted in a low-loss bandpass filter with 3-stages is suggested. The size of the T-SRR in the proposed bandpass filter with low dielectric constant PCB can be easily controlled. And the ${\lambda}/4$ transmission line theory is applied. The proposed T-SRR and filter have the center frequency of 10 GHz with QL value of 184 for military-satellite communication system in I band. The experimental results of the filter show that the insertion and return losses are 1.44 dB and 17.3 dB with bandwidth of 10 %, respectively. The proposed filter will be redesigned by IPD material etc. should be placed here. These instructions give you guidelines for preparing papers for JICCE.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.1
• /
• pp.103-107
• /
• 2009

In this paper, we designed and implemented a dual band chip antenna for WLAN, which contains within the small LAN card contrary to the enternal AP(Access Point) antenna. Limiting about the antenna size, we used dielectrics of high permittivity. Totally considering problems of demand-supply, price and characteristics, we used that relative dielectrics of ceramic is 9.8 and the thickness is 3.5mm and 5mm. Ceramic antenna can be used not only triple mode of IEEE 802.11.a,g and b but also broadband. The frequency bands have wideband characteristics of 2.4~2.5GHz and 4.9~5.85GHz and relatively constant performance.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.26 no.6
• /
• pp.1-6
• /
• 1989

Narrowband bandpass weveguide filters using inductive post obstacles in rectangular waveguide are designed and constructed to have an equal-ripple bandwidth of 50MHz (0.56% fractional band-width) at a center frequency of 9GHz. Both the triple-post and the single-post configurations are realized and compared. The measured center frequency, bandwidth, and attenuation characteristics for both filters show good agreement with the theoretical calculations. When the two filters are compared, the insertion loss characteristic of the triple-post filter is better than that of the single-post filter by 0.8dB at the passband.