• Journal of the Korean Society of Hazard Mitigation
• /
• v.9 no.1
• /
• pp.57-64
• /
• 2009

This study intends to evaluate of the characteristics of pavement deformation and develop the model for prediction model in the asphalt layer using a regression analysis. In test, there are two different asphalt binders and 5 different aggregate types. The air voids of hot mix asphalt are 6% and 10% for target value. Repeated triaxial compression test with 3 different confining pressures was used for test at 3 different test temperatures. It is going to verify the main parameters for permanent deformation of HMA and to develop the distress model. This paper is to figure out the factor affecting the pavement deformation, and then to develop model the pavement deformation for asphalt mixture. Also, the reliability of prediction model has been studied. The permanent deformation prediction model for asphalt mixtures with temperature, loading time, and air voids has been developed and the proposed permanent deformation prediction model has been validated by using the multiple regression approach which is called Statistical Package for the Social Sciences(SPSS).

• Journal of The Korean Society of Agricultural Engineers
• /
• v.63 no.6
• /
• pp.17-26
• /
• 2021

Greenhouses have been damaged due to the uplift pressure from strong wind, for which rebar piles are often installed near the greenhouse to resist the pressure. For the effective design of rebar piles, it is necessary to access the shear strength of soil on which the greenhouse is constructed. This study experimentally evaluates the shear strength of the soil beneath the greenhouse. Four soil samples were collected from four agricultural sites, and prepared for testing with 75, 80, 85, and 90% compaction rates. One-dimensional unconfined compression test (UC), consolidated-undrained triaxial test (CU), and resonant column test (RC) were performed for the evaluation of shear strength and shear modulus. Generally, the higher shear strength and modulus were observed with the higher compaction rates. In particular, the UC shear strength increases with the increase of #200 sieve passing rate. Resulting from the CU test, the sample with the most of coarse soil had the highest friction angle, but the variation is small among samples. Resulting from the CU and RC tests, the ratio of maximum shear modulus with the major principle stress at failure was the higher at the finer soil. The ratio was two to three times greater than the ratio from the standard sand. This indicates that the shear strength is lower for the fine soil than the coarse soil at the same shear modulus. The results of this study will be a useful resource for the estimation of the pull-out strength of the rebar pile against the uplift pressure.

• Geomechanics and Engineering
• /
• v.18 no.3
• /
• pp.291-298
• /
• 2019

In order to study the mechanical properties of rock salt, triaxial compression tests under different temperatures and confining pressure are carried out on rock salt specimens, the influence of temperature and confining pressure on the mechanical properties of rock salt was studied. The results show that the temperature has a deteriorative effect on the mechanical properties of rock salt. With the increase of temperature, the peak stress of rock salt decreases visibly; the plastic deformation characteristics become much obvious; the internal friction angle increases; while the cohesion strength decreases. With the increase of confining pressure, the peak stress and peak strain of rock salt will increase under the same temperature. Based on the test data, the Duncan-Chang constitutive model was modified, and the modified Duncan-Chang rock salt constitutive model considering the effect of temperature and confining pressure was established. The stress-strain curve calculated by the modified model was compared with the stress-strain curve obtained from the test. The close match between the test results and the model prediction suggests that the modified Duncan-Chang constitutive model is accurate in describing the behavior of rock slat under different confining pressure and temperature conditions.

• Journal of the Korean GEO-environmental Society
• /
• v.12 no.1
• /
• pp.27-33
• /
• 2011

In general, the shear strength of a clay specimen under the direct shear test and the triaxial compression test increases with an increase in the shear rate. This study investigates the effects of shear rate and silt content on the stress-strain behavior of remolded Gwangyang clay, by changing the shear rate and the silt content. Based on the results of the triaxial compression tests, the equi-strain line of remolded Gwangyang clay shows initially positive slope and then becomes flat at certain strain level. As the strain level where the equistrain becomes flat is different depending on the soil with different silt contents, this can be considered as the inherent property of soil.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.5
• /
• pp.27-37
• /
• 2006

Cemented Sand and Gravel (C.S.G) method has become increasingly popular in Japan and throughout the world as a construction method and material. This method is favorably used for cofferdam and large dam because a quarry and aggregate plant facility can be diminished. Also, this method can reduce construction cost, work duration and destruction of environment. In this paper, a methodology for C.S.G mix design based on so-called soil mechanics approach is proposed for trapezoid-shaped dam. The methodology consists of selection of a suitable aggregate, introduction of compaction method, processing to prepare standard specimens, and determination of mix portions. Also, unconfined compressive strength tests and large triaxial compression tests are performed. From the results of the test, correlation equation among strength, elastic modulus and unit cement is proposed.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.3
• /
• pp.89-100
• /
• 2007

In the companion paper, we provided the novel elastic-plastic constitutive model based on the micromechanics theory. Herein, the elastic and elastic-plastic deformation of granular soils is meticulously analyzed. To guarantee high accuracy of the microscopic parameter, the systematic procedure to evaluate the parameters is provided. The analysis of the elastic response during the isotropic and triaxial compression shows that the stress-level dependency of cross-anisotropic elastic moduli is induced by the power relationship of the contact force in the normal contact stiffness, while the evolution of fabric anisotropy is more pronounced during triaxial compression. The micromechanical analysis indicates that the plastic strains are likely to occur at very small strains. The plastic deformation of tangential contacts has an important role in the reduction of soil stiffness during axial loading.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.31 no.3
• /
• pp.70-80
• /
• 1989

In this research program special triaxial compression tests and dehydration-swelling tests under the condition of freeze-thaw process were conducted to show the effects of freezethaw process on the physical properties of weathered granite soil, and their results as follows; 1.Consolidation settlement of weathered granite soil mass was increased due to freeze-thaw process, and the initial tangent coefficient of dense state was higher than that of loose state. 2.Compression behaviour of soil was increased according to the decrease of freezing temperature, and when the freezing temperature was reached under - 10$^{\circ}$C, the compression rate was not influenced by change of freezing temperature. 3.The experiments showed that the void ratio and permeability of soil were converged into their values of shrinkage limit, and the permeability was higher due to the freeze-thaw process and as the lower the freezing temperature. 4.The decrease of liquid limit was indicated as the lower the freezing temperature, and as more the freeze4haw cycles, the moisture content was shown the lower side. 5.It was shown that the shrinkage was decreased by freeze-thaw process and not influenced by way of freezing temperature, but dehydration rate was higher.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.36 no.3
• /
• pp.74-83
• /
• 1994

A series of isotropic consolidation tests, undrained and drained triaxial compression tests was carried out to investigate the physical characteristics and behaviours of marine silty sands collected from the western coast of Korea. This study also included a theoretical development of the constitutive equation to evaluate stress-strain relationship and volume change of silty sands. The results and main conclusions of the study are summarized as follows; 1. Isotropic compression and swelling index are linearly decreased with an increase in relative density. 2. Both undrained shear strengh and elastic modulus are increased with an increase in relative density and confining pressure. 3. Internal friction angles obtained from drained and undrained compression tests of the soils are proportional to relative density. 4. The phenomenon of dilatancy of each sample is less profound when confining stress is increased but more profound when relative density is increased. 5. The slope of critical state lines is 1.78 for Saemangum, 1.70 for Siewha and 1.26 for Sukmoon sands. 6. In this study, Drucker-Praper type criterion is used and hardening function of Cap model is modified by hyperbolic fuction. This will improve a lack of physical meaning of hardening parameters in conventional Cap model. 7. A newly developed constitutive equation to the forementioned silty sands and checked its applicability. This is in good agreement with the measured data.

• Geomechanics and Engineering
• /
• v.13 no.1
• /
• pp.79-97
• /
• 2017

Natural clays exhibit features such as structural and anisotropy. In this work, a constitutive model that is able to replicate these two salient features of natural clays is presented. The proposed model is based on the classical S-CLAY1 model, where the anisotropy of the soil is captured through the initial inclination and rotation of the yield surface. To account for the structural of the soil, the compression curve of the reconstituted soil is taken as the reference. All parameters of the proposed constitutive model have clear physical meanings and can be conveniently determined from conventional triaxial tests. This proposed model has been used to simulate the behavior of soft soil in the undrained triaxial tests and the performance of Murro embankment in terms of settlement and horizontal displacements during embankment construction and consolidation stage. Results of numerical simulations using proposed model have been compared with the field measurement data. The comparisons show that the two features significantly influence the prediction results.

• Geotechnical Engineering
• /
• v.4 no.3
• /
• pp.43-52
• /
• 1988

The behavior of clays subjected to Repeated loading has been shown to be very different from the behavior under a single load application. Especially the behavior of pore water pressure is Qf considerable importance. The objective of this work is to experimentally study the stress-strain characteristics of clays, and this study includes the pore water pressure which is built up during the load repetition. For this study, the samples were consolidated isotropically in the triaxial cell during 24 hours, .and monotonic strain controlled triaxial test is carried out by uslng the tests of Compression failure, Cycled at failure, and Nonfailure equilibrium on remoulded samples under undrained .condition . Consequently there exists a critical level of repeated loading which seperates the behavior of a particular sample into two distinctly different patterns.