• Journal of Sensor Science and Technology
• /
• v.31 no.1
• /
• pp.12-15
• /
• 2022

In this study, we studied the effects of transfer gate on the photocurrent characteristics of gate/body-tied (GBT) metal-oxide semiconductor field-effect transistor (MOSFET)-type photodetector. The GBT MOSFET-type photodetector has high sensitivity owing to the amplifying characteristic of the photocurrent generated by light. The transfer gate controls the flow of photocurrent by controlling the barrier to holes, thereby varying the sensitivity of the photodetector. The presented GBT MOSFET-type photodetector using a built-in transfer gate was designed and fabricated via a 0.18-㎛ standard complementary metal-oxide-semiconductor (CMOS) process. Using a laser diode, the photocurrent was measured according to the wavelength of the incident light by adjusting the voltage of the transfer gate. Variable sensitivity of the presented GBT MOSFET-type photodetector was experimentally confirmed by adjusting the transfer gate voltage in the range of 405 nm to 980 nm.

• Journal of Sensor Science and Technology
• /
• v.30 no.2
• /
• pp.114-118
• /
• 2021

In this study, the sensitivity of an active pixel sensor (APS) was adjusted by employing a gate/body-tied (GBT) p-channel metal-oxide semiconductor field-effect transistor (PMOSFET)-type photodetector with a transfer gate. A GBT PMOSFET-type photodetector can amplify the photocurrent generated by light. Consequently, APSs that incorporate GBT PMOSFET-type photodetectors are more sensitive than those APSs that are based on p-n junctions. In this study, a transfer gate was added to the conventional GBT PMOSFET-type photodetector. Such a photodetector can adjust the sensitivity of the APS by controlling the amount of charge transmitted from the drain to the floating diffusion node according to the voltage of the transfer gate. The results obtained from conducted simulations and measurements corroborate that, the sensitivity of an APS, which incorporates a GBT PMOSFET-type photodetector with a built-in transfer gate, can be adjusted according to the voltage of the transfer gate. Furthermore, the chip was fabricated by employing the standard 0.35 ㎛ complementary metal-oxide semiconductor (CMOS) technology, and the variable sensitivity of the APS was thereby experimentally verified.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.10
• /
• pp.510-514
• /
• 2004

In this paper, we analytically examine the voltage transfer function dependent on input conditions for an N-Input NAND Gate. The logic threshold voltage, defined as a voltage at which the input and the output voltage become equal, changes as the input condition changes for a static NAND Gate. The logic threshold voltage has the highest value when all the N-inputs undergo transitions and it has the lowest value when only the last input connected to the last NMOS to ground, makes a transition. This logic threshold voltage difference increases as the number of inputs increases. Therefore, in order to provide a near symmetric voltage transfer function, a multistage N-Input Gate consisting of 2-Input Logic Gates is desirable over a conventional N-Input Gate.

• Journal of Sensor Science and Technology
• /
• v.19 no.4
• /
• pp.328-335
• /
• 2010

We have designed and fabricated an active pixel sensor(APS) using an optimized n-well/gate-tied p-channel metal oxide semiconductor field effect transistor(PMOSFET)-type photodetector with a built-in transfer gate. This photodetector has a floating gate connected to n-well and a built-in transfer gate. The photodetector has been optimized by changing the length of the transfer gate. The APS has been fabricated using a 0.35 ${\mu}m$ standard complementary metal oxide semiconductor(CMOS) process. It was confirmed that the proposed APS has a wider dynamic range than the APS using the previously proposed photodetector and a higher sensitivity than the conventional APS using a p-n junction photodiode.

• Journal of Sensor Science and Technology
• /
• v.23 no.4
• /
• pp.284-289
• /
• 2014

In this paper, modeling of a gate/body-tied (GBT) PMOSFET photodetector with built-in transfer gate is performed. It can control the photocurrent with a high-sensitivity. The GBT photodetector is a hybrid device consisted of a MOSFET, a lateral BJT, and a vertical BJT. This device allows for amplifying the photocurrent gain by $10^3$ due to the GBT structure. However, the operating parameters of this photodetector, including its photocurrent and transfer characteristics, were not known because modeling has not yet been performed. The sophisticated model of GBT photodetector using a process simulator is not compatible with circuit simulator. For this reason, we have performed SPICE modeling of the photodetector with reduced complexity using Cadence's Spectre program. The proposed modeling has been demonstrated by measuring fabricated chip by using 0.35 im 2-poly 4-metal standard CMOS technology.

• Journal of Power Electronics
• /
• v.17 no.5
• /
• pp.1382-1390
• /
• 2017

This paper presents a power supply for gate drivers, which uses a magnetic resonance wireless power transfer system. Unlike other methods where multiple antennas are used to supply power for the gate drivers, the proposed method uses a single antenna in an insulated receiver to make multiple mutually isolated power supplies. The power transmitted via single antenna is distributed to multiple power supplies for gate drivers through resonant capacitors connected in parallel that also block DC bias. This approach has many advantages over other methods, where each gate driver needs to be supplied with power using multiple receiver antennas. The proposed method will therefore lead to a reduction in production costs and circuit area. Because the proposed circuit uses a high resonance frequency of 6.78 MHz, it is possible to implement a transmitter and a receiver using a small-sized spiral printed-circuit-board-type antenna. This paper used a single phase-leg circuit configuration to experimentally verify the performance characteristics of the proposed method.

• Korean Journal of Materials Research
• /
• v.24 no.3
• /
• pp.135-139
• /
• 2014

To obtain the transistor with ambipolar transfer characteristics, IGZO/SiOC thin film transistor was prepared on SiOC with various polarities as a gate insulator. The interface between a channel and insulator showed the Ohmic and Schottky contacts in the bias field of -5V ~ +5V. These contact characteristics depended on the polarities of SiOC gate insulators. The transfer characteristics of TFTs were observed the Ohmic contact on SiOC with polarity, but Schottky contact on SiOC with low polarity. The IGZO/SiOC thin film transistor with a Schottky contact in a short range bias electric field exhibited ambipolar transfer characteristics, but that with Ohmic contact in a short range electric field showed unipolar characteristics by the trapping phenomenon due to the trapped ionized defect formation.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.56 no.1
• /
• pp.112-116
• /
• 2007

We have investigated the hysteresis phenomenon of a hydrogenated amorphous silicon thin film transistor (a-Si:H TFT) and analyzed the effect of hysteresis phenomenon when a-Si:H TFT is a pixel element of active matrix organic light emitting diode (AMOLED). When a-Si:H TFT is addressed to different starting gate voltages, such as 10V and 5V, the measured transfer characteristics with 1uA at $V_{DS}$ = 10V shows that the gate voltage shift of 0.15V is occurred due to the different quantities of trapped charge. When the step gate-voltage in the transfer curve is decreased from 0.5V to 0.05V, the gate-voltage shift is decreased from 0.78V to 0.39V due to the change of charge do-trapping rate. The measured OLED current in the widely used 2-TFT pixel show that a gate-voltage of TFT in the previous frame can influence OLED current in the present frame by 35% due to the change of interface trap density induced by different starting gate voltages.

• Journal of Adhesion and Interface
• /
• v.22 no.4
• /
• pp.144-152
• /
• 2021

Understanding charge transfer across the interface between organic semiconductor and gate insulator gives insight into the development of high-performance organic memory as well as highly stable organic field-effect transistors (OFETs). In this work, we firstly unveil a novel interfacial charge transfer mechanism, in which hole transfer from organic semiconductor to polymer insulator was nonlinearly boosted by localized states coupling. For this, OFETs based on rubrene single crystal semiconductor and Mylar gate insulator were fabricated via vacuum lamination, which allows stable repetition of lamination and delamination between semiconductor and gate insulator. The surfaces of rubrene single crystal and Mylar film were selectively degraded by photo-induced oxygen diffusion and UV-ozone treatment, respectively. Consequently, we found that the interfacial charge transfer and resultant bias-stress effect were nonlinearly boosted by coupling between localized states in rubrene and Mylar. In particular, the small number of localized states in rubrene single crystal provided fluent pathway for interfacial charge transport.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.50 no.4
• /
• pp.161-168
• /
• 2001

Organic thin film transitors(TFTs) are of interest for use in broad area electronic applications. For example, in active matrix liquid crystal displays(AMLCDs), organic TFTs would allow the use of inexpensive, light-weight, flexible, and mechanically rugged plastic substrates as an alternative to the glass substrates needed for commonly used hydrogenated amorphous silicon(a-Si:H). Recently pentacene TFTs with carrier field effect, mobility as large as 2 $cm^2V^{-1}s^{-1}$ have been reported for TFTs fabricated on silicon substrates, and it is higher than that of a-Si:H. But these TFTs are fabricated on silicon wafer and $SiO_2$ was used as a gate insulator. $SiO_2$ deposition process requires a high insulator which is polyimide and photo acryl. We investigated trasfer and output characteristics of the thin film transistors having active layer of pentacene. We calculated field effect mobility and on/off ratio from transfer characteristics of pentacene thin film transistor, and measured IR absorption spectrum of polymide used as the gate dielectric layer. It was found that using the photo acryl as a gate insulator, threshold voltage decreased from -12.5 V to -7 V, field effect mobility increased from 0.012 $cm^2V^{-1}s^{-1}$ to 0.039 $cm^2V^{-1}s^{-1}$ , and on/off current ratio increased from $10^5\;to\;10^6$. It seems that TFTs using photo acryl gate insulator is apt to form channel than TFTs using polyimide gate insulator.