• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2008.10a
• /
• pp.196-198
• /
• 2008

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2008.04a
• /
• pp.611-612
• /
• 2008

• Analytical Science and Technology
• /
• v.15 no.3
• /
• pp.263-269
• /
• 2002

After porous filters were manufactured using cordierite powder whose mean particle size was 200 ${\mu}m$, they were loaded with catalysts such as Pt, Pd, Cu, Co, La, $V_2O_5$ by vacuum impregnation method. And we investigated the activity of catalysts used for catalytic oxidation of VOC by passing toluene through catalyst-loaded filters. The porous filters had the apparent porosity of 62%, the compressive strength of about 10 MPa and the pressure drop of 15 mmHg at the face velocity of 5 cm/sec. The loading of catalyst decreased the porosity of the filters and increased the pressure drop and the compressive strength of them. Among the catalysts, Pt had the highest activity for catalytic oxidation and could remove more than 90% of toluene at 250 $^{\circ}C$. Below 250 $^{\circ}C$, the content of Pt catalyst had an influence on the conversion of toluene but didn't show any influence above 250 $^{\circ}C$.

• Korean Chemical Engineering Research
• /
• v.49 no.1
• /
• pp.15-20
• /
• 2011

The contamination effect of toluene in the airstream on PEM fuel cell performance was studied with various toluene concentration under different operation conditions. And the recovery of the cell performance by applying clean air and the removal of toluene in the air by adsorption of active carbon were investigated. The toluene concentration range used in the experiments was from 0.1 ppm to 5.0 ppm. The performance degradation and recovery were measured by constant-current discharging and electrochemical impedance spectroscopy(EIS). Toluene adsorption capacity of KOH impregnated active carbon was obtained from the adsorption isotherm curve. The severity of the contamination increased with increasing toluene concentration, current density and air stoichiometry, but decrease with increasing relative humidity. The cell performance was recovered by toluene oxidation with oxygen and water in humidified neat air. EIS showed that the increase of charge transfer resistance due to toluene adsorption on Pt surface mainly reduced the performance of PEMFC. Toluene adsorption capacity of active carbon decreased as KOH weight increased in KOH impregnated active carbon.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.91-91
• /
• 2012

We aim in synthesizing various functional thin films thinner than ~ 10 nm for environmental applications and photovoltaic devices. Atomic layer deposition is used for synthesizing inorganic thin films with a precise control of the film thickness. Several examples about application of our thin films for removing volatile organic compounds (VOC) will be highlighted, which are summarized in the below. 1) $TiO_2$ thin films prepared by ALD at low temperature ($<100^{\circ}C$) show high adsorption capacity for toluene. In combination with nanostructured templates, $TiO_2$ thin films can be used as building-block of high-performing VOC filter. 2) $TiO_2$ thin films on carbon fibers and nanodiamonds annealed at high temperatures are active for photocatalytic oxidation of VOCs, i.e. photocatalytic filter can be created by atomic layer deposition. 3) NiO can catalyze oxidation of toluene to $CO_2$ and $H_2O$ at $<300^{\circ}C$. $TiO_2$ thin films on NiO can reduce poisoning of NiO surfaces by reaction intermediates below $200^{\circ}C$. We also fabricated inverted organic solar cell based on ZnO electron collecting layers on ITO. $TiO_2$ thin films with a mean diameter less than 3 nm on ZnO can enhance photovoltaic performance by reducing electron-hole recombination on ZnO surfaces.

• Journal of Korean Society of Water and Wastewater
• /
• v.14 no.1
• /
• pp.76-83
• /
• 2000

This research is about wastewater containing non-biodegradable TDI(Toluene Diisocyanate) that is treated by the activated carbon adsorption method. In the case of the Fenton oxidation process being applied to the existing process, optimal pH, reaction time, chemical dosing amount, removal rate, and cost were investigated. A pilot plant test was applied after finding optimal conditions with lab experiments. The optimal conditions were pH 3~5(COD removal rate 84~88%) and reaction time 30min~1hr. In higher $H_2O_2$ dosing amount, COD removal rate was a little higher. But there was little difference in the removal rate according to $FeSO_4{\cdot}7H_2O$ dosing amount. Treatment cost was economical in the case of the Fenton oxidation process being operated earlier than activated carbon adsorption system. But chemical dosing point, chemical mixing effect, chemical dosing amount, removal rate, and the cost of facility and others must be considered in practical process.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.266-266
• /
• 2012

Ni films with a thickness of 700-800 nm were deposited on carbon fiber layers using electroless deposition, and surface structures and chemical properties of these films with various annealing temperatures (300, 600 and $900^{\circ}C$) were studied. $600^{\circ}C$-annealing under atmospheric conditions resulted in formation of porous surface structures with a mean pore size of ~100 nm, whereas the other samples showed non-porous surface structures. $600^{\circ}C$-annealed Ni film showed much higher reactivities for toluene adsorption and CO oxidation comparing to other non-porous surfaces.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.31 no.3
• /
• pp.506-510
• /
• 2002

The effect of antioxidant activity of Platycodon grandiflorum (PG) on the liposomal phospholipid membrane was investigated by spectrophotometry. Membrane oxidation causes damage to the membrane fluidity and permeability. It brings further destruction to the sustenance of biological homeostasis. In addition, it is related to several diseases, aging and carcinogenesis. The sample PG was extracted and fractionated to five different types; butanol (PGMB), ethylacetate (PGMEA), ethylether (PGMEE), hexane (PGMH) and methanol (PGMM). The oxidation indices of PGMEA and PGMEE fractions in oxidized dilinoleoylphosphatidylcholine (DLPC) liposomes had stronger antioxidant activities than that of ${\alpha}$-tocopherol and were similar to antioxidant activities compared with butylated hydroxy toluene (BHT), a well-known potent antioxidant, in oxidized DLPC liposomes. The oxidation indices of PGMM extract, PGMB and PGMH fractions exhibited weak antioxidant activity compared with ${\alpha}$-tocopherol in oxidized DLPC liposomes. The oxidation indiex of PGMEE fractions added with vitamin C showed even strong antioxidant activity in the oxidized DLPC liposomes. The oxidation activity of BHT with vitamin C also proved to be stronger than BHT without vitamin C. Therefore vitamin C evidently helps to improve the effect of antioxidant in DLPC liposomes. These results indicate that potentially bioactive substances in PGMEE fraction has a function as potent antioxidant against phospholipid membrane oxidation.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.12
• /
• pp.2405-2408
• /
• 2007

Oxidation of alkylaromatics including toluene and p-methoxytoluene has been carried out over alkali metal (AM)-containing catalysts such as AM-V/TiO2 and AM-VSb/Al2O3 in vapor-phase using oxygen as an oxidant. The selectivity for partial oxidations increases with incorporation of an alkali metal or with increasing the basicity of alkali metals (from Na to Cs), irrespective of the supports or reactants. However, the conversion is nearly constant or slightly decreasing with the addition of alkali metals in the catalyst. The increased selectivity may be related with the decreased acidity even though more detailed work is necessary to understand the effect of alkali metals in the oxidation. The AM-VSb/Al2O3 may be suggested as a potential selective catalyst for vapor-phase oxidations.

• Applied Chemistry for Engineering
• /
• v.9 no.5
• /
• pp.624-628
• /
• 1998

The aromatic organic solvents(BTX) were decomposed in the fixed bed reactor packed with a 0.5% $Pt/{\gamma}-Al_2O_3$ catalyst, then, supercritical carbon dioxide(SC-$CO_2$) was used as the reaction media. And the conversion was dependent on the inlet concentration of BTX and the molar density of SC-$CO_2$. The conversion of BTX was decreased with increasing of inlet concentration, and was increased with temperature and pressure. The maximum conversion of benzene was 98.5% at $300^{\circ}C$ and 204.1 atm, and that of toluene and xylene were 82.0 and 76.5%, respectively, at $350^{\circ}C$ and 204.1 atm. The intermediate products of partial oxidation were identified as benzaldehyde, phenol, benzenemethanol, and so on. The BTX can be effectively converted into harmless $CO_2$ and $H_2O$ at appropriate operating condition. Thus, the nontoxic recovery process was suggested as the removal method of BTX.