• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.25 no.11
• /
• pp.1759-1766
• /
• 2001

Vibration transient generated by developing localized fault in gear can be used as indicators in gear fault detection. In this paper, we propose the zoomed phase map for a fault signal using continuous wavelet transfers to detect this vibration transient. Local fault induces the abrupt fluctuation of load exciting tooth and phase lag in the vibration signal measured on the gearbox. The relatively large fault like "tip breakage" easily can be detected by the clear fluctuation of exciting load. However, minor fault like "initial pitting"cannot be detected using the load fluctuation. To defect this kind of minor fault, the phase map for a fault signal is taken into account. The phase lag by minor fault is observed well in the zoomed phase map.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.11
• /
• pp.963-968
• /
• 1998

The stress distribution in multilayer piezoelectric ceramic actuators was investigated by Finite element analysis. The y direction stress was concentrated at electrode tip. The y direction maximum stress was decreased to 4.9$\times10^ 7 N/m^2$ with internal electrode gap(a) until 0.4 mm and was not much difference with external electrode thickness(c). The stress distribution with internal layers was almost same and the stress distribution of load condition was higher than that of no load condition The y direction maximum stress increased with the number of layer and saturated at 260 layers. In the case of defective actuator, the stress distribution was disconnected around the defect and larger than that of normal actuator.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.175.1-175.1
• /
• 2014

Despite growing interest in Ge as a possible alternative to Si, reliable data on Ge surface has been relatively scarce. Using low temperature scanning tunneling microscopy (STM), we investigate band-bending effects of localized charge traps at Ge(001) surface at 78 K. For this investigation, we prepared nearly defect-free Ge(001) surface by keeping the background pressure to < $1{\times}10^{-10}$ mbar during outgassing. Ge(001) surfaces this obtained exhibit a flat-band condition, and deposition of charge traps induce a distinct, sharp boundary between pinned and depinned surface area in the constant current mode STM images. We will show the tip-surface interaction plays an essential role in producing the boundary, and discuss about the conditions that enable the pinning effect.

• Archives of Reconstructive Microsurgery
• /
• v.19 no.1
• /
• pp.37-45
• /
• 2010

Purpose: First introduced by Buncke and Rose in 1979, the neurovascular partial $2^{nd}$ toe pulp free tissue transfer has been attempted to reconstruct posttraumatic finger tip injuries. Although some surgeons prefer other reconstructive methods such as skin graft and local flap, we chose the partial $2^{nd}$ toe pulp flap owing to its many advantages. We report three successful surgical cases in which the patients had undergone this particular method of reconstruction. Methods: We retrospectively examined three cases of fingertip injury patients due to mechanical injury. Bone exposure was seen in all three cases, All had undergone partial toe pulp free flap for soft tissue defect coverage. Results: All flaps survived without any complications such as partial necrosis, hematoma or dehiscence. Although tingling sensation has returned in both cases, two-point discrimination has not returned yet. Currently no patient is complaining of any pain which gradually improved during their course of recuperation. All stitches were removed on postoperative 2 weeks. Patients are satisfied with the final surgical result and there are no signs of any edema or hematoma. Conclusion: The homodigital reconstruction of finger tip injury using the partial $2^{nd}$ toe pulp flap has numerous advantages compared to other reconstructive modalities such as its resistance to wear and tear and in that it provides a non-slip palmar digital surface. However it requires microsurgery which may not be preferred by surgeons. Advanced age of the patient can be a relative contraindication to this approach since atheromatous plaque from the donor toe can compromise flap circulation after surgery. We report three successful cases which patient age was considered appropriate. Further investigation with a larger number of cases and long term follow-up is deemed necessary.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.9 no.1
• /
• pp.75-82
• /
• 2007

As one of the main support systems, rock bolts play a crucial role in the reinforcement of tunnels. Numerical and experimental studies using a transmission method of ultrasonic guided waves are performed to evaluate the integrity of rock bolts encapsulated by grouting paste. Numerical simulations using "DISPERSE" are carried out for the selection of the optimal experimental setup, i.e. non-destructive testing (NDT) system of the rock bolt. Based on results of the numerical simulation, the calculated frequency range for NDT testing is between 20kHz and 70kHz with the first longitudinal L(1) mode. Laboratory transmission tests are performed by attaching the piezo electric sensor at the tip of the rock bolt before embedding. Both of analytical and experimental results show that the amplitude of signals as well as the wave velocity increases with increase in the defect ratio of grouting paste. The defect in grouting paste means that the space around the rock bolt is not fully filled with the grouting paste. Experimental results also show that the increase of the wave velocity is more sensitive to the defect ratio increase than that of the amplitude. This study demonstrates that the transmission technique of ultrasonic guided waves may be a valuable tool in the evaluation of the rock bolt integrity.

• Archives of Plastic Surgery
• /
• v.32 no.3
• /
• pp.287-292
• /
• 2005

The definitive correction of secondary lip nasal deformities is a great challenge for plastic surgeons. To rectify the secondary lip nasal deformities, various procedures and its modifications have been reported in many centers. However, no universal agreement exist to correct the various components of secondary nasal deformities. The secondary nasal deformity of the unilateral cleft lip has its own characteristic abnormalities including the retroplaced dome of the ipsilateral nasal tip, hooding of the alar rim, a secondary alar-columellar web, short columella, depressed alar base and so forth. Among these components of secondary nasal deformity, maxillary hypoplasia, especially in the area of piriform aperture, and alveolar bone defect can make the alar base depressed, which in turn, leads to wide and flat nasal profile, obtuse nasolabial angle coupled with subnormal nasal tip projection in aspect of aesthetic consideration. Moreover, the maxillary hypoplasia contributes to reduced size of the nasal airway in combination with other component of external nasal deformity and therefore the nasal obstruction may be developed functionally. Therefore, the current authors have performed corrective rhinoplasty with the augmentation of alar base with various methods which include rearrangement of soft tissue, vertical scar tissue flap and use of allogenic or autologous materials in 42 patients between 1998 and 2003. The symmetric alar base could be achieved, which provides the more accurate evaluation and more appropriate management of the various component of any coexisting secondary nasal deformity. In conclusion, the augmentation of alar base, as a single procedure, is a basic and essential to correct the secondary lip nasal deformities.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.25 no.1
• /
• pp.61-69
• /
• 2001

EFP(Fitness For Purpose) type defect assessment methodologies based on ECA(Engineering Critical Analysis) have been established and are in use for the structural integrity evaluation of gas pipelines. ECA usually includes the fracture mechanics analysis, and it is assumed that the J-integral uniquely characterizes the crack-tip stress-strain field. However, it has been proven that the J-integral alone can not be sufficient to characterize the crack-tip field under low levels of constraint with a single parameter. Since pipeline structures are made of ductile material, locally loaded in tension, cracks may experience low level of constraint, and therefore, J-dominance will be lost. For this reason, the level of constraint must be quantified to establish a precise assessment procedure for pipeline defects. The objective of this paper is to investigate the fracture behavior of a crack in gas pipeline(KS D 3507) by quantifying the level of constraint. For this purpose, tensile tests and CTOD tests were performed at room temperature(24$\^{C}$) and low temperature(-40$\^{C}$) to obtain the material properties. J-Q analyses were performed for SENB and SENT specimens based on 2-D finite element analyses, in order to investigate the in-plane constraint effects on pipeline defects. For precise assessment of cracks, especially shallow cracks, in KS D 3507 pipeline, constraint effect must be considered.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.23 no.4
• /
• pp.818-839
• /
• 1996

The strain gage, holographic and photoelastic analysis etc. have been used for stress analysis of prosthesis, orthodontic or orthopedic appliances and filling materials. But these methods has some limitation in analyzing the internal stress. The Finite Element Analysis has been proved to compensate this defect and widely used in this area. The purpose of this study was to compare the stress distributions of the various temporary filling methods being used in pulpotomy procedure. Three different models were designed according to temporary filling material and method: amalgam filling with ZOE base(Model I), amalgam filling with ZPC sub-base and ZOE(Model II), IRM filling only(Model III). The results of the experiment were as follows: 1. In model I under the load case 6 and 1, the significant stress was shown to be concentrated on the buccal portion of crown. 2. Model II showed the similar pattern of stress distribution to Model I. 3. In model III under load case 2, the stress was mainly distributed on the buccal cusp tip and buccal margin of filling material. In same model under the load case 3, the stress was distributed on the lingual cusp tip. 4. Based on the above data, IRM can be assumed to have advantage over the other tested materials in reducing the incidence of crown fracture by localized the stress within the filling materials.

• Archives of Plastic Surgery
• /
• v.35 no.2
• /
• pp.208-213
• /
• 2008

Purpose: Distally based superficial sural artery island flap has some disadvantages such as postoperative flap edema, congestion, and partial necrosis of the flap margin. Venous congestion is an area of considerable concern in distally based superficial sural artery fasciocutaneous flap and is one of the main reasons for failure, particularly when a large flap is needed. However, we could decrease these disadvantages by means of venous superdrainage. Methods: From June of 2006 to June of 2007, a total of two patients with soft tissue defects of lower one third of the leg underwent venous supercharging distally based superficial sural artery island flap transfer. The distal pivot point of this flap was designed at septocutaneous perforator from the peroneal artery of the posterolateral septum, which was 5 cm above the tip of the lateral malleolus. Briefly, this technique is performed by anastomosing the proximal end of the lesser saphenous vein and collateral vein to any vein in the area of the recipient defect site. Results: No venous congestion was noted in any of the two cases. No other recipient or donor-site complications were observed, except for minor wound dehiscence in one case. In 3 to 6 months follow-up, patients had minor complaints about lack of sensation in the lateral dorsal foot. Conclusion: The peroneal artery perforator is predictable and reliable for the design of a distally based superficial sural artery island flap. Elevation of the venous supercharging flap is safe, easy, and less time consuming. In conclusion, the venous supercharging distally based superficial sural artery island flap offers an alterative to free tissue transfer for reconstruction of the lower extremity.

• Archives of Craniofacial Surgery
• /
• v.19 no.2
• /
• pp.148-151
• /
• 2018

The nose is an important landmark of the face and its shape and beauty is of significant concern. The columella is the subunit between the two nostrils that provides support and projection to the nasal tip and has functional role in nostrils, as well as aesthetic. Ethiology for columellar absence or deficiency is diverse, and it is one of the most complex nasal subunits to reconstruct because of its narrow horizontal dimension, its tenuous vascularity and limited availability of adjacent tissue. We present a patient with columellar, membranous septum and upper lip defect, due to oncological resection. The lip reconstruction was designed using advancement of two upper lip edges with the technique of webster perialar/nasocheek advancement. However, the perialar/nasocheek tissue which is usually discarded was used as inferiorly based skin flaps to reconstruct the membranous septum, columellar skin and nasal vestibule lining. Rib cage cartilage graft was used as columellar strut for support. At 1-year follow-up, the patient has good nasal contour and projection. Scaring of the columella is very subtle. This is a versatile way for successful reconstruction of a columella and large central facial defect in one-stage operation. It is a method which provides very satisfactory aesthetic result with minimum patient morbidity and discomfort.