• Korean Journal of Chemical Engineering
• /
• 제35권12호
• /
• pp.2384-2393
• /
• 2018

Porous alginate-based hydrogel beads (porous ABH) have been prepared through a facile and sustainable template-assisted method using nano-calcium carbonate and nano-$CaCO_3$ as pore-directing agent for the efficient capture of methylene blue (MB). The materials were characterized by various techniques. The sorption capacities of ABH towards MB were compared with pure sodium alginate (ABH-1:0) in batch and fixed-bed column adsorption studies. The obtained adsorbent (ABH-1:3) has a higher BET surface area and a smaller average pore diameter. The maximum adsorption capacity of ABH-1:3 obtained from Langmuir model was as high as $1,426.0mg\;g^{-1}$. The kinetics strictly followed pseudo-second order rate equation and the adsorption reaction was effectively facilitated, approximately 50 minutes to achieve adsorption equilibrium, which was significantly shorter than that of ABH-1:0. The thermodynamic parameters revealed that the adsorption was spontaneous and exothermic. Thomas model fitted well with the breakthrough curves and could describe the dynamic behavior of the column. More significantly, the uptake capacity of ABH-1:3 was still higher than 75% of the maximum adsorption capacity even after ten cycles, indicating that this novel adsorbent can be a promising adsorptive material for removal of MB from aqueous solution under batch and continuous systems.

• Smart Structures and Systems
• /
• 제2권2호
• /
• pp.115-126
• /
• 2006

The Terra-Scope system is an affordable 4-D down-hole seismic monitoring system based on independent, microprocessor-controlled sensor Pods. The Pods are nominally 50 mm in diameter, and about 120 mm long. They are expected to cost approximately $6000 each. An internal 16-bit, extremely low power MCU controls all aspects of instrumentation, eight programmable gain amplifiers, and local signal storage. Each Pod measures 3-D acceleration, tilt, azimuth, temperature, and other parametric variables such as pore water pressure and pH. Each Pod communicates over a standard digital bus (RS-485) through a completely web-based GUI interface, and has a power consumption of less than 400 mW. Three-dimensional acceleration is measured by pure digital force-balance MEMS-based accelerometers. These accelerometers have a dynamic range of more than 115 dB and a frequency response from DC to 1000 Hz with a noise floor of less than $30ng_{rms}/{\surd}Hz$. Accelerations above 0.2 g are measured by a second set of MEMS-based accelerometers, giving a full 160 dB dynamic range. This paper describes the system design and the cooperative shared-time scheduler implemented for this project. Restraints accounted for include multiple data streams, integration of multiple free agents, interaction with the asynchronous world, and hardened time stamping of accelerometer data. The prototype of the device is currently undergoing evaluation. The first array will be installed in the spring of 2006.

• Steel and Composite Structures
• /
• 제13권6호
• /
• pp.571-586
• /
• 2012

The paper addresses some key issues related to the design of composite slabs with cold-formed profiled steel sheets. An experimental programme is first presented, involving six composite slab specimens tested with a view to evaluating Eurocode 4 (EC4) provisions on testing of composite slabs. In four specimens, the EC4-prescribed 5000 load cycles were applied using different load ranges resulting from alternative interpretations of the reference load $W_t$. Although the rationale of the application of cyclic loading is to induce loss of chemical bond between the concrete plate and the steel sheet, no such loss was noted in the tests for either interpretation of the range of load cycles. Using the recorded response of the specimens the values of factors m and k (related to interface shear transfer in the composite slab) were determined for the specific steel sheet used in the tests, on the basis of three alternative interpretations of the related EC4 provisions. The test results confirmed the need for a more unambiguous description of the m-k test and its interpretation in a future edition of the Code, as well as for an increase in the load amplitude range to be used in the cyclic loading tests, to make sure that the intended loss of bond between the concrete slab and the steel sheet is actually reached. The study also included the development of a special-purpose software that facilitates design of composite slabs; a parametric investigation of the importance of m-k values in slab design is presented in the last part of the paper.

• Advances in biomechanics and applications
• /
• 제1권1호
• /
• pp.41-55
• /
• 2014

Acellular intra-myocardial biomaterial injections have been shown to be therapeutically beneficial in inhibiting ventricular remodelling of myocardial infarction (MI). Based on a biventricular canine cardiac geometry, various finite element models were developed that comprised an ischemic (II) or scarred infarct (SDI) in left ventricular (LV) antero-apical region, without and with intra-myocardial biomaterial injectate in layered (L) and bulk (B) distribution. Changes in myocardial properties and LV geometry were implemented corresponding to infarct stage (tissue softening vs. stiffening, infarct thinning, and cavity dilation) and injectate (infarct thickening). The layered and bulk injectate increased ejection fraction of the infarcted LV by 77% (II+L) and 25% (II+B) at the ischemic stage and by 61% (SDI+L) and 63% (SDI+B) at the remodelling stage. The injectates decreased the mean end-systolic myofibre stress in the infarct by 99% (II+L), 97% (II+B), 70% (SDI+L) and 36% (SDI+B). The bulk injectate was slightly more effective in improving LV function at the remodelling stage whereas the layered injectate was superior in functional improvement at ischemic stage and in reduction of wall stress at ischemic and remodelling stage. These findings may stimulate and guide further research towards tailoring acellular biomaterial injectate therapies for MI.

• 영어영문학
• /
• 제64권3호
• /
• pp.453-468
• /
• 2018

Nat Turner's rebellion in 1831 was considered pre Civil War South's most dreadful nightmare due to the merciless murder of white slave owner victims. The motive of vengeance has been emphasized as that of Turner's notorious black preacher religious fanaticism. However, the recent film, The Birth of a Nation (2016) directed by Nate Parker, utilized the identical title of a film (1915) directed by D. W. Griffith. Providing limited evidence, information about the rebellion in Thomas Gray's pamphlet The Confessions of Nat Turner (1831), was the only accessible historical source for the factual event of the slaves' rebellion. In addition, William Styron's The Confessions of Turner (1967), a fictionalized biography, also examined Turner's life in the harshness of slavery. Although these two texts deal with the personal level of Nat Turner's rage and religious enthusiasm, both provide only fractured parts of the motive of vengeance. Strikingly, Parker's film interrogates the ideology of "victims," as well as the hierarchical term of "confessions," with their different positions between whites and blacks. More specifically, Parker's film offers discursive fields of proslavery arguments regarding biblical interpretations in addition to external visualization of slaves' inner emotional lives. The film demonstrates how the institution of slavery allowed slaves to be exploited, beaten, raped, through interrogating the problematic image of the "contested hero" Nat Turner. In contrast to the traditional image of blacks' bloody rebellion, the film underlines the absurdity of certain Biblical misinterpretations. It furthermore implies how the 1915 film manipulated proslavery propaganda in America.

• 한국군사과학기술학회지
• /
• 제24권2호
• /
• pp.211-218
• /
• 2021

This paper deals with the computational work to characterize the formation and pinching of a plasma in an X-pinch configuration. A resistive magnetohydrodynamic model of a single fluid and two temperature is adopted assuming a hollow conical structure in the (r,z) domain. The model includes the thermodynamic parameter of tungsten from the corrected Thomas-Fermi EOS(equation of state), determining the average ionization charge, pressure, and internal energy. The transport coefficients, resistivity and thermal conductivity, are obtained by the corrected Lee & More model and a simple radiation loss rate by recombination process is considered in the simulation. The simulation demonstrated the formation of a core-corona plasma and intense compression process near the central region which agrees with the experimental observation in the X-pinch device at Seoul National University. In addition, it confirmed the increase in radiation loss rate with the density and temperature of the core plasma.

• Structural Engineering and Mechanics
• /
• 제85권2호
• /
• pp.275-287
• /
• 2023

The use of environmental-friendly building materials is becoming increasingly popular worldwide. Compared to the normal concrete, rubber-based concrete is considered more durable, environmentally friendly, socially and economically viable. In this investigation, M20 grade concrete was designed and the fine aggregates were replaced with crumb rubber of two different micron sizes (0.221 mm and 0.350 mm). Fly ash (FA) and silica fume (SF) replaces the binder as supplementary cementitious materials at a rate of 0, 5, 10, 15, and 20% by weight. The mechanical properties of concrete including compressive strength, tensile, and flexural strength were determined. The polynomial work expectation validates the response surface approach (RSM) concept for optimizing SF and FA substitution. The maximum compressive strength (22.53 MPa) can be observed for the concrete containing 10% crumb rubber, 15% fly ash and 15% silica fume. The reduced unit weight of the rubberized concrete may be attributed to the lower specific gravity of the rubber particles. Two-way ANOVA with a significance criterion of less than 0.001 has been utilized with modest residual error from the lack of fit and the pure error. The predictive model accurately forecasts the variable-response relationship. Since, the crumb rubber is obtained from wasted tires incorporating FA and SF as a cementitious ingredient, it helps to significantly improve mechanical properties of concrete and reduce environmental degradation.

• Imaging Science in Dentistry
• /
• 제53권1호
• /
• pp.21-26
• /
• 2023

Purpose: A fully digital approach to oral prosthodontic rehabilitation requires the possibility of combining (i.e., registering) digital documentation from different sources. This becomes more complex in an edentulous jaw, as fixed dental markers to perform reliable registration are lacking. This validation study aimed to evaluate the reproducibility of 1) intraoral scanning and 2) soft tissue-based registration of an intraoral scan with a cone-beam computed tomography (CBCT) scan for a fully edentulous upper jaw. Materials and Methods: Two observers independently performed intraoral scans of the upper jaw in 14 fully edentulous patients. The palatal vault of both surface models was aligned, and the inter-observer variability was assessed by calculating the mean inter-surface distance at the level of the alveolar crest. Additionally, a CBCT scan of all patients was obtained and a soft tissue surface model was generated using patient-specific gray values. This CBCT soft tissue model was registered with the intraoral scans of both observers, and the intraclass correlation coefficient(ICC) was calculated to evaluate the reproducibility of the registration method. Results: The mean inter-observer deviation when performing an intraoral scan of the fully edentulous upper jaw was 0.10±0.09 mm. The inter-observer agreement for the soft tissue-based registration method was excellent(ICC=0.94; 95% confidence interval, 0.81-0.98). Conclusion: Even when teeth are lacking, intraoral scanning of the jaw and soft tissue-based registration of an intraoral scan with a CBCT scan can be performed with a high degree of precision.

• Safety and Health at Work
• /
• 제14권1호
• /
• pp.43-49
• /
• 2023

Background: Messaging surrounding skin cancer prevention has previously focused on the general public and emphasized how or when activities should be undertaken to reduce solar ultraviolet radiation (UVR) exposure. Generic messages may not be applicable to all settings, and should be tailored to protect unique and/or highly susceptible subpopulations, such as outdoor workers. The primary objective of this study was to develop a set of tailored, practical, harm-reducing sun safety messages that will better support outdoor workers and their employers in reducing the risk of solar UVR exposure and UVR-related occupational illnesses. Methods: We adapted a core set of sun safety messages previously developed for the general population to be more applicable and actionable by outdoor workers and their employers. This study used an integrated knowledge translation approach and a modified Delphi method (which uses a survey-based consensus process) to tailor the established set of sun safety messages for use for outdoor worker populations. Results: The tailored messages were created with a consideration for what is feasible for outdoor workers, and provide users with key facts, recommendations, and tips related to preventing skin cancer, eye damage, and heat stress, specifically when working outdoors. Conclusion: The resulting tailored messages are a set of evidence-based, expert- approved, and stakeholder-workshopped messages that can be used in a variety of work settings as part of an exposure control plan for employers with outdoor workers.

• 영어영문학
• /
• 제57권3호
• /
• pp.473-493
• /
• 2011

This paper aims, first, to trace the trajectory of Sebastian Barry's dramatic works in terms of retrieving the hidden (hi)stories of his family members, and second, to analyze his most successful play to date in both critical and commercial senses, The Steward of Christendom, in terms of the tension or even rupture between Irish national history and the dramatic representation of it. If contemporary Irish drama as a whole can be seen as an act of mirroring up to nation, Barry's is a refracting than reflecting act. Whereas modern Irish drama tends to have helped, however inadvertently, consolidate the nation-state by imagining Ireland through its other (either in the form of the British empire or the Protestant Unionist north), Barry's drama aims at cracking the surface homogeneity of Irish identity by re-imagining "ourselves" (a forgotten part of which is a community of southern Catholic loyalists). Furthermore, the "ourselves" re-imagined in Barry's drama is more fractured than unified, irreducible in its multiplicity than acquiescent in its singularity. The playwright's foremost concern is to retrieve the lives of "history's leftovers, men and women defeated and discarded by their times" and re-member those men and women who have been expunged from the imagined community of the Irish nation. This he does by endowing "every life" with "an after-life" and "every demon" with "a fairy tale." The Steward of Christendom is Barry's dramatic attempt to bestow upon the historically demonized Thomas Dunne, an Irish policeman in the British Empire, his fairy-tale redemption.