• 한국자동차공학회논문집
• /
• 제17권4호
• /
• pp.79-85
• /
• 2009

Low temperature combustion regime for the simultaneous reduction of nitrogen oxides ($NO_x$) and paticulate matter (PM) is demonstrated in single cylinder engine at various operating parameters, such as EGR rate, injection timing, EGR temperature, amount of fuel and swirl rate. Low temperature combustion is accomplished by high exhaust gas recirculation (EGR) rate in this study. Generally, the emission of $NO_x$ almost completely disappears and PM significantly increases in the first decreasing regime of oxygen concentration but after peaking about 10~12% oxygen concentration, PM then decreases regardless of fuel injection quantity. Low temperature combustion regime was extended by low EGR temperature, high injection pressure and low amount of fuel.

• The Korean Journal of Ecology
• /
• 제17권4호
• /
• pp.485-499
• /
• 1994

This study was focused on the effect of the altitude on the geographical variations of germination characteristics in the populations of Plantago asiatica L. distribute in Mt. Chiri. There was a significant difference among the 14 groups in the phenological pattern in relation to altitudes. When the altitude becomes higher, the thermal time which was required for 10 to 80% germination rate showed higher and wider distribution. On the other hand, the germination response of increasing temperature (IT) and secreasing temperature (DT) regime was classified into 3 group. The first group was the spering germination type. This group showed that the IT regime hadhigher germination rate than that of the DT regime, and was distributed in Macheon(300m) and Packmudong (500m). The second was the spring-fall germination type which was distributed in Hadong (900m) and Saemt대 (1100m). This group also showed higher germination rate in the IT regime, but the difference of the germination rate between IT and DT regime was less than that in the first group (the spring type). The third group was the early fall germination type which was found in the Nogodan (1507m), Changetomok (1750m) and Cheonwangbong (1915m). The germination rate of this group showed almost 100% similarity between IT and DT regime. These data suggested that the geographical varations of germination characteristics within species was an important ecological strategy for the survival from severe environmental conditions.

• 대한기계학회논문집
• /
• 제18권12호
• /
• pp.3297-3304
• /
• 1994

Experimental investigation have been made to study the double-diffusive nature of convection of an initially stratified salt-water solution heated from below in a cylindrical cavity. The objective is to examine the process of mixed-layer formation, the flow phenomena, the heat transfer characteristics, and temperature and concentration distribution according to the changes in the effective Rayleigh number based on the reference height which represents the relation of temperature and concentration gradient. The types of initially formed flow pattern are categorized in three regimes depending on the effective Rayleigh number ; stagnant flow regime, single mixed-layer flow regime and successively formed multiple mixed-layer flow regime. The temperature and concentration profiles are both uniform in each layer due to convective mixing in the layered flow regime, but both linear in stagnant flow regime and single mixed-layer flow regime. At the interface between adjacent layers, the temperature changes smoothly but the concentration changes rapidly. The layers expand by diffusion of concentration through the interface along with its random fluctuation.

• 대한기계학회논문집
• /
• 제19권7호
• /
• pp.1731-1740
• /
• 1995

Experimental investigations have been made to study the double-diffusive nature of convection of an initially stratified salt-water solution due to heating from below in a rotating cylindrical cavity. The objective is to examine the flow phenomena and the heat transfer characteristics according to the changes in temperature gradient, concentration gradient and rotating velocity of cavity. Thermal and solutal boundary conditions at side wall are adiabatic and impermeable, respectively. The top and bottom plate are maintained each at constant temperature and concentration. The cavity is put into a state of solid body rotation. Like the stationary case, the types of initially-formed flow pattern are classified into three regimes depending on the effective Rayleigh number and Taylor number; stagnant flow regime, single mixed-layer flow regime and successively formed multi-mixed layer flow regime. At the same effective Rayleigh number, the number of initially-formed mixed layer and its growth rate decrease as the effect of rotation increases. The temperature and concentration profiles are both uniform in each layer due to convective mixing in the layered-flow regime, but look both liner in stagnant flow regime and single mixed-layer flow regime. At the interface between adjacent layers, the temperature changes smoothly but the concentration changes rapidly.

• 한국세라믹학회지
• /
• 제35권1호
• /
• pp.23-32
• /
• 1998

전융실리카 분말로 소결하여 만든 sihca preform을 마그네슘이 함유된 용융 알루미늄에 침적시킨후 공기중에서 반응시켜 Al2O3/Al 복합체를 제조하였다. 복합체 제조시 반응온도의 변화에 대해 용융 알루미늄의 침투거동을 조사한 결과 3가지 영역, 즉 저온영역(75$0^{\circ}C$-85$0^{\circ}C$), 중온영역(90$0^{\circ}C$-95$0^{\circ}C$), 고온영역(100$0^{\circ}C$$\leq$)으로 구분되었다. 저온영역에서는 반응온도에 비례해서 침투속도가 증가하였으나, 중간온도 영역은 치환반응에 의해 생성된 알루미나의 상전이에 따른 영향으로 저온영역인 85$0^{\circ}C$에서보다 오히려 침투속도가 감소하였다. 고온영역중 100$0^{\circ}C$이상에서 침투가 일어나지 않는 것은 용융 알루미늄중의 마그네슘이 먼저 실리카와 반응하여 silica preform의 표면에 치밀한 스피넬층을 형성하기 때문으로 판명되었다.

• 한국환경과학회지
• /
• 제21권12호
• /
• pp.1425-1433
• /
• 2012

Water temperature in the eastern part of the Yellow Sea (EYS) during winter (JFM) and summer (JJA) from 1964 to 2009 and Siberian High Pressure Index (SHI) and Arctic Oscillation index (AOI) during winter (JFM) from 1950 to 2011 were used to analyze long-term variation in oceanic and atmospheric conditions and relationship between winter and summer bottom water temperature. Winter water temperature at 0, 30 and 50 m had fluctuated highly till the late of 1980s, but after this it was relatively stable. The long-term trends in winter water temperature at both depths were separated with cold regime and warm regime on the basis of the late 1980s. Winter water temperature at 0m and 50m during warm regime increased about $0.9^{\circ}C$ and $1.1^{\circ}C$ respectively compared to that during cold regime. Fluctuation pattern in winter water temperature matched well with SHI and AOI The SHI had negative correlation with water temperature at 0 m (r=-0.51) and 50 m (r=-0.58). On the other hand, the AO had positive correlation with Winter water temperature at 0 m (r=0.34) and 50 m (r=0.45). Cyclic fluctuation pattern of winter water temperature had a relation with SHI and AO, in particular two to six-year periodicity were dominant from the early of the 1970s to the early of the 1980s. Before the late of 1980s, change pattern in winter water temperature at 0 and 50 m was similar with that in the bottom water temperature during summer, but after this, relationship between two variables was low.

• 한국가시화정보학회지
• /
• 제18권1호
• /
• pp.18-25
• /
• 2020

The droplet impact behavior is dominated by some parameters such as surface temperature, We number, surface and fluid property. Especially, Leidenfrost effect which prevents the contact between surface and droplet is very powerful phenomenon for determining droplet impact behavior. Due to this effect, the impact regime is divided into contact boiling regime and film boiling regime whether the droplet contact with the surface. Many studies have found that surface micro-structures which processed by surface processing are effective to overcome the Leidenfrost effect. In this study, droplet impact behaviors were compared using ethanol both on flat and laser-ablated Al surface. On the flat surface, impact regime was mainly divided by surface temperature. And there is key dominant parameter for each regime. On the laser-ablated surface, we could see changed impact regime and different impact behavior such as jetting and ejection of tiny droplets despite of same impact conditions.

• The Korean Journal of Ecology
• /
• 제19권3호
• /
• pp.231-240
• /
• 1996

The germination responses of Cassia mimosoides var. nomame seeds to temperature were examined under various conditions. The temperature range allowing germination was $20~40^{\circ}C$, and the linear relationship between the germination rate and temperature appeared to exist between $28~38^{\circ}C$ The total thermal time required for germination (10~80%) of C. mimosoides seeds ranged from 259 Kh (degree Kelvin$\times$hours) to 421 Kh and base temperature range was relatively constant, i.e., $23.39~26.68^{\circ}C$. In the increasing temperature (IT) regime, C. mimosoides seeds started to germinate at $16^{\circ}C$ and showed greater germination rate with increasing temperatures. The final germination rate was 64% at $36^{\circ}C$. On the other hand, in the decreasing temperature (DT) regime, the seeds began to germinate at $36^{\circ}C$, and the final germination rate was 52% at $20^{\circ}C$. An induced dormancy occurred at $16^{\circ}C$ in the DT regime.

• 대한기계학회논문집B
• /
• 제31권9호
• /
• pp.764-771
• /
• 2007

The objective of the present work is to evaluate the evaporation heat flux of deposited droplet on the hot surface by using of inverse heat transfer technique. On the basis of measured temperature, a integral form solution is determined for the transient temperatures beyond the two positions by using Green's function technique. This method first approximates the temperature data with a half polynomial series of time. we compared this result with constant radius model in single phase regime, nucleate boiling regime, film boiling regime respectively. this paper performed the experiments as following conditions: (a)the surface temperature is within the range between $80^{\circ}C\;and\;160^{\circ}C$ in the conduction, (b) droplet diameter are 2.4 and 3.0mm. (c) surface roughness is $0.18{\mu}m$.

• Korean Chemical Engineering Research
• /
• 제52권6호
• /
• pp.821-825
• /
• 2014

바이오매스의 수증기 가스화 특성을 고온 영역에서 살펴보고자 열중량 분석기(thermobalance)에서 톱밥 촤의 수증기 가스화 연구를 수행하였다. 반응 온도를 $850^{\circ}C$에서 $1400^{\circ}C$까지 수증기 분압을 0.3, 0.5, 0.7 atm으로 변화시키며 가스화 실험이 수행되었다. 반응 kinetics 해석은 기체-고체 화학반응의 세 가지 모델이 이용되었고 이 중 modified volumetric model이 중량 변화를 가장 잘 나타내었다. 가스화 온도 $900^{\circ}C$를 기준으로 diffusion control regime과 reaction control regime의 두 단계로 가스화가 구분되었으며 이때 각각의 regime에 대하여 활성화에너지와 빈도인자를 도출하고 수증기 분압의 영향을 살펴보았다. 가스화와 동시에 수성가스화 변환반응이 진행되어 생성기체의 $H_2$ 농도가 CO에 비하여 2배 정도 높은 값을 나타내었다.