• The Plant Pathology Journal
• /
• v.16 no.5
• /
• pp.257-263
• /
• 2000

Infection with rice blast fungus (Magnaporthe grisea) significantly reduced foliar net photosynthesis (A) of rice cultivars: Ilpoom, Hwasung, and Choochung in greenhouse experiments. By measuring the amount of diseased leaf area with a computer image analysis system, the relation between disease severity (DS) and net photosynthetic rate was curvilinearly correlated (r=0.679). Diseased leaves with 35% blast symptom can be predicted to have a 50% reduction of photosynthesis. The disease severity was linearly correlated (r=0.478) with total chlorophyll (chlorophyll a and chlorophyll b) per unit leaf area(TC). Light use efficiency was reduced by the fungal infection according to the light response curves. However, dark respiration (Rd) did not change after the fungal infection (p=0.526). Since the percent of reduction in photosynthesis greatly exceeded the percent of leaf area covered by blast lesions, loss of photosynthetic tissue on an area basis could not by itself account for the reduced photosynthesis. Quantitative photosynthetic reduction can be partially explained by decreasing TC, but cannot be explained by decreasing Rd. By photosynthesis (A)-internal CO$_2$ concentration (C$_i$ curve analysis, it was suggested that the fungal infection reduced ribulose-1,5-bisphosphate carboxylase/oxygenase (Rubisco) activity, ribulose-1,5-bisphosphate (RuBP) regeneration, and inorganic phosphate regeneration. Thus, the reduction of photosynthesis by blast infection was associated with decreased TC and biochemical capacity, which comprises all carbon metabolism after CO$_2$ enters through the stomata.

• ETRI Journal
• /
• v.33 no.4
• /
• pp.528-536
• /
• 2011

In this paper, we analyze the location accuracy of real-time locating systems (RTLSs) in multipath environments in which the RTLSs comply with the ISO/IEC 24730-2 international standard. To analyze the location error of RTLS in multipath environments, we consider a direct path and indirect path, in which time and phase are delayed, and also white Gaussian noise is added. The location error depends strongly on both the noise level and phase difference under a low signal-to-noise ratio (SNR) regime, but only on the noise level under a high SNR regime. The phase difference effect can be minimized by matching it to the time delay difference at a ratio of 180 degrees per 1 chip time delay (Tc). At a relatively high SNR of 10 dB, a location error of less than 3 m is expected at any phase and time delay value of an indirect signal. At a low SNR regime, the location error range increases to 8.1 m at a 0.5 Tc, and to 7.3 m at a 1.5 Tc. However, if the correlation energy is accumulated for an 8-bit period, the location error can be reduced to 3.9 m and 2.5 m, respectively.

• Nuclear Engineering and Technology
• /
• v.55 no.9
• /
• pp.3352-3358
• /
• 2023

Nuclear medicine seems to be a decent choice of medicine in the recent decade. The radioactive isotopes ⁵¹Cr, ⁸⁹Sr, ⁹⁹Tc, ¹³¹I, ¹³³Xe, ¹³⁷Cs and ¹⁵³Sm are extremely essential in nuclear medicine. The excitation functions of the ⁵⁴Fe (n, α) ⁵¹Cr, ⁹²Zr (n, α) ⁸⁹Sr, ¹⁰²Rh (n, α) ⁹⁹Tc, 134Cs (n, α) ¹³¹I, ¹³⁶Ba (n, α) ¹³³Xe, ¹⁴⁰La (n, α) ¹³⁷Cs and ¹⁵⁶Gd (n, α) ¹⁵³Sm reactions were calculated in this study using the EMPIRE 3.2.3 and TALYS 1.95 nuclear codes. Additionally, the cross sections at 14-15 MeV were calculated using empirical formulae and the experimental data. The computer codes were compared to the experimental data and Empirical formulas as well as the evaluated data (TENDL 2021, JENDL 3.3, JENDL 5, JEFF 3.3, EAF 2010, CENDL 3.1, CENDL 3.2, ROSFOND 2010, FENDL 3.2 b, and BROND 3.1).

• The Korean Journal of Nuclear Medicine
• /
• v.14 no.2
• /
• pp.61-66
• /
• 1980

We studied four patients with muscle necrosis associated with acute renal failure to evaluate the diagnostic value of the bone scan in this disease. The illness followed carbon monoxide poisoning in two patients, acute physical exertion in one and contaminated intramuscular injection in the other. Whole-body rectilinear bone scans using technetium 99m-methyldiphosphonate were done. In all patients, increased muscle labelling at the regions of suspected muscle injury was showed, and in one, it was after normalization of serum muscle enzyme levels. In one patient, the bone scan was rechecked 8 months later and showed no residual abnormality. Above all, the site and precise extent of muscle injury could be detected and the degree of muscle labelling seemed to correlate with the severy of muscle injury. These findings suggest that isotope scanning may be useful in the diagnosis of patients with acute muscle necrosis.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.51 no.4
• /
• pp.159-164
• /
• 2002

This paper presents the design and fabrication of a high-Tc superconducting (HTS) power supply for charging of the HTS magnet load, and its characteristics have been analyzed through experiments. HTS power supply consists of two heaters, an electromagnet, a Bi-2223 solenoid and a Bi-2223 pancake magnet load. In this experiment, 331 mH electromagnet and 0.8 A dc heater current were used, and 8.5 sec and 17 sec were used for pumping period. Mechanism of the superconducting switch is used for heater-trigger. In order to measure the pumping-current with respect to the magnet flux changes, hall sensor was installed at the center of the Bi-2223 pancake load. The experimental observations have been compared with the theoretical predictions. In this experiment, the pumping-current has reached about 1.2 A. In computer simulation, the maximum pumping-current of the system has been predicted to be about 2.7 A.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.51 no.7
• /
• pp.364-369
• /
• 2002

In this paper, 3-D magnetostatic finite element simulation of a rotux type Low-Tc superconducing (LTS) superconducting power supply, finite element method, cryogenic system, superconducting foil by generated magnetic flux from the rotating pole. The magnetic flux density on the superconducting foil caused by two exciters is therefore sufficiently greater than its critical magnetic flux density and it is an essential point in LTS power supply design. To establish the sufficient flux path of this machine, ferromagnetic materials is used in this power supply. When ferromagnetic materials is used at extremely low temperature, its characteristic of magnetization differs to that at room temperature. For this reason, special consideration is needed in the magnetic analysis of cryogenic systems. When the excitation current is 10A, the normal spot appears on superconducting foil. The results of this analysis are calculated and compared with the experimental results. The linkage flux due to the excitation current of 10, 20, 30, 40 and 50A are respectively $1.30{\times}10-4$, $2.67{\times}10-4$, $5.08{\times}10-4$ and $6.15{\times}10-4Wb$.

• Archives of Pharmacal Research
• /
• v.21 no.2
• /
• pp.89-105
• /
• 1998

In the past decade, significant progress has been achieved in the battle against hepatitis B virus. In addition to the immunomodulating agents such as interferon-.alpha., and thymosin, many novel antiviral agents have been discovered, among which nucleoside analogues are the mainstay. New-generation compounds such as 3TC and famciclovir have shown promise in the treatment of patients chronically infected by this virus, and are on the line for approval. However, viral rebound after cessation of therapy still remains a major problem. Additionally, the reports on the drug resistance to these antiviral agents suggest that combination therapy will be the eventual strategy (Bartholomew et al., 1997; Tipples et al., 1996). Therefore, developments of safe and effective antiviral agents which do not cross-resist with currently available antiviral drugs are still much needed.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.25 no.5
• /
• pp.731-740
• /
• 2001

A numerical study on the quantitative analogy between the fully developed turbulent flow in a straight square duct rotating about an axis perpendicular to that of the duct and that in a stationary curved duct of square cross-section is carried out. In order to clarify the similarity of the two flows, dimensionless parameters K(sub)TR=Re(sup)1/4/√Ro and Rossby number, Ro, in a rotating straight duct flow were used as a set corresponding to K(sub)TC=Re(sup)1/4/√λ and curvature ratio, λ, in a stationary curved duct flow so that they have the same dynamical meaning as those of the fully developed laminar flows. For the large values of Ro or λ, it is shown that the flow field satisfies the asymptotic invariance property, that is, there are strong quantitative similarities between the two flows such as flow patterns and friction factors for the same values of K(sub)TR and K(sub)TC.

• Electrical & Electronic Materials
• /
• v.8 no.2
• /
• pp.158-164
• /
• 1995

Solid solutions Sr$_{2}$(Ta$_{1-x}$ Nb$_{x}$)$_{2}$O$_{7}$, (x=0.0-1.0), composed of strontium tantalate(Tc=-107.deg. C) and strontium-niobate(Tc=1342.deg. C) were prepared by the conventional mixed oxide method and the flux method(molten salt synthesis method). Phase relation, sintering temperature, grain-orientation and dielectric properties for sintered ceramic samples were investigated with different compositions. Both Curie temperature and dielectric constant at Curie temperature were increased, and sintering behavior and the degree of grain-orientation were improved with the increase of Nb content. The single phase Sr$_{2}$(Ta/sib 1-x/Nb$_{x}$)$_{2}$O$_{7}$ powder was synthesized by using the flux method at lower temperatures, and sintering temperature was also reduced by using the flux method-derived powder than using the mixed oxide-derived powder. Sintering characteristics and dielectric properties of the specimens prepared by the flux method were better than those derived through the conventional mixed oxide method.thod.hod.

• The Korean Journal of Nuclear Medicine
• /
• v.32 no.4
• /
• pp.314-324
• /
• 1998

Purpose: This study was performed to evaluate the outcome of encephalo-duro-arterio-synangiosis (EDAS) surgery with rest/acetazolamide Tc-99m HMPAO SPECT in moyamoya disease. Materials and Methods: Rost/acetazolamide subtraction SPECT with consecutive acquisition were done before and 2 months after 21 EDAS surgeries in 18 patients. Perfusion decrease was graded visually for 14 areas of each hemisphere as 0 (normal) to 3 (defect) using 4 point scoring system. Postoperative rest perfusion or perfusion reserve was compared with preoperative ones. Results: Among 294 areas of 21 hemispheres, rest perfusion abnormality was found in 91 areas of 15 hemispheres. Decrease of perfusion reserve was found in 146 areas of 18 hemispheres. Six hemispheres having normal rest perfusion and 12 of 15 hemispheres having rest perfusion abnormality showed reserve decrease. Three having rest perfusion defect did not change after acetazolamide in preoperative SPECT. After operation, 16 patients (89%) demonstrated clinical improvement. Fifteen among 18 hemispheres (83%) with decreased reserve improved. Rest perfusion abnormality improved in 6 among the 15 hemispheres (40%). The areas having rest perfusion and/or reserve decrease improved in 87 among 146 areas (60%). Decrease of reserve, improved in 85% (68/80). However, areas without reserve decrease also improved in 29% (19/66). The better was preoperative rest perfusion in involved areas or the more decreased vascular reserve, the more improved perfusion and reserve after operation. Conclusion: We conclude that assessment of perfusion and Perfusion reserve using rest/acetazolamide brain perfusion SPECT predict the surgical outcome in patients with moyamoya disease.