• Journal of the Korean Society of Physical Medicine
• /
• v.8 no.3
• /
• pp.443-448
• /
• 2013

PURPOSE: In recent years, senior friendly device is growing rapidly because of population aging The study was designed to investigate the effects of table height of electronic bed on upper extremity and trunk EMG in elderly. METHODS: Thirty right-handed elderly without history of neurological and musculoskeletal dysfunction were participated in this study. Three heights of the table (3/3 height, 2/3 height, and 1/3 height between top of the shoulder and olecranon) were provided. During the eating performance, surface electromyography (EMG) was used to measure muscle activity, and electrodes were attached to the deltoid middle fiber, serratus anterior, suprapinatus, upper trapezius, rhomboideus, cervical part of longissimus, thoracic part of longissimus, lumbar part of longissimus on right. One way ANOVA was conducted for the statistical analysis. RESULTS: There were significant differences in deltoid middle fiber, suprapinatus, upper trapezius, rhomboideus, lumbar part of longissimus in the 3 different height of table (p<.05). The deltoid middle fiber, suprapinatus, upper trapezius, and lumbar part of longissimus were significantly increased in higher table than lower table(p<.05). And the rhomboideus was significantly decreased in higher table than lower table(p<.05). CONCLUSION: This study demonstrates that different height of table affect upper extremity and trunk muscle activity. The table height of olecranon is the best for elderly.

• Journal of Biomedical Engineering Research
• /
• v.29 no.6
• /
• pp.484-492
• /
• 2008

Sit to stand(STS) movement is one of the most common activity in daily life. In addition, Korean traditionally stand up from various sitting heights in one's daily life compared to other foreigners. As Korea enter rapidly to the aging society, needs of the elderly's independent life are increasing. Therefore the importance of research about the analysis of elderly's activity in daily life is rapidly increasing. In this study, we analyzed joint movements and changes of muscle length during STS(sit-to-stand) at various sitting heights(table seat, bath seat, bottom) in the Korean elderly's daily life by using the motion analysis and musculoskeletal modeling. Ten Korean elderly and young were participated in this experiment. Three heights of sitting posture which could represent typical sitting in Korean daily life were chosen as table seat(42cm), bath seat(21cm) and bottom(0cm). As the results, the elderly showed both smaller knee/hip flexion and larger trunk flexion relatively in comparison to the young during table seat STS. The elderly also showed larger dorsiflexion and smaller ROM of knee, hip, trunk compared to the young during bath seat STS. Additionally, the elderly showed larger plantarflexion, hip flexion, smaller knee flexion and trunk flexion during the first half of bottom STS and larger knee flexion, hip flexion and trunk flexion during the second half of bottom STS. In addition, we could know contraction and relaxation characters of major muscles in lower limb during various STS through the analysis of changes in muscle length by musculoskeltal modeling.

• Physical Therapy Rehabilitation Science
• /
• v.12 no.2
• /
• pp.130-139
• /
• 2023

Objective: This study aimed to analyze the effects and characteristics of the height of the treatment table on the force and time of ground reaction (GR) and contact hand (CH) generated from the therapist's feet to generate thrust during spinal manipulation (SM). Design: A cross-sectional survey study Methods: Thirty-six healthy subjects were recruited. SM was performed on the ilium using a knee-high table, where the therapist felt it was easy to control the subject's posture and body shape and comfortable to generate force, as well as a relatively high thigh-high table. The force and time generated by the therapist's GR and CH were simultaneously measured through a force plate. Results: As a result, there was a significant difference in peak force and rundown force at the therapist's GR according to the table height (p < 0.05). In the therapist's CH, there was a significant difference between PreMin (preload minimum) force and peak force (p < 0.05), and there was a significant difference between the time from PreMin to peak and the time of the entire section (p < 0.05). Conclusions: As a result, the generation of increased CH force and faster thrust duration were confirmed by mobilizing the reduced GR force of the therapist to generate thrust than the relatively high table on the knee-high table.

• Journal of the Korean Society of Physical Medicine
• /
• v.8 no.3
• /
• pp.289-294
• /
• 2013

PURPOSE: The purpose of this study was to examine differences in erect spinae activities at different height of table during ultrasound therapy in order to propose a optimum work environment. METHODS: Twenty five healthy adult males and females volunteered to participate in this study. EMG signals of both erector spinae(T10, T12, L2, L4) were recorded throught the surface electromyography system at different height of table(45cm, 56.2cm, 67.5cm) during ultrasound therapy work. RESULTS: The higher table heights was, the lower %RVC of the T10, T12, L2, L4 erect spinae at both sides. The left and right T10, T12 and the left L4 showed significant differences. The lower the spinal level was, the higher %RVC of both erect spinae at 45cm, 56.2cm, 67.5cm. The left erect spinae at 56.2cm, right erect spinae at 45cm, 67.5cm showed significant differences. CONCLUSION: The muscle activities of both erect spinae decreased at higher table height and increased lower spinal level. We identified lower table height are risk factor of spine work related musculoskeletal disorders.

• Structural Engineering and Mechanics
• /
• v.90 no.6
• /
• pp.577-590
• /
• 2024

Considering the Column-Supported Group Silos (CSGSs) often arranged by rows in practical applications, earthquake responses will be affected by group effect. Since group effect presenting uncertainties, establishing the analytic model and evaluating characteristics of CSGSs seems necessary. This study aimed at providing a simplified method to evaluate seismic performances of the CSGSs. Firstly, the CSGSs with different storage granule heights are used as numerical examples to derive the base shear formula for three-particle dynamic analytical model. Then, the base shear distribution coefficient is defined as the group effect index. The simplified calculation method of the group silos based on the distribution coefficients is proposed. Finally, based on the empty, half, and full granular storage conditions, the empirical design parameters for the group silos system are given by combining finite element simulation with shaking table test. The group effect of storage granule heights of group silos on its frequency and base shear are studied by comparative analysis between group silos and independent single silo. The results show that the frequency of CSGSs decreases with the increasing weight of the stored granule. The connection between the column top and silo bottom plate is vulnerable, and structural measures should be strengthened to improve its damage resistance. In case of different storage granule heights, distribution coefficients are effective to reconstruction the group effect. The complex calculations of seismic response for CSGSs can be avoided by adopting the empirical distribution coefficients obtained in this study. The proposed method provides a theoretical reference for evaluation on the seismic performances of the CSGSs.

• Proceeding of Spring/Autumn Annual Conference of KHA
• /
• 2001.11a
• /
• pp.77-82
• /
• 2001

This paper is contents that measure the ventilation rates and temperature by driving condition of exhaust fan, vapor, contaminant occurrence amount of carbon dioxide etc. In kitchen of apartment house. The ventilation rates in the apartment kitchen measured by Tracer Gas Method. And, temperature of when cook by gas table hood lower part 10cm and floor upside 10cm of kitchen central part, 120cm, 210cm heights measure. As ventilation rates measurement result, ventilation number of times was 0.7(number of times/hour) when did not to operate exhaust fan. but we were measured by 2.3(number of times/hour) when drove strongly. As temperature measurement result at cooking by gas table, temperature showed highest in hood lower part 10cm of case that do not operate exhaust fan. Temperature at kitchen central was most low in 10cm height in talc floor, and 210cm were measured highest. Concentration of carbon dioxide is very high by 4,350ppm after measurement time 10 minutes in state who do not operate exhaust fan at cooking by gas table.

• Journal of the East Asian Society of Dietary Life
• /
• v.1 no.3
• /
• pp.217-237
• /
• 1991

To examine the following day party and the following evening party in the Man Kyong Jeon, the authors studied“Jin Chan Eui Gue”, which is a historical record published in 1887(King Go-Jong). The results obtained from the study were as follows, 1. There were fixed arranging tables(22) and taking-away tables in the dining table of the following day party. 2. There were fixed arranging tables(5) and taking-away tables in the dining table of the following evening party. 3. Food and flowers were distributed to the 390 attendants in the following day party. 4. There were no distribution of food and flowers to the attendants in the following evening party. 5. Arrangements of the following day party and following evening party were the same as those of the main party. 6. The arranged seat of the King, Go-Jong was facing the south. 7. According to the status or class of the attendant, the pattern or size of table settings were differentiated in the kinds of food, table flowers chinaware etc. 8. In the arrangements of table for the King, the heights of food on the dishes were as following levels. 1 dish : 1chok(1척) 6 dishes : 8 chon(8촌) 4 dishes : 7 chon(7촌)

• Journal of International Academy of Physical Therapy Research
• /
• v.3 no.2
• /
• pp.469-474
• /
• 2012

The purpose of this study is to analyze the correlation between the stature and the muscle performance ratings and the subjective discomfort rations at performing lower arm's pronation and supination according to change sin the height of working table for more efficient performance at designing a working table and performing a work. For the purpose, this study conducted an experiment targeting 40 people in their 20s, who were classified into 4 groups each group composing 10 people at intervals of 5cm from the standard stature of 166.5cm. The experiment measured the maximum isometric pronation and the supination muscular power, and at measuring the factors, the heights of working tables were set as 800mm, 850mm, and 900mm. From the measurement results, it was found that the stature and the maximum muscular power was correlated. That is, as the experiment groups's average stature is higher, the maximum muscular power was higher. For the correlation between the motion patterns(pronation and supination) and the maximum muscular power, it was seen that the maximum muscular power was higher at performing the pronation than the supination. In the correlation between motion patterns and the subjective discomfort ratings, it was seen that the subjective discomfort rating was higher at performing the supination than the pronation. For the correlation between height adjustment and the subjective discomfort ratings, as the height of working table was lower, the subject discomfort rating was lower. Therefore there was no difference in the maximum muscular power according to the height changes of working table, but it was found that as the working table was higher, the user felt more comfortable.

• Journal of the East Asian Society of Dietary Life
• /
• v.1 no.3
• /
• pp.239-257
• /
• 1991

To examine the next following day party and the next following evening party in the Man Kyong Geon, the authors analyzed“Jin Chan Eui Gue”, which is a historical record, published in 1887(King Go-Jong). The results obtained from the study were as follows, 1. The dining tables of next following day party were composed of two types:fixed arranging tables(22), and taking-away tables. 2. The dinind tables of next following evening party were also composed of two types:fixed arranging tables(6), and taking-away tables. 3. Food and flowers were distributed to the 290 attendants at the next following evening party. 5. According to the status or class of the attendants, the pattern or size of table settings were differentiated in the kinds of food, heights of food, flowers china ware etc. 6. Arrangements of the next following day party and the next following evening party were the same as those of the main party. 7. The arranged seat of the Crown Prince was facing the west. 8. In the arrangements of tables for the Crown Prince, the heights of food on dishes as following levels, 1 dish : 1chok(1척) 6 dishes : 8 chon(8촌) 5 dishes : 7 chon(촌)

• Korean Journal of Radiology
• /
• v.24 no.7
• /
• pp.681-689
• /
• 2023

Objective: Three-dimensional rotational angiography (3D-RA) is increasingly used for the evaluation of intracranial aneurysms (IAs); however, radiation exposure to the lens is a concern. We investigated the effect of head off-centering by adjusting table height on the lens dose during 3D-RA and its feasibility in patient examination. Materials and Methods: The effect of head off-centering during 3D-RA on the lens radiation dose at various table heights was investigated using a RANDO head phantom (Alderson Research Labs). We prospectively enrolled 20 patients (58.0 ± 9.4 years) with IAs who were scheduled to undergo bilateral 3D-RA. In all patients' 3D-RA, the lens dose-reduction protocol involving elevation of the examination table was applied to one internal carotid artery, and the conventional protocol was applied to the other. The lens dose was measured using photoluminescent glass dosimeters (GD-352M, AGC Techno Glass Co., LTD), and radiation dose metrics were compared between the two protocols. Image quality was quantitatively analyzed using source images for image noise, signal-to-noise ratio, and contrast-to-noise ratio. Additionally, three reviewers qualitatively assessed the image quality using a five-point Likert scale. Results: The phantom study showed that the lens dose was reduced by an average of 38% per 1 cm increase in table height. In the patient study, the dose-reduction protocol (elevating the table height by an average of 2.3 cm) led to an 83% reduction in the median dose from 4.65 mGy to 0.79 mGy (P < 0.001). There were no significant differences between dose-reduction and conventional protocols in the kerma area product (7.34 vs. 7.40 Gy·cm², P = 0.892), air kerma (75.7 vs. 75.1 mGy, P = 0.872), and image quality. Conclusion: The lens radiation dose was significantly affected by table height adjustment during 3D-RA. Intentional head off-centering by elevation of the table is a simple and effective way to reduce the lens dose in clinical practice.