• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.16 no.1
• /
• pp.55-60
• /
• 2016

In the traditional wireless LAN model, scan procedure to search a new AP starts when the predefined number of Rx failure of beacon frames are occurred. In this case, lots of data packet loss occur during MN's handover because loss of the relatively longer data packet starts before the small-sized beacon loss. Newly developed scanning mechanism in this paper has the beacon counter that increases when the Rx power level of beacon frame is less than the threshold and the previous rx power level. New scan procedure starts when the counter exceeds the predefined number. Beacon Rx power threshold is verified and performance of the new WLAN model is evaluated under UDP and TCP traffic environment.

• Journal of information and communication convergence engineering
• /
• v.4 no.2
• /
• pp.71-74
• /
• 2006

A basic access method about IEEE 802.11 MAC layer protocol using IEEE 802.11 wireless LANs is the DCF thatis based on the CSMA/CA. But, cause of IEEE 802.11 MAC layer uses original backoff algorithm (exponential backoff method), when collision occurred, the size of contention windows increases the double size Also, a time of packet transmission delay increases and efficienty is decreased by original backoff scheme. In this paper, we have analyzed TCP packet transmission time of IEEE 802.11 MAC DCF protocol for wireless LANs a proposed enhanced backoff algorithm. It is considered the transmission time of transmission control protocol (TCP) packet on the orthogonal frequency division multiplexing (OFDM) in additive white gaussian noise (A WGN) and Rician fading channel. From the results, a proposed enhanced backoff algorithm produces a better performance improvement than an original backoff in wireless LAN environment. Also, in OFDM/quadrature phase shift keying channel (QPSK), we can achieve that the transmission time in wireless channel decreases as the TCP packet size increases and based on the data collected, we can infer the correlation between packet size and the transmission time, allowing for an inference of the optimal packet size in the TCP layer.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2006.05a
• /
• pp.530-533
• /
• 2006

Recently, a basic access method about IEEE 802.11 MAC layer protocol using IEEE 802.11 wireless LANs is the DCF thatis based on the CSMA/CA. But, cause of IEEE 802.11 MAC layer uses original backoff algorithm (exponential backoff method), when collision occurred, the size of contention windows increases the double size. Also, a time of packet transmission delay increases and efficiency is decreased by original backoff scheme. In this paper, we have analyzed TCP packet transmission time of IEEE 802.11 MAC DCF protocol for wireless LANs a proposed enhanced backoff algorithm. It is considered the transmission time of transmission control protocol (TCP) packet on the orthogonal frequency division multiplexing (OFDM) in additive white gaussian noise (AWGN) and Rician fading channel. From the results, a proposed enhanced backoff algorithm produces a better performance improvement than an original backoff in wireless LAN environment. Also, in OFDM/quadrature phase shift keying channel (QPSK), we can achieve that the transmission time in wireless channel decreases as the TCP packet size increases and based on the data collected, we can infer the correlation between packet size and the transmission time, allowing for an inference of the optimal packet size in the TCP layer.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2007.05a
• /
• pp.1346-1348
• /
• 2007

본 논문에서 제안하는 오류 공유 시스템은 홈 네트워크의 LAN 및 WAN 환경에서 UDP 브로드 캐스팅 및 IP 멀티캐스팅을 지원하며 적은 부하로 응용 프로그램에서의 오류를 다수의 사용자가 공유하도록 지원한다. 특히 기존의 TCP 를 이용한 방법과는 달리 참여자의 수에 관계없이 일정한 전송률과 동일한 응답 시간을 보장함으로써 동시에 모든 참여자들이 같은 결과의 오류를 인식하게 되며 사용자의 수의 증가에 따른 영향을 적게 받는다.

• Proceedings of the IEEK Conference
• /
• 2003.11b
• /
• pp.53-56
• /
• 2003

Ethernet is one of the most successful LAN technologies. Now gigabit ethernet is available in real network and some network interface cards(NIC) supports TCP segment offloading (TSO), IP checksum offloading(ICO), Jumbo frame and interrupt moderation. If we use this features appropriately, we obtain high throughput with low CPU utilization. This paper represents the network performance by varying above features.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.12 no.4
• /
• pp.379-384
• /
• 2002

This paper represents the mobile robot system remote controlled by PDA(personal digital assistance). So far, owing to the development of internet technologies, lots of remote control methods through internet have been proposed. To control a mobile robot through internet and guide it under unknown environment, We propose a control method activated by PDA. In a proposed system, PDA acts as a user interface to communicate with notebook as a controller of the mobile robot system using TCP/IP protocol, and the notebook controls the mobile robot system. The information about the direction and velocity of the mobile robot feedbacks to the PDA and the PDA send new control method produced from the fuzzy inference engine.

• Proceedings of the Korea Contents Association Conference
• /
• 2008.05a
• /
• pp.569-572
• /
• 2008

I proposed wireless ordering system using Qt embedded. This system will make the good use of real life applications and make fit for practical use. I embodied data input, transfer, gathering and back-transfer on wireless network using TCP/IP protocol on QSocket provided by Qt. Server environment is Linux 9.0 and gcc-2.95.3 on PC, and three target-boards consist PXA255 processor with wireless-LAN card which communicate through wireless access pointer. Software tools on target-board are gcc, tmake, qt-X11, qt-embedded and etc. I designed touch-screen interface for user convenience.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.915-919
• /
• 2005

It is materialized an unmanned vehicle system as a part of Intelligent Transportation System (ITS) which is a fundamental constituent for unmanned vehicle. Remote control system, monitoring system and remote operating system which are consisted of unmanned vehicle system. Network program by TCP/IP socket, and real-time control & operating controlled by servo-motors from a remote place, those are used to verify safety and stability of the unmanned vehicle system in this research. This unmanned vehicle is divided into two major sections which are an unmanned vehicle part and control station part. The server PC is installed on the unmanned vehicle and a client PC is installed at a remote place, which can control the u manned vehicle. In this research work, main theme is that we experimented and tested to check the speed and utilization of the wireless LAN communication.

• Proceedings of the KIEE Conference
• /
• 2001.11c
• /
• pp.50-52
• /
• 2001

반도체 장비간 통신의 표준인 SECS(SEMI Equipment Communication Standard)는 반도체 제조 업체에서 많이 사용되고 있다. SECS-I의 단점을 보완하기 위해 제안된 HSMS (High-speed SECS Message Services)는, TCP/IP를 지원하고 SECS-I에 비해 통신 속도가 높다. 사용자는 HSMS를 이용하여 LAN을 통한 장비 제어 및 모니터링이 가능하게 되었다. 그러나, 네트워크의 확장에 대한 관심 고조로 기존의 제한된 영역의 네트워크 구성에 대한 변화가 필요하게 되었다. 또한 사용자가 항상 LAN의 범위 내에서 장비 모니터링 및 제어하기에는 위치적 제약이 많다. 그렇지만 HSMS는 Web을 통한 데이터 전송 요구를 수용하지 못하고 있다. 따라서 SECS-II message가 Web을 통해 전송될 수 있는 새로운 포맷이 필요하다. 본 논문에서는, 구조화된 데이터를 정의하기 유리한 마크업 언어인 XML을 이용하여, SECS-II message를 Web으로 전송할 수 있는 포맷을 정의하고 이를 구현한다.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.107-107
• /
• 2000

This paper focuses on a method to connect mobile devices such as mobile robot, ACV and UTC with Profibus network. In this paper, the IEEE 802.11 wireless LAN is used for wireless extension of Frofibus, and four major issues are introduced to implement the wireless extended Profibus; First, the integration method between Profibus and IEEE 802.11 is introduced. Second, the implementation method of gateway is proposed. Three, the virtual polling mode algorithm is developed for satisfaction of real-time characteristics required in industrial network. Finally, we implement a experimental model, and carried out the performance analysis of wireless extended Profibus. This results show that wireless extended Profibus is suitable to industrial network such as automated container terminal.