• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.7
• /
• pp.1295-1302
• /
• 2016

In this paper, a black box, which is provided the reliability and user safety of home battery energy storage system connected with solar energy generation, is developed. In the developed scheme, a status and diagnosis data of battery management system, power conditioning system, solar energy generation and grid is measured. This status and diagnosis data is stored and displayed in the developed black box. In addition, this status and diagnosis data is stored and displayed in a monitoring system and a smart phone of user. A performance evaluation of the developed black box is carried out using emulator of home battery energy storage system connected with solar energy generation. Consequently, the developed black box is proved its superiority of the reliability and user safety.

• Proceedings of the KIEE Conference
• /
• 1993.07b
• /
• pp.833-836
• /
• 1993

A flyback type power converter circuit for switched reluctance motor drives is presented. In this converter circuit, the energy extracted from an off going phase is stored in an additional capacitor. The energy stored is used to either be returned to the source frequently or energize the conducting phase during the conduction interval through the transformer. The additional switch to pass the energy stored in the capacitor to the source or the conducting phase is switched under a relatively low voltage condition. Its switching frequency is relatively high so that the size of the transformer can be reduced. The design guideline for the capacitor and the transformer is described. The effectiveness of the presented converter circuit is compared to other circuits through the analysis and experiment.

• The Bulletin of The Korean Astronomical Society
• /
• v.39 no.1
• /
• pp.69.2-69.2
• /
• 2014

To estimate free magnetic energy stored in an active region is a key to the quantitative prediction of activity observed on the Sun. This energy is defined as an excess over the potential energy that is the lowest energy taken by a magnetic structure formed in the solar atmosphere including the solar corona. It is, however still difficult to derive the configuration of a coronal magnetic field only by observations, so we have to use some observable quantity to estimate free magnetic energy. Recently, by performing a coordinated series of three-dimensional magnetohydrodynamic simulations of an emerging flux tube that transfers intense magnetic flux to the solar atmosphere we have found an universal power-law relation between free magnetic energy and emerged magnetic flux, the latter of which is a possibly observed quantity. We further investigate what causes this relation through a comparison with a model of linear force-free field.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.67 no.3
• /
• pp.160-167
• /
• 2018

In this paper, a black box, which is provided the reliability and user safety of home battery energy storage system connected with solar energy generation, is developed. In the developed scheme, a status and diagnosis data of battery management system, power conditioning system, solar energy generation and grid is measured. This status and diagnosis data is stored and displayed in the developed black box. In addition, this status and diagnosis data is stored and displayed in a monitoring system and a smart phone of user. A performance evaluation of the developed black box is carried out using emulator of home battery energy storage system connected with solar energy generation. Consequently, the developed black box is proved its superiority of the reliability and user safety.

• Nuclear Engineering and Technology
• /
• v.54 no.6
• /
• pp.2334-2337
• /
• 2022

Deuterium-tritium reaction is the most promising one in term of the highest nuclear fusion cross-section for the reactor. So it is one of urgent issues to develop materials and components that are simultaneously resistant to high heat flux and high energy neutron flux in realization of the fusion energy. 2.45 MeV neutron production was reported in D-D reaction in KSTAR and regarded as beam-target is the dominant process. The feasibility study of KSTAR to wide area neutron source facility is done in term of D-D and D-T reactions from the empirical scaling law from the mixed fast and thermal stored energy and its projection to cases of heating power upgrade and DT reaction is done.

• Applied Biological Chemistry
• /
• v.31 no.2
• /
• pp.147-153
• /
• 1988

An assessment of the nutritional aspects on irradiated garlic bulbs, stored for 10 months at low$(3{\pm}1^{\circ}C,\;75{\sim}85%\;R.H.)$ and room$(12{\pm}5^{\circ}C,\;75{\sim}85%\;R.H.)$, was performed by means of investigations on the changes in some chemical composition. Ionizing energy treatment at 0.1kGy gamma-ray brought about no significant changes in the moisture content of stored garlic, but it contributed to the reduction of the changes in total available carbohydrate content of stored garlic. After 8 months of storage, the content of free sugars was significantly higher in nonirradiated garlic than in irradiated garlic, especially in low temperature storage. The 0.1kGy irradiation at the sprout-inhibition dose had no apparent effect on the content of ascorbic acid in stored garlic, and sulfurcontaining amino acids appeared to be little affected by the irradiation at 0.1kGy, even though there were some sensitive amino acids like glutamic and aspartic acids.

• Solar Energy
• /
• v.9 no.3
• /
• pp.44-54
• /
• 1989

Heat transfer phenomena during inward melting process of the phase change material were studied experimentally. N-docosane paraffin [$C_{22}H_{46}$] is used for phase change material and its melting temperature is $42.5^{\circ}C$. Experiments were performed for melting of an initially no-sub cooled or subcooled solid in a horizontal cylinder, in order to compare and investigate the radial temperature distribution, ratio of melting and melted mass, various energy components stored from the cylinder wall, figure of the melting front in the horizontal cylinder. The solid-liquid interface motion during phase change was recorded photographically. The experimental results reaffirmed the dominant role played by the conduction at early stage, by the natural convection at longer time during inward melting in the horizontal cylinder. Ratio of melting and melted mass are more influenced by wall temperature, rather than by the initial temperature of solid. The latent energy is the largest contributor to the total stored energy.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.03a
• /
• pp.577-587
• /
• 2004

A coaxial pulsed plasma thruster (PPT) with a Teflon cavity was designed, and its performance characteristics were examined varying stored energy, cavity length and capacitance. The PPT was tested as the entire system including the discharge circuit, and the results were explained with both the transfer efficiency and the acceleration efficiency. The transfer efficiency is defined as the fraction of energy in capacitors supplied into plasma, and the acceleration efficiency as the fraction of energy supplied into plasma converted to thrust energy. To estimate these efficiencies, the equivalent plasma resistance was defined and calculated using energy conservation during discharge. The equivalent plasma resistance proportionally increased with cavity length, and therefore the current peak increased with decreasing cavity length. The energy density calculated by the transfer efficiency was increased with decreasing cavity length. As a result, higher acceleration efficiency and lower transfer efficiency were obtained with shorter cavity length. Accordingly, there was an optimal cavity length for the thrust efficiency. The specific impulse and the impulse bit per unit stored energy ranged from 390 s and 50 $\mu$ Ns/J for a cavity length of 34 mm to 825 s and 11 $\mu$ Ns/J for a cavity length of 4 mm when the stored energy was fixed to 21.4J. Thus, it was showed that the performance of this PPT approached that of electromagnetic-acceleration-type PPT with decreasing cavity length. The PPT achieved thrust efficiencies of 10-12% at 21.4 J and 6-7% at 5.35 J at cavity lengths between 14 mm and 29 mm.

• Proceedings of the Korean Nuclear Society Conference
• /
• 2004.10a
• /
• pp.1417-1418
• /
• 2004

• Proceedings of the KSME Conference
• /
• 2007.05a
• /
• pp.1231-1236
• /
• 2007

This study presents the static and dynamic actuating performances of a bending piezoelectric actuator with a thin sandwiched PZT plate under a static load. The stored elastic energy within the actuators which occurs during a curing process is obtained through a flexural bending test. An actuating performance is evaluated in terms of an actuating displacement at the simply supported condition. The results reveal that an actuator that consists of a top layer having a high elastic modulus and a low coefficient of thermal expansion exhibits a better performance than the rest of actuators due to the formation of the large stored elastic energy within the actuator system. When actuators are excited at the alternating current voltage, the effect of PZT ceramic softening results in a slight reduction in the resonance frequency of each actuator as the applied electric field increases. It is thus suggested that the static and dynamic actuating characteristics of bending piezoelectric actuators with a thin sandwiched PZT plate should be simultaneously considered in controlling their performances.