• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.5
• /
• pp.418-426
• /
• 2016

This paper analyzes the effect of resistance error to the performance of sensorless drive system of surface-mounted permanent magnet synchronous machine (SMPMSM) based on the back-EMF observer. The analysis shows that the bandwidth of the entire sensorless drive system decreased in the low-speed region when using smaller resistance value than the actual one in the back-EMF observer. Even if the back-EMF observer invokes estimation error, the entire sensorless drive system does not make any steady-state position error. These characteristics may have positive effects such as extension of the low speed limit that goes further down in the sensorless drive. The validity of the analysis is verified by the experimental setup comprising the MG set.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.2
• /
• pp.183-189
• /
• 2011

An alignment algorithm for strapdown inertial navigation systems is proposed, in which the psi angle error model is utilized. The proposed alignment algorithm is derived from the Psi angle error model which has been widely used in real-time navigation systems. The equation for expecting steady state alignment error is also derived. The proposed algorithm was verified through real-time experiments. Experimental results show that the proposed algorithm can be used in the inertial navigation system and GNSS/INS integrated navigation system to get an initial attitude of the vehicle.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.5
• /
• pp.1172-1179
• /
• 1996

General adaptive noise canceller(ANC) suffers from the misadjustment of adaptive filter weights, because of the gradient-estimate noise at steady state. In this paper, an adaptive noise cancellation algorithm with speech detector which is distinguishing speech from silence and adaptation-transient region is proposed. The speech detector uses property of adaptive prediction-error filter which can filter the highly correlated speech. To detect speech region, estimation error which is the output of the adaptive filter is applied to the adaptive prediction-error filter. When speech signal apears at the input of the adaptive prediction-error filter. The ratio of input and output energy of adaptive prediction-error filter becomes relatively lower. The ratio becomes large when the white noise appears at the input. So the region of speech is detected by the ratio. Sign algorithm is applied at speech region to prevent the weights from perturbing by output speech of ANC. As results of computer simulation, the proposed algorithm improves segmental SNR and SNR up to about 4 dBand 11 dB, respectively.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.108.2-108
• /
• 2001

This paper presents the application of adaptive phase-locked loop (adaptive PLL) technique to control the process variable of the process control system. The adaptive algorithm is related to the error. When the error of the system is changed, the adaptive gain will be directly changed according to the error. If the value of the adaptive gain is large, the value of the error will be large. In this experiment, the reference input is 50% step input. The experimental result in controlling the first order lag process by the adaptive PLL shows that the response of the controlled system has no overshoot, short rise time, and zero steady-state error. The experimental result also shows that when the output disturbance enters to the process control system, the adaptive PLL can maintain the stability of the system and the effect of the output disturbance can also be fast rejected. The adaptive PLL has better performance ...

• 제어로봇시스템학회:학술대회논문집
• /
• 1991.10a
• /
• pp.1-6
• /
• 1991

This paper is concerned with the design of a robust tracking controller using a state observer on a robotic manipulator under the disturbance. The controller is designed to follow a step or ramp reference input without steady state error in the presence of a disturbance and a system parameter variation. In most cases, since all the state vectors are not measured, unmeasurable state vectors must be estimated or reconstructed. A reduced order observer is proposed to estimate unmeasurable state vectors of the non-linear system. Some problems are caused by the Coulomb friction, the disturbance, and the spring effect of a link between the drive motor and the manipulator arm. The state variables, directly measured and estimated by the reduced order observer, are fed back to the controller. When the robot system exhibits the 'limit cycle, the feedback gains initially obtained by optimal control theory are changed. As a result, the limit cycle is eliminated by the new controller gains,

• Journal of international Conference on Electrical Machines and Systems
• /
• v.3 no.3
• /
• pp.289-297
• /
• 2014

This paper proposed a novel high performance sensorless control scheme for IPMSM based on an extended nonlinear state observer. The gain-matrix of the observer has been derived by using state linearization method. Steady state errors in estimated rotor position and speed due to parameter inaccuracy have been analyzed, and an equivalent flux error is defined to represent the overall effect of parameter errors contributing to the wrong convergence of the estimated rotor speed as well as rotor position. Then, an online compensation strategy was proposed to limit the estimation errors in rotor position and speed. The effectiveness of the extended nonlinear state observer is validated through simulation and experimental test.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.26 no.8
• /
• pp.27-34
• /
• 2012

This paper proposes variable incremental conductance(IC) algorithm for maximum power point tracking(MPPT) control of photovoltaic. The conventional perturbation & observation(PO) and IC MPPT control algorithm generally uses fixed step size. A small step size reduces a tracking error in the steady state but slows a tracking speed in the transient state. Also, a large step size is fast a tracking speed but increases a tracking error. Therefore, this paper proposes variable IC MPPT algorithm that adjust automatically step size according to operating conditions. To improve a tracking speed and accuracy, when operating point is far from the maximum power point(MPP), the step size uses maximum value and when a operating point is near from the MPP, the step size uses variable step size that adjust according to slope of P-V curve. The validity of MPPT algorithm proposed in this paper prove through compare with conventional PO and IC MPPT algorithm.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.45.1-45
• /
• 2001

This paper proposes a Mamdani fuzzy PID controller for controlling a process with small dead time. The controller composes of a parallel structure of fuzzy PI controller and fuzzy PD controller. Each controller has two inputs, error and change of error. Hence, the control signal of the proposed controller is the average value of the output of the fuzzy PI and PD controllers. The Mamdani fuzzy PID controller is easily to be adjusted to meet the desired control system performances both in transient state and steady state. The simulation results of the proposed Mamdani fuzzy PID controller by using the same parameters (proportional gain, integral time and derivative time) as the conventional PID controller are shown. The response of the Mamdani fuzzy PID control system is faster than the conventional PID control system. Both system responses have ...

• Journal of Institute of Control, Robotics and Systems
• /
• v.8 no.3
• /
• pp.193-198
• /
• 2002

In this paper, we Propose a PD+I fuzzy controller using an error-accumulating applying factor. In fuzzy control, analytical study was done formerly, in which fuzzy control can be classified by PD type and PI type, and also the study for getting merits of both types was done, too. But the mixed type has a complex structure and many parameters. The proposed fuzzy controller is 2-input 2-out-put and PD type fuzzy control is used as a basic structure. And the proposed controller annihilates a steady-state error and improves transient responses because of using the error-accumulating applying factor which is determined in the real time along the current state of controlled process. Futhermore it is easy to tune the system because of decreasing the number of scaling factors and the I type controller with resetting resolves the integral wind-up problem. Finally we apply the proposed scheme to various plants and show the performance betterment.

• 제어로봇시스템학회:학술대회논문집
• /
• 1997.10a
• /
• pp.195-198
• /
• 1997

This paper proposes the effective compensation method of the rotor time constant of induction motor. An indirect vector control method is highly dependent on the motor parameters. To solve the problem of performance degradation due to parameter variation in an indirect vector control of induction motor, we compensate the rotor time constant by current error feedback. The proposed method is a simple on-line rotor time constant compensation method using the information from terminal voltages and currents. As the current error, difference between current command and estimated current, approaches to zero, the value of rotor time constant in an indirect vector controller follows the real value of induction motor. This scheme is valid transient region as well as steady state region regardless of low or high speed. This method is verified by computer simulation. For this, we constructed the simulation model of induction motor, indirect vector controller and current regulated PWM (CRPWM) voltage source inverter (VSI) using SIMULINK in MATLAB.