• Journal of Korean Society of Transportation
• /
• v.24 no.6 s.92
• /
• pp.89-102
• /
• 2006

The purpose of this paper is to develop a dynamic OD estimating model to overcome the limitation of depicting teal situations in dynamic simulation models based on static OD trip. To estimate dynamic OD matrix we used the hybrid discrete choice model(called the 'Demand Simulation Model'), which combines travel departure time with travel mode and travel path. Using this Demand Simulation Model, we deduced that the traveler chooses the departure time and mode simultaneously, and then choose his/her travel path over the given situation In this paper. we developed a hybrid simulation model by joining a demand simulation model and the supply simulation model (called LiCROSIM-P) which was Previously developed. We simulated the hybrid simulation model for dependent/independent networks which have two origins and one destination. The simulation results showed that AGtt(Average gap expected travel time and simulated travel time) did not converge, but average schedule delay gap converged to a stable state in transportation network consisted of multiple origins and destinations, multiple paths, freeways and some intersections controlled by signal. We present that the hybrid simulation model can estimate dynamic OD and analyze the effectiveness by changing the attributes or the traveler and networks. Thus, the hybrid simulation model can analyze the effectiveness that reflects changing departure times, travel modes and travel paths by demand management Policy, changing network facilities, traffic information supplies. and so on.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.5
• /
• pp.700-707
• /
• 2017

In the international natural gas market, natural gas has markedly low calories. The domestic calories standard of natural gas was changed and the performance and efficiency of many industrial machines using natural gas were affected because of low caloric natural gas. Therefore, in this study, a dual fuel engine fueled with natural gas and diesel was tested to examine the effects of the CNG substitution rate on the combustion characteristics, such as thermal efficiency, COVimep and heat release rate. The CNG substitution rate was defined as the ratio of CNG instead of diesel, which was calculated as the total energy. The conditions of the tested engine were fixed $1800rpm/500N{\cdot}m$. In addition, diesel fuel was injected at $16^{\circ}CA$ BTDC and the fuel pressure was fixed at 85 MPa; the lower heating value of CNG was $10,400kcal/Nm^3$. The results of the engine test showed that the amount of diesel fuel was changed according to the CNG substitution rate. Therefore, when the substitution rate was increased, the amount of diesel fuel was decreased, which affected the energy for ignition. In addition, the ignition delay duration was increased, which affected the thermal efficiency and torque. On the other hand, the COVimep was less than 5% and a stable combustion state of the engine was shown.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.8
• /
• pp.2484-2496
• /
• 2000

High speed switches have been developing to interconnect a large number of nodes. It is important to analyze the switch performance under various conditions to satisfy the requirements. Queueing analysis, in general, has the intrinsic problem of large state space dimension and complex computation. In fact, The petri net is a graphical and mathematical model. It is suitable for various applications, in particular, manufacturing systems. It can deal with parallelism, concurrence, deadlock avoidance, and asynchronism. Currently it has been applied to the performance of computer networks and protocol verifications. This paper presents a framework for modeling and analyzing ATM switch using stochastic activity networks (SANs). In this paper, we provide the ATM switch model using SANs to extend easily and an approximate analysis method to apply A TM switch models, which significantly reduce the complexity of the model solution. Cell arrival process in output-buffered Queueing A TM switch with finite buffer is modeled as Markov Modulated Poisson Process (MMPP), which is able to accurately represent real traffic and capture the characteristics of bursty traffic. We analyze the performance of the switch in terms of cell-loss ratio (CLR), mean Queue length and mean delay time. We show that the SAN model is very useful in A TM switch model in that the gates have the capability of implementing of scheduling algorithm.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.12
• /
• pp.6191-6196
• /
• 2012

Aims and Background: Traditional chemotherapy strategies for human leukemia commonly use drugs based on cytotoxicity to eradicate cancer cells. One predicament is that substantial damage to normal tissues is likely to occur in the course of standard treatments. Obviously, it is urgent to explore therapies that can effectively eliminate malignant cells without affecting normal cells. Our previous studies indicated that ginsenoside $Rg_1$ ($Rg_1$), a major active pharmacological ingredient of ginseng, could delay normal hematopoietic stem cell senescence. However, whether $Rg_1$ can induce cancer cell senescence is still unclear. Methods: In the current study, human leukemia K562 cells were subjected to $Rg_1$ exposure. The optimal drug concentration and duration with K562 cells was obtained by MTT colorimetric test. Effects of $Rg_1$ on cell cycle were analyzed using flow cytometry and by SA-${\beta}$-Gal staining. Colony-forming ability was measured by colony-assay. Telomere lengths were assessed by Southern blotting and expression of senescence-associated proteins P21, P16 and RB by Western blotting. Ultrastructural morphology changes were observed by transmission electron microscopy. Results: K562 cells demonstrated a maximum proliferation inhibition rate with an $Rg_1$ concentration of $20{\mu}\;mol{\cdot}L^{-1}$ for 48h, the cells exhibiting dramatic morphological alterations including an enlarged and flat cellular morphology, larger mitochondria and increased number of lysosomes. Senescence associated-${\beta}$-galactosidase (SA-${\beta}$-Gal) activity was increased. K562 cells also had decreased ability for colony formation, and shortened telomere length as well as reduction of proliferating potential and arrestin $G_2$/M phase after $Rg_1$ interaction. The senescence associated proteins P21, P16 and RB were significantly up-regulated. Conclusion: Ginsenoside $Rg_1$ can induce a state of senescence in human leukemia K562 cells, which is associated with p21-Rb and p16-Rb pathways.

• Journal of the Korean Vacuum Society
• /
• v.7 no.4
• /
• pp.368-373
• /
• 1998

As device dimensions approach submicrometer size in ULSI, the demand for interlayer dielectric materials with very low dielectric constant is increased to solve problems of RC delay caused by increase in parasitic resistance and capacitance in multilevel interconnectins. Fluorinated amorphous carbon in one of the promising materials in ULSI for the interlayer dielectric films with low dielectric constant. However, poor thermal stability and adhesion with Si substrates have inhibited its use. Recently, amorphous hydrogenated carbon (a-C:H) film as a buffer layer between the Si substrate and a-C:F has been introduced because it improves the adhesion with Si substrate. In this study, therfore, a-C:F/a-C:H films were deposited on p-type Si(100) by ECRCVD from $C_2F_6, CH_4$and $H_2$gas source and investigated the effect of forward power and composition on the thickness, chemical bonding state, dielectric constant, surface morphology and roughness of a-C:F films as an interlayer dielectric for ULSI. SEM, FT-IR, XPS, C-V meter and AFM were used for determination of each properties. The dielectric constant in the a-C:F/a-C:H films were found to decrease with increasing fluorine content. However, the dielectric constant increased after furnace annealing in $N_2$atomosphere at $400^{\circ}C$ for 1hour due to decreasing of flurorine content. However, the dielectric constant increased after furnace annealing in $N_2$atmosphere at $400^{\circ}C$ for 1hour due to decreasing of fluorine concentration.

• Journal of Drive and Control
• /
• v.12 no.4
• /
• pp.60-70
• /
• 2015

A front-end loader (FEL) mounted on an agricultural tractor is one of the most commonly used implements for farm work. However, when the tractor carries material using the bucket attached to the FEL on a sloping ground, the materials can spill or roll back over the operator due to the tilted body, thereby requiring the bucket surface to remain level at a constant value regardless of varying slopes. In this study, an active system for controlling the angle of the FEL bucket on a tractor based on the real-time measurement of ground slopes was developed to enable the bucket to constantly remain level. A FEL simulator operated based on an electro hydraulic proportional valve (EHPV) was constructed in the laboratory to develop a proportional-integral-derivative (PID) controller forming a virtual electronic control unit (ECU) on the computer, which could automatically adjust the bucket angles depending on varying input angles while sending SAE-J1939 associated messages via CAN BUS to the EHPV. The different parameter values for the PID controller due to the gravity effect of the bucket were determined using a manual PID tuning method while assuming that the tractor travels on either an ascending slope or a descending slope. The developed PID control-based self-leveling system showed a mean of steady-state errors of within $1^{\circ}$ and a mean of delayed times of ~ 0.8s when the step input of $+20^{\circ}$ was given, implying that the developed system and control algorithm would be effective in maintaining the bucket angle at a certain value. Future studies include the improvement of the control algorithm to reduce such a time delay as well as the application of the developed algorithm to the FEL mounted on a tractor tested at a testing ground.

• The KIPS Transactions:PartC
• /
• v.11C no.3
• /
• pp.361-370
• /
• 2004

All active nudes which have no physically direct connection with each other in If network must be able to compose and manage network topology Informations. Besides one active program can be performed by the active nodes when every active packet for this program is transmitted without any loss of packets. Also the active packets should be transmitted effectively to minimize the transmission delay and securely from threatens. In this thesis, the discovery scheme of active nodes is adapted for active nodes in IP networks to compose and manage the topology information. The scheme for the efficient, reliable and secure transmission of active packets is also proposed. The sequence number is assigned to every active packet. If a receiver detects the loss of active packet checking the sequence number, the receiver requests the retransmission of the lost packet to the previous active node. kiter receiving an active packet and adapting security and reliability schemes, intermediate active nodes not only copy and send the Packet Instantly but also apply some suity mechanisms to it. And the active packet transmission engine is proposed to provide these transmission schemes The simulation of the adapted active node discovery scheme and the proposed active packet transmission engine is performed. The simulation results show that the adapted active node discovery scheme is efficient and the proposed active engine has the low latency and the high performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.1A
• /
• pp.96-103
• /
• 2000

The voice traffic is one of the most important real-time objects in WATM(Wireless Asynchronous Transfer Mode) networks. In this paper, we propose a new MAC(Medium Access'Control) protocol for the efficienttransmission of voice traffic over WATM networks in the multimedia environment and compare the performanceto existing similar protocols. The new protocol separates the reservation slot period for voice and that for data toguarantee some level of QoS(Quality of Service) in voice traffic. This is denoted by a slot assignment functiondepending on the frame size. According to the characteristics of voice traffic which is repeatedly in silent states,the protocol allocates voice reservation request slots dynamically with respect to the number of silent(off state)voice sources and also sends the first block of talkspurt restarted after silent period with a reservation requestslot to reduce the access delay.The simulation results show that the proposed protocol has better performance than Slotted Aloha in bandwidthefficiency, and can serve a certain level of QoS by the given slot assignment function even when the number ofvoice terminals varies dynamically. This means we can observe that the new MAC protocol is much better thanthe NC-PRMA(None Collision-Packet Reservation Multiple Access) protocol.

• Journal of the Korea Society of Computer and Information
• /
• v.16 no.6
• /
• pp.165-178
• /
• 2011

A gigantic ship is constructed by assembling various types of ship blocks, each block being made by cutting and piecing the steel-plates together. The steel-plate piling process as the initial stage of ship construction sorts and manages the steel-plates according to the ship blocks that the steel-plates are used to make. The steel-plate piling process poses some problems such as process delay due to piling errors, safety vulnerability due to the handling of extra heavy-weight objects, and the uncertainty of work plan due to lack of information management in the pile spaces. We constructed a steel-plate piling process system based on the context-aware computing to resolve such problems. We built simulation system that can simulate the piling process and then established a smart space within the system by using tags, sensors and a real-time location system in order to collect context information. Workers receive an appropriate or intelligent service from the system.

• Sleep Medicine and Psychophysiology
• /
• v.6 no.1
• /
• pp.46-51
• /
• 1999

Objectives: Patients with premenstrual dysphoric disorder(or PMDD) have impairments of the social, occupational or academic function due to psychological or somatic symptoms, which have the characteristic pattern of symptom exacerbation in the week before menses begin and remission shortly after the onset of menses. In the chronobiological view, many researchers have assumed that the etiology of PMDD is the advanced circadian rhythm. It has been suggested that light has a therapeutic effect on PMDD, because evening light results in phase delay of circadian rhythm through the biochemical changes including melatonin. Methods: The authors investigated the therapeutic effect of light therapy on four patients with prospectively diagnosed PMDD by DSM-IV criteria using clinical psychiatric interview, Premenstrual Assessment Form(PAF) and Daily Rating Form(or DRF). In the evening(6:30pm-8:00pm), the 2,500 lux light administered for seven consecutive days during the symptomatic late luteal phase of menstrual cycle. Beck Depression Inventory(or BDI), Hamilton Rating Scale for Depression(or HAM-D), Spielberg State Anxiety Inventory(or SA), and DRF were evaluated before and after seven days of light therapy. Results: Premenstrual symptoms of PMDD could be effectively treated with the evening bright light therapy, especially in PMDD patients with atypical symptoms. In addition, the light therapy seemed to more effective on the psychologic symptoms than the somatic symptoms of PMDD. There was no significant side-effect of light therapy, except the transient and mild eye-strain in one case. Conclusions: In spite of the results of limited data from our clinical trial, the authors suggest that the potential use of light therapy as an alternative to the pharmacological management of patients with PMDD.