• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.10a
• /
• pp.154-162
• /
• 2005

In this paper, site response analyses were performed based on equivalent linear technique using the shear wave velocity profiles of 162 sites collected around the Korean peninsula. The site characteristics, particularly the shear wave velocities and the depth to the bedrock, are compared to those in the western United States. The results show that the site-response coefficients based on the mean shear velocity of the top 30m ($V_{S30}$) suggested in the current code underestimates the motion in short-period ranges and overestimates the motion in mid-period ranges. Also the current Korean code based on UBC is required to be modified considering site characteristics in Korea for the reliable estimation of site amplification. From the results of numerical estimations, new regression curves were derived between site coefficients ($F_a$ and $F_v$) and the fundamental site periods, and site coefficients were grouped based on site periods in the regions of shallow bedrock. The standard deviations of the proposed method was reasonable compared to site classification based on $V_{S30}$. Finally, new site classification system is recommended based on site periods for regions of shallow bedrock depth in Korea.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.7A
• /
• pp.725-733
• /
• 2006

In this paper, we propose an algorithm which makes the frequency of output signal synchronize with frequency of input signal in Equalization Digital On-channel Repeater (EDOCR) system which was proposed to overcome the disadvantage of conventional Digital On-Channel Repeater (DOCR). Also, we verify the algorithm by using the mathematical equivalent model and analysis the performance by implying the algorithm to EDOCR. The main idea is to use the frequency offset information, which comes from carrier recovery in the receiving part of EDOCR, when the demodulated symbol is re-modulated in transmitting part. Based on the proposed algorithm, EDOCR not only makes the output signal synchronized with input signal in frequency but also emit the output signal which satisfies the ATSC transmission standard without additional equipments such as Global Positioning System (GSP).

• Journal of Positioning, Navigation, and Timing
• /
• v.10 no.3
• /
• pp.229-234
• /
• 2021

In this paper, a study was conducted on the power amplifier control required to design an eLoran transmitter system using a low-height antenna. The eLoran transmitter developed during the eLoran technology development project conducted in Korea used a small 35 m antenna due to the difficulty of securing a site for antenna installation. This antenna height is very low compared to the height of 750 m which is required for eLoran 100 kHz signal transmission without any radiation loss. In the case of using such a small antenna, not only the radiation efficiency of the transmission is lowered, but also the power module control must be performed more precisely in order to transmit the eLoran standard signal. The equivalent RLC circuit of the transmitter system was implemented and transient analysis was conducted to derive the input required voltage for satisfying the output requirement. The voltage waveform was also generated by the RLC circuit analysis to generate the eLoran signal. Furthermore, we suggest power width modulation method to control eLoran power amplifier module more sophisticatedly.

• Journal of Intelligence and Information Systems
• /
• v.22 no.2
• /
• pp.115-125
• /
• 2016

The Bollinger Band indicating the current price position in the recent price action range is obtained by adding/substracting the simple standard deviation (SSD) to/from the simple moving average (SMA). In this paper, we first compare the characteristics of the SMA and the exponential moving average (EMA) in the operator's point of view. A basic equation is obtained between the interval length N of the SMA operator and the weighting factor ${\rho}$ of the EMA operator, that makes the centers of the 1st order momentums of each operator impulse respoinse identical. For equivalent N and ${\rho}$, frequency response examples are obtained and compared by using the discrete time Fourier transform. Based on observation that the SMA operator reacts more excessively than the EMA operator, we propose a novel exponential standard deviation (ESD) band centered at the EMA and derive an auto recursive formula for the proposed ESD band. Practical examples for the ESD band show that it has a smoother bound on the price action range than the Bollinger Band. Comparisons are also made for the gap corrected chart to show the advantageous feature of the ESD band even in the case of gap occurrence. Trading techniques developed for the Bollinger Band can be straight forwardly applied to those for the ESD band.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.5
• /
• pp.1-8
• /
• 2013

This paper implements an integrated vehicle chassis system of ACC(Adaptive Cruise Control) and LKS(Lane Keeping System) based on OSEK OS to vehicle operating system and analyzes its performance through experiments. In recent years active safety and advanced driver assistance system has discussed to improve safety of vehicle. Among the rest, We integrate ACC that controls longitudinal velocity of vehicle and LKS that assists a vehicle in maintaing its driving lane, then implement integrated control system in vehicle. Implemented control system uses OSEK/VDX proposed standard, which is aiming at reusability and safety of software for vehicle and removal hardware dependence of application software. Redesigned control system based on OSEK OS, which is supported by OSEK/VDX, can manage real-time task, process interrupt and manage shared resource. We show by results performed EILS(ECU-In-the-Loop Simulation) that OSEK OS-based integrated controller of ACC and LKS is equivalent conventional integrated controller of ACC and LKS.

• Journal of Arbitration Studies
• /
• v.23 no.2
• /
• pp.81-113
• /
• 2013

The World Trade Organization (WTO) offers remedies for non-compliance by the introduction of compensation or retaliation in the Dispute Settlement Understanding (DSU). There are no the provisions under the WTO DSU and it seems unclear what retaliation is attempting to achieve. Therefore, it is unclear whether the goal of WTO retaliation is to induce compliance or to restore the balance between the rights and the obligations of WTO members. It has been claimed the WTO has a strong dispute settlement system by providing retaliation when the recommendations and rulings of Dispute Settlement Body (DSB) are not complied with. But this seems to be inadequate to bring about effective and timely compliance. Especially there is a problem with free riding by a violating member because the level of retaliation is determined from the expiration of a reasonable period of time, providing an incentive to delay compliance. Also the level of the suspension of concessions or other obligations authorized by the DSB is equivalent to the level of nullification or impairment, according to DSU Article 22.4. However, if the member concerned objections to the level of the suspension proposed, the matter shall be referred to arbitration. The arbitrator shall not examine the nature of the suspension of concessions or other obligations to be suspended but shall determine whether the level of such suspension is equivalent to the nullification or impairment. The arbitrator makes an assessment standard of equivalence by comparing the suspension of concessions or other obligations and the nullification or impairment calculated in terms of the amount of trade. But it is necessary that other standards replace the quantitative standards when the level of the nullification or impairment cannot be quantified by concrete damages.

• Journal of the Korean Geotechnical Society
• /
• v.26 no.6
• /
• pp.39-44
• /
• 2010

In case of the design method, which is used in the inside and outside of the country, on corrugated multi plate structures, section modulus would be determined by assuming 2-dementioanl equivalent section of those structures. However, it is impossible to consider 3-dimentional effects when 2-dimentional design method is applied since structures are reinforced with a pattern of the 1200, 1600 mm reinforcements except the 800 mm reinforcement. Thus, in this study, technical specification standard is analyzed for the existing corrugated multi plate design methods, and section strengths, moments, and so on of equivalent and practical sections are compared and estimated using 3-dimentional FEM (finite element method) for semicircles and architectural features widely used. Based on the results of that analysis, analytical basis for 3-dimentional design of the CBS-RIB is suggested.

• Journal of Aerospace System Engineering
• /
• v.16 no.3
• /
• pp.42-51
• /
• 2022

An eVTOL aircraft, which is required to operate with low pollution/low noise in urban environments, mostly use battery-powered electric propulsion systems as power sources, not traditional propulsion systems such as reciprocating or turbine engines. Accordingly, certification preparation for the electric propulsion system and securing the safety of the electric propulsion system, are important issues. In the U.S., special technical standards equivalent to FAR Part 33 were issued to certify electric engines, and in Europe, various special conditions were established to certify electric propulsion systems. Thus, in Korea, the technical standards for the electric propulsion system for eVTOL aircraft must also be prepared in line with the U.S. and Europe. In this paper, SC E-19, the technical standard of the electric/hybrid propulsion system (EHPS) in special conditions, was analyzed. Additionally, securing the safety of the electric propulsion system of the aircraft are proposed, through the collaboration of SC E-19 technical standards with the existing aircraft safety evaluation procedure ARP 4761. Finally, through a case study of the Ehang 184 electric propulsion system, it has been confirmed that the proposed safety assurance method is applicable at the aircraft level.

• Composites Research
• /
• v.18 no.4
• /
• pp.14-20
• /
• 2005

To determine the effect of chemical structure of aromatic amino curing agents on thermal and mechanical properties, standard epoxy resin DGEBF (diglycidylether of bisphenol F) was cured with diaminodiphenyl methane (DDM) and diaminodiphenyl sulphone (DDS) in a stoichiometrically equivalent ratio. From this work the effect of aromatic amino curing agents on the thermal and mechanical properties is significantly influenced by the chemical structure of curing agents. In contrast, the results show that the DGEBF/DDS system having the sulfone structure between the benzene rings had higher values in the thermal stability, density, shrinkage ($\%$), thermal expansion coefficient, tensile modulus and strength, flexural modulus and strength than the DGEBF/DDM system having methylene structure between the benzene rings, whereas the DGEBF/DDS system presented low values in maximum exothermic temperature, conversion of epoxide, and grass transition temperature. These results are caused by the relative effects of sulfone group having strong electronegativity and methylene group having (+) repulsive property. The result of fractography shows that the grain distribution of DGEBF/DDS system is more irregular than that of the DGEBF/DDM system.

• Lingua Humanitatis
• /
• v.8
• /
• pp.331-367
• /
• 2006

In this paper I attempted to investigate the matters related with the clarification of the close relationship between writing system and pronunciation. On the way of pursuing the research on the subject I found the fact that the same topic has been the main academic target in Korea. There have been some remarks about English alphabets and pronunciation. Nevertheless, the relation between alphabet codes and pronunciation tokens wasn't considered as the main key to master the English pronunciation correctly and completely. As the main target of this paper I argue that it is necessary to comprehend the connection. Then, we can recognize the significant role of alphabetic structure for understanding the gist of pronunciation exercise. This paper is classified into four parts. Each part consists of the material to affirm the fact that writing system should be the inevitable equivalent of sound system, and vice versa. In the first section I show that the development of the way of pronouncing English words is closely related with the endeavors of the scholars. While performing the survey of the studies about the alphabetic structure of the age many scholars found that the spelling construction was recorded without any common denominator. Thus, they not only sought to stage the bedrock for the standard written form of words but also to associate the alphabet letters with phonetic features. Secondly I mention the negative aspect of the 'only spelling based English pronunciation education' for the educational goal of 'Phonics methodology.' In this part I suggest the essentiality of phonemic properties with the phonetic prospect: phonemic awareness. Thirdly I refer to the standardization of the spelling system of English. As the realm of application of the language is extended toward the various professional areas such as commercial, scientific, and cultural spheres, it is quite natural to assume that the usage of the language will be transformed according to the areas in the world. Fourthly I introduce the first English-Korean grammar book with the section of 'the introduction to English pronunciation.' At the chapter the author explained the sound features of English based on the regulation of 'Scientific Alphabet' of U.S.A. In the transcribing system all the symbols were postulated on the basis of the English alphabet form instead of the separate phonetic signs of IPA.