• Journal of Advanced Navigation Technology
• /
• v.15 no.6
• /
• pp.1053-1058
• /
• 2011

In this paper, we propose a concatenated single antenna diversity system to assure the data transmission reliability between flight type air nodes which move according to their atypical orbit, then analyze its performance. The proposed system achieve a diversity gain using single antenna and a coding gain from convolutional code simultaneously. Simulation result about the bit error rate(BER) of the proposed system shows that its BER performance is about 9.5dB greater than convolutional code at $10^{-4}$ and about 14dB greater than space time block code at $10^{-3}$ which has a full diversity gain. In addition, compared with space time trellis code with diversity gain and coding gain, the proposed system shows the better 4dB at a BER of $10^{-5}$. Therefore, it is necessary that concatenated single antenna diversity should be adopted to the reliable data transmission of flight type air nodes.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.12
• /
• pp.4305-4323
• /
• 2014

In this paper, we investigate the degrees of freedom (DOF) of the Y channel consisting of three single-antenna users and a two-antenna common access relay, where each user intends to exchange independent messages with the other two users with the assistance of the relay. We show that the DOF of this particular scenario is 1.5. In order to prove this result, we firstly derive a DOF upper bound based on cut-set bound by allowing cooperation among users, which shows that the total DOF is upper bounded by 1.5. Then we propose a novel transmission scheme based on asymmetric signal space alignment (ASSA) to demonstrate the achievability of the upper bound. Theoretical evaluation and numerical results confirm that the upper bound can be achieved by utilizing ASSA, which also proves the optimality of the ASSA-based scheme in terms of DOF. Combining the upper bound and achievability, we conclude that the exact DOF is 1.5. Moreover, we present a novel iterative joint beamforming optimization (I-JBO) algorithm to further improve the sum rate. Numerical simulations have been provided to demonstrate the convergence speed and performance advantage of the I-JBO algorithm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.5
• /
• pp.681-688
• /
• 2000

In this paper, a planar antenna that is small and light, is designed and analyzed aiming handset antenna of IMT-2000. Employing the Ensemble simulator based on a MoM, design-parameters are found to determine a resonant frequency. Therefore, it is analyzed with the Ensemble simulation and FDTD numerical for resonating at the allocated frequency for IMT-2000 in the fixed antenna dimension of 21$^{\circ}$wing angle that is a design parameter. Analyzing with FDTD method, Though the results of FDTD are very exact, this analysis introduces errors due to the staircasing approximation in the slope of bowtie. To reduce this error, it is divided to 4-ranges where the cell contains the boundary of perfect conductor/free space. Then, each range is calculated by different by different equation, which modify the H-field to add the component of the area and length of the cell filled with free space. Therefore, the modified FDTD algorithm provided with a narrow bandwidth of return loss calculated with a standard FDTD algorithm that can be extended to the desired ranges.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.47 no.10
• /
• pp.705-711
• /
• 2019

Dynamic behaviors of the deployable composite reflector antenna are numerically and experimentally investigated. Equations of the motion are formalized using Kane's equation by considering multibody systems with two degrees of freedom such as folding and twisting angles. To interpret structural deformations of the reflector antenna, the composite reflector is modeled using a beam model with the FSDT(First-order Shear Deformation Theory). To determine design parameters such as a torsional spring stiffness and a damping coefficient depending on deployment duration, an inverted pendulum model is simply applied. Based on the determined parameters, dynamic characteristics of the deployable reflector are investigated. In addition, its results are verified and compared through deployment tests using a gravity compensation device.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.1
• /
• pp.90-97
• /
• 2010

In this paper, we propose antenna topology and ground plane shape to improve the performance of PIFA (Planar Inverted F Antenna) which is built-in mobile phone. First, we designed the PIFA antenna consists of multiple radiators to provide multi-current paths. Then we designed U-shaped ground plane on the PCB under the antenna. The proposed antenna structure shows TRP/TIS improvement of 2.0 dB/3.7 dB for GSM and 2.2 dB/ 2.0 dB for DCS and 0.8 dB/1.5 dB for PCS and 1.3 dB/0.7 dB for WCDMA at the free space.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.1 s.92
• /
• pp.1-8
• /
• 2005

This paper proposes a new type of a dual-band internal antenna for GPS/PCS handsets. The antenna has three monopoles in different lengths, and this structure is referred as a 3-fingers type antenna in this paper. The antenna with low-profile structure is designed to use internal space of handset maximally. The fabrication and the measurement are accomplished by attaching the 3-finger type antenna to the inside of a commercial handset. We obtain gain of 1.97 dBi$\~$0.66 dBi in the GPS band, and -0.92 dBi$\~$1.02 dBi in the PCS band and almost omni-directional patterns at all bands.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.2
• /
• pp.74-79
• /
• 2010

We have designed a millimeter-wave passive imaging sensor with multi-horn antenna array. Six horn array antenna is suggested that it is integrated into one housing, and this antenna is effectively configurated m space to assemble with LNA of WR-10 structure. Antenna is designed to have the peak gain of 17.5dBi at the center frequency of 94GHz, and the return loss of less than -25dB in W-band, and the small aperture size of $6mm{\times}9mm$ for antenna configuration with high resolution. LNA is designed to have total gain of more than 55dB and noise figure of less than 5dB for good sensitivity. We made a detector for DC output translation of millimeter-wave signal with zero bias Schottky diode. It is shown that good sensitivity of more than 500mV/mW.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.5
• /
• pp.2325-2331
• /
• 2012

Planar square-spiral antenna using a strip conductor is proposed and analyzed for RFID system in UHF band operating from 860MHz to 960MHz. By varying the length of common line, detached distance, strip line-space, strip line-width and the number of spiral turn, the optimized antenna are designed and fabricated in compact size without a matching-stub between the input port of the proposed antenna and RFID tag chip. From the optimized results, the frequency bandwidth in VSWR<2 has covered 100MHz in the RFID UHF band. The antenna gain has obtained 3.5dBi at the center frequency of 910MHz and the desired beam pattern has shown directional pattern on elevation and azimuth angle. Therefore, the proposed antenna is suitable for practical RFID applications requiring various tag chips with the specific input impedance.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.3
• /
• pp.230-239
• /
• 2009

In this paper, we propose a novel on-glass antenna for FM radio reception in a recreation vehicle(RV). We use a multi-loop structure that takes advantage of a broad matching bandwidth and a high vertical radiation gain by efficiently utilizing a given space of a quarter glass in spite of the simple planar structure. Transparency of the antenna is also improved by adjusting the stripline widths based on the induced current distributions. The proposed antenna is printed on a quarter glass of a commercial vehicle and antenna performances such as the return loss and the gain are measured in a semi-anechoic chamber. The result shows the average gain of -9.67 dBi along the bore-sight direction($\theta=90^{\circ}$, $\phi=270^{\circ}$) in the FM radio band(80$\sim$l10 MHz), which is higher than a commercial monopole typed on-glass antenna($G_{ave}$=-12.49 dBi) and micro-antenna($G_{ave}$=-19.24 dBi) mounted on the roof of the RV.

• Journal of Advanced Navigation Technology
• /
• v.25 no.5
• /
• pp.384-389
• /
• 2021

An optimal ground station (GS) antenna pattern design method for network-based UAV command and control communication systems considering complexity and performance is presented. The GS antenna consists of multiple side sectors and one upward sector. The antenna gain for each vertical/horizontal angle of the GS antenna according to the change of antenna design parameters such as the number of sectors, horizontal and vertical beam-width, and tilt-angle is modeled, and the effect of the parameter changes on the signal-to-noise ratio (SNR) distribution in the virtual three-dimensional space is analyzed. It is observed that the tilt-angle of the side sectors has the greatest effect on the performance, and the longer the distance between GSs, the higher the maximum altitude and the smaller the number of side sectors, the tilt-angle should be lower. In addition, it is observed that the wider vertical beam-width of the side sector is advantageous in maximizing the lowest SNR, but narrow vertical beam-width is advantageous in maximizing the average SNR.